• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2008.03a
• /
• pp.53-58
• /
• 2008

Film cooling effectiveness on a flat plate was measured with pressure sensitive paint. The pressure sensitive paint(PSP) changes the intensity of its emissive light with pressure and the characteristic was used in film cooling effectiveness measurement. The film coolants were air and nitrogen, and by comparing the intensity of PSP coated surface with each coolant, the film cooling effectiveness was calculated. Three blowing ratio of 0.5, 1, and 2 were tested with two mainstream turbulence intensities. Results clearly showed the effect of blowing ratio and mainstream turbulence intensity. As the blowing ratio increases, the film cooling effectiveness was decreased near the film cooling holes. However, the film cooling effectiveness far downstream from the injection hole was higher for higher blowing ratio. As the mainstream turbulence intensity increased, the film cooling effectiveness was decreased at far downstream from the injection hole.

• Journal of Environmental Impact Assessment
• /
• v.24 no.2
• /
• pp.163-174
• /
• 2015

Urbanization caused various environmental problems like destruction of natural water cycle and increased urban flood. To solve these problems, LID(Low Impact Development) deserves attention. The main objective of LID is to restore the water circulation to the state before the development. In the previous studies about the LID, the runoff reduction effect is mainly discussed and the effects of each techniques of LID depending on rainfall types have not fully investigated. The objective of this research is to evaluate the effect of LID using the quantitative simulation of rainwater runoff as well as an amount of infiltration according to the rainfall and LID techniques. To evaluate the water circulation of LID on the development area, new land development areas of Hanam in South Korea is decided as the study site. In this research, hydrological model named STORM is used for the simulation of water balance associated with LID. Rainfall types are separated into two categories based on the rainfall intensity. And simulated LID techniques are green roof, permeable pavement and swale. Results of this research indicate that LID is effective on improvement of water balance in case of the low intensity rainfall event rather than the extreme event. The most effective LID technique is permeable pavement in case of the low intensity rainfall event and swale is effective in case of the high intensity rainfall event. The results of this study could be used as a reference when the spatial plan is made considering the water circulation.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.17 no.3
• /
• pp.289-295
• /
• 2014

The composition of bright flash device is a pyrotechnic mixture consisting of metal powder, oxidizer and additives. A pyrotechnic mixture of bright flash device generates a bright flash through burning after being ignited by initiator. The function of bright flash is to distract or incapacitate electro optical sensor systems and enemy eyes temporally. This study is to develop composition of pyrotechnic mixture of bright flash and to analyze the test results by considering intensity and efficiency of light.

• Korean Journal of Soil Science and Fertilizer
• /
• v.50 no.6
• /
• pp.674-683
• /
• 2017

The frequency and intensity of soil moisture stress associated with climate change has increasing, and the stability of field crop cultivation has decreasing. This experiment was conducted to investigate the effect of soil moisture management method on growth and yield of corn. Soil moisture was managed at the grade of WSM (wet soil moisture, 34.0~42.9%), OSM (optimum soil moisture, 27.8~34.0%), DSM (dry soil moisture, 20.3~27.8%), and ESM (extreme dry moisture, 16.6~20.3%) during V8 (8th leaf stage)-VT (tasseling stage). After VT, irrigation was limited. The treated amount of irrigation was 54.1, 47.7, 44.0 and 34.5% of total water requirement, respectively. The potential evapotranspiration during the growing period was $3.29mm\;day^{-1}$, and upward movement of soil water was estimated by the AFKAE 0.5 model in the order of ESM, DSM, OSM, and WSM. We could confirm this phenomenon from actual observations. There was no significant difference in leaf characteristics, dry matter, and primary productivity depending on the level of soil moisture, but leaf development was delayed and dry weight decreased in DSM. However, dry weight and individual productivity of DSM increased after irrigation withdrawal compared to that of OSM. In DSM, ear yield and number of kernels per ear decreased, but water use efficiency and harvest index were higher than other treatments. Therefore, it is considered that the soil moisture is concentratedly managed before the V8 period, the V8-VT period is controlled within the range of 100 to 500 kPa (20.3~27.8%), and no additional irrigation is required after the VT.

• Journal of Biomedical Engineering Research
• /
• v.36 no.5
• /
• pp.162-168
• /
• 2015

In this study, we suggested the performance and safety testing guideline for low intensity pulsed ultrasound (LIPUS) represented by the ultrasound fracture treatment device and cartilage treatment device and low intensity focused ultrasound (LIFU) represented by ultrasonic face lifting device. For these study, the international standards and management regulations of Korea, Japan and United State were analyzed. And the usefulness and applicability were evaluated by testing with commercial equipment and reflecting the views of the industry and experts. As a result of this study, the safety and performance test guidelines for low intensity therapeutic ultrasound device were proposed by presenting the 10 items for LIPUS and 12 items for LIFU. The suggested guidelines are considered a high utilization in the domestic testing and approval authorities. And they are also thought to be useful to new technology development.

• Journal of Korean Society of Forest Science
• /
• v.89 no.5
• /
• pp.591-597
• /
• 2000

This studies were carried out to investigate the optimum shading for seedling cultivation of Cornus controversa and C. walteri. The experiment was performed under five different shading scheme such as 100%, 50%, 30%, 10%, and 2% of the natural full sun light intensity for 7 months in the field condition. Two species showed the highest height growth under 50% of relative light intensity, and the highest diameter growth at root collar was observed both under 100% and 50% of relative light intensity. C. controversa seedlings grown under 50% of relative light intensity produced more total biomass than control seedlings, but root biomass was less in the seedlings under 50% of relative light intensity. In case of C. walteri, total biomass production of the seedlings under 50% of relative light intensity was lower than that of the seedlings under full sun light intensity, but leaves and shoot biomass was slightly high under 50% of relative light intensity. Great reductions of height growth and diameter growth at root collar, and biomass production were observed below 30% of relative light intensity in the both species. T/R ratio of the two species was highest under 30% of relative light intensity, and the chlorophyll content of the seedlings tended to be increased by reduction of relative light intensity.

• Horticultural Science & Technology
• /
• v.32 no.5
• /
• pp.600-606
• /
• 2014

The objective of this study was to determine the effects of seedling ages of scions and rootstocks for grafting and light intensity during their cultivation in a closed transplant production system on the growth and development of grafted cucumber transplants. Cucumber scions and rootstocks were cultivated under 5 photosynthetic photon flux (PPF) levels: 100, 140, 180, 230, and $280{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$ in a closed transplant production system. The scions were grafted onto the rootstocks at 8, 9, 10, 11, and 12 days after sowing (DAS). Hypocotyl length of scions and rootstocks decreased significantly as PPF increased, and an increase in dry weight with increasing PPF was more pronounced in scions. After grafting, cucumber transplants were grown in a greenhouse until 22 DAS and were then transplanted for investigation of their growth and development. Plant height, leaf area, and fresh weight of cucumber transplants grafted at 8, 9, and 10 DAS were greater, but light intensity during cultivation of scions and rootstocks did not significantly affect the early growth of cucumber transplants after grafting. The number of female flowers in grafted cucumber after transplanting was highest when scions and rootstocks were cultivated under PPF 140 and $180{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$ and were grafted at 8 DAS. These results indicate that controlling environmental conditions in a closed transplant production system during the production of scions and rootstocks can advance grafting time and promote the growth and development of grafted cucumber transplants.

• Proceedings of the Korean Aquaculture Society Conference
• /
• 2003.10a
• /
• pp.132-133
• /
• 2003

The marine dinoflagellate genus Alexandrium comprise PSP producing A. acatenella, A. angustitabuzatum, A. catenella, A. fundyense, A. minutum, A. ostenfezdii, A. tamiyavanichii and A. tamarense. In monitoring toxic Alexandrium, rapid and exact species identification is one of the significant prerequisite work, however we have suffered confusion of species definition in Alexandrium. To surmount this problem, we chose DNA probing, which has long been used as an alternative for conventional identification methods, primarily relying on morphological approaches using microscope in microbial field. Oligonucleotide DNA probes targeting rRNA or rDNA have been commonly used in diverse studies to detect and enumerate cells concerned as a culture-indetendent powerful tool. Despite of the massive literature on the HAB species containing Alexandrium, application of DNA probing for species identification and detection has been limited to a few documents. DNA probes of toxic A. tamarense, A. catenella and A. tamiyavanichii, and non-toxic A. affine, A. fraterculus, A. insuetum and A. pseudogonyaulax were designed from LSU rDNA D1-D2, and applied to whole cell-FISH. Each DNA probes reacted only the targeted Alexandrium cells with very high species-specificity within Alexandrium. The probes could detect each targeted cells obtained from the natural sea water samples without cross-reactivity. Labeling intensity varied in the growth stage, this showed that the contents of probe-targeted cellular rRNA decreased with reduced growth rate. Double probe TAMID2S1 achieved approximately two times higher fluorescent intensity than that with single probe TAMID2. This double probe did not cross-react with any kinds of microorganisms in the natural sea waters. Therefore we can say that in whole-cell FISH procedure this double DNA probe successfully labeled targeted A. tamiyavanichii without cross-reaction with congeners and diverse natural bio-communities.

• Journal of Distribution Science
• /
• v.18 no.1
• /
• pp.71-83
• /
• 2020

Purpose: Because the energy consumption, economic growth and logistics development are still the heated topics which have attracted many scholars' interests. Therefore, this paper attempts to analyze the effect of logistics development on the economic growth, explore the effect of the economic growth on energy consumption and to discuss the effect of the logistics development on energy intensity. Research design, data and methodology: Using the panel data over the period 2000-2017 of 156 countries and employing the country & year fixed effect model, system generalized method moments and random effect model, the empirical analyses of this propositions are performed. Results: The empirical findings present that the logistics development is positively related to the economic growth. The energy consumption in the t-1 period and economic growth are positively related to the current energy consumption. The logistics development is negatively related to the energy intensity. Meanwhile, the empirical findings also indicate that there is a great difference about these effects among the four sub-samples (low income 18 countries, low middle income 49 countries, upper middle income 44 countries, high income 49 countries). Conclusions: Based on the evidences in this paper provided, we can find that these variables can affect each other.

• Korean Journal of Veterinary Research
• /
• v.30 no.1
• /
• pp.41-49
• /
• 1990

These experiments were carried out to develop a novel, simple, and rapid method to determine urinary sulfonamides using fluorescamine by spectrofluorometry. To get optimal conditions for the sulfonamide-fluorescamine reaction, sulfonamides such as sulfamethazine, sulfamerazine, sulfadimethoxine and sulfamonomethoxine, dissolved in buffers with various pH ranges were reacted with various concentrations of fluorescamine. and then, the fluorescence intensity and stability of the fluorophore were measured. To eliminate the interfering substances in urine, the fluorophore in buffers and urine with a definite pH range was extracted with some organic solvents. After then the fluorescence intensity was measured in organic and aquous phases. The results obtained were summarized as follows: 1. The maximal fluorescence of sulfonamides was presented in acidic state, pH 4.5~5.0, at 30 minutes after reaction. 2. The optimal concentration ratio of sulfamethazine and ffuorescamine was more than 1 : 40 in mole. 3. In pH 4.0, the intensity was maximal but was time-dependent, whereas in pH 8.0, the intensity was time-independent. 4. Sulfamethazine-fluorescamine conjugate could be dissolved in some of organic solvents in acidic state such as chloroform, n-butanol, and ethylacetate. 5. Sulfamethazine-flnorescamine conjugate in swine urine coule be extracted with ethylacetate in acidic state, pH 4.0~5.0.