• Korean Journal of Soil Science and Fertilizer
• /
• v.48 no.3
• /
• pp.189-193
• /
• 2015

Bad drainage problems from paddy fields adjacent to roads are caused by higher constructed roads which change topography of paddy fields to concave topography and artificial pan to prevent road erosion when road constructions are occurred. This study investigated effects of topography changes on soils by road constructions. Soil samples were investigated by physico-chemical analyses and micromorphology analyses from representative soil profile of Sachon series and soil samples. The characteristics of Sachon series that were adjacent to roads were fewer redoximorphic features (RMF) and increase in grey layers than the original Sachon series. The characteristics of Yecheon Series were shown from Jeollanamdo - Suncheon > Chungchungnamdo - Cheonan > Gangwondo - Wonju. Mosaic speckles were shown from micromorphological analyses because of repeat of shrink and expansion by wetting and drying. The location of graying in soil clods were found from coarse stone blocks to fine stone blocks and color changes of composed particles were also found.

• Journal of the Korean GEO-environmental Society
• /
• v.17 no.5
• /
• pp.37-46
• /
• 2016

In order to determine the variability of environmental characteristics of lightweight air-foamed soil using marine clay according to freezing-thawing and soaking conditions, unconfined compressive strength of the lightweight air-foamed soil samples made by changing the amount of cement under curing conditions of outdoor low temperature, underground or indoor wetting were observed. Compressive strength was not increased under freezing-thawing (temperature range of $-9.1^{\circ}C{\sim}17.2^{\circ}C$) regardless of the amount of cement but the more cement using, it was increased rapidly by underground curing conditions within 30 cm beneath ground level. Therefore, it is necessary to install insulation layer cutting off exterior cold air after construction of lightweight air-foamed soil in condition of freezing-thawing. Bulk density was increased too small under the long-time soaking condition, it tended to decrease rapidly when samples were dried up and had below 6% of water contents. But variability of compressive strength and bulk density was very small for preventing drying and keeping its wet state. The lightweight air-foamed soil that installed beneath ground water level or covered by soil can be evaluated as a long-term reliable construction material.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.09a
• /
• pp.764-771
• /
• 2010

The stability analysis method of an unsaturated slope considering the suction stress was performed on the infinite sand slope. During drying and wetting processes, the Soil-Water Characteristics Curve (SWCC) of the sand with the relative density of 75% was measured using the automated SWCC apparatus. Also, the Suction Stress Characteristics Curve (SSCC) was estimated. Based on these results, the stability analysis of an unsaturated infinite slope was carried out considering the slope angle, the weathering zone and the relative change in friction angle as a soil depth. According to the result of slope stability analysis, the safety factors of slope were less than 1 when the slope angles were more than $50^{\circ}$. The safety factors of slope tend to increase with increasing the depth from the ground surface. Especially, the safety factors have a tendency to increase and decrease above near the ground water level due to the suction stress. The maximum safety factor of slope in this analysis was occurred at the Air Entry Value (AEV) of drying process. The influence range of suction stress above the ground water level can be found out and can be defined as the funicular zone which means the metric suction range from the air entry point to the point of residual volumetric water content.

• Journal of the Korean Geotechnical Society
• /
• v.33 no.11
• /
• pp.97-104
• /
• 2017

A bentonite mixing with local soil widely used as liner layer for landfill should have low permeability less than $1{\times}10^{-7}cm/s$. But there are several limitations of bentonite used as liner layer, such as drying shrinkage cracking, ineffective waterproof ability under salt water condition like flocculation under sea water. The purpose of this research is the development of a salt resistance bentonite by mixing sepiolite and guar gum to overcome the weak points of bentonite to get high water resistance capacity and permeability coefficient below $1{\times}10^{-7}cm/s$ under salt water condition. After having performed drying shrinkage cracking test, swelling index test, compaction test, and hydraulic conductivity test we confirmed the optimal mixing ratio of materials and evaluated the performance of materials.

• Journal of Industrial Technology
• /
• v.3
• /
• pp.75-85
• /
• 1983

This study is conducted to provide useful fertilizer or soil conditioner of sludge from nightsoil treatment plant. Several possibilities present themselves. The major sink for disposal of waste sludge is the land, and in this case values will be measured primarily in terms of agricultural benefits. According to the result of sludge drying experiment, the drying rate with mixing once a day was more increased by three times than the state without mixing. And in sludge, N was 7-9%, P was 0.85-4.14%, and coliform groups in dried sludge were 75 MPN/gr.

• Geomechanics and Engineering
• /
• v.33 no.1
• /
• pp.29-40
• /
• 2023

Xanthan gum and starch compound biopolymer (XS), an environmentally friendly soil-binding material produced from natural resources, has been suggested as a slope protection material to enhance soil strength and erosion resistance. Insufficient wet strength and the consequent durability concerns remain, despite XS biopolymer-soil treatment showing high strength and erosion resistance in the dried state, even with a small dosage of soil mass. These concerns need to be solved to improve the field applicability and post-stability of this treatment. This study explored the utilization of an alkaline-based cation crosslinking method using calcium hydroxide and sodium hydroxide to induce non-thermal gelation, resulting in the enhancement of the wet strength and durability of biopolymer-treated soil. Laboratory experiments were conducted to assess the unconfined compressive strength and cyclic wetting-drying durability performance of the treated soil using a selected recipe based on a preliminary gel formation test. The results demonstrated that the uniformity of the gel structure and gelling time varied depending on the ratio of crosslinkers to biopolymer; consequently, the strength of the soil was affected. Subsequently, site soil treated with the recipe, which showed the best performance in indoor assessment, was implemented on the field slope at the bridge abutment via compaction and pressurized spraying methods to assess feasibility in field implementation. Moreover, the variation in surface soil hardness was monitored periodically for one year. Both slopes implemented by the two construction methods showed sufficient stability against detachment and scouring, with a higher soil hardness index than the natural slope for a year.

• Korean Journal of Environmental Agriculture
• /
• v.19 no.5
• /
• pp.442-449
• /
• 2000

The bioremediation is an economic technology to remove the organopollutants from soil. It is often found that the remediation could not remove the compounds below the levels determined by vigorous extractions as required by regulatory agencies. The reason for the reduced bioavailability with increasing time of aging has been accredited to the sequestration of the compounds in remote sites within or between soil particles. Then, the aging could be defined as the time-dependent sequestration. Partitioning and entrapment have been suggested as mechanism for aging. The rate and extent of the sequestration varies among dissimilar soils. The bioavailability of aged pollutants in soil could be measured by bioassays, mild solvent extraction, and soild-phase extractions. The sequestration could be affected by many factors including various soil properties, wetting and drying cycle, and the presence of cosolutes and NAPLs etc. The bioavailability and sequestration should be considered to determine the environmentally acceptable endpoint.

• Asian-Australasian Journal of Animal Sciences
• /
• v.12 no.2
• /
• pp.220-225
• /
• 1999

The environmental conditions in smallholder dairy farms especially the effects of dairy wastes on waters and soil were the main objectives of this investigation. Forty-three dairy farms from an older dairy cooperative (Nongpho Dairy Cooperative, NP) were compared with four dairy fauns from relatively new dairy cooperative (Kamphaengsaen Dairy Cooperative, KS) for the quality parameters of water and soil samples during a 12-month period. Forty-three farms at NP were from three geographical areas and three levels farm crowdedness. The results from this study clearly showed that the waste waters from older dairy barns contained much higher levels of organic and inorganic substances which could create environmental pollution if not properly managed. The differences in waste water qualities due to areas and seasons were not significant, while waste water samples from crowded farms tended to contain higher averages of waste water parameters such as COD and BOD. Highly significant correlations between pairs of waste water parameters indicated that certain parameters can be used without the need for chemical analysis of some other parameters. The qualities of well water on dairy farms as well as water samples from public waterways nearby indicated some contamination of dairy wastes such as manure. Storage and sun-drying of dairy manure on bare soil surface could result in the contamination of underground water and nearby water sources. Some recommendations from this study if implemented can prevent environmental pollution in smallholder dairy farms.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.37 no.1
• /
• pp.81-89
• /
• 1995

The aim of the work described in this paper is to develope a constitutive model for the prediction of an unsaturated Soil and to confirm the application of the model, which is composed of the elastic and plastic part in consideration of the matric suction and the net mean stress. From test results, volume changes and deviator stresses are analyzed at each state and their relationships are formulated. And the application of the model to silty sands is con- firmed by the comparison between test and predicted results. During drying-wetting and loading-unloading processes for isotropic states, the agreement between predicted and test results are satisfactory. And predicted deviator stresses are well agreed with test results in shearing process. Overall acceptable predictions are reproduced in high confining pressure. Usefulness of the model is confirmed for the unsat- urated soil except volumetric strain, which is not well agreed with the test results due to deficiency of dilatancy of the model in low confining pressure. It is, therefore, recom- mended to study the behavior of dilatancy for an unsaturated soil.

• Journal of the Korean GEO-environmental Society
• /
• v.13 no.4
• /
• pp.71-76
• /
• 2012

Shear strength of soil is power that resists failure and sliding according to any face in soils and one of the most important factors during engineering properties of soil. Shear strength is used for engineering science problems as bearing capacity methods of foundation or piles, slope stability after dam or Cutting Embankment and stability problem analysis of soils as lateral earth pressure of soil structures, ets. This study has analyzed shear strength change of samples classified 2.00mm(10sieve)와 0.85mm(20sieve), 0.475mm(40sieve) using direct shear tester after removing and drying cohesive soil ingredient of Weathered granite soil Therefore, this study would help studies about shear strength properties by particle size.