• Journal of electromagnetic engineering and science
• /
• 제7권3호
• /
• pp.122-128
• /
• 2007

In this paper, we present the design and measurement of a side-fed circularly-polarized patch antenna with a dielectric loading. The antenna consists of a comer-truncated rectangular patch, an L-shaped ground plane, a dielectric loading material, and a coaxial probe. An antenna operating at the UHF band (910 MHz) for the RFID reader applications is optimized using a commercial software. The size of the patch is reduced by a factor of 1.73 by loading the patch with mono-cast(MC) nylon. Measurements of the fabricated antenna show performance characteristics comparable to those of much larger commercial RFID reader antennas.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2003년도 춘계종합학술대회
• /
• pp.546-550
• /
• 2003

For dual-band operation, it can be done by loading two pair of narrow slots in the equilateral-triangular patch, one embedded close to the side edges of the patch and the other inserted at the bottom edge of the patch. The obtained two operating frequencies are of same polarization planes. The frequency ratio of the two operating frequencies is turnabled by varing the positions and lengths of the inserted slots at the bottom edge of the patch. In this paper, A single-feed equilateral-triangular microstrip patch with two pairs of narrow slot for dual-frequency operation is printed on the substrate(TMN-4 Rosers Co.) of the 60 miles. the antenna radiation characteristics are calculated by Ensemble ver. 5.0 software, and compared with the experimental results.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2001년도 하계종합학술대회 논문집(1)
• /
• pp.397-400
• /
• 2001

In this paper, to improve bandwidth of microstrip antenna, we discussed the patch structure using Aperture Stacked Patch. To provid PCS service and IMT-2000 service simultaneous, a microstrip patch antenna needs impedance bandwidth of 22%. But typical microstrip patch antennas have impedance bandwidth of 3∼6%. To analyze characteristics of microstrip pach antenna, we used Ensemble of commercial software. The microsrtip patch antenna was designed and fabricated, tuned. We get following results; 650MHz(33%) of impedance bandwidth for VSWR 1.5. The measured gain of ASP microstrip antenna is 6.94dBi.

• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 2003년도 Proceedings of ACRS 2003 ISRS
• /
• pp.1093-1095
• /
• 2003

MSC(Multi-Spectral Camera) system is a remote sensing instrument to obtain high resolution ground image. MSC system includes main control unit, called SBC(Single Board Computer). SBC controls all the sub-units of MSC system and communicates with spacecraft bus. The software developed for SBC should be reliable and autonomous to support various kinds of imaging missions. It is being developed using VxWorks real-time operating system to manage all tasks for all units efficiently. In this paper, the characteristics of the embedded software on the MSC system will be presented. It covers the hardware related characteristics like the BSP(Board Support Package), device driver and code patch mechanism.

• ETRI Journal
• /
• 제46권4호
• /
• pp.683-696
• /
• 2024

The point cloud provides viewers with intuitive geometric understanding but requires a huge amount of data. Moving Picture Experts Group (MPEG) has developed video-based point-cloud compression in the range of 300-700. As the compression rate increases, the complexity increases to the extent that it takes 101.36 s to compress one frame in an experimental environment using a personal computer. To realize real-time point-cloud compression processing, the direct patch projection (DPP) method proposed herein simplifies the complex patch segmentation process by classifying and projecting points according to their geometric positions. The DPP method decreases the complexity of the patch segmentation from 25.75 s to 0.10 s per frame, and the entire process becomes 8.76 times faster than the conventional one. Consequently, this proposed DPP method yields similar peak signal-to-noise ratio (PSNR) outcomes to those of the conventional method at reduced times (4.7-5.5 times) at the cost of bitrate overhead. The objective and subjective results show that the proposed DPP method can be considered when low-complexity requirements are required in lightweight device environments.

• Steel and Composite Structures
• /
• 제16권2호
• /
• pp.203-220
• /
• 2014

Stress intensity factors are numerically investigated for interfacial edge crack between two dissimilar composite plates jointed with single side composite patch. Variation of stress intensity factor under Mode I loading condition is examined for different material models and fiber orientation angles of composite plates and patch. ANSYS 12.1 finite element analysis software is used to obtain displacements of crack surfaces in the numerical solution and repaired plates are modeled in three dimensions. Obtained results are presented in the form of graphs. It is found that fiber orientation angle of composites is an effective parameter on interfacial stress intensity factor.

• ETRI Journal
• /
• 제31권5호
• /
• pp.554-564
• /
• 2009

In information security and network management, attacks based on vulnerabilities have grown in importance. Malicious attackers break into hosts using a variety of techniques. The most common method is to exploit known vulnerabilities. Although patches have long been available for vulnerabilities, system administrators have generally been reluctant to patch their hosts immediately because they perceive the patches to be annoying and complex. To solve these problems, we propose a security vulnerability evaluation and patch framework called PKG-VUL, which evaluates the software installed on hosts to decide whether the hosts are vulnerable and then applies patches to vulnerable hosts. All these operations are accomplished by the widely used simple network management protocol (SNMP). Therefore, system administrators can easily manage their vulnerable hosts through PKG-VUL included in the SNMP-based network management systems as a module. The evaluation results demonstrate the applicability of PKG-VUL and its performance in terms of devised criteria.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2003년도 하계종합학술대회 논문집 I
• /
• pp.625-628
• /
• 2003

In this paper, a wideband two-layer H-shaped microstrip antenna for WLAN is designed and studied experimentally. To increase the bandwidth of microstrip patch antenna, a configuration of stacked type using parastic element is used, Furthermore, to reduce the size of microstrip patch antenna, the first technique is H-shaped patch type. the second technique is that the main radiator and parastic patch are shorted to the ground plane using ten shorting posts. The antenna bandwidth and radiation characteristics are calculated by ENSEMBLE ver. 5.0 simulation software, and compared with the experimental results, Experimental results show that the return loss is less than -10dB over the band of 5.086GHz to 5.832GHz, which is quite good agreement with the calculations.

• 융합보안논문지
• /
• 제4권2호
• /
• pp.43-51
• /
• 2004

운영체제 및 응용프로그램들은 프로그램 개발 과정의 특성상 보안 취약성을 가지고 있다. 최근 이러한 취약성을 악용하는 침해사례가 증가하고 있으며, 그 피해의 파급효과가 더욱 커지고 있다. 패치의 분배 및 설치는 취약성을 이용하는 침해사고를 예방하기 위한 가장 중요한 요소 중의 하나이다. 특정 기관이나 조직은 다양한 운영체제 및 응용프로그램을 사용하기 때문에 관리자가 매번 신속하게 모든 시스템들에 대하여 패치를 설치하기는 어려움이 있다. 본 논문에서는 중앙의 관리자가 패치관리서버를 이용하여 Windows, Linux, Solaris 클라이언트 시스템들에 대하여 안전하게 패치를 자동분배하고 설치하는 패치관리시스템을 설계 및 구현하였다 또한, 대규모 네트워크를 지원하기 위하여 확장성을 고려한 계층적인 패치 분배 구조로 설계 및 구현하였다.

• Journal of Information Processing Systems
• /
• 제14권3호
• /
• pp.590-599
• /
• 2018

Multivariate finite mixture model is becoming more and more popular in image processing. Performing image denoising from image patches to the whole image has been widely studied and applied. However, there remains a problem that the structure information is always ignored when transforming the patch into the vector form. In this paper, we study the operator which extracts patches from image and then transforms them to the vector form. Then, we find that some pixels which should be continuous in the image patches are discontinuous in the vector. Due to the poor anti-noise and the loss of structure information, we propose a new operator which may keep more information when extracting image patches. We compare the new operator with the old one by performing image denoising in Expected Patch Log Likelihood (EPLL) method, and we obtain better results in both visual effect and the value of PSNR.