• Proceedings of the Korean Vacuum Society Conference
• /
• 2015.08a
• /
• pp.185.2-185.2
• /
• 2015

Tin Oxide (SnO2) has been widely investigated as a transparent conducting oxide (TCO) and can be used in optoelectronic devices such as solar cell and flat-panel displays. In addition, it would be applicable to fabricating the wide bandgap semiconductor because of its bandgap of 3.6 eV. There have been concentrated on the improvement of optical properties, such as conductivity and transparency, by doping Indium Oxide and Gallium Oxide. Recently, with development of fabrication techniques, high-qulaity SnO2 epitaxial thin films have been studied and received much attention to produce the electronic devices such as sensor and light-emitting diode. In this study, powder sputtering method was employed to deposit epitaxial thin films on sapphire (0001) substrates. A commercial SnO2 powder was sputtered. The samples were prepared with varying the growth parameters such as gas environment and film thickness. Then, the samples were characterized by using XRD, SEM, AFM, and Raman spectroscopy measurements. The details of physical properties of epitaxial SnO2 thin films will be presented.

• Journal of the Korean Applied Science and Technology
• /
• v.8 no.1
• /
• pp.45-49
• /
• 1991

The synthesis of urocanic acid which was started D-fructose, and its alkyl esters, urocanic ethyl ester and urocanic isobutyl ester, were prepared by esterificated. Urocanic ethyl ester and urocanic isobutyl ester were insoluble in water and soluble most organic solvents (ethanol, benzene, toluene, pyridine, THF, DMF) which adds to their practical applicability, and absorb ultraviolet light of greater wavelength than the free acid and there by are more effective for shielding sensitive materials, including the humanbody, from the chemically most effective portion of the solar ultraviolet spectrum.

• Journal of The Korean Astronomical Society
• /
• v.28 no.1
• /
• pp.77-87
• /
• 1995

An attempt has been made to analyze time series of $H_\alpha,\;H_\beta,\;and\; H_\gamma$ line profiles taken from a 3B/X6.1 flare which occurred on Oct. 27, 1991 in an active region, NOAA 6891. A total of 22 sets of $H_\alpha,\;H_\beta,\;and\; H_\gamma$ taken with a low and non-uniform time resolution of 10-40 seconds were scanned by PDS with absolute intensity calibration to derive the physical characteristics of the material in the flare chromosphere. Our . results are as follows: (1) The lower Balmer lines observed during the flare activity are broadened by Stark effect. (2) At the peak of the flare activity, the electron temperature of the Balmer line emitting region reaches up to 35000K and its geometrical thickness increases to a scale of $10^4km$, suggesting that high energy particles penetrate deep into the photospheric level.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2011.10a
• /
• pp.12.1-12.1
• /
• 2011

최근 p-type 결정질 실리콘 태양전지의 광열화현상(light induced degradation)에 대한 관심이 높아지면서, 이를 해결하기 위한 많은 연구들이 수행되고 있다. 본 연구에서는 LID 현상을 원천적으로 제거 할수 있는 n-type 기판을 이용하여, 상업적으로 양산화 가능한 공정을 도입하고, 시뮬레이션을 통하여 고효율화 방안을 제시하고자 한다. 이를 위해 일반적인 p-type 결정질 실리콘 태양전지 제작 공정을 사용하여 알루미늄이 도핑된 후면 에미터 구조의 n-type 결정질 실리콘 태양전지를 제작하였으며, PC1D 시뮬레이션을 통해서 n+/n/p+구조의 n-type 결정질 실리콘 태양전지의 에너지 변환 효율 향상을 위한 방안을 제시하였다.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2009.10a
• /
• pp.399-401
• /
• 2009

Transparent conductive metal oxide films of $In_{2-x}Ti_xO_3$ (ITiO) and $In_{2-x}Sn_xO_3$ (ITO) were deposited by RF magnetron sputtering at substrate temperature of $300^{\circ}C$ and at high rate (${\sim}10$nm/min). Electrical and optical properties of the films were investigated as well as film structure and morphology, as it is compared with the commercial F:$SnO_2$ (FTO) glass. Near infrared ray transmittance of ITiO is the highest for wavelengths over 1000nm, which can increase dye sensitized compared to ITiO and FTO. Dye-sensitized solar cells (DSCs) were fabricated using the ITiO, ITO and FTO. Photoconversion efficiency (${\eta}$) of DSC using ITiO is 5.5%, whereas 5.0% is obtained from DSC with ITO. both at 100 mW/$cm^2$ light intensity.

• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.2182_2183
• /
• 2009

최근 화석연료에 대한 에너지의존도가 높아지면서 철도차량분야에서 대체에너지를 도입하기 위한 연구가 이루어지고 있다. 본 논문에서는 지자체를 중심으로 활발하게 진행되거나 검토되고 있는 경량전철 시스템에 대해 대체에너지로 각광받고 있는 태양광 발전시스템에 대한 도입 타당성 검토를 연구하였다. 경량전철 전력설비 계통에 태양광 발전시스템을 연계하고자 했을 때, 검토되어야 할 기술적인 사항 등에 대한 조사하였으며, 특히 태양전지판을 경량전철 노선 벽면에 설치하였을 때 발전량이 확보할 수 있는지에 대한 선행연구를 하였다.

• 한국신재생에너지학회:학술대회논문집
• /
• 2011.05a
• /
• pp.105.1-105.1
• /
• 2011

To enhance the performance of photovoltaic a-Si:H solar cells with a hybrid-type light absorbing structure of single crystal silicon nanoparticles (Si NPs) in a-Si:H matrix, single crystal Si NPs were produced by laser pyrolysis. The Si NPs were synthesized by $SiH_4$ gas decomposition using a $CO_2$ laser. The properties of Si NPs were controlled by process parameters such as $CO_2$ laser power, reactive gas pressure, and $H_2/SiH_4$ gas flows. The crystalline properties and sizes of Si NPs were analyzed by High Resolution Transmission Electron Microscopy (HRTEM). The sizes of Si NPs were controllable in the range of 5-15 nm in diameter and the effects of process parameters of laser pyrolysis were systematically investigated.

• New & Renewable Energy
• /
• v.1 no.1 s.1
• /
• pp.79-86
• /
• 2005

This study conducted an analysis of economic feasibility with unit generating costs calculated based on scenarios of capacity factors, discount rates, government supporting rates, installation costs. However, It Is clear that few new and renewable energies can meet the tariffs [government purchasing prices] set by the government in light of the current market reality. Without the government support, solar PV is not economically feasible at the tariff of \716.40/kWh. in the case of wind Power, the current tariff of \107.66/kWh is not enough to make it competitive except for a mid- and large-scale wind farm The analysis showed that even small hydro is not economically acceptable at the current tariff of \73.69/kWh.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.11 no.1
• /
• pp.8-14
• /
• 1975

The optical properties of the sea water were studied by use of underwater lux-meters in the coastal waters of Busan from May to November 1975. The absorption coefficient of the sea water in the area ranges from O. 169 to 1. 049 and the mean absorpflOn coefficient is 0.413. Maximum monthly mean absorption coefficient (0. 56) was observed in August, while the minimum was O. 338 in September. There was a distinct discontinuity layer of the absorption coefficient in accordance with the thermocline and the halocline in summer. The mean transparency of the area was 3. 8 meters, and transparency in autumn was higher than that in summer. The relation between absorption coefficient (m) and transparency (D) was deduced, m=1. 57/ D. The rate of light penetration at 5 m-layer of sea water was 2. 5 percent when the solar altitude was six degree in July 1975.

• 한국태양에너지학회:학술대회논문집
• /
• 2009.04a
• /
• pp.256-262
• /
• 2009

Purpose of this study is embody the environmental-friendly military facility model that applied renewable energy, passive design method and high efficiency equipment. In the introduction of this study, defined problem of existing military facility and classification of military facility are performed. Also, environmental friendly military facility is defined through classified by scale and building equipment method. In the renewable energy chapter, photovoltaic system and wind turbine system are considered And then, LED light, photovoltaic panel, motor, inverter are analyzed in the high efficiency equipment chapter.