• Structural Engineering and Mechanics
• /
• 제65권3호
• /
• pp.303-314
• /
• 2018

Shear walls are a typical member under a complex stress state and have complicated mechanical properties and failure modes. The separated-elements model Genetic Evolutionary Structural Optimization (GESO), which is a combination of an elastic-plastic stress method and an optimization method, has been introduced in the literature for designing such members. Although the separated-elements model GESO method is well recognized due to its stability, feasibility, and economy, its adequacy has not been experimentally verified. This paper seeks to validate the adequacy of the separated-elements model GESO method against experimental data and demonstrate its feasibility and advantages over the traditional elastic stress method. Two types of reinforced concrete shear wall specimens, which had the location of an opening in the middle bottom and the center region, respectively, were utilized for this study. For each type, two specimens were designed using the separated-elements model GESO method and elastic stress method, respectively. All specimens were subjected to a constant vertical load and an incremental lateral load until failure. Test results indicated that the ultimate bearing capacity, failure modes, and main crack types of the shear walls designed using the two methods were similar, but the ductility indexes including the stiffness degradation, deformability, reinforcement yielding, and crack development of the specimens designed using the separated-elements model GESO method were superior to those using the elastic stress method. Additionally, the shear walls designed using the separated-elements model GESO method, had a reinforcement layout which could closely resist the actual critical stress, and thus a reduced amount of steel bars were required for such shear walls.

• 한국전산유체공학회지
• /
• 제4권3호
• /
• pp.44-51
• /
• 1999

A modified version of SST turbulence model is suggested to simulate unsteady separated flows over oscillating airfoils. The original SST model, which shows good performance in predicting various steady flows, often results in oscillatory behavior of aerodynamic loads in large separated flow regions. It is shown that this oscillatory behavior is due to the adoption of the absolute value of vorticity in generalizing the original model. As a remedy, a modification is made such that the vorticity in the original SST model is replaced by strain rate. The present model is verified for a mild separated airfoil flow at fixed angle of incidence and for unsteady flowfields about oscillating airfoils. The results are compared with BSL model and original SST model. It is illustrated that the present model gives a better agreement with the experimental results than other two models.

• Nuclear Engineering and Technology
• /
• 제47권6호
• /
• pp.669-677
• /
• 2015

A mechanistic model for void fraction prediction with improved interfacial friction factor in nearly horizontal tubes has been proposed in connection with the development of a condensation model package for the passive auxiliary feedwater system of the Korean Advanced Power Reactor Plus. The model is based on two-phase momentum balance equations to cover various types of fluids, flow conditions, and inclination angles of the flow channel in a separated flow. The void fraction is calculated without any discontinuity at flow regime transitions by considering continuous changes of the interfacial geometric characteristics and interfacial friction factors across three typical separated flows, namely stratified-smooth, stratified-wavy, and annular flows. An evaluation of the proposed model against available experimental data covering various types of fluids and flow regimes showed a satisfactory agreement.

• Food Science and Biotechnology
• /
• 제16권2호
• /
• pp.183-186
• /
• 2007

The type of mixed gel network of $\kappa$-carrageenan/agar was determined by applying rheological principles. Apparent Young's modulus of the mixed gels was mathematically analyzed with (a) simply adding the moduli of two component gels, (b) phase-separated type's upper and lower bound models, (c) interpenetrating type's logarithmic model. The experimental data fitted the estimates from the operation (a). Whereas, as for the models (b), the experimental values in the agar-rich region fitted the estimates of the upper bound model, but in the $\kappa$-carrageenan-rich region slightly deviated from those of the lower bound model. It reflected an evidence of a phase-separated type, although it was not typical, that there must be data good-fit in the agar-rich and $\kappa$-carrageenan-rich regions with the upper and lower bound models, respectively. Experimental values disagreed with estimates of the model (c). Gel time was analyzed to evince the phase-separated type. As agar concentrations increased at a fixed amount of $\kappa$-carrageenan, gel time gradually decreased and then sharply increased and decreased again. The pattern of such change in gel time also represented a typical behavior of phase-separated type's mixed gels.

• 대한기계학회논문집
• /
• 제19권11호
• /
• pp.3014-3021
• /
• 1995

This study is carried out in order to evaluate the performances of the Reynolds stress turbulence models such as SSG and GL models in the calculation of separated flow over backward-facing stepp.In addition, two slow return-to-isotropy models, YA and Rotta models combined with rapid part of SSG model are also tested. The finite volume method is used to discretize the governing differential equations, and the power-law scheme is used to approximate the convection terms. The SIMPLE algorithm is used for pressure correction in the governing equations. The results show that SSG model gives the better prediction near the reattachment point than GL model. In cases that the rapid term of SSG model is combined with Rotta and YA slow models, the results show the better predictions of stress components in recirculation zone, but indicate inaccuracy in the predictions of mean velocity.

• 대한기계학회논문집B
• /
• 제24권3호
• /
• pp.467-476
• /
• 2000

An unsteady numerical simulation was performed for locally-forced separated and reattaching flow over a backward-facing step. The local forcing was given to the separated and reattaching flow by means of a sinusoidally oscillating jet from a separation line. A version of the $k-{\varepsilon}-f_{\mu}$ model was employed, in which the near-wall behavior without reference to distance and the nonequilibrium effect in the recirculation region were incorporated. The Reynolds number based on the step height (H) was fixed at $Re_H=33000$, and the forcing frequency was varied in the range $0{\leq}St_H{\leq}2$. The predicted results were compared and validated with the experimental data of Chun and Sung. It was shown that the unsteady locally-forced separated and reattaching flows are predicted reasonably well with the $k-{\varepsilon}-f_{\mu}$ model. To characterize the large-scale vortex evolution due to the local forcing, numerical flow visualizations were carried out.

• 대한기계학회논문집B
• /
• 제24권2호
• /
• pp.316-323
• /
• 2000

A nonlinear low-Reynolds-number heat transfer model is developed to predict turbulent flow and heat transfer in separated and reattaching flows. The $k-{\varepsilon}-f_{\mu}$ model of Park and Sung (1997) is extended to a nonlinear formulation, based on the nonlinear model of Gatski and Speziale (1993). The limiting near-wall behavior is resolved by solving the $f_{\mu}$ elliptic relaxation equation. An improved explicit algebraic heat transfer model is proposed, which is achieved by applying a matrix inversion. The scalar heat fluxes are not aligned with the mean temperature gradients in separated and reattaching flows; a full diffusivity tensor model is required. The near-wall asymptotic behavior is incorporated into the $f_{\lambda}$ function in conjunction with the $f_{\mu}$ elliptic relaxation equation. Predictions of the present model are cross-checked with existing measurements and DNS data. The model preformance is shown to be satisfactory.

• 대한기계학회논문집B
• /
• 제34권1호
• /
• pp.9-18
• /
• 2010

2 상 유동 압력강하에 대한 모델은 균질유동모델과 분리유동모델 두 가지가 있다. 많은 선행 연구자들은 마이크로채널에서의 2 상 유동 압력강하에 대한 상관식을 제시하였고, 대부분은 분리유동모델에 해당하는 Lockhart- $Martinelli^{(27)}$의 수정된 상관식에 기초하고 있다. 본 연구에서는 사각 마이크로채널에서의 압력강하에 대한 연구를 위해서 액상의 물과 기상의 질소를 사용하여 사각 마이크로채널에서의 실험을 수행하였다. 2 상 마찰 압력강하는 2 상 유동양식에 큰 연관성을 가지고 있는 결과를 확인할 수 있었다. 6 가지의 2 상 점성 모델을 포함한 균질유동 모델 ($Owen^{(21)}$'s, $MacAdams^{(22)}$'s, Cicchitti et ${al.}^{(23)}$'s, ${al.,}^{(24)}$ Beattie and ${Whalley,}^{(25)}$ Lin et ${al.}^{(26)}$)과 6 가지의 분리유동 모델 (Lockhart and $Martinelli,^{(27)}$ ${Chisholm,}^{(31)}$ Zhang et ${al.,}^{(15)}$ Lee and ${Lee,}^{(5)}$ Moriyama and ${Inue,}^{(4)}$ Qu and $Mudawar^{(8)}$)에 대한 평가를 실험결과와 비교를 통해 수행하였다. 가장 우수한 2 상 점성 모델은 Beattie and Whalley 의 모델이었고, 가장 우수한 분리유동 모델은 Qu and Mudawar 의 상관식이였다. 균질유동모델과 분리유동모델 모두에 대해서 2 상 유동양식에 종속성을 나타내었다. 그러므로, 본 연구에서는 2 상 유동 양식에 기초한 새로운 상관식을 균질유동모델과 분리유동모델에 대해 각각을 제시하였다.

• 동의생리병리학회지
• /
• 제20권3호
• /
• pp.581-589
• /
• 2006

These studies were investigated the effects of Gamicheungpyehwadam-tang (CPHDT) on immune-cell regulation in association with bronchial asthma in OVA-induced mouse model. The administration of 400 mg/kg CPHDT significantly reduced the number of total cells in lung, peripheral lymph node and spleen in OVA-induced bronchial asthma mouse model. The administration of 400 mg/kg CPHDT significantly reduced $CD3^+,{\;}CD19^+$and $CD3^+,{\;}CD69^+$ cell numbers separated from lung, peripheral lymph node and spleen in OVA-induced bronchial asthma mouse model. CPHDT significantly reduced $CD3^+/CCR3^+,{\;}CD4^+,{\;}B220^+/IgE^+$, and $CD3^+/DX5^+$ cell numbers separated from lung, peripheral lymph node and spleen in OVA-induced bronchial asthma mouse model in a dose dependent manner, However, CPHDT significantly reduced $CD8^+$ cell numbers from only lung and spleen. The administration of CPHDT significantly reduced $NK^+$ cell numbers separated from lung of OVA-induced bronchial asthma mouse model in all concentrations, but 200 mg/kg CPHDT reduced $NK^+$ cell numbers separated from peripheral lymph node. These results suggest that CPHDT has anti-asthma and anti-allergy effects. In addition to, CPHDT may be useful treatment of asthma based on the further studies about the individual efficacy search of the components of CPHDT and the adding of variety drugs to CPHDT.

• 대한기계학회논문집B
• /
• 제25권1호
• /
• pp.87-95
• /
• 2001

A numerical study was made of heat transfer in locally-forced turbulent separated and reattaching flow over a backward-facing step. The local forcing was given to the flow by means of sinusoidally oscillating jet from a separation line. A Rhee and Sung version of the unsteady $\kappa$-$\varepsilon$-f(sub)u model and the diffusivity tensor heat transfer model were employed. The Reynolds number was fixed at Re(sub)H=33,000 and the forcing frequency was varied in the range 0$\leq$fH/U(sub)$\infty$$\leq$2. The condition of constant heat flux was imposed at the bottom wall. The predicted results were compared and validated with the experimental data of Chun and Sung and Vogel and Eaton. The enhancement of heat transfer in turbulent separated and reattaching flow by local forcing was evaluated and analyzed.