• Korean Journal of Environmental Agriculture
• /
• v.30 no.1
• /
• pp.31-36
• /
• 2011

BACKGROUND: Disposal of slurry animal manure produced by an anaerobic slurry-type barn method is not easy since the animal slurry contain high moisture content which makes solid-liquid separation a difficult process. However, recently, the interest about anaerobic digestion process as an environment-friendly waste disposal method has gained a wide interest because it can treat highly organic matter contained by the piggery slurry, decrease the odor after treatment, and enable the effective recovery of the methane gas which is a valuable energy resource. The objectives of this study were to identify the solubilization characteristics and to improve the anaerobic digestion efficiency of piggery slurry through full-scale anaerobic digestion experiments. METHODS AND RESULTS: In a full-scale continuous anaerobic digestion operation, the adaptability of single anaerobic digestion and its digestion efficiency were also evaluated in the farm field. The actual pH range and alkalinity concentration of piggery slurry used during the operation were comparatively higher than the concentrations of pH and alkalinity in the digestion tank which were stable at 7.5~8.0, 4,008 mg/L (as$CaCO_3$), respectively. The removal efficiency of organic matter (TCOD) by anaerobic digestion was 75~90% and methane gas production amount was at 0.33 L/L/day, a little higher than that of ordinary animal manure. CONCLUSION(s): Our findings showed higher recovery of highly purified methane and greater efficiency of anaerobic tank digestion since its methane gas content was at 65~70%.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.28 no.6
• /
• pp.579-585
• /
• 2006

Introduction: The fibular free flap is now considered as the first choice for long mandibular discontinuity defect. In spite of its good bone quality for implant installation, its diameter is too narrow to rehabilitate the masticatory function with implant installation. In this report, distraction osteogenesis was used for the augmentation of bone to install the dental implant in the mandible which was reconstructed with a vascularized fibular free flap. Patients and Methods: Three patients undertook the vertical augmentation of grafted fibular bone and dental implants were installed. On the day 8 post-surgery, the activation of the distractor was started at the rate of 1 mm twice a day. The total amount of distraction was 15 mm in two patients and 12.5 mm in one patient. Twelve implants were installed in three patients. Dental implants were simultaneously installed during removal of the distraction device in two patients. In one patient, the implant installation was delayed after device had been removed. All three patients showed the symptoms of mild to severe postoperative infection during the activation and consolidation. However, the distracted site showed undisturbed bone regeneration. Conclusion: The distraction osteogenesis showed the reliable results for the vertical augmentation of fibular bone which was used for the mandibular reconstruction. However, the great tendency of postoperative infection must be considered and clinically controlled.

• THE INTERNATIONAL COMMERCE & LAW REVIEW
• /
• v.34
• /
• pp.77-108
• /
• 2007

The traditional name given to the insurance of third party liabilities and certain contractual liabilities which arise in connection with the operation of ships is protection and indemnity(P & I) insurance. P & I insurance is very different from traditional hull and machinery insurance in that shipowners' hull and machinery insurance is designed primarily to protect the assured against losses to his vessel, whereas P & I insurance seeks to indemnify an shipowner in respect of the discharge of legal liabilities he has incurred in operating his own vessels. This study is to examine the background of establishment of British P & I clubs md, therefore, the identity of P & I insurance. The present British P & I clubs are the remote descendants of the many small and local hull mutual insurance clubs that were formed by British shipowners in the end of 18th century. At that time, British shipowners were dissatified with the state of marine insurance market and, therefore, established clubs together in mutual hull insurance clubs. After the removal of the company monopoly in 1824, greater competition had a good effect on the rates, terms of cover and service offered by the commercial marine insurance market and by Lloyd's underwriters, and the hull clubs became less necessary and went into decline. The burden of British shipowners on liabilities to third parties was steadily increased after the middle of the 19th century, but the amount insured under hull policy was limited in the insured value of the ship. Eventually, the first protection club, that is, the Shipowners' Mutual Protection Society was formed in 1855. It was designed to like past mutual hull clubs, but to cover liabilities for loss of life and personal injury and also the collision risks excluded from the current marine policies, particularly the excess above the limits in hull policies. In 1870, the risks of liability for loss of or damage to cargo carried on board the insured ship was first awarded by the British shipowners. After 1874, many protection clubs formed indemnity club to cover the risk of liability for loss or damage to cargo. As mentioned above, British P & I clubs have been steadily changed according to the response of shipowners under the rapidly changing law of British shipowners' liability, and so on in the future.

• Journal of the Korean Wood Science and Technology
• /
• v.41 no.4
• /
• pp.276-286
• /
• 2013

The goal of this study was to investigate change of thermal decomposition feature of miscanthus (Miscanthus sacchariflorus) after removal of inorganic constituents using distilled water (D.I-w; 30, 60 and $90^{\circ}C$). The carbon content was increased whereas the oxygen content was decreased with the temperature of D.I-w treatment. Moreover, ash content was slightly decreased from 4.6% of control to 3.2% of $90^{\circ}C$ D.I-w treated sample. Results of total monomeric sugar contents and X-ray diffraction (XRD) analysis showed that structural changes of cellulose/hemicellulose regions did not occurr during D.I-w treatment. Results of inductively coupled plasma emission spectrometer (ICP-ES) showed that miscanthus has the largest amount of inorganic constituents such as potassium (5,644 ppm), phosphorus (3,995 ppm), magnesium (1,403 ppm) and calcium (711 ppm). Thermogravimetric analysis (TGA) confirmed that the yield of char slightly decreased whereas the yield of volatiles increased with increasing D.I-w treatment temperature. In addition, differential thermogravimetric analysis (DTGA) indicated that the maximum decomposition rate ($V_M$) and temperature ($T_M$) corresponding to VM were varied from $0.82%/^{\circ}C$, $360.60^{\circ}C$ of control to $1.17%/^{\circ}C$, $362.62^{\circ}C$ of $90^{\circ}C$-D.I-w treated sample.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.37 no.4
• /
• pp.383-396
• /
• 1992

In order to find out the reasons for the excessive accumulation of certain fertilizer elements in arable land in Korea, which may be a detrimental factor for her sustainable agriculture in the future, total requirement of fertilizers were estimated from the huge number of soil test data obtained throughout the country using the fertilizer requirement models based on the soil analysis data and the concepts of multi nutrient factor balance or starter fertiliazer. The total fertilizer requirements estimated based on the present soil fertility status were much less than those estimated from the suspected cropping area of various crops cultivated depending on the conventional fertilizer recommendation for each crops or the actual amount of fertilizer elements consumed through National Agricultural Cooporative Federation(NACF). The excessive accumulation of certain fertilizer elements in arable land in Korea must be due to excessively high dose of chemical fertilizers as well as those farm wastes such as animal wasts produced unexpectedly in large amounts or crop residues. And it is suggested that the improved fertilizer recommendation must be developed in consideration both with the soil fertility status and the amounts of nutrient removal by each crop, and that the high analyzed complex fertilizers commonly used by farmers must ugently be developed in a form containing low P and K with Mg and slow release type N for the better balanced management practices of soil fertility by farmers arid for their practices of sustainable agriculture.

• Journal of Conservation Science
• /
• v.32 no.3
• /
• pp.377-384
• /
• 2016

There are physical and chemical method for removement of a lacquered layer existing on the surface when gilding an iron Buddha, these caused environmental pollution by surface degradation and is very noxious for conservation scientist's health. Thus, on this study, we conducted a lacquered layer removement experiments using Nd:YAG Laser which is contactless and eco-friendly. Specimens were made by polishing $5{\times}5$ size of iron(99.9%) specimens surfaces evenly and by differing of number of coating of unrefined lacquer, so there were thickness differences of $10{\mu}m$, $20{\mu}m$, and $30{\mu}m$. The laser machine used in this study was Nd:YAG Laser, and we used two wavelength modes; 1064 nm(160~180 mJ) for infrared light region and 532 nm(50~350 mJ) for ultraviolet light region. The experiment done by investigating the transition of specimens' surfaces with laser wavelength, energy, and numbers of investigation. The remain amount of lacquered layer surfaces before/after laser irradiation was investigated by stereoscopic microscope, observation by SEM, Non-contact Surface Roughness Measurement Device, and FT-IR etc. As a result of each analysis, we could verify the thickness of $10{\mu}m$, $20{\mu}m$ of lacquered layer removed without surface degradation when using 1064 nm wavelength with $1.0J/cm^2$ density. We could find out that Nd:YAG Laser is effective for removing remained lacquered layers when gilding an iron Buddha. In the future, when not only the metal has made various studies also wood lacquered furniture or the like, it seems to be utilized to remove the lacquer without surface damage.

• Applied Biological Chemistry
• /
• v.37 no.4
• /
• pp.295-302
• /
• 1994

For the development of biological wastewater treatment process using photosynthetic bacteria (PSB), photosynthetic sludge process consisted of anaerobic digestion and PSB reactor were designed for the treatment of swine wastewater and the optimal operating conditions in flask-scale were examined. Photosynthetic bacteria from soil, pond, rice field, ditch etc. were isolated in synthetic medium containing high amount of organic acids and finally isolated one strain KK14 which showed the most degradating ability of organic acids was selected for the treatment of swine wastewater. It was identified as Rhodopseudomonas palustris. In the anaerobic digestion stage, the maximum organic acid productivity was obtained at pH 5.0, $37^{\circ}C$, HRT 2 day and under anaerobic standing condition. The optimal operating conditions of PSB reactor for the treatment of swine wastewater were pH 7.0, $30^{\circ}C$ under 4,000 lux illumination, and optimal initial COD loading (kg COD/kg D. C. W of PSB) was 2 (20% v/v seeding) in the main purification stage. Maximum removal rate of COD reached 92% under the above optimal conditions for 5 days.

• Korean Journal of Environmental Agriculture
• /
• v.17 no.4
• /
• pp.329-334
• /
• 1998

This study was conducted in order to investigate removal rate of organic matter, nitrogen and phosphorus to reduce environmental polluation with treatment to attach combined septic tank to 3 stage soil filter after mixing anaerobic treated water of livestock wastewater and low concentrated wastewater generated in farm house. Because anaerobic filter bed was packed in combined septic tank and a microorganism was accumulated in combined septic tank with increasing hydraulic retention time(HRT), if HRT $4{\sim}12day$, CODcr was removed $63.4{\sim}84.0%$. Also, $NH_4\;^+-N$ and $PO_4\;^{3-}-P$ were removed $3.9{\sim}5.4%$ and $18.3{\sim}29.0%$, respectively. In being re-treated by 3 stage soil filter, although hydraulic loading rate was gradually increased, CODcr, $NH_4\;^+-N$ and $PO_4\;^{3-}-P$ were removed above 90% due to filtration, adsorption, ion exchange, and action of soil microorganism. Generally, the attached treatment of combined septic tank and 3 stage soil filter did suitably treat livestock wastewater to water standard of discharge applied from '96 year, in view of decreasing pollution loading amount and recycling of agricultural water.

• Korean Journal of Environmental Agriculture
• /
• v.29 no.2
• /
• pp.152-158
• /
• 2010

Biosorption is considered to be an alternative method to replace the present adsorbent systems for the treatment of metal contaminated wastewater. In this study, by-product which was abandoned from brewing factory was used to remove metal component in aqueous solution. The experimental results showed that the range of the removal efficiency is 60~91% and adsorption equilibrium was reached in about 3 hr. FT-IR and stereo microscope has been used to observe the surface conditions and changes in functional groups by calcination. At the end of elution, the amount of nitrogen and phosphorus in water was increased 11 and 7 times compare raw sample to calcinated samples. The Langmuir isotherm adequately described the adsorption of waste materials and the maximum adsorption capacity was 28.17 mg/g for Cd. The overall results suggested that waste material might can be used for biosorption of Cd.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.7
• /
• pp.667-674
• /
• 2020

The adsorption of reactive orange 16 (RO 16) dye by activated carbon was investigated using the amount of adsorbent, pH, initial concentration, contact time and temperature as adsorption variables. The investigated process parameters were separation coefficient, rate constant, rate controlling step, activation energy, enthalpy, entropy, and free energy. The adsorption of RO 16 was the highest at pH 3 due to the electrostatic attraction between the cations (H⁺) on the surface of the activated carbon and the sulfonate ions and hydroxy ions possessed by RO 16. Isotherm data were fitted into Langmuir, Freundlich and Temkin isotherm models by applying the evaluated separation factor of Langmuir (RL=0.459~0.491) and Freundlich (1/n=0.398~0.441). Therefore, the adsorption operation of RO 16 by activated carbon was confirmed as an appropriate removal method. Temkin's adsorption energy indicated that this adsorption process was physical adsorption. The adsorption kinetics studies showed that the adsorption of RO 16 follows the pseudo-second-order kinetic model and that the rate controlling step in the adsorption process was the intraparticle diffusion step. The positive enthalpy change indicated an endothermic process. The negative Gibbs free energy change decreased in the order of -3.16 <-11.60 <-14.01 kJ/mol as the temperature increased. Therefore, it was shown that the spontaneity of the adsorption process of RO 16 increases with increasing temperature.