• Journal of Satellite, Information and Communications
• /
• v.7 no.2
• /
• pp.30-35
• /
• 2012

In this paper, we proposed spectrum sensing using cooperative relay to solve problem of sensing performance degradation due to CPE (Customer-Primise equipments) which causes low SNR (signal-to-noise ratio) problem. This system model is expected that cooperative relay scheme guarantees the high sensing performance by its diversity gain. Based on these backgrounds, in this paper, we apply to cooperative relay scheme to the CR (cognitive radio) system, and simulation results show comparison of the sensing performance combining method EGC and MRC.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.9
• /
• pp.1141-1145
• /
• 2018

Generally, in nuclear plants, distance relay (21R) has adapting to protect and to operate main protective of transmission lines and backup protective of main generator. Operation of 21R was required and based on exactly accurate calculation and criteria. But presently method of 21R setting has applied according to protection devices operation guide of KPX, excepting IEEE and ISA standards, which have a difference review directions, consider parameters and devices, also consideration factors were affected to relay operations by uncertain guides. therefore this paper proposed new protection relay setting method and unvague criteria from IEEE 741 and ANSI/ISA 67.04.01, and reviewed a different results through numerical calculation results for methods and criteria including previous and established 21r setting by IEEE, ANSI/ISA Technical standards.

• Proceedings of the KIEE Conference
• /
• 2007.07a
• /
• pp.501-502
• /
• 2007

This paper describes a distance relay that operates in conjunction with a current transformer (CT) compensation algorithm. A distance relay detects a fault based on the ratio of the voltage to the current. If a CT saturates, the calculated impedance becomes larger. This causes maloperation or operating time delay of the distance relay. A compensating algorithm estimates the correct secondary current from the severely distorted currents even when the measurement CTs are used. The correct current is estimated by adding the calculated magnetizing current to the measured secondary current. Test results show that the proposed distance relay can detect a fault without the operating time delay even when the secondary currents are extremely distorted because of use of measurement CTs.

• Journal of Internet Computing and Services
• /
• v.11 no.3
• /
• pp.43-51
• /
• 2010

In this paper, we evaluate the system throughput and the method of optimal wireless resource allocation for the access zone (AZ) and relay zone (RZ) in downlink when the cell coverage is extended using the non-transparent Relay Station (RS) in a 2-hop cellular relay system based on IEEE802.16j, which uses the OFDMA-TDD structure. For the analyses, we first introduce the MAC (Media Access Control) frame structure in the non-transparent mode, then we investigate the interfering elements in both AZ and RZ for the network devices such as the Mobile Station (MS) and RS. Through computer simulation, we analyze the cell coverage extension and system throughput in terms of the distance between Base Station (BS) and RS, then we present the amount of the optimal allocation of wireless resource for the AZ and RZ in downlink using our results.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.46 no.1
• /
• pp.55-62
• /
• 2009

In this paper, we propose a method on the training sequence based on channel estimation issues for relay networks that employ amplify-and-forward(AF) transmission scheme. In $^{[1]}$ and $^{[2]}$, we have to point out that jointly estimating the channel from source to relay and from relay to destination suffers from many drawbacks in fast fading case because the estimation of previous pilots is not suitable for current channel. In this paper, we consider a new joint estimation of overall channel impulse response(CIR) using one OFDM signal without pilots. Using the maximum likelihood(ML) function, we derive a channel estimator by taking the frequency domain of transmitted signal as Gaussian and averaging the ML function over the resulting Gaussian distribution. Simulation results show that our proposed channel estimator performs a fraction of 1dB compared with $^{[1]}$ in high SNR region.

• Journal of Communications and Networks
• /
• v.14 no.4
• /
• pp.352-363
• /
• 2012

In this paper, we study the role of cooperative relays to provide and improve secure communication rates through decodeand-forward (DF) strategies in a full-duplex multiple relay network with an eavesdropper. We consider the DF scheme as a basis for cooperation and propose several strategies that implement different versions of this scheme suited for cooperation with multiple relays. Our goal is to give an efficient cooperation paradigm based on the DF scheme to provide and improve secrecy in a multiple relay network. We first study the DF strategy for secrecy in a single relay network. We propose a suboptimal DF with zero forcing (DF/ZF) strategy for which we obtain the optimal power control policy. Next, we consider the multiple relay problem. We propose three different strategies based on DF/ZF and obtain their achievable secrecy rates. The first strategy is a single hop strategy whereas the other two strategies are multiple hop strategies. In the first strategy, we show that it is possible to eliminate all the relays' signals from the eavesdropper's observation (full ZF), however, the achievable secrecy rate is limited by the worst source-relay channel. Our second strategy overcomes the drawback of the first strategy, however, with the disadvantage of enabling partial ZF only. Our third strategy provides a reasonable compromise between the first two strategies. That is, in this strategy, full ZF is possible and the rate achieved does not suffer from the drawback of the first strategy. We conclude our study by a set of numerical results to illustrate the performance of each of the proposed strategies in terms of the achievable rates in different practical scenarios.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.7
• /
• pp.24-31
• /
• 2009

Resource reservation scheme is an effective method to guarantee QoS for handoff calls in the next generation multimedia mobile communication systems, but it causes negative impacts on blocking probability of new calls. In this paper, to optimize the tradeoff between dropping probability of handoff calls and blocking probability of new calls, relay station based handoff prioritization control algorithm is proposed. In this algorithm, the relay station participates in handoff procedure and enables mobile stations to have guaranteed prompt service after handoff by providing highly efficient data transmission. In this paper, Markov chain models of the proposed handoff prioritization schemes are developed, and dropping probability of handoff packets and blocking probability of new packets are derived. By numerical analysis, the proposed algorithm has been proved to outperform conventional handoff prioritization schemes in terms of dropping probability of handoff packets and blocking Probability of new packets.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.7A
• /
• pp.640-648
• /
• 2011

We propose relay selection schemes using STBC (Space Time Block Coding) technique in OFDM (Orthogonal Frequency Division Multiplexing)-based wireless systems. The proposed schemes select the optimum relay having the maximum instantaneous equivalent channel gain among multiple candidate relays. Also, in order to reduce the system overhead, a symbol grouping method which groups some amount of symbols before selecting the optimum relay is proposed. The simulation results show that the proposed relay selection schemes can obtain more selection diversity gain as the number of selectable relay candidates increases. Furthermore, the proposed scheme with the symbol grouping can reduce system overhead without any degradation of the performance in fading channels with low frequency selectivity.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.13 no.2
• /
• pp.711-732
• /
• 2019

Many unmanned aerial vehicle (UAV) applications have been employed for performing data collection in facilitating tasks such as surveillance and monitoring objectives in remote and dangerous environments. In light of the fact that most of the existing UAV relaying applications operate in conventional half-duplex (HD) mode, a full-duplex (FD) based UAV relay aided wireless network is investigated, in which the UAV relay helps forwarding information from the source (S) node to the destination (D). Since the activated UAV relays are always floating and flying in the air, its channel state information (CSI) as well as channel capacity is a time-variant parameter. Considering decode-and-forward (DF) relaying protocol in UAV relays, the cooperative relaying channel capacity is constrained by the relatively weaker one (i.e. in terms of signal-to-noise ratio (SNR) or signal-to-interference-plus-noise ratio (SINR)) between S-to-relay and relay-to-D links. The channel capacity can be optimized by adaptively optimizing the transmit power of S and/or UAV relay. Furthermore, a hybrid HD/FD mode is enabled in the proposed UAV relays for adaptively optimizing the channel utilization subject to the instantaneous CSI and/or remaining self-interference (SI) levels. Numerical results show that the channel capacity of the proposed UAV relay aided wireless networks can be maximized by adaptively responding to the influence of various real-time factors.

• Journal of Information Processing Systems
• /
• v.12 no.2
• /
• pp.275-294
• /
• 2016

A primary task in wireless sensor networks (WSNs) is data collection. The main objective of this task is to collect sensor readings from sensor fields at predetermined sinks using routing protocols without conducting network processing at intermediate nodes, which have been proved as being inefficient in many research studies using a static sink. The major drawback is that sensor nodes near a data sink are prone to dissipate more energy power than those far away due to their role as relay nodes. Recently, novel WSN architectures based on mobile sinks and mobile relay nodes, which are able to move inside the region of a deployed WSN, which has been developed in most research works related to mobile WSN mainly exploit mobility to reduce and balance energy consumption to enhance communication reliability among sensor nodes. Our main purpose in this paper is to propose a solution to the problem of deploying mobile data collectors for alleviating the high traffic load and resulting bottleneck in a sink's vicinity, which are caused by static approaches. For this reason, several WSNs based on mobile elements have been proposed. We studied two key issues in WSN mobility: the impact of the mobile element (sink or relay nodes) and the impact of the mobility model on WSN based on its performance expressed in terms of energy efficiency and reliability. We conducted an extensive set of simulation experiments. The results obtained reveal that the collection approach based on relay nodes and the mobility model based on stochastic perform better.