• 전기전자학회논문지
• /
• 제5권1호
• /
• pp.91-99
• /
• 2001

공기 갭을 갖는 이방성 매질의 기판과 덮개층 구조에서 사각 마이크로스트립 안테나 공진 주파수의 파수 영역에 대해 해석하였다. 일축성 매질의 특성을 나타내는 텐서의 구성 관계식으로부터 파수영역에서의 다이애딕 그린 함수를 유도하였으며 이 결과를 푸리에 변환을 사용하여 공간에서의 전계 적분 방정식으로 수식화하였다. 캘러킨 모멘트법을 사용하여 적분 방정식을 이산화하였으며 기저함수로는 정현적 함수를 선택하였다. 수치해석 결과의 타당성을 검증하기 위해 기존의 결과와 비교, 일치된 결과를 얻었으며 공기 갭의 두께, 패치 길이 그리고 덮개층의 비유전율과 이방성 덮개층의 이방성 비의 변화에 따른 공진 주파수의 변화가 제시되고 분석되었다.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2008년도 춘계 학술발표회 초청강연 및 논문집
• /
• pp.90-96
• /
• 2008

Engineered mixtures composed of rigid sand particles and soft rubber particles are tested to investigate their behavior with strain level. Mixtures are prepared with different volumetric sand fractions (sf) to identify response using small strain resonant column, intermediate strain oedometer, and large strain direct shear tests. The small strain shear modulus and damping ratio are determined with volumetric sand fractions. The asymmetric frequency response curve increases with decreasing sand fraction. Linear responses of shear strain and damping ratio with shear strain are observed at the mixture of sf=0.2. Vertical strain increases with decreasing sand fraction. Mixtures with $04.{\leq}sf{\leq}0.6$ show the transitional stress-deformation behavior from rubber-like to sand-like behavior. The friction angle increases with the sand fraction and no apparent peak strength is observed in mixture without sf=1.0.

• Journal of Biosystems Engineering
• /
• 제30권1호
• /
• pp.38-44
• /
• 2005

In this study, the acoustic response technique was applied to evaluate the maturity of melon nondestructively. The acoustic response signals through melon were obtained by microphone and signal conditioner with the lapse of days after fruit set. The acoustic parameters such as resonant frequencies and the spectrum energy ratio were analyzed. To investigate the relation between acoustic parameters and firmness of melon, the compression test was performed. Three resonant frequencies representing f1, f2 and f3 were 150 to 250 Hz, 300 to 400 Hz, and 450 to 550 Hz, respectively. The resonant frequencies were shifted to the lower frequencies and the magnitude of spectrum decreased as the maturity of melon increased. Some significant correlations were found between melon firmness and the spectrum energy ratio in some frequency ranges. It is possible to estimate the maturity of melon by acoustic response technique.

• 터널과지하공간
• /
• 제21권6호
• /
• pp.480-493
• /
• 2011

암석의 동적물성은 내진설계의 동적해석에 필요한 물성이다. 본 연구에서는 충남 연기군 지역의 화강암 시험편을 대상으로 양단자유 공진주시험을 실시하여 동적물성인 동탄성계수, 동전단계수, 감쇠비 등의 특성을 분석하고, 역학적 물성과의 상관관계를 분석하였다. 탄성파속도를 기준으로 동적물성을 분석한 결과, 탄성파속도가 빠를수록 동탄성계수와 동전단계수는 선형적으로 증가하는 경향을 보였으며, 감쇠비는 비선형적으로 감소되는 것으로 조사되었다. 논문은 사인형태의 입사파에 대한 장점을 설명하고 또한 동하중에 대한 암석의 크기효과를 설명하고 있다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 Proceedings ICPE 01 2001 International Conference on Power Electronics
• /
• pp.295-300
• /
• 2001

A variety of high voltage DC power supplies employing the high frequency inverter are difficult to achieve soft switching considering a quick response and no overshoot response under the wide load variation ranges which are used in medical-use x-ray high voltage generator from 20kV to 150kV in the output voltage and from 0.5mA to 1250mA, respectively. The authors develops soft switching high voltage DC power supply designed for x-ray power generator applications, which uses series resonant inverter circuit topology with a multistage voltage multiplier instead of a conventional high voltage diode rectifier connected to the second-side of a high-voltage transformer with a large turn ratio. A constant on-time dual mode frequency control scheme operating under a principle of zero-current soft switching commutation is described. Introducing the multistage voltage multiplier, the secondary transformer turn-numbers and stray capacitance of high-voltage transformer is effective to be greatly reduced. It is proved that the proposed high-voltage converter topology with dual mode frequency modulation mode control scheme is able to be the transient response and steady-state performance in high-voltage x-ray tube load. The effectiveness of this high voltage converter is evaluated and discussed on the basis of simulation analysis and observed data in experiment.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2009년도 하계학술대회 논문집
• /
• pp.401-401
• /
• 2009

Recently, demands for the development of compact, lightweight power supplies with higher power density and higher efficiency have been increased. Since Piezoelectric Transformer (PT) was emerged in device and material industry, it has been suggested as a viable alternative to the magnetic transformer in some applications. PT has some advantages such as low profile and mechanical energy transfer with little electromagnetic interface (EMI). Also, PT can provide high voltage stepping ratio with good isolation and requires no copper windings saving copper usage especially for large voltage conversion differences. Conventional control of PT converter has mainly two-way. One is the pulse frequency modulation (PFM) control method and the other is the pulse width modulation (PWM) control with frequency fixed method. It is known that the maximum PT efficiency can be obtained when it operates near the resonant frequency of the PT. And, also PT's resonant frequency moves according to the load condition. Therefore, selection of PT converter control method is very difficult. This paper analyzes general piezo-electric converter modeling and proposes a guide-line to selection of control method and stabilization control.

• Current Optics and Photonics
• /
• 제5권1호
• /
• pp.66-71
• /
• 2021

The resonance characteristics of H-shaped metamaterials, whose widths were varied while keeping the height constant, were investigated in the terahertz (THz) frequency range. The H-shaped metamaterials were numerically analyzed in two modes in which the polarization of the incident THz electric field was either parallel or perpendicular to the width of the H-shaped structure. The resonant frequency of the metamaterial changed stably in each mode, even if only the width of the H shape was changed. The resonant frequency of the metamaterial operating in the two modes increases without significant difference regardless of the polarization of the incident electromagnetic wave as the width of the H-shaped metamaterial increases. The electric field distribution and the surface current density induced in the metamaterial in the two modes were numerically analyzed by varying the structure ratio of the metamaterial. The numerical analysis clearly revealed the cause of the change in the resonance characteristics as the width of the H-shaped metamaterial changed. The efficacy of the numerical analysis was verified experimentally using the THz-TDS (time-domain spectroscopy) system. The experimental results are consistent with the simulations, clearly demonstrating the meaningfulness of the numerical analysis of the metamaterial. The analyzed resonance properties of the H-shaped metamaterial in the THz frequency range can be applied for designing THz-tunable metamaterials and improving the sensitivity of THz sensors.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1996년도 봄 학술발표회 논문집
• /
• pp.180-185
• /
• 1996

Construction activities and operation of transportation facilities have caused unfavorable effects such as civil petitions associated with vibration-induced damages or nuisances. The objedtive of this research is to develop vibration-controlled concrete containing foams, latex, rubber powders, plastic resins and etc as a concrete mixture. As the first step to achieve this research, preliminary mix designs have been carried out to find out an appropriate mix proportion above 200kg/㎠ in uniaxial compressive strength, and investigate their dynamic mechanical characteristics such as dynamic elastic moduli, material damping ratio, Poisson's ratio, resonant frequency and etc.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1997년도 추계학술대회 논문집
• /
• pp.13-20
• /
• 1997

In this paper, the voltage step-up ratio, efficiency and input impedance of the PMN-PZT cert- mic transformer(PT) were investigated for the variation of resonant frequency according to lead resistance. The output voltage and voltage step-up ratio are increased with the the increase of load resistance. The efficiency of PT showed the maxinum value of 91% at R$_{L}$ of 500k$\Omega$X>

• 콘크리트학회논문집
• /
• 제22권5호
• /
• pp.625-632
• /
• 2010

콘크리트의 탄성계수 결정을 위해 다양한 시험기법이 사용되고 있다. 충격공진시험(IR: impact resonance test)은 비파괴시험으로서 간편한 시험장치와 단순한 시험방법이며 반복성이 뛰어나다. 또한 충격공진시험은 탄성계수 뿐만 아니라 감쇠비 결정이 가능하다. 이 연구에서는 콘트리트 시편에 대한 충격공진시험의 다양한 영향요소(시편거치 방법, 충격하중원의 특성, 신호획득 속도 등)를 평가하고 최적의 시험조건을 제시하였다. 이 연구에서 적용한 모든 시험조건 범위에서 충격공진시험에서 측정된 결과의 변동량은 공진주파수 결정에 있어서 ${\pm}0.3%$, 감쇠비 결정에 있어서 ${\pm}10.0%$로 나타났다. 충격공진시험에서 결정된 탄성계수와 정적시험에서 결정된 탄성계수를 변형률 크기를 고려하여 비교하면 비교적 서로 잘 일치함을 확인하였다.