• The Journal of the Acoustical Society of Korea
• /
• v.22 no.8
• /
• pp.652-659
• /
• 2003

High-frequency(40∼120 kHz) reflection loss measurements on the water-sandy sediment with a flat interface were conducted in a water tank for various grazing angles. The water tank(5×5×5 m) was filled with a 0.5 m-thick-flat bottom of 0.5ø-mean-grain-size sand. Reflection losses, which were experimentally obtained as a function of grazing angle and frequency, were compared with the forward loss model, APL-UW model (Mourad & Jackson, 1989). For frequencies below 60 kHz, the observed losses well agree with the reflection loss model, however, in cases for frequencies above 70 kHz, the observed losses are greater by 2∼3 dB than the model results. The model calculation, which does not fully account for the vertical scale of roughness due to grain size, produce less bottom losses compared to the observations that correspond to large roughness based on the Rayleigh parameter in the wave scattering theory. In conclusion, for the same grain-size-sediment, as frequencies increase, the grainsize becomes the scale of roughness that could be very large for the frequencies above 70 kHz. Therefore, although the sea bottom was flat, we have to consider the frequency dependence of an effect of roughness within confidential interval of grain size distribution in reflection loss model.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.25 no.4
• /
• pp.364-371
• /
• 2022

Surface state change of ammunition generated during the storage period increases the surface roughness and this affects the flight of ammunition, but there are no research results quantitatively indicating this. In this study, the drag force for each Mach number of howitzer shells was calculated through CFD to which the surface data of the howitzer shell was applied, and analysis of trajectory was performed using drag force values as an input of the 4th Runge-Kutta method, and the degree of decrease of the maximum range caused by the surface roughness of the howitzer shell was estimated. As a result, it was confirmed that the maximum range of howitzer shell with high surface roughness was 1.12 % shorter than that of howitzer shell without roughness. It was confirmed that the effect of surface roughness on the trajectory is not negligible.

• Korean Journal of Remote Sensing
• /
• v.26 no.5
• /
• pp.497-510
• /
• 2010

In this study, comparisons of the backscattering coefficients and the coherence values which had been extracted from SAR (Synthetic Aperture Radar) images such as JERS-1, ENVISAT and ALOS satellites with surface roughness, surface geometric and soil moisture content were carried out. As the results of analysis using the backscattering coefficient and coherence values from SAR images, the coherence was shown high in the region containing more of mud fraction due to higher viscosity of fine grain-size. A lot of tidal channels were well developed in the Ganghwa tidal flat, affecting the drainage of seawater and subsequent soil moisture content by exposure time of tidal flat. The backscattering coefficient. consequently, appeared to be lower in sand flat and mix flat with decrease of soil moisture. In contrast, most mud flats were distributed at high elevation so that soil moisture was not much influenced by seawater. The backscattering coefficient in mud flat seemed to have a relationship with the density of tidal channel. In addition, lowering backscattering coefficients in the all Ganghwa tidal flat was observed when surface remnant water increased according to the amount of rainfall. The correlation between backscattering coefficient, coherence and sediment environment factors in the Ganghwa tidal flat was investigated. In the future, more quantitative spatial analysis will be helpful to well understand the sedimentary influence of various sediment environment factors.