• Journal of Korean Dental Science
• /
• v.16 no.1
• /
• pp.80-86
• /
• 2023

We report two rare cases of extensive bilateral subcutaneous emphysema that occurred during ordinary dental procedures. An air-driven high-speed handpiece, routinely used in dental procedures may cause subcutaneous emphysema when high pressure air is introduced into the loose connective tissues below the dermal layer. The first case occurred with surgical extraction of the lower third molar. The air introduced into the fascial spaces near the surgical field spread to the contralateral spaces, as well as the neck and chest areas. The second case also showed extensive bilateral subcutaneous emphysema caused by the introduction of compressed air from the handpiece during crown preparation without any invasive procedure. Cases where the emphysema extends beyond the treatment site to involve the contralateral cervicofacial areas have been rarely reported. Predicting the occurrence of subcutaneous emphysema is difficult, so it is important to exercise caution during routine dental treatment. If significant bilateral cervicofacial swelling is suspected to be due to subcutaneous emphysema, prompt diagnosis with securing the patient's airway will be necessary.

• The Journal of Korea Assosiation for Disability and Oral Health
• /
• v.7 no.1
• /
• pp.33-37
• /
• 2011

The ectopic eruption is defined as abnormal eruption which gives to displacement of the teeth and abnormal root resorption of adjacent teeth. The prevalence of ectopic eruption is reported to vary 2~6%, most of them are in the maxilla. Etiologic factors include narrow maxilla, large maxillary teeth, inclined eruption path of the first molar, retruded position of the maxilla and hereditary factor. Irreversible ectopic eruption where the second primary molar is lost often causes mesial tipping and rotation of the permanent molar, unfavorable occlusion and space deficiency for the second premolar. Ectopically erupted teeth should be treated early to maintain normal development of the dentition, harmony of facial growth and occlusal support. The method of the treatment are classified as follows : appliances that is positioned at the contact point for unlocking and the distal movement, fixed appliance that is connected to more than one tooth, and occlusion guiding method after disking or extraction of the second deciduous molar. A case report of a patient with bilaterally ectopic eruption of maxilla and mandible first permanent molar was present. Also, the patient who had experienced the chronic myelogenous leukemia, show various dental developmental complications. The ectopic eruption was treated with a Halterman appliance that was a effective way of correcting of ectopic eruption of the permanent first molar.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.35 no.1
• /
• pp.167-174
• /
• 2008

Mandibular first molar and primary molars usually have two roots, on the mesial and distal sides. Occasionally, these molars have an extra root located in the distolingual aspect. Prevalence of the 3-rooted first permanent molar shows ethnic variation, ranging from about 3% in Caucasian to about 20% in Mongoloid group, which includes Chinese, Japanese, Eskimo, American and Canadian Indians. The frequency of the mandibular molar with three roots decreases in the order of the first permanent molar, the second primary molar, and the first primary molar. If the mandibular first or second primary molar has an additional distolingual root, the adjacent molars, including the first permanent molar, posterior to it also may have it. Coronal morphologic change can occur in the mandibular first primary molars with three roots: the crown had more triangular-shape compared to the one with two roots, possibly affected by the presence of additional distolingual root. Clinically, exact diagnosis and treatment should be taken with those teeth for pulp canal treatment, extraction, and SS Cr.

• The Journal of the Korean dental association
• /
• v.23 no.7 s.194
• /
• pp.625-630
• /
• 1985

11 years 7 months old female had a reverse object of anterior teeth and class III molar relationship. Maxillary right and left canines were erupted labially and lower left lateral incisor was congenitally missed. She was treated by rapid palatal expansion and full band technique with extraction of maxillary and mandibular second molars. The following results were obtained. 1. Maxilary arch was expanded. 2. Anterior cross-bite and crowding was corrected. 3. Molar relationship was corrected. 4. Profile was somewhat improved.

• The korean journal of orthodontics
• /
• v.46 no.5
• /
• pp.280-289
• /
• 2016

Objective: The aim of this study was to analyze tooth movement and arch width changes in maxillary dentition following nonextraction treatment with orthodontic mini-implant (OMI) anchorage in Class II division 1 malocclusions. Methods: Seventeen adult patients diagnosed with Angle's Class II division 1 malocclusion were treated by nonextraction with OMIs as anchorage for distalization of whole maxillary dentition. Three-dimensional virtual maxillary models were superimposed with the best-fit method at the pretreatment and post-treatment stages. Linear, angular, and arch width variables were measured using Rapidform 2006 software, and analyzed by the paired t -test. Results: All maxillary teeth showed statistically significant movement posteriorly (p < 0.05). There were no significant changes in the vertical position of the maxillary teeth, except that the second molars were extruded (0.86 mm, p < 0.01). The maxillary first and second molars were rotated distal-in ($4.5^{\circ}$, p < 0.001; $3.0^{\circ}$, p < 0.05, respectively). The intersecond molar width increased slightly (0.1 mm, p > 0.05) and the intercanine, interfirst premolar, intersecond premolar, and interfirst molar widths increased significantly (2.2 mm, p < 0.01; 2.2 mm, p < 0.05; 1.9 mm, p < 0.01; 2.0 mm, p < 0.01; respectively). Conclusions: Nonextraction treatment with OMI anchorage for Class II division 1 malocclusions could retract the whole maxillary dentition to achieve a Class I canine and molar relationship without a change in the vertical position of the teeth; however, the second molars were significantly extruded. Simultaneously, the maxillary arch was shown to be expanded with distal-in rotation of the molars.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.36 no.3
• /
• pp.475-480
• /
• 2009

An infraoccluded tooth is a tooth that has failed to erupt to be in line with adjacent teeth in the vertical plane of occlusion. Multiple complications can occur as a result of an infraoccluded tooth. Tipping of neighboring teeth, loss of space opposing teeth elongation, increased susceptibility to dental caries and abnormal eruption path, impaction and rotation of permanent successor are the consequences of infraocclusion of primary molar. Therefore, early diagnosis and treatment is the key to prevent the complications. Treatment options can be periodic follow-up, temporary restoration or extraction of the infraoccluded tooth depending on the presence of the successor, the extent of infraocclusion and the extent of tilting of the neighboring teeth. The infraoccluded primary molars with permanent successors present tend to exfoliate normally. However, failure to do periodic check up of the infraoccluded teeth may lead to serious complications. In these cases, surgical extractions are often necessary after space regaining and space maintainers should be placed until the eruption of the permanent successors are completed.

• The Journal of the Korean dental association
• /
• v.25 no.11 s.222
• /
• pp.1069-1077
• /
• 1987

Two brothers aged 15 1/6 and 12 2/3 years were diagnosed as Class I malocclusion with ectopic eruption of the upper left central incisor in the elder brother and etopic eruption in the upper right second premolar in the younger. All 4 second molars were extracted at the same time in both brothers. The treatment results were as follows. 1. In the elder brother, the third molars were fully erupted and their angulations were excellent at 3 years post-treatment. 2. In the younger brother, the lower right third molar was mesially erupted and upper third molars were still undergoing eruption at 3 years post-treatment. 3. Assessment of panex films of both brothers at aged 15 showed an earlier eruption of the third molars in the younger brother. 4. A longer post-treatment supervision of the third molars was required in the younger brother. 5. The facial probiles were enhanced and the ectopic eruptions were corrected in both brothers.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.27 no.1
• /
• pp.98-102
• /
• 2000

Ectopic eruption is out of a normal position by local eruption disturbance in the developing permanent molar. The prevalence of ectopic eruption is reported to be the between 2 and 6%, most often associated maxillary first permanent molar whereas, the occurrence for the mandibular is quite rare. The etiologic factors of ectopic eruption are inadequate arch length, lack of growth in the posterior region of the jaw, mesially inclined eruption path of first permanent molars, abnormally large first permanent molars, hereditary factor and a stainless steel crown which has been improperly restored. Ectopic eruption can be treated by the use of brass wire, separating elastics, distal disking and Humphrey appliance and the use of removable appliance and cervical traction headgear after extraction of the second primary molar. This case was that lower right first permanent molar was mesially tilted state by locking on the stainless steel crown of a lower right second primary molar. The stainless steel crown was removed and Humphrey appliance was set. Like this case, ectopic eruption could be happened by the stainless steel crown which improperly restored. In restoration of the stainless steel crown, selection of proper size, trimming and contouring are very important.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.41 no.4
• /
• pp.194-197
• /
• 2015

The amniotic membrane is the innermost layer of fetal membrane and is attached to the chorion in the placenta. This membrane has been used for nearly a century in varied fields such as ophthalmology, reconstructive surgery, and burn treatment. In this case report, we used a human amniotic membrane to repair an iatrogenic oroantral communication that occurred during the extraction of the patient's right upper second molar. A splint was given after the perforation was covered with human amniotic membrane and healing was clinically evaluated at various intervals. The outcome of the study revealed that the human amniotic membrane was an efficient graft material for repairing the defect caused by an iatrogenic oroantral communication following tooth extraction.

• The korean journal of orthodontics
• /
• v.19 no.1 s.27
• /
• pp.45-59
• /
• 1989

This study was undertaken to analyze the displacement and stress distribution in the mandible according to the pulling directions during mandibular first molar cervical traction after mandibular second molar extraction. The 3-dimensional finite element method(FEM) was used for a mathematical model composed of 594 elements and 1019 nodes. An orthodontic force, 450 gm, was applied to the each mandibular first molar in parallel, and below the occlusal plane by $7^{\circ}\;and\;25^{\circ}$ and meet the midsagittal plane by $40^{\circ}$ toward posterior direction. The results were as follows: 1. Mandibular teeth were displaced in more downward, posterior and lateral direction. Especially high stress was noted in case of parallel pull than in case of below the occlusal plane by $7^{\circ}\;and\;25^{\circ}$. 2. Mandibular first molar was moved bodily. 3. Generally, alveolar bone, mandibular body, ascending ramus and mandibular angle portion were displaced in downward, posterior and lateral direction. But coronoid process was displaced in downward, forward and lateral direction, and anterior and inner middle portion of condyle head and neck were displaced in downward, forward and medial direction, and posterior and outer middle portion of condyle head and neck were displaced in upward, forward and medial direction. 4. Maximum stress was observed at the condyle head and neck portion. With steeper direction of force, condyle head and neck showed more stress than parallel relation to the occlusal plane.