• Journal of Korean Tunnelling and Underground Space Association
• /
• v.21 no.5
• /
• pp.621-640
• /
• 2019

Quantitative stability assessment of underground cavities can be presented as a factor of safety based on the Shear Strength Reduction Method (SSRM). Also, SSRM is one of the stability evaluation methods commonly used in slope stability analysis. However, there is a lack of research that considers the relationship between the probability of occurrence of cavities in the ground and the potential failure surface of the slope at the same time. In this study, the effect of small underground cavities on the failure behavior of the slope was analyzed by using SSRM. Considering some of the glaciology studies, there is a case that suggests that there is a cavity effect inside the glacier in the condition that the glacier slides. In this study, the stability evaluation of underground cavities and slope stability analysis, where SSRM is used in geotechnical engineering field, was carried out considering simultaneous conditions. The slope stability analysis according to the shape and position change of underground cavities which are likely to occur in the lower part of a mountain road was analyzed by using SSRM in FLAC3D software and the influence of underground cavities on the slope factor of safety was confirmed. If there are underground cavities near slope potential failure surface, it will affect the calculation of a factor of safety. The results of this study are expected to be basic data on slope stability analysis with small underground cavities.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.52 no.3
• /
• pp.31-38
• /
• 2010

Various fundamental and practical theories and technologies are needed for the development of Best Management Practices (BMPs) to manage the problems. The objectives of this paper was to investigate the effect of fertilizer and Non-point suource (NPS) pollution discharges from the field. The effect of fertilizer application was measured with respect to 10 % and 20 % slopes, respectively, using artificial rainfall simulator. The effect of fertilizer application on runoff was not significant because the effect of slope and rainfall intensity were overwhelmed. Runoff from 20 % plots was 21 % larger than that from 10 % plots. While groundwater discharge from 10 % plots was about 70 % larger than that from 20 % plots. It was concluded that runoff and groundwater discharge were largely affected by slope. T-N concentration in groundwater was much higher than that in runoff for both 10 % and 20 % plots. While T-P concentration in groundwater was lower than that in runoff. It explained that T-N moved well through soil pores without adsorption and other chemical reactions but T-P was well adsorbed on the surface of soil particles.

• Journal of the Korean Geotechnical Society
• /
• v.31 no.9
• /
• pp.5-15
• /
• 2015

In this study, rainfall-induced slope stability and coupling effect are investigated using hydro-mechanical finite element model. This model is developed by formulating constitutive and coupled balance equations and is verified by comparing the numerical results with field matric suction. The homogeneous soil layer (soil column) and soil slope are modeled by this model, and the results of variation in matric suction, mean effective stress, porosity, displacement, factor of safety are compared with those of staggered analysis. It is found that the vertical and horizontal displacement from coupling analysis considering change in porosity is larger than that of staggered analysis. The displacement and matric suction from coupling analysis by rainfall infiltration can affect slope instability, which shows a progressive failure behavior. The lowest factor of safety is observed under short-term rainfall. This results confirm the fact that coupling analysis is needed to design soil slope under severe rain condition.

• Journal of the Korean Geotechnical Society
• /
• v.17 no.6
• /
• pp.245-255
• /
• 2001

Existing cut-and-cover tunnels are designed regardless of cut-slope under the assumption that the overburden weight of backfill soil acts on tunnel arch and the earth pressure at rest acts on tunnel walls. However, actual earth pressures acting on the tunnel lining depend on open-cut size composed of cut-slope and cut-width, and thus the tunnel lining shows a different structural behavior. This study investigated the effect of cut-slope on structural behavior of the cut-and-cover tunnel lining as follows; Firstly, a comprehensive numerical analysis method using FLAC2D code was used and verified by field measurements of tunnel profile. Secondly, based on the verified numerical analysis technique, earth pressure acting on the lining, and displacement and sectional force developed on the lining were estimated with various shapes of cut-slopes$30^{\circ}\;, 456{\circ},\; 60^{\circ},\; and\;75^{\circ}%). Numerical analysis results indicate that the steeper cut-slope shows the more displacement and moment of the tunnel lining.

• Journal of the Korean Geotechnical Society
• /
• v.16 no.1
• /
• pp.51-64
• /
• 2000

This paper presents a procedure of calculating a safety factor of the unsaturated slope suffering from the rainfall infiltration. The process of infiltration into a slope due to rainfall and its effect on the behavior of the soil slope are examined by using a two dimensional finite element flow-deformation coupled analysis. A factor of safety is calculated at various elapsed times after the commencement of rainfall as in the following procedure. First, stresses are estimated at each Gaussian point from the coupled finite element analysis. Then, the global stress smoothing method is applied to get a continuous stress field. Based on this stress field, a factor of safety is calculated for a specified slip surface by a stress integration scheme. Then, a search strategy is used to find out a critical slip surface which is associated with the minimum factor of safety. Some numerical examples are analyzed in order to study the effect of hydraulic conductivity on the slope stability during rain-induced infiltration. According to the results, local failure zone can be formed near the slope surface due to inhomogeneous distribution of hydraulic conductivity If the failure zone is once formed, then the region extends until a large amount of slide activates. Therefore the local failure can be neglected no longer in the stability analysis.

• Geomechanics and Engineering
• /
• v.14 no.4
• /
• pp.345-354
• /
• 2018

Currently, layered geogrid method (LGM) is the commonly practiced technique for reinforcement of slopes. In this paper the geogrid-box method (GBM) is introduced as a new approach for reinforcement of rock-soil slopes. To achieve the objectives of this study, a laboratory setup was designed and the slopes without reinforcements and reinforced with LGM and GBM were tested under the loading of a circular footing. The effect of vertical spacing between geogrid layers and box thickness on normalized bearing capacity and failure mechanism of slopes was investigated. A series of 3D finite element analysis were also performed using ABAQUS software to supplement the results of the model tests. The results indicated that the load-settlement behavior and the ultimate bearing capacity of footing can be significantly improved by the inclusion of reinforcing geogrid in the soil. It was found that for the slopes reinforced with GBM, the displacement contours are widely distributed in the rock-soil mass underneath the footing in greater width and depth than that in the reinforced slope with LGM, which in turn results in higher bearing capacity. It was also established that by reducing the thickness of geogrid-boxes, the distribution and depth of displacement contours increases and a longer failure surface is developed, which suggests the enhanced bearing capacity of the slope. Based on the studied designs, the ultimate bearing capacity of the GBM-reinforced slope was found to be 11.16% higher than that of the slope reinforced with LGM. The results also indicated that, reinforcement of rock-soil slopes using GBM causes an improvement in the ultimate bearing capacity as high as 24.8 times more than that of the unreinforced slope.

• Journal of the Korean Geotechnical Society
• /
• v.28 no.6
• /
• pp.63-70
• /
• 2012

The authors discuss the effect of hydraulic conductivity on the suction profile and stability of a typical cut-slope subjected to low intensity rainfall. The initial suction value above the ground table in the unsaturated zone is assumed to be 15 kPa. The uncoupled approach of finite element and limit equilibrium method is used to evaluate the stability of the cut-slope at different elapsed times of rainfall. The finite element seepage analysis shows that the soil in the unsaturated zone always remains unsaturated during the course of low intensity rainfall. Furthermore, the slope stability remains practically unchanged so long as the wetting front remains in the unsaturated zone but it decreases noticeably when the wetting front reaches and elevates the ground water table level.

• Journal of the Korean GEO-environmental Society
• /
• v.7 no.2
• /
• pp.5-14
• /
• 2006

It has been reported that the failure of a slope in weathered soils or rocks induced by intensive rainfall occurs mainly within 2.0m below the ground surface, and that the effect of rainfall on the rise of the ground water level is not significant if the ground water level inside the slope is not so high before rainfall. Most slopes in Korea, however, have been examined to rather fail at the deeper part since they are usually designed on the basis of assumption that the ground water level rises up to the surface when raining. In this study, the rise of ground water level and slope stability were examined in order to verify the appropriateness of the current ground water level condition that has a significant effect on slope stability using the average daily rainfall in Seoul for the last 30 years. The result showed that the ground water level appears to rise up to 6.0~41.0% of the slope height respectively, and therefore the currently applied condition of ground water level may be somewhat overestimated.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.03a
• /
• pp.1304-1312
• /
• 2008

In this study, the analysis to the preference level on slope measuring instrument of weight values on effect factors find out the reasonable monitoring on slope was performed, in which used AHP(Analytic Hierarchy Process) techniques. The results on professional group, such as the industry, academic, institute and government, analyzed that the very important effect factors, which were indicator of various collapse type, convenience of instrument management, The evaluation of preference level on the slope measuring instrument analyzed the invar wire extensometer which was high level at convenience of install, economical efficiency of install and convenience of instrument management.

• Journal of computational fluids engineering
• /
• v.15 no.3
• /
• pp.81-86
• /
• 2010

In this paper, a three-dimensional numerical study on flow pattern in winter along connecting passageway of a composite building was conducted using a commercial CFD package. The incompressible Navier-Stokes equation coupled was solved by using SIMPLE algorithm in order to find steady solutions. It was shown that a upward flow is generated inside the building in winter due to buoyancy effect and that the air inside connecting passageway flows from the shorter building to the taller one regardless of the slope of the passageway. Further, it was found that the magnitude of air velocity inside connecting passageway increases as the uphill slope to the taller building increases and decreases as the downhill slope to the taller one increases, although the variation in the magnitude of fluid velocity is not substantial. Lastly, it was shown that the maximum air velocity inside connecting passageway is less than the allowable limit for all the cases considered in this study.