• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2012.05a
• /
• pp.364-367
• /
• 2012

In this paper, AXI4 BUS was implemented using Verilator and C/C++ for verification of SoC platform H/W IP which is based on AXI4 BUS. In this paper we proposed a method to verify the AXI4 BUS based SoC platform H / W IP by implemented AXI4 BUS on PC using Verilator and C/C++. The result shows AXI4 BUS based H/W IP that is verified by implemented AXI4 BUS is to perform the same behavior on FPGA environment.

• Journal of Environmental Health Sciences
• /
• v.19 no.3
• /
• pp.29-35
• /
• 1993

This study was performed to obtain optimal conditions for reduction of color in dye wastewaters using coagulation-sedimentation processes with redox reactions. The reduction of color as well as organic matters variation was observed after coagulation-sedimentation processes using FeSO$_4$ $\cdot$ 7H$_2$O and NaOCl. Coagulation-redox reaction was done with the dose of Coagulant and oxidant at various pH values. Redox reaction was done through jar-mixing and aeration. The results of study were as follows: 1. In the coagulation-sedimentation processes using FeSO$_4$ $\cdot$ 7H$_2$O, color reduction was heigher at pH 3. With variance of dosage of FeSO$_4$ $\cdot$ 7H$_2$O, color reduction was higher at 250 mg/l. When coagulation-sedimentation using FeSO$_4$ $\cdot$ 7H$_2$O 250 mg/l was added at pH 3, the reduction of color, COD$_{Mn}$, and COD$_{Cr}$ showed 47.6%, 21.3% and 22.1%, respectively. 2. When NaOCI was added at level of 100 ppm in raw wastewater at pH 3, the reduction of color, COD$_{Mn}$, and COD$_{Cr}$ showed 30.2%, 5.5% and 6.2%, respectively. 3. After coagulation-sedimentation processes by addition of FeSO$_4$ $\cdot$ 7H$_2$O, when NaOCl was added at level of 250 mg/l in supernant, color reduction was 47.8% in aeration and 37.5% in jar-mixing. 4. Color reduction by aeration was higher than that by jar-mixing.

• Textile Coloration and Finishing
• /
• v.12 no.6
• /
• pp.389-395
• /
• 2000

A natural colorants was extracted from cherry by 10wt% aqueous acetic acid solution as an extractant. Silk and cotton fabrics were dyed with the cherry extract in the temperature range of $40-80^\circ{C}$ and for the time range of 30-60min. by pre- and post-mordanting with various mordants, their dyeability and fastness were investigated. The natural cherry extract prepared in this study has a maximum absorbance at 520nm. It was found that the optimum dyeing temperature and time were $40^\circ{C}$ and 50min, respectively. The pre-mordanting method was more effective than post-mordanting. All mordants except $SnCl_2\cdot{2H}_2O\;and\;FeSO_4\cdot{7H}_2O$ were effective for silk fabrics. However, the dyeability on cotton fabrics increased in the order of $CrK(SO_4)_2\cdot{12H_2O>(CH_3COO)_2Cu\cdot{H}_2O>CuSO_4\cdot{5H}_2O>AlK(SO_4)_2\cdot{12H}_2O>FeSO_4\cdot{7H}_2O>SnCl_2\cdot{2H}_2O$ among the mordants used in this study Fastness(light, water, washing, perpspiration fastness) on the silk and cotton fabrics increased with using mordants. The post-mordanting using mordant$(CH_3COO)_2Cu\cdot{H}_2O$ among the various mordants in this study gave the best fastness.

• Journal of Food Hygiene and Safety
• /
• v.10 no.4
• /
• pp.231-237
• /
• 1995

Bacillus subtilis SH-1 have been isolated and identified from coastal sea, in Pusan, The optimal cultural characterization of Bacillus subtilis SH-1 for 속 production of bacteriolytic enzyme was determained. Bacillus subtilis SH-1 produced the bacteriolytic enzyme well in the medium consist of 1.0% glucose, 1.0% yeast extract, 1.0% NaCI, 0.02% $K_2HPO_4,\;0.002%\;MgSo_4{\cdot}7H_2O,\;0.001%\;MnSO_4{\cdot}5H_2O,\;0.0001%\;FeSO_4{\cdot}7H_2O$. The optimal medium pH, incubation temperature, and shaking tome for the highest production of the enzyme were 8.0, $30^{\circ}C$ and 28 hours respectively.

• Journal of the Korean Chemical Society
• /
• v.45 no.1
• /
• pp.7-13
• /
• 2001

The interaction of benzenesulfonate anion and its derivatives ($C_6H_5SO_3^-, p-$CH_3C_6H_4SO_3^-, and $p-C_2H_5C_6H_4SO_3^-$) with the micellar system of cationic surfactant TTAB(tetradecyltrimethylammonium bromide) was studied by UV/Vis spectrophotometric method. The solubilization constants($K_s$) of benzenesulfonate anions into the micellar phase of this surfactant have been measured with the change of temperature. The effects of additives(n-pentanol and NaBr) on the solubilization of benzenesulfonate anions by this surfactant system have been also measured. There was a great decrease on the values of $K_s$ and CMC simultaneously with these additives so that the measured values of ln$K_s$ were linear relationships with the values of lnCMC. For the thermodynamic study, various thermodynamic parameters(${\Delta}G^0_s$, ${\Delta}H^0_s$ and ${\Delta}S^0_s$) have been calculated and analyzed from the dependence of Ks values on temperature.

• Resources Recycling
• /
• v.10 no.1
• /
• pp.25-31
• /
• 2001

The heat treatment of PVC film containing PVC 65ft, DOP (Dioctyl Phthalate) 32% as plasticizer, Ca-Zn stearates and sur-face agent was performed under several conditions to study the dehydrochlorination of PVC and char production. In the case of $H_2$ $SO_4$, the dehydrochlorination was ca.100% at $250^{\circ}C$ for 3h. The char involving the smaller pores was produced with hydro-thermal treatment. The pore size became small with increasing the treatment time and temperature. In the case of treatment with $Ca(OH)_2$, the sizes of pores produced in char were about sever ~10 $\mu\textrm{m}$ at$ 225^{\circ}C$ for 12h. In the case of $_2$$SO_4$, the size of pores were about 1 $\mu\textrm{m}$ in 5M $_H2$$SO_4$for 12h.

• Journal of Korean Society on Water Environment
• /
• v.24 no.4
• /
• pp.415-422
• /
• 2008

Drinking water treatment is enhanced by coagulant dosages and chlorine injection because of pH increase in raw water in droughty seasons such as spring and fall. But water quality deterioration is occurred by increase in residual aluminium and disinfection by-products. Coagulation process can be used to control natural organic matter (NOM) during water treatment. The effect of coagulation process appeared to depend on the pH of water rather than coagulant dosages. In this study, for water treatment in high pH season $H_2SO_4$ was applied for pH adjustment at full scale. Before and after pH adjustment by $H_2SO_4$ injection, water quality of drinking water was evaluate. In the result of investigation of total organic carbon (TOC) removal in high pH season, TOC was removed approximately 30~40%, which showed decrease in water treatment efficiency. Also, it is increased both particle numbers and residual Al concentration in the water. After $H_2SO_4$ injection for adjustment to pH<7.5 in settled water, treated water turbidity decreased in 0.047 NTU from 0.059 NTU, and particle numbers of filtered water decreased in 20/mL from 90/mL. On the other side, TOC removal efficiency increased in approximately 10% after adjustment of pH. In the result of decrease in pH in raw water through more coagulants and prechlorine without $H_2SO_4$ injection, trihalomethanes (THMs) concentration increased in $16{\mu}g/L$ from $8{\mu}g/L$.

• Journal of Power System Engineering
• /
• v.20 no.3
• /
• pp.17-21
• /
• 2016

The corrosion behavior of aluminum alloys in the $H_2SO_4$ solution was investigated based on potentiodynamic techniques. Electrochemical properties, such as corrosion potential($E_c$), passive potential($E_p$), corrosion current density($I_c$), corrosion rate(mpy), of Al-Mg-Si, Al-Cu-Si and Al-Si alloys were characterized at room temperature. Passive aluminum oxide film, which including $Al_2(SO_4)_3$ and $3Al_2O_34SO_38H_2O$, were uniformly formed on the surface via the reaction of Al with $SO{_3}^{2-}$ or $SO{_4}^{2-}$ ions in the $H_2SO_4$ solution and the dependence of the corrosion behavior on the alloying element was discussed. The selective leaching of alloy element increased with increasing Cu content in the aluminum alloys.

• Transactions of the Korean hydrogen and new energy society
• /
• v.6 no.2
• /
• pp.91-100
• /
• 1995

To investigate the surface state of $Mg_2Ni$ which was exposed to the air, a chemical treatment was undertaken with $H_2SO_4$ solution. During chemical treatment, the change of pH was measured continuously and the chemically treated specimen was hydrided to study the effect of chemical treatment on the hydrogenation. The pH changing behavior with the various $H_2SO_4$ concentration appeared very diffemrently. Especially in the solution including 3CC $H_2SO_4$, the behavior of pH change can be divided 3 steps. It is also shown that the $Mg_2Ni$ chemically treated with $H_2SO_4$ can be hydrided even under room temperature. By the SEM observation the was reasion that after chemical treatment the surface of a particle was covered with Ni layer.

• Nuclear Engineering and Technology
• /
• v.55 no.6
• /
• pp.2256-2262
• /
• 2023

The electrochemical corrosion behaviors of SA106 Grade B (SA106B) carbon steel in H₂SO₄4-N₂H₄ and H₂SO₄-N₂H₄-CuSO₄ solutions at 95 ℃ have been investigated with the addition of commercial corrosion inhibitors (CI#30 and No. 570S), to determine the stability of SA106B in the hydrazine-based reductive metal ion decontamination (HyBRID) process. The potentiodynamic polarization experiment revealed that the corrosion inhibitors were capable of lowering the corrosion rate of SA106B in H₂SO₄-N₂H₄ solution. It was found that the corrosion inhibitors induced formation of fixed surface layer on the carbon steel upon the corrosion. This corrosion inhibition performance was reduced in the presence of CuSO₄ in the solution owing to the chemical reactions between organic compounds in the corrosion inhibitors and CuSO₄. CI#30 showed a better corrosion inhibition effect in the H₂SO₄-N₂H₄-CuSO₄ solution. Although the corrosion inhibitors can provide better stability to SA106B in the HyBRID solution, their application should be carefully considered because it may result in reduced decontamination performance and increased secondary waste generation.