• Journal of Sensor Science and Technology
• /
• v.21 no.6
• /
• pp.395-401
• /
• 2012

The bond strength of three types of $TiO_2$ coatings onto fluorine-doped $SnO_2$ (FTO) glass was investigated with the aid of a tape test according to ASTM D 3359-95. Transmittance was then measured using an UV-vis spectrophotometer in the wavelength range of 300 nm to 800 nm to evaluate the extent of adhesion of $TiO_2$ nanorods/nanoparticles on FTO glass. A sharp interface between the coating layer and the substrate was observed for single $TiO_2$ coating ($TiO_2$ nanorods/FTO glass), which may be detrimental to the bonding strength. In multicoating sample ($TiO_2$ nanorod/$TiO_2$ nanoparticle/$TiO_2$ nanoparticle/FTO glass), the tape test was not performed due to severe peeling-off prior to the test. On the other hand, the dual coating sample ($TiO_2$ nanorod/$TiO_2$ nanoparticle/FTO glass) showed minimum variation of transmittance (4%) after the test, suggesting that the topcoat adheres well with the FTO substrate due to the presence of the $TiO_2$ nanoparticle buffer layer. The use of a $TiO_2$ nanorod electrode layer with good adhesion may be attributed to the excellent dye sensitized solar cell performance.

• Nuclear Engineering and Technology
• /
• v.55 no.7
• /
• pp.2662-2669
• /
• 2023

For the precise measurements of special nuclear materials (SNM) including Pu and Am isotopes, we have used phoswich detector combination of two single crystal scintillators of Gd₃Ga₃Al₂O₁₂:Ce and CsI:Tl. High detection efficiency and sensitivity along with high figure of merit for the discrimination of these phoswich detectors ensures the detection and discrimination of thermal neutrons and gammas from spontaneous fission of Pu and other isotopes in presence of high gamma background. Using this detector, the low energy gammas, which is stopped completely in 1mm thick disc of GGAG, can be also discriminated from high energies gamma and shows linearity in wide range of sample quantities. By changing only the appropriate shielding, the similar setup was used for thermal neutron detection and shows a very good linearity over wide range. The quantity of a test sample was also calculated accurately by using the measured calibrated plot.

• YAKHAK HOEJI
• /
• v.32 no.4
• /
• pp.281-286
• /
• 1988

For the investigation of medicinal resources in Hydrocotyle species, the studies were conducted to evaluate the pharmaco-constituents in Hydrocotyle japonica MAKINO (Umbelliferae), which is used as folk medicine in Korea. From the methyl alcohol extract of the whole plant, $isorhamnetin-3-O-{\beta}-D-galactoside$ ($C_{22}H_{22}O_{12}{\cdot}1/3H_2O$, bright yellow needle crystal, mp $247{\sim}248^{\circ}C$, $[{\alpha}]_D^{28}^{\circ}=-52.27^{\circ}$ in pyridine), one of three flavonol substances in extrat, was isolated and identified by physicochemical properties and spectroscopic evidences (UV, IR, NMR and MS etc.,) in comparison with authentic sample. This flavonoid was appeared from Hydrocotyle japonica MAKINO through phytochemical approaches at the outset.

• Journal of Magnetics
• /
• v.1 no.1
• /
• pp.1-3
• /
• 1996

The $YBa_2Cu_3O_{7-x}$ structure has been fluorinated by a gas phase exchange technique. The ${^19}F$NMR (nuclear magnetic resonance) spin-lattice relaxation rate (1/T1) measurements on a fluorinated sample gave superconducting energy gap of $2\Delta=4.6kT_c$.

• Journal of Magnetics
• /
• v.2 no.2
• /
• pp.35-37
• /
• 1997

A sample of YBa2Cu3O7-x fluorinated by a high temperature (400$^{\circ}C$) gas exchange technique has been investigated by means of 19F NMR (nuclear magneti resonance) measurements in both superconducting and normal state. As a result, behaviors characteristic of the superconductor, including a peculiarity in the spin-lattice relaxation rate (1/T1) around 250 K, were observed.

• Journal of Magnetics
• /
• v.2 no.2
• /
• pp.42-45
• /
• 1997

The microscopic physical properties of nonstoichiometric garnet EuxFe2-xO3 (x=0.8 and 0.7) have been studied by the methods of X-ray diffraction at room temperature and M ssbauer spectroscopy within the temeperature range of 12-560 K. The X-ray diffraction patterns of the samples show coexistence of dominant garnet and a small portion of unknown crystal phase. But the M ssbauer spectra for the sample of EF08 and EF07 near N el temperature determined to be equally 549$\pm$5K show that there are no any other extra crystal phases within the experimental error. The results of which the temperature dependence of M ssbauer parameters was anlyzed by the spin-wave theory and Debye model are in good agreement with the fact that the sample of EF08 has some vacancies at a-and/or d-sites.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.1
• /
• pp.194-198
• /
• 2012

In this work, we studied the microstructural changes of ITO during the annealing process. ITO nanoparticles were prepared by the sol-gel method using indium tin hydroxide as the precursor. The prepared sample was investigated using TEM, powder XRD, XPS, DRIFT, and 2D correlation analysis. The O 1s XPS spectra suggested that the microstructural changes during the annealing process are closely correlated with the oxygen sites of the ITO nanoparticles. The temperature-dependent in situ DRIFT spectra suggested that In-OH in the terminal sites is firstly decomposed and, then, Sn-O-Sn is produced in the ITO nanoparticles during the thermal annealing process. Based on the 2D correlation analysis, we deduced the following sequence of events: 1483 (due to In-OH bending mode) ${\rightarrow}$ 2268, 2164 (due to In-OH stretching mode) ${\rightarrow}$ 1546 (due to overtones of Sn-O-Sn modes) ${\rightarrow}$ 1412 (due to overtones of Sn-O-Sn modes) $cm^{-1}$.

• Membrane and Water Treatment
• /
• v.14 no.4
• /
• pp.181-189
• /
• 2023

The Covid-19 pandemic has increased demand for chlorine-based sanitizing solutions, most of which contain hypochlorous acid (HOCl) as an active agent. Free chlorine (HOCl) in these sanitizers is crucial for their efficacy. Disposable test strips are affordable and convenient tools for determining various qualitative and quantitative parameters. In this study, disposable opto-chemical test strips were developed by physically immobilizing 3,3',5,5'-tetramethylbenzidine (TMB) and o-dianisidine (o-D) reagents on chromatography and filter paper-based test strips for the visualization and detection of free chlorine in the form of HOCl. The reagents undergo a rapid color change upon reaction with chlorine through a redox reaction. The paper-based test strips showed rapid color change within a minute and a low sample volume requirement (1 ml). This portable, disposable paper-based test strip is a simple and cost-effective way to rapidly detect the presence of HOCl sanitizers for home and field applications. Both TMB and o-D successfully detected chlorine. Chromatography paper proved to be the more efficient option among the two papers used as substrates for the reagents (TMB and o-D). It exhibited high retention capacity and high performance in terms of color transformation when reacting with HOCl, even after two months of storage.

• Journal of Ceramic Processing Research
• /
• v.19 no.6
• /
• pp.483-491
• /
• 2018

Effects of additives on phase development and physico-mechanical properties of mullite-carbon was investigated. Powdered clay, kaolinite and graphite of predetermined compositions were blended with additives using ball mill for 3 hrs at 60 rev/min. Samples were produced by uniaxial compression and sintered between $1400^{\circ}C$ and $1600^{\circ}C$ for one hr. They were characterized for various properties, developed phases and microstructural features. It was observed that the properties and phase developments in the samples were influenced by the additives. 10 wt % SiC served as nucleating point for SiC around $1400^{\circ}C$. 10wt % $TiO_2$ lead to development of 2.5 wt % TiC at $1500^{\circ}C$ which increased to 6.8 wt % at $1600^{\circ}C$. Ifon clay in the sample leads to development of anorthite and microcline in the samples. 10wt % $TiO_2$ is effective as anti-oxidant for graphite up to $1500^{\circ}C$. Base on strength and absorbed energy, sample C (with 10wt % $TiO_2$) sintered at $1500^{\circ}C$ is considered to be optimum.

• Journal of the Korean Society of Food Culture
• /
• v.5 no.2
• /
• pp.243-251
• /
• 1990

We determined the structure of main saponin which extracted from the shoot of Aralia Elata. The results were as follows. 1. The main aglycons and suger of the total saponins of Nr2 sample were identified as oleanolic acid and hederagenin, and glucose, arabinose and rhamnose. A probable new aglycon was isolated and inferred as 1, 3-methylenedioxy-3-dehydroxyoleanolic acid. 2. One compound of Fh saponin (named as Elatoside $Fh_2$) which was obtained first in this species was elucidated as 3-O-$({\alpha}-L-arabinopyranosyl(1{\rightarrow}2)-{\beta}-D-gluco-pyranosyl)$-28-O-${\beta}-D-glucophyranosyl$ oleanolic acid on the basis of chemical and spectral evidence of IR, $^1H$, $^{13}C-NMR$ and MS.