• Journal of Korean Society for Atmospheric Environment
• /
• v.31 no.4
• /
• pp.368-377
• /
• 2015

Bunker C fuel oil is a high-viscosity oil obtained from petroleum distillation as a residue. The sulfur content of bunker C fuel oil is limited to 4.0% or even lower to protect the environment. Because bunker C fuel oil is burned in a furnace or boiler for the generation of heat or used in an engine for the generation of power, carbon dioxide is emitted as a result of combustion. The objective of this study is to investigate $CO_2$ emission characteristics of bunker C fuel oil by sulfur contents. Calorific values and carbon contents of the fuels were measured using the oxygen bomb calorimeter method and the CHN elemental analysis method, respectively. Sulfur and hydrogen contents, which were used to calculate the net calorific value, were also measured and then net calorific values and $CO_2$ emission factors were determined. The results showed that hydrogen content increases and carbon content decreases by reducing sulfur contents for bunker C fuel oil with sulfur contents less than 1.0%. For sulfur contents between 1.0% and 4.0%, carbon content increases as sulfur content decreases but there is no evident variation in hydrogen content. Net calorific value increases by reducing sulfur contents. $CO_2$ emission factor, which is calculated by dividing carbon content by net calorific value, decreases as sulfur content decreases for bunker C fuel oil with sulfur contents less than 1.0% but it showed relatively constant values for sulfur contents between 1.0% and 4.0%.

• Journal of the Korean Ceramic Society
• /
• v.48 no.3
• /
• pp.246-250
• /
• 2011

Effects on sintering and electrical properties of $La_{0.7}Ca_{0.3}Cr_{0.9}Co_{0.1}O_{3-{\delta}}$ system, a interconnect material for cylindrical and flat tubular solid oxide fuel cells (SOFC), have been investigated by Ca-source when using $CaCO_3$ and $CaF_2$. When using $CaCO_3$ and $CaF_2$ was mixing as Ca-source, single phased perovskite solid solution was observed for each sample. The sintering temperature was decreased by $CaF_2$ contents was increased. When using 0.1 mole $CaF_2$ was densely sintered at $1400^{\circ}C$ and relative density was 93.8%. Also, electrical conductivity in oxidation and reducing atmosphere was 47, 4.3 S/cm, respectively, due to $F^-$ ion enhance the electrical conductivity in reducing atmosphere.

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.11a
• /
• pp.433-437
• /
• 2006

Pt/Nafion self-humidifying membranes for Polymer Electrolyte Membrane Fuel Cell(PEMFC) were synthesized via supercritical-impregnation methods. The Nafion 112 membranes were impregnated with Pt(II)$(acetylacetonate)_2$ from a supercritical carbon dioxide $(scCO_2)$ solution at $80^{\circ}C$ and 30MPa. After the impregnation, the pressure decreased slowly by releasing $CO_2$. And the Pt-impregnated Nafion membrane was converted Pt deposited Nafion membrane by reducing agent, sodium borohydride $(NaBH_4)$ with various concentrations under $50^{\circ}C$ and 2 hours. The prepared Pt-impregnated Nafion (Pt/Nafion) composite membrane were investigated by Electron Prove Micro analysis (EPMA) and X-rat Diffraction analysis (XRD) which showed distribution of Pt particle and Scanning Electron Microscopy (SEM) and Atomic Force Microscopy (AFM) a which revealed morphology of surface of Pt/Nafion composite membrane. The performance of the Pt/Nafion 112 membranes was examined in PEMFC as aself-humidifyin membranes using purpose-built equipment.

• The Journal of Asian Finance, Economics and Business
• /
• v.8 no.2
• /
• pp.801-808
• /
• 2021

The issue of the relationship between environmental degradation and human health has been widely addressed by medical doctors. However, economists have sparsely debated it. The release of carbon dioxide (CO2) into the air can cause several environmental problems and, thus, it can affect human health. Therefore, it is imperative to examine the effect of CO2 emissions on life expectancy in the D-8 countries (Malaysia, Indonesia, Bangladesh, Nigeria, Egypt, Iran, Pakistan, and Turkey) from 1992 to 2017. The panel ARDL method is employed and, then, the PMG estimator is selected. The results show that economic growth, population growth and health expenditure can significantly and positively affect life expectancy, but CO2 emissions can have a significant and negative effect on life expectancy. Since, the major findings reveal that life expectancy can be explained by CO2 emissions. Hence, it is important to formulate policies on reducing CO2 emissions so that life expectancy will not be affected. Energy diversification policies should be formulated or improved in some countries. This is to ensure that the countries are not highly dependent on non-renewable energy that can harm the environment. The government should increase its expenditure on the health sector to save more lives by extend human lifespan.

• Journal of the Korean Ceramic Society
• /
• v.17 no.4
• /
• pp.179-187
• /
• 1980

Perovskite-type oxide catalysts in the $\textrm{LaMnO}_3$ family were prepared by both freeze drying and precipitation technique, and their catalytic activities with respect to the oxidation of CO with $O_2$ were measured in the composite gases. Freeze drying is a new technique for the prevention of migration of the solutes during drying. Therefore, the corrugated cordierite monolith fabricated with the Ø 1mm stainless steel bar was directly impregnated with nitrate solutions containing the appropriate cations, freeze dried and calcined. Precipitation was done by using $\textrm{(NH_4)}_2\textrm{CO}_3$ but the precipitated catalysts gave lower catalytic than the freeze dried samples due to, in part, relatively high calcining temperature. In this study, freeze dried composition had high catalytic activity, and their apparent activation energy for oxidation of CO was calculated by the rate plots using the data where the percent conversion of CO was less than 20%.

• Transactions of the Korean hydrogen and new energy society
• /
• v.26 no.5
• /
• pp.499-506
• /
• 2015

Recently the Korean government announced its decision to select the $3^{rd}$ proposal, which targets reducing $CO_2$ by 37% of the BAU level by 2030, for the Intended Nationally Determined Contribution (INDC). According to this proposal, natural gas (or equivalent gas) combined cycle (NGCC) are suggested as alternatives for conventional pulverized coal (PC). In this study, we analyzed the environmental, economic, and energy mixing aspects of synthetic natural gas combined cycle(SNGCC) using NETL material (2011~2012 version) and other domestic materials (2014 version). We found the following conclusions: 1) Considering carbon capture and storage (CCS) integration, $CO_2$ emission factors of SNGCC and supercritical PC are the same. However, 60% of $CO_2$ from SNGCC is produced as high pressure and high purity (99%) gas, making it highly suitable for CCS, which is now strongly supported by the government. 2) Based on the economic analysis for SNGCC using domestic materials and comparison with NGCC, it was found that the settlement price of SNGCC was 30% lower than that of NGCC.

• Nuclear Engineering and Technology
• /
• v.28 no.5
• /
• pp.458-466
• /
• 1996

The effects of dopants on the modification of microstructure of UO$_2$ and UO$_2$-4wt%CeO$_2$ sintered pellets have been studied in hydrogen and $CO_2$/CO mixture atmospheres by using $Ta_2O_5$, TiO$_2$ and $Nb_2O_5$ as sintering additives. The dopant were added as oxide powders and homogenized by attrition milling. The mixed powders were pressed, and then sintered in hydrogen at 1$700^{\circ}C$ , or in oxidizing atmosphere using Controlled $CO_2$/CO mixtures at 125$0^{\circ}C$. Both density and microstructure of UO$_2$ are modified by the addition of dopants in reducing atmosphere. The sintered density is increased with $Ta_2O_5$ addition up to 0.33wt% and subsequently decreased with higher content of the additive. The effect on the densification and the gain growth are apparent with the addition of 0.24wt% $Nb_2O_5$. With 0.lwt% titania and 0.6wt% $Ta_2O_5$, the sintered density is decreased, but the grain size is increased. In oxidizing atmosphere, the grain sizes for UO$_2$ doped with the above additives are smaller than that for pure UO$_2$. The grain size of Ta or Nb-doped UO$_2$ is decreased with increasing $CO_2$/CO ratio, but that of pure UO$_2$or T-doped UO$_2$ is increased. A large portion of second phases is observed in UO$_2$ doped with 0.lwt% TiO$_2$ sintered in hydrogen atmosphere, while, in $CO_2$/CO atmospheres, the second phases or dopant agglomerates are not observed. For UO$_2$-4wt%CeO$_2$ mixed oxide, the effect of additives on the gain growth is not so much as that for the pure UO$_2$. This is attributed to the formation of clusters by dopant cations and Ce ions, so that the additives contribute to a lesser exent to the grain growth for the mixed oxide.

• Laser Solutions
• /
• v.11 no.1
• /
• pp.32-35
• /
• 2008

In the remote welding system using $CO_2$ laser, laser beam can be rapidly transferred to a workpiece by moving mirrors of scanner system. So, it makes reducing the cycle time of welding process. We can also use and apply various patterns of weld beads by linear controlled mirrors. But most of the domestic car makers have usually applied use stitch-shaped weld bead. In that case, we don't have the merit of remote welding system efficiently. Therefore, in this paper, we investigated the characteristic of weld strength according to patterns of weld bead on $CO_2$ laser welding. And we also studied the relationship between shape of weld bead and value of tensile load.

• Journal of Energy Engineering
• /
• v.26 no.2
• /
• pp.73-79
• /
• 2017

In nucleation assisted crystallization process formed $CO_2$ leaves as colloid gas and is used as the template by the rapidly growing crystals in the nucleation site. This emulsion of $CaCO_3$ micro-crystals & $CO_2$ micro-bubbles forms hollow particles. Formed hollow particles are double walled, both internal and external faces belonging to the cleavage aragonites which separate the surrounding water from the enclosed gas cavity. Hence, the reverse reaction of $CO_2$ with water forming Carbonic Acid is not possible and the pH stability is maintained. In fact every excess $CaCO_3$ crystals are buffering any carbonic acid left over. This $CO_2$ based nucleation technology prevents scale formation in water channels, but it also helps to reduce the previously formed scales. This process takes out water dissolved $CO_2$ in almost-visible micro-bubbles forms that helps reducing previously formed scale over a period of time (depends on the usage period). The aragonite crystals can't form scale because of its stable molecular structure and neutral surface electro potentiality.

• Journal of the Korean Ceramic Society
• /
• v.35 no.9
• /
• pp.899-904
• /
• 1998

Interface reaction between LSMC and YSZ is discussed with chemical composition of LSMC. The reac-tivity between LSMC and YSZ increased with increasing Co amount and A-site deficient perovskite is very effective on reducing reactivity. The (La0.8Sr0.2)xMn0.8Co0.2O3 (X=0.9-1) composition is not reactive with YSZ in experimental range. The electrode reaction reaction resistance increases due to reaction product.