• ETRI Journal
• /
• v.33 no.1
• /
• pp.125-127
• /
• 2011

This letter presents a new type of resonator, namely, the split quarterwave microstrip resonator (SQMR), to improve the poor harmonic suppression and low Q-factors in conventional quarterwave microstrip resonators. An oscillator incorporating the proposed SQMR is designed, fabricated, and tested to demonstrate that, not only the second harmonic suppression, but also the phase noise of the oscillator can be improved. The oscillator with the SQMR shows improved second harmonic suppression of -74.59 dBc and phase noise figure of merit of -169.77 dBc/Hz at 1 MHz offset.

• Journal of electromagnetic engineering and science
• /
• v.5 no.2
• /
• pp.92-96
• /
• 2005

This paper presents a novel microwave oscillator incorporating a simple microstrip ring type resonant cell as its terminating resonance component. Reduced chip size, higher dc-ac power efficiency, superior harmonic characteristics can be achieved from the introduction of a compact microstrip ring resonator cell. The oscillator provides a second harmonic suppression of 26.51 dB and the output power of 2.046 dBm at 2.11 GHz.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.1
• /
• pp.46-50
• /
• 2013

A modified design that can reject the nth harmonic components in the Wilkinson power divider is presented. After adding transmission lines of electrical lengths determined by suppression terms between two transformers of the traditional design, a solution of the modified Wilkinson divider can be found. Experimental results show the second and third harmonic suppression to be -45.3 dB and -46.4 dB, respectively, while maintaining the conventional performance at the fundamental frequency.

• Journal of electromagnetic engineering and science
• /
• v.6 no.3
• /
• pp.160-164
• /
• 2006

This paper describes a compact printed helical resonator and its application to a microwave oscillator circuit implemented in coplanar waveguide(CPW) technology. The high Q-factor and spurious-free characteristic of the resonator contribute to the phase noise reduction and the harmonic suppression of the resulting oscillator circuit, respectively. The designed resonator resonating at the frequency of 5.5 GHz showed a loaded Q of 180 in a chip area of only 40 % of the corresponding miniaturized hairpin resonator without any spurious resonances. The fully planar oscillator incorporated with this resonator showed additional phase noise reduction of 10.5 dB at 1 MHz offset and a second harmonic suppression enhancement of 6 dB when compared to those of a conventional CPW oscillator without the planar helical resonator(PHR) structure.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.8
• /
• pp.811-818
• /
• 2002

In this paper, a shorting pin and slot-loaded microstrip patch antenna is designed and fabricated. A shorting pin and slots are used for harmonic suppression on an inset fed antenna. A shorting pin and slot properties are analyzed by cavity model of the rectangular patch and the characteristics of the designed antenna are described. The designed antenna provides a gain of 7 dBi at the fundamental frequency, 5.8 GHz. In the second and third harmonic frequencies, the proposed antenna has gain suppression properties of -3.3 dB and -14.3 dB at each harmonic frequency, respectively.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.6
• /
• pp.22-25
• /
• 2010

This paper presents the modified design that can reject the harmonic signals in the branch-line coupler. After adding open stubs at the center of quarter-wavelength lines of the traditional design, all network parameters can be determined by network equivalence, in order to maintain the conventional function at the operating frequency and suppress its harmonic terms to de chosen. Experimental results show the second and third harmonic suppressions to be -37.5 and -42.7dBs, while maintaining conventional performance at the fundamental frequency.

• Journal of Power Electronics
• /
• v.18 no.6
• /
• pp.1659-1669
• /
• 2018

An improved circulating current suppression control method is proposed in this paper. In the proposed controller, an outer loop of the average capacitor voltage control model is used to balance the sub-module capacitor voltage. Meanwhile, an individual voltage balance controller and an arm voltage balance controller are also used. The DC and harmonic components of the circulating current are separated using a low pass filter. Therefore, a multiple quasi-proportional-resonant (multi-quasi-PR) controller is introduced in the inner loop to eliminate the circulating harmonic current, which mainly contains second-order harmonic but also contains other high-order harmonics. In addition, the parameters of the multi-quasi-PR controller are designed in the discrete domain and an analysis of the stability characteristic is given in this paper. In addition, a simulation model of a three-phase MMC system is built in order to confirm the correctness and superiority of the proposed controller. Finally, experiment results are presented and compared. These results illustrate that the improved control method has good performance in suppressing circulating harmonic current and in balancing the capacitor voltage.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2005.11a
• /
• pp.101-106
• /
• 2005

This paper presents a new microwave oscillator incorporating a corrugated coplanar waveguide (CCPW) electromagnetic bandgap (EBG) structure as its terminating resonance component. The use of a compact CCPW EBG structure was effective in reducing the phase noise and improving the harmonic characteristics of the microwave oscillator circuit without additional backside processing and drastic size increment. The fully planar CCPW oscillator oscillating at the frequency of 5.41 GHz showed a phase noise characteristic of -90.7 dBc/Hz at 100kHz offset and a second harmonic suppression of 42.67 dB.

• Journal of electromagnetic engineering and science
• /
• v.6 no.4
• /
• pp.235-243
• /
• 2006

In this paper, the fractal shape is applied to microstrip band pass filters and integrated on a high-resistivity Si substrate to solve conventional $2^{nd}$ harmonic problem. Conventional microstrip coupled line filters are popular in RF front ends, because they can be easily fabricated and integrated with other RF components. However, they typically have large second harmonics that can cause unwanted interference in interested frequency bands. Without any additional filters, the proposed Koch shape filters have suppressed the $2^{nd}$ harmonics by about -40 dB, so they can be used in systems such as direct conversion receiver with stringent harmonic suppression requirements.

• 한국정보통신설비학회:학술대회논문집
• /
• 2009.08a
• /
• pp.293-297
• /
• 2009

In this thesis, design of a VCO(Voltage controlled Oscillator) with a novel tuning mechanism is presented for the Radar system. This circuit, the 9.5 GHz oscillator is designed and implemented by restructuring microstrip resonator to raise Q value and to require a wide frequency tuning range. This product is fabricated on 2.6 Teflon substrate and device is NE722S01. In this paper, The new microstrip resonator VCO is proposed to achieve the characteristic of a wide frequency tuning range. This microstrip resonator VCO shows the phase noise characteristic of -108.3 dBc/Hz at 1 MHz offset from the fundamental frequency, the output power of 5.7 dBm and the second harmonic suppression of -38 dBc for the VCO are obtained. The manufacture VCO shows a frequency tuning range of 193.8 MHz. The proposed micro trip resonator VCO can be used for X-band Radar System with required tuning range.