• Journal of Electrical Engineering and Technology
• /
• v.10 no.4
• /
• pp.1453-1459
• /
• 2015

Loss of excitation (LOE) relay is prevalently used to protect synchronous generator. The widely used method for synchronous generator LOE protection is a negative offset mho relay with two zones. The basis of this relay is identical to mho impedance relay. In other words, this relay calculates impedance by measuring voltage and current at the generator terminal. On the other hand, the presence of series compensation, changes measured voltage and current signals during loss of excitation. This paper reveals that the presence of series compensators such as fixed series capacitors (FSCs) and static synchronous series compensator (SSSC) causes a significant delay on the performance of generator LOE relay. It is also shown that the presence of SSSC causes the LOE relay to be under-reached. Different operating modes of the power system, the SSSC and also different percentages of series capacitive compensations have been considered in the modeling. All the detailed simulations are carried out in the MATLAB/Simulink environment using the SimPowerSystems toolbox.

• The Journal of the Korea Contents Association
• /
• v.17 no.10
• /
• pp.334-342
• /
• 2017

Due to the development of telecommunication technology, the relay broadcasting system is changing rapidly. The introduction of the wireless mobile communication relay (DMNG) method has enabled the one-man relay, which has resulted in absolute reductions in terms of equipment and manpower. However, it is a reality that the basic level of broadcasting such as broadcasting stability and image quality is becoming less complete. This paper analyzes wireless telecommunication relay equipment and broadcasting system called 'backpack', and discusses future development plan. To do this, we analyze the success and failure cases of backpack relay broadcasting and present concrete plans.

• The Journal of Engineering Research
• /
• v.3 no.1
• /
• pp.139-146
• /
• 1998

Frame relay is a high speed wide area network technology that is used to connect various networks. Combining the advantages of packet switching and circuit switching, frame relay offers high throughput and reliability that is perfect for a variety of today's business applications. In this study, we briefly characterize frame relay technology, survey standardization activities and investigate domestic frame relay market. We developed an experimental system for the dial-up service to access remotely an enterprise network using frame relay network, and tested the performance and cost effect of the experimental system.

• Journal of KIISE:Information Networking
• /
• v.37 no.4
• /
• pp.294-300
• /
• 2010

In this paper, We analysis of effective coverage extension for Tri-sector cellular systems using Multi-hop Relay based on IEEE802.16j system. In the proposed international standard of IEEE 802.16j MMR (Mobile Multi-hop Relay) use of the omni-directional antenna, 3-sector and 6-sector antenna is considered to Base Station and Relay Station. Omni-directional antenna service can offer as all directions but a throughput decreases due to the signal interference of near Relay Stations. In the directional antenna, cause of an interference with the base station which it arranges an antenna so that a beam can have the direct and does with neighbor Base Station and Relay Station can be reduced interference, therefore the effective throughput is higher than the omni-directional antenna system. But, In case of Base Station and Relay Station use the directional antenna, the efficiency which the directional antenna has the Co-channel interference due to in the different cell by the channel reuse is decreased. In this study, we propose the structure of arranging the Base Station and Relay Station having the directional antenna in the NBTC, WBTC antenna in a multi-tier. It compared and analyzed with the mode that the multi-hop Relay Station has the omni-directional antenna, Relay Station are used the NBTC antenna and the WBTC antenna system also, We analyze a relation between the performance degradation and the cell coverage extension which it follows because the number of hop in the multi-hop Relay Station.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.2
• /
• pp.13-18
• /
• 2008

In this paper, we consider an amplifying-and-forward(AF) dual-hop relaying system where the source node transmits to a destination node with the help of R relay nodes. We assume that the source node equips M transmit antennas, but only one antenna is equipped at the each node of relay and destination. The outage probabilities are presented when the transmit maximum-ratio-combining(MRC) is used at the source-relay(S-R) links, and the best relay selection, which selects only one relay that contributes the most to the received signal-to-noise ratio(SNR) as active relay, is combined. Simulation results validate these analytical results.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.13 no.6
• /
• pp.562-567
• /
• 2020

In this paper, this is a study on the correction of protection relays to monitor temporary power facilities for storage tanks especially transformers to block and protect faults such as insulation breakdown. When an abnormality such as a short circuit or a ground fault occurs in the power system, it is important to detect this quickly cut off the device and equipment in which the fault occurred and separate it from the power system to correct the protection relay so that it does not interfere with power supply. In addition the fault current calculation that accurately applies the fault type and the cause of the fault for protection cooperation will be the most important factor in the correction of the protection relay. For protection coordination a study was conducted on the method of coordination for protection of power facility protection for storage tanks such as over current relay, ground over current relay, under voltage relay, and ground over voltage relay applied to temporary.

• KSCI Review
• /
• v.14 no.2
• /
• pp.117-122
• /
• 2006

In this paper, we designed and implemented the DCS(Distributed Control System) terminal remote monitoring board for build total unified management system based wireless communication on automatic control system fields. Also, it tested and evaluated for check an usability and performance. The board monitored relay and fuse status at power management room real-time. Therefore, we expected economic effects extend relay life-time that pre-detected errors and prevented relay fault.

• Journal of Communications and Networks
• /
• v.13 no.3
• /
• pp.250-256
• /
• 2011

A two-way relaying (TWR) system is analyzed, where two source terminals with unequal numbers of antennas exchange data via an amplify-and-forward relay terminal with a single antenna. In the system considered herein, the link quality between the sources and relay can generally be asymmetric due to the nonidentical antenna configuration, power allocation, and relay location. In such a general setup, accurate bounds on the average sum rate (ASR) are derived when beamforming or orthogonal space time block coding is employed at the sources. We show that the proposed bounds are almost indistinguishable from the exact ASR under various system configurations. It is also observed that the ASR performance of the TWR system with unequal numbers of source antennas is more sensitive to the relay location than to the power allocation.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.55 no.12
• /
• pp.646-652
• /
• 2006

This study identifies the comparison of Technical specification and Characteristics of DC Protection Relay(ETCPU200) used in DC Distribution System in Korea. ETCPU200 has completed Field Test and approved its capability by finding out causes of recent operations through lately developed digital DC protection relay in parallel operation at Maebong-Substation, Sangbong-Substation, Nakseongdae-Substation, Euljirosaga-Substation, Jegi-Substation and Chongyangri T/P area. It also examines additional features for efficient System Analysis and Operations.

• Journal of Satellite, Information and Communications
• /
• v.5 no.1
• /
• pp.94-99
• /
• 2010

In this paper, we discuss a proposed two hop relay network with PB/MC-CDMA(partial block MC-CDMA) technique. The main advantages of PB/MC-CDMA system are the increased cell capacity and the high quality of performances. In the system, we employ relay scheme to focus on the coverage reduction and hotspot problem, hotspot is a location where a cluster of users are blocked or dropped for the reason of insufficient frequency resources. Frequency resource allocation scheme is put forward in a three cells system according to each problem. The simulation result shows the performance of the two hop transmission is better than the direct transmission and the proposed network can support much more users to relief hotspot effect compared to the conventional one.