• Analytical Science and Technology
• /
• v.24 no.5
• /
• pp.368-377
• /
• 2011

In this study, we analyzed the relationship between noise and air pollution from 6 residential sites from 6 districts in Seoul. The survey of all noise date obtained from 6 sites were also compared between road and nonroad area and between active (06:00-22:00) and inactive time bands (22:00-06:00). Comparison of the data between two time bands indicates that their differences are not large enough. On the other hand, if comparison of data is made by correlation analysis for road and non-road areas, strong correlations between noise levels and air pollution tend to be prevalent consistently in road area relative to the non-road area. In contrast, a correlation between noise levels and air pollution tends to decrease at the road area in inactive period relative to active period.

• Journal of Korean Society for Atmospheric Environment
• /
• v.28 no.1
• /
• pp.94-104
• /
• 2012

The purpose of this research is to quantify the compliance of on-road emission from a light duty diesel vehicle, based on a comparison to emission regulation standard. $NO_x$, CO and THC emissions were measured using a portable device on a selected real-world driving route with a length of approximately 22 km. On-road measurements were repeated by 10 times on a same route to reflect variability in traffic conditions. A test route was divided into 22 road links with length of 1 km to analyze emission results with higher spatial resolution. The average emissions of $NO_x$, CO and THC over total travel distance, which is approximately 220 km, were quantified to be in compliance with emission regulation standards. Under higher spatial resolution, $NO_x$ concentration exceeded a standard in 92 links out of 220 links. The extended time in stop period and the stop-and-go driving cycle were identified as two important reasons for increased $NO_x$ emissions in observed cases. Heavy traffics showed higher $NO_x$ emissions than free flow. These results indicate that the real-world vehicle emissions might exceed the compliance level associate with traffic conditions. Another interesting observation of this research is that the on-road emission characteristics can be independent to the average speed of road links with higher spatial resolution. Variability in on-road emission might not be fully described by solely relying on an average speed, because variability in traffic conditions and road conditions can influence on real-world vehicle emissions.

• Journal of Korean Society on Water Environment
• /
• v.37 no.4
• /
• pp.286-295
• /
• 2021

The removal efficiency of road-deposited sediment (SDR) by road sweeping was analyzed by performing particle size analysis before and after road sweeping at four highways during May to December 2019. The SDR accounted for the largest proportion in the range of 250 to 850 ㎛ and the degree of its proportion had an effect on the particle size distribution curve. The particle size distribution of the collected sediments showed a similar distribution at all sites. Below 75 ㎛, the removal efficiency of SDR showed a constant value around 40%, but above 75 ㎛, it increased as the particle size increased. The removal efficiency was 82-90% (average 86%) for gravel, 66-93% (average 79%) for coarse sand, 35-92% (average 64%) for fine sand, 29-69% (average 44%) for very fine sand, 19-58% (average 40%) for silt loading, 10-59% (average 40%) for TSP, 13-57% (average 40%) for PM10, and 15-61% (average 38%) for PM2.5. SDR removal efficiency showed an average of 69% for the four highways. It was found that if the amount of SDR was less than 100 g/m², it was affected by the road surface condition and had a large regional deviation. As such, the amount of SDR and the removal efficiency increased. The fine particles, which have relatively low removal efficiency, contained a large amount of pollutants, which is an important factor in water and air pollution. Therefore, various measures to improve the removal efficiency of fine particles in SDR by road sweeping are needed.

• 한국도로학회:학술대회논문집
• /
• 2009.11a
• /
• pp.63-66
• /
• 2009

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.12 no.2
• /
• pp.196-205
• /
• 2024

In this study, sample collection and quantification analysis of Tire and Road Wear Particles (TRWP) from the road surface were conducted to predict the amount of TRWP generated on the road surface moving by environmental compartment depending on rainfall intensity. Samples were collected from TRWP remaining on the road surface two days after the 3 days average rainfall (0-60 mm/day) occurred and the road surface was completely dry. Only TRWP were separated from the collected samples through size and density separation, and the difference in the content of TRWP remaining on the road surface after rainfall was based on the value of 60.2 g o f TRWP o n a day witho ut rain (0 mm/day). By calculating, it was co nfirmed that 0-49.4 g o f TRWP can mo ve to the environmental compartment depending on the intensity of rainfall. In addition, it was confirmed that when the rainfall intensity was 60 mm/day, the amount of TRWP moving to each environmental section was 3.75 times higher compared to 5 mm/day, and using the results of previous research, the total amount of TRWP that can be transported to the environmental compartment by rainfall from the domestic road environment annually is 9,592 tons, and 288 tons of this can be affected by marine microplastics. However, this study has limitations in terms of limited space and predicted results, but it would like to mention the need to improve the domestic road environment and sewage treatment system to reduce TRWP. In the future, we plan to conduct sample collection and concentration analysis studies of TRWP in real environmental compartments to verify the results of this study.

• International Journal of Highway Engineering
• /
• v.16 no.6
• /
• pp.181-189
• /
• 2014

PURPOSES : Ambiguous decision on whether rural or urban area for road design can increase the construction cost and restrict the land use of surrounding area. However, administrative classification on rural and urban area is not directly related to road design because of this classification is not based on the engineering viewpoint, so method which can explain the road design context is required. METHODS : Method which enables to identify the area for road design is suggested based on the deceleration expected to be experienced by drivers who use the road section concerned. Deceleration rate corresponding to the area such as rural or urban suggested in Road Design Guideline is used as the criteria to identify the area by comparing this value with the estimated deceleration rate at the road section concerned. Speed profile method is utilized to derive the deceleration rate, and speed estimation way for reflecting both road geometry and intersection is suggested using stopping sight distance concept. RESULTS : The procedure of the method application is suggested, and the design example utilizing the method is provided. CONCLUSIONS : The method is expected to be used to identify the area for road design with engineering viewpoint, and design consistency among the roads with similar driving environment can be made.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.37 no.3
• /
• pp.314-321
• /
• 2024

Low road lighting is a lighting device that complements the shortcomings of existing pillar-type street lights. It is a lighting device that emits light from the side of the road surface and adjusts the luminance of the road surface like a light carpet. In this paper, to achieve full commercialization, we analyzed the luminance of the installed road surface and studied whether lighting could replace existing road lighting. In this study, the LMK (Luminance Measurement Camera) LABSOFT program was used to measure and analyze the surface luminance of road lighting, and the RELUX program was used to evaluate and analyze the simulation performance to determine light-based lighting conditions. A study was conducted to determine whether replacing pillar-type road lighting with low-level road lighting in a real environment would ensure comfortable and safe night vision for drivers at night.

• International Journal of Highway Engineering
• /
• v.16 no.3
• /
• pp.67-74
• /
• 2014

PURPOSES : This study is to investigate the countermeasures against heavy snow on road in Seoul: Focusing on Seocho 1-dong. METHODS : Since 2000, three cases of the top 10 in the highest snow fall depth in a day occurred in 2001(234mm, 156mm) and 2010(258mm) and the possibility of heavy snow is getting higher. 10 days after heavy snow fall when the snow thaws, socio-economic damages occurred often. For example, the insufficient snow removing, difficulty in patients transfer, crash accidents, injuries from a fall, the increasing cost of snow removing etc. RESULTS : For the effective deploying snow removing equipment and workers, it is necessary to understand emergency snow removing spots. Seocho 1-dong was tested because it contains mountains, hill and urban areas as well as various buildings and road types exposures. CONCLUSIONS : Based on the domestic and international heavy snow researches, the elements for vulnerability were analyzed and vulnerable areas to snow fall were derived.

• KIEAE Journal
• /
• v.4 no.3
• /
• pp.95-101
• /
• 2004

As a part of acoustical design, it is often necessary to quantify aspects of an existing environment and to predict the result of adding an acoustical treatment. The most common sources of exterior noise, also termed as environmental noise,(or community noise) are traffic noise, air craft noise, industrial noise, etc. Transportation(air, road, and rail)noise is the dominant and most common source of noise exposure in residential neighborhoods, and the annoyance is its most consequential effect. The road traffic noise becomes aggravated due to the rapid increase of vehicles. It has a great effect on the dwelling environment. Therefore we investigate the characteristics and sources of the road traffic noise through grasping the status of the road traffic noise. In the present study, preceding studies investigated the noise level of urban areas in Seoul were reviewed and the noise level of urban areas in Seoul was measured at first, fifth, tenth, and nineteenth floor for two days of weekdays and two days of weekend.

• Journal of Forest and Environmental Science
• /
• v.32 no.1
• /
• pp.1-9
• /
• 2016

Accessibility of urban green space, as an important index of evaluating the service level of urban green space, not only shows the resident's access to green space, but also reflects the environment quality of urban living. Since the quantity, area and space distribution of the patches in urban green space directly affect the function of urban green space and the quality of urban environment, the research on the accessibility of urban green space holds great significance to improve the service of urban green space and the living environment quality. Based on GIS software, this research uses the road network and the population distribution data of Nanjing's city proper to conduct quantitative analysis of the accessibility of park green space and the convenience for residents to travel under different forms of transportation. After the case analysis, the author tests the application of road network in studying the accessibility of urban park green space and proposes a GIS-based method to study the accessibility and the rational layout of urban green space.