• 한국태양에너지학회:학술대회논문집
• /
• 한국태양에너지학회 2011년도 추계학술발표대회 논문집
• /
• pp.74-79
• /
• 2011

Concentration characteristics of the KIER solar furnace are analyzed with a heat flux measurement technique. Total heat capacity of 40kW was confirmed within 1.04% average error, and the normalized maximum heat flux of 3,452 $kW/m^2$ was proved. Non-Gaussian flux distribution in the vertical direction implies that reflectors should not be random rather inclined downwards. Moreover, we characterized flux distribution variations with furnace blind opening ratio, distance from the focal plane, and misalignment of the measurement system. Based on the results, the heat flux distribution can be simply estimated once reflectivity and direct normal insolation values are known. This study will be helpful to the design and the performance evaluation of receivers or chemical reactors.

• Ocean and Polar Research
• /
• 제29권4호
• /
• pp.411-418
• /
• 2007

We studied the bottom morphology and sedimentary environments of the Masan Bay using high-resolution Chirp seismic profiles and sediments data. According to deep-drilled core samples (up to 20 m thick) penetrated into the weathered rock basement, the sediments consist largely of three sediment types: the lower sandy gravel facies (Unit I) of 1-4 m in thickness, the middle sandy mud and/or muddy sand facies(Unit II) of 1-2 m thick and the upper mudfacies (Unit III) of over 10 m in thickness. The sedimentary column above the acoustic basement can be divided into two major sequences by a relatively strong mid-reflector, which show the lower sedimentary sequenc e(T) with parallel to subparallel internal reflectors and the upper sedimentary sequence(H) with free acoustic patterns. Acoustic basement, the lower sedimentary sequence (T), and the upper sequence (H) are well correlated with poorly sorted massive sandy gravels (Unit I), the sand/mud-mixed sediment (Unit II), and the muddy facies(Unit III), respectively. The acoustic facies and sediment data suggest that the Masan bay is one of the most typical semi-enclosed coastal embayments developed during the Holocene sea-level changes. The area of the Masan Bay reduced from about $19\;km^2$ in 1964 to about $13\;km^2$ in 2005 by reclamation, and its bottom morphology changed as a result of dredging of about $2{\times}10^7\;m^3$.

• Journal of the Society of Naval Architects of Korea
• /
• 제38권1호
• /
• pp.62-71
• /
• 2001

Prediction of ship's signature of RCS(Radar Cross Section) and TES(Target Echo Strength) is mostly required in the initial design stage of naval craft, because RCS is directly related to the radar detection while TES to the sonar detection. In this research, a numerical scheme using a curved-patch physical optics method is proposed to evaluate signature of a perfectly reflecting curved object. The scheme is validated by comparing numerical RCS values of circular cylinder, sphere and NACA3317 airfoil with available data. It is also further applied to predict RCS of a surfaced submarine and TES of fully submerged one. Major reflectors of the surfaced or submerged submarine for the various incident angles of radar and sonar waves are investigated as well.

• The Bulletin of The Korean Astronomical Society
• /
• 제38권1호
• /
• pp.56.1-56.1
• /
• 2013

We have carried out follow-up observations of transiting extrasolar planets using small- to medium-sized reflectors located in Korea. Using the 0.60m telescope stationed at CbNUO (Chungbuk National University Observatory) we have achieved a photometric precision of 1.48 milli-magnitudes (root-mean-square scatter of data) of a HAT-P-09b (transit duration of 3.43 hrs) transit light curve (transit depth ~ 1.3%) with V=12.3 mag for the host star. We expect a photometric precision of 1.0 - 1.2 milli-magnitude for brighter targets (V ~ 10 - 11 mag). The transit technique and its application will be outlined. The results of test observations will be presented and the defocus technique will be discussed.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• 제10권3호
• /
• pp.340-350
• /
• 1999

In this paper, W-type reflector antennas modified from corner reflector antenna structure were proposed and the radiation characteristics were analyzed using the method of moments. The analysis results such as gain, F/B, half power beamwidth, and radiation pattern are presented as functions of dipole height h and back edge spacing d. Also, the proposed antenna was compared with corner reflector antennas in the same size of side reflectors, W-type reflector antenna was found to exhibit somewhat higher gain and larger F/B than corner reflector antennas. To verify the analysis results, W-type reflector antenna was fabricated and the radiation characteristics were measured. The measured results show good agreement with the calculated results.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• 제24권9호
• /
• pp.908-914
• /
• 2013

A shaped Cassegrain antenna is designed from the condition of the same path length at the equi-phase surface by using the conservation of energy and Snell's law. In order to improve the phase error efficiency of aperture surface, the surface profile of the main and sub-reflectors is found to satisfy the power distribution and the equi-phase condition at the aperture surface. The sidelobe levels of 36.4 dB and 33.9 dB are achieved at the AZ and EL planes, respectively from numerical calculation by physical optics method at Ku band and the directivity of designed antenna is 10 percent greater than that of conventional antenna.

• Journal of the Korean Geophysical Society
• /
• 제3권4호
• /
• pp.227-234
• /
• 2000

Amplitude anomalies or bright spots are often linked to hydrocarbon-bearing reservoirs but can also be caused by tuning effect resulting from interference when two reflectors are close together. Tuning effect can be removed from amplitude maps before seismic amplitude and reservoir thickness data are converted into estimates of hydrocarbon accumulations. The most straightforward way of removing tuning effect or 'detuning' is by comparing the reservoir amplitude in seismic data with the response of wedge or thin-bed models and calibrating the reservoir amplitude using the tuning curves from the models. Volumetric estimation for amplitude plays must be based on detuned amplitude maps because hydrocarbon volumes can be significantly overestimated when conventional amplitude maps are used.

• Journal of electromagnetic engineering and science
• /
• 제4권2호
• /
• pp.87-92
• /
• 2004

A millimeter-wave distributed frequency doubler has been designed with distributed block and frequency tunable output reflectors. The simulated conversion loss of 9.5 ㏈ to 7.7 ㏈ from 54.6 ㎓ to 62.4 ㎓ output frequencies is achieved with fundamental and third harmonic signal rejections of more than 10 ㏈c. The fabricated chip has the size of 1.2 mm${\times}$1.0 mm. Some measured results of frequency and bias dependent characteristics are presented for the fabricated PHEMT MMIC frequency doubler. The designed doubler has two transistors, and if one of the transistors fails the doubler unit still operates with reduced gain. The failure effect of the PHEMT has been simulated, and compared to the measured data of which one PHEMT is not operating properly.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• 제15권1호
• /
• pp.7-12
• /
• 2001

Tbis topic is about the development of a 2-dimensional specular reflector design aid software. For a long and cylindrical shaped lamp with perfect diffusing smface, direction and quantity of reflected light flux from a specular reflector strip can be calculated consideJing reabsorption by the lamp itself. Assuming a reflector as a combination of several strip segments, the reflected flux is calculated as position, length and declination of each segment are detennined. At each step, calculated reflected flux distribution and desired flux distribution is compared graphically and numerically, so that roost optimized and efficient reflector shape can be decided by the designer. We think that this software would be useful for designing reflectors for relatively long light sources, such as fluorescent lamp, tubular high pressure sodium lamp, low pressure sodium lamp, and so on. so on.

• Journal of Navigation and Port Research
• /
• 제26권2호
• /
• pp.199-207
• /
• 2002

Radar Cross Sections(RCS) for the radar targets are measured and their performance characteristics are analyzed through computer simulation. In addition, constructional features for the commercial radar reflectors are investigated. Then, the optimum design condition of a passive-type radar reflector was chosen. The results show that the octahedral-type radar reflector with 10$\lambda$ sized circular plates has best performance in X-band($\lambda$=3.2cm). However, to comply with newly adopted 2000 SOLAS regulations, larger sized circular plate is required to provide at both X-band and S-band.