• KEPCO Journal on Electric Power and Energy
• /
• 제1권1호
• /
• pp.1-8
• /
• 2015

When the line and switchgear of the substation system are disconnected, ferro-resonance can occur. This happens even if the capacitive reactance and inductive reactance are not equal, which are not common resonance conditions. Resonance conditions vary depending on the busbar configuration environment. Although the damping resistance method applying the existing saturable reactor to cope with ferro-resonance has been successfully applied on site, there can be loss of normal function during long-term operation. The reason is because the rise in the operating frequency of saturable reactors means the saturation number is increased. Therefore, it can no longer function as saturable reactor since the resistor having inadequate capacity is burned out. To address this problem, in this paper, an EMTP-based simulation test was performed by designing and applying a dual reactor method, which adds an extended divergence reactor to the 1st side of the VT. The test result confirms that when the divergence reactor is inserted, the voltage and current values obtained at the 1st side and 2nd side of the VT as well as current values of divergence reactor part were stabilized from the transient phenomena and return to normal values. When compared with existing measures, although this method is similar in adding having a reactor added to a system regarding ferro-resonance, it has the advantage of being able to prevent ferro-resonance in advance since the reactor is added before the system is saturated. In addition, because it does not use damping resistance, it can extend the equipment life and stabilize its operation. Therefore, there are a lot of differences in terms of its operating characteristics and achivement of goal between the conventional method and new divergence reactor method.

• 한국추진공학회지
• /
• 제16권5호
• /
• pp.89-96
• /
• 2012

기존의 펄스에코법은 스틸 연소관 내부에서 고무면으로 초음파를 입사시키므로 검사 도중에 고무면이 오염될 수 있으며, 이로 인해 치명적인 미접착 결함을 유발시킬 수 있다. 상기 방법을 보완할 수 있는 시험 기법을 개발하기 위해 스틸/고무 접착 시험편을 제작하여 스틸면으로 초음파를 입사시켰다. 스틸/고무 접착 시험편으로부터 측정한 고무 공진 주파수는 이론적으로 예측한 공진 주파수와 일치하였다. 본 논문은 고무 공진 주파수를 이용하여 고무 두께를 측정할 수 있는 초음파 공진법에 대해 기술하였다.

• Journal of Electrical Engineering and Technology
• /
• 제13권5호
• /
• pp.1908-1916
• /
• 2018

This paper proposes a controller design method for suppressing the resonance generated in the slave motor in the middle and low speed operation range, according to the load and parameter differences between two motors, during parallel operation using the master and slave method that controls two surface permanent magnet synchronous motors connected in parallel by a single inverter. The proposed resonance suppression controller is directly obtained by analyzing the resonance characteristics, using the lead controller method. Therefore, it is possible to fundamentally reduce trial and error to set the controller gain. In addition, because the proposed resonance suppression controller was designed as a lead controller, the stability region of the system increased owing to the added zero point, making the system robust with respect to parametric variations. Simulations and experiments confirmed the usefulness of the proposed method and the system's robustness with respect to parametric variations.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2012년도 제38회 춘계학술대회논문집
• /
• pp.562-569
• /
• 2012

기존의 펄스에코법은 스틸 연소관 내부에서 고무면으로 초음파를 입사시키므로 검사 도중에 고무면이 오염될 수 있으며, 이로 인해 치명적인 미접착 결함을 유발시킬 수 있다. 상기 방법을 보완할 수 있는 시험기법을 개발하기 위해 스틸/고무 접착 시험편을 제작하여 스틸면으로 초음파를 입사시켰다. 스틸/고무 접착 시험편으로부터 측정한 고무 공진 주파수는 이론적으로 예측한 공진 주파수와 일치하였다. 본 논문은 고무 공진 주파수를 이용하여 고무 두께를 측정할 수 있는 초음파 공진법에 대해 기술하였다.

• 한국자기공명학회논문지
• /
• 제7권1호
• /
• pp.46-54
• /
• 2003

We synthesized a contrast agent for MRI that is capable of binding to the ABP-1 receptor and enhancing the contrast of the targeted cells. We used a lysine dendrimer (G=3)DTPA[Gd] as the contrast agent and synthesized a biotinylated polyclonal antibody for ABP-1 as the first antibody. Lysine dendrimers were prepared using the solid phase peptide synthesis method.$^3$ Amino-terminated lysine dendrimers were then coupled to DTPA using the anhydride method. Gd was complexed with the DTPA-lysine dendrimer in an acidic solution of 3 eq GdCl$_3$ to one of DTPA. The lysine dendrimer-DTPA[Gd] and avidin were conjugated in MES solution, pH 6.0, using EDC as the coupling reagent. The biotin-avidin system was used to link the polyclonal antibody and contrast agent. K562 cells were used for imaging.

• 한국멀티미디어학회논문지
• /
• 제18권4호
• /
• pp.541-545
• /
• 2015

Wireless power transmission which can transmit the electrical power through the air is the promise technology. In this paper, the effects of wireless power transmission using magnetic resonance method have been studied on coil material, resonance frequency, and antenna type. We have found copper tube as a coil material had the better characteristics than that of enameled wire, and the optimal resonance frequency was 13.6MHz in the range of from 1MHz to 20MHz. And the double square spiral type antenna as a load coil was the best. The power transmission distance by magnetic resonance method with 13.6MHz was 150 cm.

• Structural Engineering and Mechanics
• /
• 제86권3호
• /
• pp.361-371
• /
• 2023

Boundary condition is an important factor affecting the vibration characteristics of structures, under different boundary conditions, structures will exhibit different vibration behaviors. On the basis of the previous work, this paper extends to the nonlinear resonance behavior of axially moving graphene platelets reinforced metal foams (GPLRMF) plates with geometric imperfection under different boundary conditions. Based on nonlinear Kirchhoff plate theory, the motion equations are derived. Considering three boundary conditions, including four edges simply supported (SSSS), four edges clamped (CCCC), clamped-clamped-simply-simply (CCSS), the nonlinear ordinary differential equation system is obtained by Galerkin method, and then the equation system is solved to obtain the nonlinear ordinary differential control equation which only including transverse displacement. Subsequently, the resonance response of GPLRMF plates is obtained by perturbation method. Finally, the effects of different boundary conditions, material properties (including the GPLs patterns, foams distribution, porosity coefficient and GPLs weight fraction), geometric imperfection, and axial velocity on the resonance of GPLRMF plates are investigated.

• 대한토목학회논문집
• /
• 제33권2호
• /
• pp.595-608
• /
• 2013

본 연구는 항만 공진 현상을 고려한 계류선박의 동요량 산정방법을 제시하고 공진현상이 선박의 동요에 미치는 영향을 정량적으로 평가한 것이다. 공진 현상의 해석은 타원형완 경사방정식을 채용한 CGWAVE 모형을 사용하였고, 계류선박의 동요 해석은 3차원 Green 함수 모형을 사용하였다. 본 방법은 현지 계류선박의 동요량 계측 결과를 이용하여 타당성을 검증하였고, 포항신항의 최근 파랑 관측 자료와 비교하여 현지 항만의 적용성을 검토하였다. 파랑 관측 기록에서 얻어진 포항신항의 공진주기는 80분, 33분, 23분, 8분 등의 장주기 성분과 항내 슬립에서 발생한 주기 42초, 54초, 60초 등의 외중력파 성분이었으며 공진 해석 모형은 이들 공진주기를 잘 재현하였다. 본 연구에서는 포항신항의 제 8부두에 5,000톤, 10,000톤, 30,000톤의 선박이 계류되었을 때 공진 성분을 포함한 경우와 포함하지 않은 경우의 동요량을 각각 산정하여 공진 현상이 선박 동요에 미치는 영향을 검토하였다. 공진 성분을 포함한 경우는 그렇지 않은 경우에 비하여 12~400 %의 동요량 증가를 보였다. 공진 현상이 동요량에 미치는 영향은 Surge, Heave 동요는 선박이 클 수록, Roll과 Yaw 동요는 반대로 선박이 작을 수록 커짐을 알 수 있었다.

• KEPCO Journal on Electric Power and Energy
• /
• 제6권4호
• /
• pp.473-480
• /
• 2020

In this paper, we proposed a high frequency equivalent circuit considering parasitic impedance components for differential noise analysis on the input stage during DC-DC buck converter switching operation. Based on the proposed equivalent circuit model, we presented a method to measure parasitic impedance parameters included in DC bus plate, IGBT, and PCB track using the gain phase method of a network analyzer. In order to verify the validity of this model, a DC-DC prototype consisting of a buck converter, a signal analyzer, and a LISN device, and then resonance frequency was measured in the frequency range between 150 kHz and 30 MHz. The validity of the parasitic impedance measurement method and the proposed equivalent model is verified by deriving that the measured resonance frequency and the resonance frequency of the proposed high frequency equivalent model are the same.

• 전력전자학회논문지
• /
• 제20권2호
• /
• pp.144-151
• /
• 2015

The present study proposes a method for modeling a SONAR transducer with dual resonance. The Butterworth van-Dyke (BVD) model, a conventional SONAR transducer modeling method, can model only one resonance point. Hence, to address its disadvantage and to model the dual resonance, a dual resonance BVD model consisting of two serial BVD models is proposed. The two BVD models are connected in a series, and each simulate resonance at low frequency and high frequency, which allows the modeling of two resonance points. Eight elements compose the equivalent circuit by connecting the BVD models in a series, which is twice as great as that of the existing BVD model. The element value of the dual resonance BVD model is extracted by using the particle swarm optimization method. Analysis was also performed to identify the effects of changes in the value of elements that compose the equivalent circuit on the impedance characteristics of the equivalent circuit through simulation in which element values varied.