• Proceedings of the KSME Conference
• /
• 2001.11b
• /
• pp.388-393
• /
• 2001

An experimental study is conducted to investigate the interaction of vortices over a delta wing with leading edge extension(LEX) through the off-surface flow visualization and the 5-hole probe measurements of the wing wake region. Especially, the application of a new visualization technique is employed by ultrasonic humidifier water droplet and laser beam sheet. The results, both the off-surface visualization and the 5-hole probe, show that LEX tends to stabilize the vortices of the delta wing up to the high angle of attack even though the model is yawed. With increasing yaw, the windward leading edge vortex moves inward, and closer to the wing surface, while the leeward vortex moves outwards and away from the wing surface. The vortex interaction is promoted in the windward side, and is delayed in the leeward side.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.33 no.8
• /
• pp.842-848
• /
• 2009

Fatigue failures are often occurred at welded joints where stress concentrations are relatively high due to the joint geometry. Although employing good detail design practices by upgrading the welded detail class enables to improve the fatigue performance, in many cases, the modification of the detail may not be practicable. As an alternative, the fatigue life extension techniques that reduce the severity of the stress concentration at the weld toe region, remove imperfections and introduce local compressive welding residual stress, have been applied. These techniques are also used as definite measures to extend the fatigue life of critical welds that have failed prematurely and have been repaired. In this study, a hammer peening procedure for using commercial pneumatic chipping hammer was developed, and the effectiveness is quantitatively evaluated. The pneumatic hammer peening makes it possible to give the weld not only a favorable shape reducing the local stress concentration, but also a beneficial compressive residual stress into material surface. In the fatigue life calculation of non-load carrying cruciform specimen treated by the pneumatic hammer peening, the life was lengthened about ten times at a stress range of 240MPa, and fatigue limit increased over 65% for the as-welded specimen.

• Journal of Korean Physical Therapy Science
• /
• v.23 no.1
• /
• pp.24-32
• /
• 2016

Purpose: Muscle imbalance around the knee region, especially quadriceps imbalance, is considered one of the main contributing factors to the development and progression of knee dysfunction based on the changes observed via electromyography (EMG). This study aimed to investigate the effect of vastus lateralis (VL) inhibition taping using non-elastic tape on the EMG activity of the vastus medialis oblique (VMO) and VL during isometric knee extension. Method: Thirty-three healthy young adults (11 males and 22 females) were recruited. With and without VL inhibition taping, the participants performed isometric knee extension in the sitting position for a total of 7 seconds. Result: VMO/VL EMG ratio significantly increased after VL inhibition taping (p<.05). Conclusion: These findings suggest that VL inhibition taping may contribute to VL inhibition and may help improve VMO/VL ratio in young adults. We expect VL inhibition taping to be useful in individuals with greater VL than VMO activity

• Proceedings of the KSRS Conference
• /
• 2007.10a
• /
• pp.33-36
• /
• 2007

We have persistently constructed gridded products of surface wind/wind stress over the world ocean using satellite scatterometer (ERS and Qscat). They are available for users as the Japanese Ocean Flux data sets with Use of Remote sensing Observation (J-OFURO) data together with heat flux components. Recently, a new version data of the Qscat/SeaWinds based on improved algorithm for rain flag and high wind-speed range have been delivered, and allowed us to reconstruct gridded product with higher spatial resolution. These products are validated by comparisons with in-situ measurement data by mooring buoys such as TAO/TRITON, NDBC and the Kuroshio Extension Observation (KEO) buoys, together with numerical weather prediction model products such as the NCEP-1 and 2. Results reveal that the new product has almost the same magnitude in mean difference as the previous version of Qscat product and much smaller than the NCEP-1 and 2. On the other hand, it is slightly larger root-mean-square (RMS) difference than the previous one and NCEPs for the comparison using the KEO buoy data. This may be due to the deficit of high wind speed data in the buoy measurement. The high resolution product, together with sea surface temperature (SST) one, is used to examine a new type of relationship between the lower atmosphere and upper ocean in the Kuroshio Extension region.

• The Plant Pathology Journal
• /
• v.17 no.3
• /
• pp.154-158
• /
• 2001

A severe root rot of kiwifruit caused by a species of Phytophthora occurred in 1-to 5-year-old vines at the south coast region of Korea in 1997. Infected vines exhibited leaf chlorosis, scorch and defoliation, root and stem rot, and eventual death. The disease was relatively severe in poorly drained lowlands, of which 19 out of 23 fields were damaged by the disease. Meanwhile, only one among 58 upland fields was infected by the disease. Incidence of infected vines reached over 80% in heavily damaged fields and a species of Phytophthora was isolated from inner tissues of roots, stems, and rhizosphere soils of the plants. The causal pathogen was identified as P. drechsleri based on its mycological characteristics. Pathogenicity of the fungus was confirmed by artificial inoculation to seedlings of kiwifruit 'Hayward'. The pathogen was re-isolated from the inoculated plants showing symptoms similar to those observed in the fields. Root rot of kiwifruit caused by P. drechsleri has not been reported previously in Korea.

• Archives of Pharmacal Research
• /
• v.22 no.6
• /
• pp.542-548
• /
• 1999

The UL47 gene (b 60390-b 60388) located in the unique long region of the human cytomegalovirus (HCMV) AD169 strain genome was analyzed RNA mapping. Northern blot analysis showed that the UL47 gene was expressed at late times after infection (72 h postinfection). The 9.7-kb transcript was expressed in the infected cells but not in phosphonoformate-treated cells at 72 hpi, indicating that the UL47 gene was only expressed at late times after infection. To map the 5'-end and 3'-end of UL47 transcripts, primer at late times after infection. To map the 5'-end and 3'-end of UL47 transcripts, primer extension and RNase protection analysis were performed. Primer extension analysis revealed that the transcription initiation site of UL47 was located in 27 bp downstream (b 60323) of the TATA box motif. The sizes of UL47 ORF (approximately 2.9-kb) and UL48 ORF (approximately 6.7-kb) deduced from computer sequence analysis suggest that the expressed 9.7-kb transcript of UL47 uses the 3'-end polyadenylation signal of Ul48. The result of RNase protection determined that the 3'-end of UL47 RNA utilized the 3'-end polyadenylation signal of UL48, which is located in HCMV genome b 70082.

• Journal of Korean Society of Rural Planning
• /
• v.20 no.4
• /
• pp.45-54
• /
• 2014

The main purpose of this study is to provide the back-from-city farmers with the information about the melon cultivation technology by surveying 268 farm houses in the major melon producing districts such as Seongju and Chilgok. For the purpose, this study classifies the essential technologies that the melon experts think as most important into 6 categories: size of plastic film house, covering film, varieties of oriental melon, lagging cover, ventilation method and ways to reduce repeated-cultivation damage. The result of the study shows that the back-from-city farmers should consider the following items when they choose to cultivate oriental melons. For the size of plastic film house, the ventilation method and the covering film of plastic film house, it is better to choose the latest technology. Even though it may require larger initial investment, the latest technology can increase the production and lower the cost. In case of variety, it is better to choose popular or the most widely grown ones rather than the new ones. The lagging cover should be selected in consideration of climate conditions such as average temperature and humidity, transplant time and harvest time of the farming region.

• Korean Journal of Veterinary Research
• /
• v.28 no.2
• /
• pp.221-226
• /
• 1988

Normal swine brains at 1 to 70 days after birth were used to investigate the presence and morphology of the subependymal layer (SL) in the ventricle walls. The brain samples were taken from 27 pigs of 4 swine breeds. The results were summarized as follows: 1. SLs were observed on the walls of the lateral ventricle (LV) but none were observed on the walls of the 3th and 4th ventricles. 2. SLs of the LV walls were composed of mainly 3-to 10-cell layers in thickness. The thinest region of SLs was composed of only 1-to 2-cell thick on the dorsal and ventral walls, and the thickest region was composed of 250-to 300-cell thick on extension region of the SLs into the angle between the corpus callosum and caudate nucleus. 3. Of the LV parts observed, the SL thickness were 25-to 45-cell thick on the anterior horn, 3-to 10-cell thick on the body, 100-to 220-cell thick on the angle region between the corpus callosum and caudate nucleus, and 3-to 5-cell thick the superior walls of the posterior horn. Also the SL thickness was more thick on the anterior region than those on the posterior region. 4. SLs may be classified as three types by the cell distribution; one type of them is closely arranged cell region with the distinctive lateral margin from the periventricular white matter, the other type is loosely arranged cell region with the undistinctive lateral margin, and another type is two-subdivided region as the loosely and closely arranged cell layers in a layer. 5. SLs were extensively thick in young age but gradually decreased in size and cell number with age after 20-day age. SL layers were composed of mainly oligodendrocytes, astrocytes and immature cells of them. Morphological differences of SL in different breeds of pigs were not observed.

• Journal of Agricultural Extension & Community Development
• /
• v.5 no.1
• /
• pp.93-102
• /
• 1998

The objectives of the study were 1) to make the reasonable standard, 2) to select the objective and scientific method and process for the location-allocation of a new provincial capital city. The Main standard of location-allocation were suggested as follows ; 1) Integration of province 2) Convenience of Administration service 3) Accomodations of new provincial capital city 4) Balanced development by region. The validity of location-allocation were reviewed the population potentials and nodal accessibilities. The population potential was examined to find the maximum point of administrative demand, and the locationallocation model was examined to find the minimum point of the aggregated travel-cost to a proposed provincial government office. The nodal accessibilities measured in travel-time distance and actual values. Two major concerns in locating public facilities are efficiency and equity.

• Journal of Agricultural Extension & Community Development
• /
• v.16 no.3
• /
• pp.557-586
• /
• 2009

The objective is to find the classification criteria between urban and rural, and to classify the urban and rural area all the country in Korea. For the research objectives, reviews of related literature and statistical yearbooks were used for finding criteria and analysing data. Through reviewing the literature, some indicators were selected in views of rurality and urbanity, and gathered the data from statistical yearbooks. And factor analysis was used to find first and second factor for classifying region. Six factors as a city surrounding(36%), non-farmer household population ratio(28.1%), cultivated acreage(12.48%), agricultural production surrounding (12.40%), the farm family number change(5.58%) and household number rise and fall(5.54%) were finding. And rurality factors were cultivated acreage, agricultural production surrounding, the farm family number change and household number rise and fall, and urbanity factors were city surrounding and non-farmer household population ratio. Based on the first and second factor loaded amount, four type regional classification was followed.