• Applied Chemistry for Engineering
• /
• v.18 no.2
• /
• pp.162-167
• /
• 2007

Hydrogen production and its dynamics were investigated in the continuous anaerobic digestion process using Clostridium beijerinckii Donker 1926. In this work, glucose was used as a substrate and hydraulic retention times (HRT) were 0.5, 0.25 or 0.125 day. The removal efficiency of carbohydrate was over 99% under all of HRT conditions. As HRT was shorter, COD removal efficiency became lower while hydrogen content in the total gas and hydrogen production rate became higher. The cell growth yield and hydrogen production yield were 0.27 g-VSS/g-glucose and 0.26 L/g-glucose, respectively, at the steady state. It is expected that the microorganism is able to produce hydrogen when used in the wastewater treatment containing carbohydrate such as glucose. Also, the results in this study could be applied to the actual hydrogen gas production, a promising alternative energy.

• Physical Therapy Korea
• /
• v.8 no.1
• /
• pp.9-19
• /
• 2001

During therapy sessions, feedback is often provided concurrently by the physical therapist as the patient attempts to perform a movement and after the movement attempt. This feedback is provided to enhance the patient's balance abilities. However, recent studies in nondisabled populations have suggested that frequent feedback may be detrimental to retention or learning of motor skills. This study compared the effects of 100% relative frequency of knowledge of performance (KP) with 66% relative frequency of KP for motor learning on balance retraining in patients with hemiplegia. Twenty patients with hemiplegic were randomly assigned to one of two experimental groups. The acquisition phase consisted of 16 blocks of 5 trials for 2 days (80 total practice trials). The retention phase consisted of 2 blocks of a short-term retention test, one day after the end of the acquisition phase and a long-term retention test, one week after the end of the short-term retention test. In the 100% feedback condition, participants received feedback after every practice trial. A faded KP schedule was used in the 66% condition. No significant differences were found between the two groups during all experimental phases (acquisition and retention phases), (p>.05). However, there were significant decreases in balance index for both groups of acquisition phase (p<.05). These results suggest that 66% relative frequency of KP is not more effective than 100% relative frequency of KP with respect to retention over time when hemiparetic patients attempt to learn balance.

• Proceedings of the Korea Technical Association of the Pulp and Paper Industry Conference
• /
• 2000.06a
• /
• pp.1-10
• /
• 2000

The development of paper machines, increasing machine speeds with new, mostly low basis weight and/or high ash content paper grades, as well as the fact that several trends regarding process items have increased the sensitivity of papermaking. At the same time, papermakers are looking for flexibility in the production line. We can say that with all PMs the biggest benefits with the lowest capital spending can be achieved by focusing on improved wet end management. In order to manage wet end chemistry on a paper machine, our goal is to control sub-process through which we can influence the operation of the entire wet end with maximum effect. Key measurements and controls are-white water consistency control which is the most effective way to control retention - charge demand measurement and control which takes care of concentration of the anionic material entering to PM -ash measurements and controls which are deeply related to retention and paper quality This paper presents and concentrates to two of these key controls ; retention and charge. The purpose of charge control is to give the process control the tools to react to changes caused by amount of dissolved and colloida material incoming to wet end system. It is called coagulation or fixing control. Retention control is then taking care of retention aid flow to the process by responding any changes seen in white water consistency. It is called flocculation control. Each of these solutions separately , and even more effectively all together, stabilize the wet end operations and so greatly improve the produced paper quality and machine runnability. Practical results will be presented and they are referring to the latest mill cases. We have developed the first wet end measuring system in the late 1980s and control solutions based on this modern measuring technology were completely updated in 1990s. This paper introduces the principle, operation , and results of our unique wet end analyzers (retention and charge ) which are at the level of automation solutions as a part of paper machine quality control Especially our newest member of the platform , on-line charge analyzer has reached and set new standards to the on-line charge monitoring.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.32 no.5
• /
• pp.44-53
• /
• 2000

The development of paper machines, increasing machine speeds with new, mostly low basis weight and/or high ash content paper grades, as well as the fact that several trends regarding process items have increased the sensitivity of papermaking. At the same time, papermakers are looking for flexibility in the production line. We can say that with all PMs, the biggest benefits with the lowest capital spending can be achieved by focusing on improved wet end management. In order to manage wet end chemistry on a paper machine, our goal is to control subprocesses through which we can influence the operation of the entire wet end with maximum effect. Key measurements and controls are - white water consistency control which is the most effective way to control retention. - charge demand measurement and control which takes care of concentration of the anionic material entering to PM. - ash measurements and controls which are deeply related to retention and paper quality. This paper presents and concentrates to two of these key controls: retention and charge. The purpose of charge control is to give the process control the tools to react to changes caused by amount of dissolved and colloidal material incoming to wet end system. It is called coagulation or fixing control. Retention control is then taking care of retention aid flow to the process by responding any changes seen in white water consistency. It is called flocculation control. Each of these solutions separately, and even more effectively all together, stabilize the wet end operations and so greatly improve the produced paper quality and machine runnability. Practical results will be presented and they are referring to the latest mill cases. We have developed the first wet end measuring system in the late 1980s and control solutions based on this modern measuring technology were completely updated in 1990s. This paper introduces the principle, operation, and results of our unique wet end analyzers (retention and charge) which are at the level of automation solutions as a part of paper machine quality control. Especially our newest member of the platform, on-line charge analyzer has reached and set new standards to the on-line charge monitoring.

• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.2
• /
• pp.175-180
• /
• 2008

The objective of this study was to investigate biosorption of organic matter on EPS(Extracellular Polymeric Substances) at different SRT(Sludge Retention Time) in a SBR(Sequencing Batch Reactor) process, which was operated with the following operation steps : Fill-React-Settle-Decant-Idle. The hydraulic retention time was set to be 24 hours. The results obtained from this study showed that the organic removal efficiency per unit microbial biomass decreased with increasing SRT, and the corresponding EPS amount also did. The percent removal of organic by biosorption increased with SRT, and it reached to 53.2% at SRT of 30 days. However, the highest biosorption per microbial biomass(48.6 mgCOD/gVSS) was found at SRT of 2 days. The EPS analysis was performed by measuring TSS, TCOD$_{Cr}$, and TKN. The EPS production per unit microbial biomass was observed to be high at a low SRT. Due to the above result, the floc formation was hindered and therefore poor settlement of sludge resulted in decreasing the COD removal efficiency. It was therefore concluded that the consideration of the system design should include the characteristic of EPS as well as other factors such as SRT, MLSS, and organic loading.

• Journal of Multimedia Information System
• /
• v.5 no.4
• /
• pp.235-244
• /
• 2018

Potential maximum soil moisture retention (S) is a dominant parameter in the Soil Conservation Service (SCS; now called the USDA Natural Resources Conservation Service (NRCS)) runoff Curve Number (CN) method commonly used in hydrologic modeling for event-based flood forecasting (SCS, 1985). Physically, S represents the depth [L] soil could store water through infiltration. The depth of soil moisture retention will vary depending on infiltration from previous rainfall events; an adjustment is usually made using a factor for Antecedent Moisture Conditions (AMCs). Application of the method for continuous simulation of multiple storms has typically involved updating the AMC and S. However, these studies have focused on a time step where S is allowed to vary at daily or longer time scales. While useful for hydrologic events that span multiple days, this temporal resolution is too coarse for short-term applications such as flash flood events. In this study, an approach for deriving a time-variable potential maximum soil moisture retention curve (S-curve) at hourly time-scales is presented. The methodology is applied to the Napa River basin, California. Rainfall events from 2011 to 2012 are used for estimating the event-based S. As a result, we derive an S-curve which is classified into three sections depending on the recovery rate of S for soil moisture conditions ranging from 1) dry, 2) transitional from dry to wet, and 3) wet. The first section is described as gradually increasing recovering S (0.97 mm/hr or 23.28 mm/day), the second section is described as steeply recovering S (2.11 mm/hr or 50.64 mm/day) and the third section is described as gradually decreasing recovery (0.34 mm/hr or 8.16 mm/day). Using the S-curve, we can estimate the hourly change of soil moisture content according to the time duration after rainfall cessation, which is then used to estimate direct runoff for a continuous simulation for flood forecasting.

• Korean Journal of Occupational Health Nursing
• /
• v.6 no.1
• /
• pp.53-71
• /
• 1997

Across sectional study was performed to evaluate the chronic effects on central nerve system(CNS) of cumulative exposure of complex organic solvents, using neurobehavioral test. Subjects were 66 (male) dock yard painters of some large ship industry which is located in Ulsan. The neurobehavioral test battery used in this study was NCTB (Neurabehavioral Core Test Battery recommended by WHO(World Health Organization), which consisted of 7 items-Profile of mood states (POMS), Simple reaction time, Santa Ana dexterity test. Digit span, Digit symbol, Benton visual retention test and Pursuit aiming. The subjects were classified by 3 groups according to duration of employment(group 1 ; less than 9 years, group 2 ; 10-14 years, group 3 ; more than 15 years). The results of performance were analyzed considering of work duration, age, educational level, alcohol drinking, smoking and testing time as confounding factors. Benton visual retention test, pursuit aiming correct dot and sum of dot showed significant differences among the groups, and decreased with increasing work duration. It indicated that the mean scores of performance ability were lowering according to work duration. Besides, the tests that didn't show statistical significances but showed linear trends were depression-dejection, vigor, fatigue of POMS, slowest time of simple reaction time and digit span forward. Most of the neurobehavioral test items were correlated with age and educational level. After controlling of confounding factors-age and educational level, the results followed ; digit span backward was different significantly. Tension-anxiety, depression-dejection, anger-hostility of POMS, SD and slowest time of simple reaction time, Santa Ana dexterity test non-preferred hand, digit span forward, Benton visual retention test and pursuit aiming correct dot decreased with increasing of work duration. The correlation analysis was done in order to find out the relationship between subjective symptom and the scores of neurobehavioral core test battery. According to the results of analysis there were no items that had statistical significant relationship(p<0.05).

• Proceedings of the IEEK Conference
• /
• 2000.11b
• /
• pp.325-328
• /
• 2000

The control of the data retention time is a main issue for realizing future high density dynamic random access memory. In this paper, we propose the new implantation scheme by gate-related ion beam shadowing effect and buffer-enhanced $\Delta$ Rp increase using buffered N- implantation with tilt and 4X-rotation that is designed on the basis of the local-field-enhancement model of the tail component. We report an excellent tail improvement of the retention time distribution attributed to the reduction of electric field across the cell junction due to the redistribution of N- concentration which is intentionally caused by Ion Beam Shadowing and Buffering Effect using tilt implantation with 4X-rotation.

• Journal of Environmental Health Sciences
• /
• v.26 no.4
• /
• pp.15-20
• /
• 2000

The studies of swine wastewater treatment aim to development of process using soil microorganism. Removal rate of swine wastewater containing organic matter was 99 percent in case of high loading rate. Microorganism was devoted to improve the treatment efficiency of the process. According to the result obtained from biological treatment of high loading rate swine wastewater. Hydraulic retention time was 2.3 days in unit process of biological phosphorus removal. BO $D_{rm}$ / $P_{rm}$ ratio was 1122 in room temperature anaerobic process and 355.6 in mesophilic anaerobic process. And then phosphorus removal rate mesophilic anaerobic process was 3 time as much as than room temperature acaerobic process.

• Membrane and Water Treatment
• /
• v.1 no.4
• /
• pp.253-271
• /
• 2010

A theoretical study for the flux enhancement by pulsation of transmembrane pressure is presented for osmotic pressure controlled ultrafiltration under laminar flow regime. The transient velocity profile is solved analytically using Green's function method. Time dependent convective diffusive equation is solved to quantify the membrane surface concentration and the permeate flux, numerically. The effects of the amplitude and frequency of pulsation on flux, surface concentration and observed retention are studied.