• Journal of Energy Engineering
• /
• v.5 no.2
• /
• pp.108-114
• /
• 1996

It is one of the most important factors to enhance the efficiency of the solar collectors by in-creasing collecting efficiency and decreasing heat loss. The pulse electrodeposition method has been involved in this study to improve characteristics of the solar selective coating on 230cm${\times}$60cm substrates and electrical efficiency of the process. The composition of the electrolyte was 280 g/$\ell$ chromic acid, 15 g/$\ell$ propionic acid, and 10 g/$\ell$ appropriate additive. 230cm${\times}$60cm copper and aluminium sheets were utilized as the substrates. It has been observed that the black chrome coatings exhibited reasonable optical properties for commercialization when the plating parameters were properly controlled; the absorptance was 0.98 and 0.97 and omittance was 0.17 and 0.23 for copper and aluminium substrate, respectively. This study implies that the pulse current electrolysis method could be applied to the large scale substrates, and the various products can be avilable after the consideration of the thermal conductivity, heat transfer efficiency and cost problems of the substrates.

• Clean Technology
• /
• v.24 no.4
• /
• pp.307-314
• /
• 2018

In this study, NMO (Natural Manganese Ore), $MnO_2$, and $Mn_2O_3$ catalysts were used in the selective catalytic reduction process to remove nitrogen oxides (NOx) using $NH_3$ as a reducing agent at low temperatures in the presence of oxygen. In the case of the NMO (Natural Manganese Ore), it was confirmed that the conversion of nitrogen oxides in the stability test did not change even after 100 hours at 423 K. The Kinetics experiments were carried out within the range where heat and mass transfer were not factors. From a steady-state Kinetics study, it was found that the low-temperature SCR reaction was zero order with the respect to $NH_3$ and 0.41 ~ 0.57 order with the respect to NO and 0.13 ~ 0.26 order with the respect to $O_2$. As temperature increases, the reaction order decreases as a result of $NH_3$ and oxygen concentration. It was confirmed that the reaction between the $NH_3$ dissociated and adsorbedon the catalyst surface and the gaseous nitrogen monoxide (E-R model) and the reaction with the adsorbed nitrogen monoxide (L-H model) occur.

• BMB Reports
• /
• v.39 no.4
• /
• pp.383-393
• /
• 2006

Little is known concerning the mechanisms responsible for the transplacental transfer of thiamine. So, the aim of this work was to characterize the placental uptake of thiamine from the maternal circulation, by determining the characteristics of $^3H$-thiamine uptake by a human trophoblast cell line (BeWo). Uptake of $^3H$-thiamine (50-100 nM) by BeWo cells was: 1) temperature-dependent and energy-independent; 2) pH-dependent (uptake increased as the extracellular medium pH decreased); 3) $Na^+$-dependent and $Cl^-$-independent; 4) not inhibited by the thiamine structural analogs amprolium, oxythiamine and thiamine pyrophosphate; 5) inhibited by the unrelated organic cations guanidine, N-methylnicotinamide, tetraethylammonium, clonidine and cimetidine; 6) inhibited by the organic cation serotonin, and by two selective inhibitors of the serotonin plasmalemmal transporter (hSERT), fluoxetine and desipramine. We conclude that $^3H$-thiamine uptake by BeWo cells seems to occur through a process distinct from thiamine transporter-1 (hThTr-1) and thiamine transporter-2 (hThTr-2). Rather, it seems to involve hSERT. Moreover, chronic (48 h) exposure of cells to caffeine ($1\;{\mu}M$) stimulated and chronic exposure to xanthohumol and iso-xanthohumol (1 and $0.1\;{\mu}M$, respectively) inhibited $^3H$-thiamine uptake, these effects being not mediated through modulation of the expression levels of either hThTr-1 or hSERT mRNA.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.1295-1296
• /
• 2008

Hydrogen peroxide ($H_2O_2$) biosensor is one of the most developing sensors because this kind of sensors is highly selective and responds quickly to the specific substrate. Hemoglobin (Hb) has been used as ideal biomolecules to construct hydrogen peroxide biosensors because of their high selectivity to $H_2O_2$. The direct electron transfer of Hb has widely investigated for application in the determination of $H_2O_2$ because of its simplicity, high selectivity and intrinsic sensitivity. An electrochemical detection for hydrogen peroxide was investigated based on immobilization of hemoglobin on DNA/Fe(pyterpy)$^{2+}$ modified gold electrode. The pyterpy monolayers were firstly an electron deposition onto the gold electrode surface of the quartz crystal microbalance (QCM). It is offered a template to attach negatively charged DNA. The fabrication process of the electrode was verified by quartz crystal analyzer (QCA). The experimental parameters such as pH, applied potential and amperometric response were evaluated and optimized. Under the optimized conditions, this sensor shows the linear response within the range between $3.0{\times}10^{-6}$ to $9.0{|times}10^{-4}$ M concentrations of $H_2O_2$. The detection limit was determined to be $9{\times}10^{-7}$ M (based on the S/N=3).

• Membrane and Water Treatment
• /
• v.7 no.6
• /
• pp.521-537
• /
• 2016

Laboratory-scale experiments were carried out to investigate the adsorption equilibrium, the adsorption kinetics and facilitated transport of two cationic dyes (Methylene Blue (MB) and Rhodamine B (RB)) on Polymer Inclusion Membrane (D2EHPA-PIM). Different adsorption isotherms (Freundlich, Langmuir and Temkin models) as well as kinetics models indicated that the adsorption process is spontaneous and exothermic. Under the optimal conditions, the adsorption removal efficiencies reach about 93% and 97% for MB and RB respectively. Different extraction values by D2EHPA-PIM were obtained for the two cationic dyes: MB is weakly extracted at pH 2.0 (E% = 18.7%) whilst E% = 82.4% was observed for RB at the same pH. This difference was exploited in a mixture containg both the 2 cationic dyes for the selective extraction of RB at pH 2. Desorption of both dyes was achieved from the membrane by using acidic aqueous solutions and desorption ratio up to 90% was obtained. The formulas of the extracted complexes by the PIMs were, determined by the method of slopes. The dyes transport was elucidated using mass transfer analysis where in it found relatively high values of the initial flux ($J_0$) as 41.57 and $18.74{\mu}mol.m^2.s^{-1}$ for MB and RB respectively.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.14 no.1
• /
• pp.68-78
• /
• 2006

In the past few years, considerable efforts have been directed towards the further development of Urea-SCR(selective catalytic reduction) technique for diesel-driven vehicle. Although urea possesses considerable advantages over Ammonia$(NH_3)$ in terms of toxicity and handling, its necessary decomposition into Ammonia and carbon dioxide complicates the DeNOx process. Moreover, a mobile SCR system has only a short distance between engine exhaust and the catalyst entrance. Hence, this leads to not enough residence times of urea, and therefore evaporation and thermolysis cannot be completed at the catalyst entrance. This may cause high secondary emissions of Ammonia and isocyanic acid from the reducing agent and also leads to the fact that a considerable section of the catalyst may be misused for the purely thermal steps of water evaporation and thermolysis of urea. Hence the key factor to implementation of SCR technology on automobile is fast thermolysis, good mixing of Ammonia and gas, and reducing Ammonia slip. In this context, this study performs three-dimensional numerical simulation of urea injection of heavy-duty diesel engine under various injection pressure, injector locations and number of injector hole. This study employs Eulerian-Lagrangian approach to consider break-up, evaporation and heat and mass-transfer between droplet and exhaust gas with considering thermolysis and the turbulence dispersion effect of droplet. The SCR-monolith brick has been treated as porous medium. The effect of location and number of hole of urea injector on the uniformity of Ammonia concentration distribution and the amount of water at the entrance of SCR-monolith has been examined in detail under various injection pressures. The present results show useful guidelines for the optimum design of urea injector for reducing Ammonia slip and improving DeNOx performance.

• Proceedings of the Korean Society of Embryo Transfer Conference
• /
• 2002.11a
• /
• pp.118-118
• /
• 2002

Programmed cell death (PCD) is thought as a well-controlled process by which unwanted cells are selectively eliminated. During the last decade many researches have elucidated molecules and their interactions involved in cell death by using largely in vitro induction of cell death or survival signals in a more defined manner, While these critical information and novel findings provide us with clearer understanding of mechanisms underlying cell death, it does by no means explain how PCD occurs and which cells or tissues are affected during normal embryonic development in vivo. In this study, we used zebrafish to examine whether the PCD is occurring selectively or randomly in developing embryos by whole mount in situ TUNEL analysis with specific markers for neural cells. The result revealed that the degree and distribution of TUNEL staining varied considerably throughout gastrulation stage, and there was also a number of TUNEL-negative embryos. Most of TUNEL-positive cells were scattered randomly throughout the blastoderm. During the gastrulation stage about 75 % of the embryos analyzed exhibited more than 5 TUNEL-positive cells. As the dorsal epiblast begins to thicken rather abruptly near the end of gastrulation, TUNEL-positive cells were mainly located along the dorsal side. Although there were some variations in TUNEL staining during segmentation and pharyngeal stages, TUNEL staining continued to be localized to the central nervous system, and was also detected in the sensory organs, trigeminal ganglions, and the primary sensory neurons. High levels of the cell death in developing brain between 20-somite and prim-6 stages are thought to play a role in the morphogenesis and organization of the brain. At prim-16 stage, cell death is considerably reduced in the brain region. Dying cells are mainly localized to the prospective brain region where ectodermal cells are about to initiate neurogenesis. As development progressed, high levels and more reproducible patterns of cell death were observed in the developing nervous system. Intensive TUNEL staining was restricted to the trigeminal ganglions, the primary sensory neurons, and sensory organs, such as olfactory pits and otic vesicles. Thus, PCD patterning in zebrafish embryos occurs randomly at early stages and becomes restricted to certain region of the embryos. The spatio-temporal pattern of PCD during the early embryonic development in zebrafish will provide basic information for further studies to elucidate genes involved in. regulation of PCD largely unknown in vivo during vertebrate embryogenesis.

• International Commerce and Information Review
• /
• v.18 no.3
• /
• pp.275-306
• /
• 2016

This paper investigates the success and failure factors of technology commercialization for SMEs developing public sector technologies. The 2014 Korea Technology Transfer Commercialization Status Report states that only 30% of the technologies that are transferred are being used and the rest are neglected. The objective of this paper is to determine the relationship between quantitative variables and the success rate of technology commercialization of 1,222 SMEs in Korea by using three analyzes (cross tabulation, process and logistic) methodologies to increase the success of public technology commercialization. The outcome shows that the number of successful technology deployment cases and the number of IPR registration cases have a positive impact on the success rate of public technology commercialization. The statistical outcome also verifies that unnecessary technology development, more attempts and failures of technology development, and longer lead time in the planning phase have a negative impact on the success rate of the public technology development and commercialization. For policy implications, the government should be selective in supporting public technology commercialization and development for SMEs as not all technology attempts exert positive effects.