• Proceedings of the Korea Concrete Institute Conference
• /
• 2003.05a
• /
• pp.89-94
• /
• 2003

In this research, the physical properties of self compacting concrete using ground granulated blast furnace slag and fly ash as a part of cement were investigated. Concrete using ground granulated blast furnace slag and fly ash was prepared with various ground granulated blast furnace slag(30-50 volume %) and fly ash(10-20 volume %) replacement for cement. The effect of each of the materals, which have effects on self compacting concrete made by the basic mix proportion used granulated blast furnace slag and fly ash after hardening, has been checked. The workability, flowing characteristics, resistance of segregation of materals, air content, and compressive strength of concrete using ground granulated blast furnace slag and fly ash were tested and the results were compared with those of ordinary portland cement concrete. In the experiment, we acquired satisfactory results at the point of flowing characteristics and strengths of concrete using ground granulated blast furnace and slag fly ash within the replacement ratio of 65%

• Proceedings of the International Microelectronics And Packaging Society Conference
• /
• 2003.11a
• /
• pp.133-137
• /
• 2003

The effect of Bi additions to the eutectic Sn-3.5Ag solder alloy on the growth kinetics of the intermetallic compound (IMC) layers during solid-state aging of Sn-Ag-Bi/Cu solder joints has been Investigated. The Bi additions enhanced the growth rate of the total IMC layer comprising of $Cu_6Sn_5$ and $Cu_3Sn$ sublayers. This enhanced IMC growth rate was primarily due to the rapid increase In the growth rate of $Cu_6Sn_5$ sublayer. The growth rate of $Cu_3Sn$ sublayers was little influenced and appeared to be retarded by the Bi additions. The observed growth behavior of $Cu_6Sn_5$ and $Cu_3Sn$ sublayers could be understood if the interfacial reaction barrier at the $Cu_6Sn_5/solder$ interface were reduced by the segregation of Bi at the interface.

• Journal of the Korean Ceramic Society
• /
• v.37 no.2
• /
• pp.145-151
• /
• 2000

In order to investigate the rheological properties of belite-rich cement(BRC) added polycarbonate-based superplasticizer and blastfurnace slags which have different blaines at 4500, 6000 and 8000$\textrm{cm}^2$/g, the change of minislumps and mortar slumps are measured with time. The rheological properties improve as specific surface area of added slag decreases or amount of polycarbonate-based superplasticizer increases. The slump loss can be controlled effectively by the steric hinderance effect of polycarbonate-based superplasticizer. According to the results, when mix proportion of the mortar is 1.5% mass content of superplasticizer and 30% mass addition of blastfurnace slag which blaine is 4500$\textrm{cm}^2$/g, the best mortar slump can be achieved without any significant segregation of materials.

• Journal of Powder Materials
• /
• v.1 no.1
• /
• pp.79-84
• /
• 1994

The mechanism of activated sintering of tungsten powder was discussed in terms of diffusion and segregation of activator atoms at W grain boundaries. Shrinkage behaviours of W-0.2wt.% Ni, W-0.2wt.% Cu or pure W powder compacts during sintering at low temperatures of 900~ $1200^{\circ}C$ were investigated. It was found that the Cu additive inhibits sintering process causing lower densification than pure W compact while remarkable shrinkage occurred in the Ni added W powder. Such contrary effect was explained by comparing self diffusion processes along Ni or Cu segregated W boundaries in which Ni segregants enhance but Cu atoms retard the migration of W atoms at W boundaries.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.44 no.1
• /
• pp.70-73
• /
• 1999

This study was conducted to ascertain the chromosomal locations and effect of quantitative trait loci (QTL) associated with the physical traits of rice (Oryza sativa L.) eating quality. One hundred sixty four recombinant inbred lines (MGRILs) of F$_{11}$ were derived from the cross between Milyang 23 (Tongil type) and Gihobyeo (japonica type). They were evaluated for six physical traits of cooked rice. Transgressive segregation was observed for all examined traits. Significant QTL were detected (LOD$\geq$2.0) in three traits, including single QTL for adhesiveness, gumminess, and chewiness of cooked rice, respectively. Phenotypic variation explained by each QTL ranged from 6.3% to 14.6%. However, no significant QTL was detected for hardness, cohesiveness, and elasticity of cooked rice. Pleiotropic effects of single QTL on different traits are observed.d.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.43 no.3
• /
• pp.66-76
• /
• 2001

Recently the use of the antiwashout underwater concrete with the antiwashout admixture is increased considerably. Antiwashout underwater concrete is quite different in concept from conventional underwater concrete. By mixing an antiwashout admixture with concrete, the viscosity of the concrete is increased and its resistance to segregation under the washing action of water is enhanced. The aims of this research is statistically evaluated to mix proportion factor of antiwashout underwater concrete. Experiment was performed to analyze the influence variables(cement, water, and antiwashout admixture) on fundamental characteristics of antiwashout underwater concrete. The influence variables can be considered for use in a wide range of underwater work where their have statistically significant effect on the characteristics(fluidity, filling ability, resistance to washout, etc.) of antiwashout underwater concrete.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2009.05a
• /
• pp.91-93
• /
• 2009

A large steel ingot needs to be larger and larger in size and an ultra high clean, no defect in quality with a low hot top ratio for the resent heavy industry. The demands are very difficult to achieve simultaneously because of their contradictive effect to each other in results. In this study, 30ton steel ingot was cast in a foundry with an optimized design parameter of cast mold and cast process conditions for the low hot top ratio, 12%. The cast ingot was analyzed in macro defect, segregations, and cleanness. No macro defect was founded in central surface of the ingot. The degree of segregation and cleanness are in the controlled range with a sound quality.

• Journal of Korea Foundry Society
• /
• v.12 no.1
• /
• pp.25-31
• /
• 1992

The effects of Si and austempering temperature on the fracture characteristics and the microstructures of austempered ductile irons were investigated. As Si content increased from 2.28% to 3.0%, the precipitation of carbides during bainitic transformation and was suppressed the amount of retained austenite increased resulting in the increase in the fracture toughness. It is believed that the high Si limited the formation of martensite in the microstructure and minimized the segregation of the other elements at cell boundaries. But in samples with too high Si content as 3.3%, the formation of islands of free ferrite in the bainitic structures was observed and the fracture toughness was measured to have degraded.

• Journal of Aquaculture
• /
• v.10 no.4
• /
• pp.395-402
• /
• 1997

The study has been conducted in order to understand the inheritance of body color in the wild type zebrafish (zebra danio), Danio rerio, and its golden mutant (golden danio). The body color was also studied to determine the effect of golden coloration on the survival rate of zebrafish eggs and larvae up to 15 days after fertilization. Reciprocal monohybrid crosses between the wild and the golden type of zebrafish indicated that golden coloration was controlled by a single gene which had two alleles. Transmission of these alleles from parents to their progenies followed the principles of dominance and segregation based on Mendelian inheritance. Similar results from the reciprocal crosses implied that a locus for golden coloration was located on an autosomal chromosome. On the other hand, average survival rates from four different types of mating between, and within, zebra and golden danio suggested that golden coloration seemed to be associated with the survival rate of zebrafish, especially in its early embryonic stage. This indicated that homozygous recessive golden mutation was likely to weaken the golden danio's chance of survival.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.3 no.3
• /
• pp.177-185
• /
• 1999

In this study, study about fly ash and blast-furnace slag used as substitutive materials for cement, and the influence on the neutralization of high flow concrete durability with these substitutive materials was performed and analyzed. The results are as follows 1) Aggregate segregation was partially improved with the progress of the admixture input at the mix proportion above slump flow 65 cm 2) Compressive strength with the progress of the increasement of fly ash input was decreased in early age, but decrease range was improved in long term age. Also, in case of blast-furnace, similar or improved compressive strength was appeared. 3) The neutralization depth with fly ash input was noticeably increased. But blast-furnace slag was effective to prevent. 4) In this experiment, high powder content was advantageously affected on preventive effect of the neutralization, and the relationship between the compressive strength and the neutralization depth was inversely proportional.