• Journal of the Korean Society of Visualization
• /
• v.14 no.3
• /
• pp.28-31
• /
• 2016

In this study, we investigate the wake characteristics in two cases which are laminar inflow and turbulent inflow. To solve the flow with wind turbines and its wake, we use large eddy simulation (LES) technique with actuator line method (ALM) and turbulent inflow of Turbsim. Turbulent inflow which contains the characteristic of the stable atmospheric boundary layer is used. We perform the quantitative analysis of velocity deficit and turbulence intensity in two cases. Time series of velocity deficit at the first, the second column in two cases are compared to observe the performance of wind turbine. The performance in the first column in laminar inflow is overestimated compared to that in turbulent inflow. And we observe that wake in the case with turbulent inflow drive to the span-wise direction and wake recovery in turbulent inflow is more effective. In quadrant analysis of Reynolds stress, the ejection and the sweep motion in turbulent inflow case are bigger than those in laminar inflow case.

• 한국신재생에너지학회:학술대회논문집
• /
• 2005.06a
• /
• pp.361-365
• /
• 2005

Since the fuel cell uses the hydrogen for its fuel. it has no emission and higher efficiency than an internal combustion engine. Also fuel cell is much quieter than engine generator and generates heat much less than engine generator. So it has advantage of Army's 'si lent watch' capability and the ability to operate undetected by the enemy. The fuel cell hybrid system combines a fuel cell power system with an ESS. The ESS (e.g., batteries or ultracapacitors) reduces the fuel cell's peak power and transient response requirements. It allows the fuel cell to operate more efficiently and recovery of vehicle energy during deceleration. The battery has high energy density, so it has the advantage regarding driving distance. However, it has a disadvantage considering dynamic characteristic because of low power density. One other hand. the ultracapacitor has higher power density, so it can handle sudden change or discharge of required power. Yet. it has lower energy density. so it will be bigger and heavier than the battery when it has the same energy. This paper proposes the power management strategy for multi-power source fuel cell hybrid system. which is applied with the merits of both battery and ultra capacitor by using both of them simultaneous.

• Korean Journal of Pharmacognosy
• /
• v.15 no.3
• /
• pp.139-146
• /
• 1984

High performance liquid chromatographic separation is described for the analysis of bile acids after hydrolysis in seven commercial crude bile drugs and ox and pig galls. They are simultaneously separated with HPLC mobile phase of acetonitrile/0.5% ammonium carbonate (pH 6.7) (25.5 : 74.5) at a flow rate $(1.0{\rightarrow}1.5ml/min.)$ and differential refractometer. The linearity of calibration curve and recovery test are good by using the method. The analysis of major bile acids in seven commercial crude bile drugs using the described method is presented. Sample no. 1 of them is similar to separation pattern of ox gall. Sample no. 6 of them is supposed to be genuine bear gall on the basis of identification of ursodeoxycholic acid. Sample $no.\;2{\sim}5$ and 7 of them are supposed to be pig gall on the basis of identification of hyodeoxycholic acid which is a characteristic component of pig gall.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.16 no.1
• /
• pp.71-77
• /
• 2008

This paper proposes an Electronic Throttle Body (ETB) model considering a non-linearity of DC motor driver which is integrated with a H-bridge and a gate driver. A propagation delay and reverse recovery time of switching components cause non-linear characteristic of DC motor driver. This non-linearity affects not only the amateur voltage of DC motor, but also entire behaviour and parameters of ETB. In order to analyze the behavior of ETB more accurately, this non-linear effect of DC motor driver is modeled. The developed ETB model is validated by use of the step response and ramp response experiments, and it shows relatively accurate results compared with linear DC motor driver model.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.66 no.8
• /
• pp.1215-1221
• /
• 2017

Parametric array transducers are used for highly directional speaker in an air environments. Piezoelectric micromachined ultrasonic transducers for parametric array transducers need DC-biased voltage driving signals in order to get high-directional quality-sound features. The existing power amplifier such as class A amplifiers has low efficiency and require large volume heatsinks. To overcome the above-mentioned disadvantages of the conventional amplifier, this paper proposes a new power amplifier system. The proposed power amplifier system ensures high linearity of output characteristic by utilizing the push-pull class B type amplifier. Furthermore, the proposed power amplifier system gets high efficiency because it contains the DC-DC converter-type power supply which can perform energy recovery and envelope tracking function. Also the paper suggests the detailed circuit topology. Its characteristics are verified by the detailed experimental results.

• Journal of The Korean Society of Clinical Toxicology
• /
• v.4 no.2
• /
• pp.131-136
• /
• 2006

Metronidazole is an antimicrobial drug widely used against various types of infectious agents, including protozoa, amoeba, Helicobacter pylori, and anaerobes. Metronidazole may produce some adverse effects on hematologic, immunologic, neurologic and other systems. We report a case of reversible metronidazole-induced encephalopathy. The toxic dose of metronidazole and the onset of encephalopathy were variable. Two patients showed abnormally high signal intensity in the bilateral dentate nucleus of cerebellum, and characteristic abnormalities were detected by brain magnetic resonance imaging (MRI) and T2-weighted images, fluid-attenuated inversion recovery images and/or diffusion weighted imaging (DWI). Discontinuation of metronidazole resulted in the improvement of the neurologic symptoms over a period of two to three weeks. We followed up the brain MRI with DWI in one case following obvious clinical improvement, and the previously detected lesion had disappeared.

• Journal of The Korean Society of Clinical Toxicology
• /
• v.9 no.2
• /
• pp.39-48
• /
• 2011

In mass casualty situation due to radiological accidents, it is important to start aggressive management with rapid triage decisions. External contamination needs immediate decontamination and internal contamination should be treated with special expertise and equipment to prevent the rapid uptake of radionuclides by target organs. Acute radiation syndrome shows a sequence of events that varies with the severity of the exposure. More severe exposures generally lead to more rapid onset of symptoms and severe clinical findings. After the massive exposure, various systems of the body reflect their severe damages that can lead to death within hours or up to several months. The disease progression has classically been divided into four stages: prodromal, latent, manifest illness, and recovery or death. Three characteristic clusters of symptoms including the hematopoietic syndrome, the gastrointestinal syndrome and the cerebrovascular syndrome are all associated with the acute radiation syndrome. The standard medical management of the patients with a potentially survivable radiation exposure includes good medical, surgical and supportive measures. Specific treatment with cytokines and bone marrow transplantation should be considered. The management of internal contamination is much the same as the treatment of poisoning. The standard decontamination should be applied to reduce uptake, and the chelating agents can be administered to enhance the clearance of radioisotopes. Radioactive iodine ($^{131}I$) as one of the nuclear fission products can increase the incidence of thyroid cancer in children. Potential benefit of potassium iodide prophylaxis is greater especially in neonates, infants and small children.

• Proceedings of the IEEK Conference
• /
• 2001.10a
• /
• pp.693-698
• /
• 2001

This paper establishes a coding method system including the liberation and size distribution of recycling materials in the shredder operation. Every particle in the shredded product becomes a code number using the liberation model and size distribution equation transforming of weight percentage into particles number percentage. One set of database can be obtained after all particles have been coded. This database is suitable for the size reduction operation in the process simulation of waste recycling. Coupling with the developed air classification, sizing and separating operations, the whole process simulation will be completely established for diversified application. A typical simulation for the rolling cutting shredder product of waste TV had been demonstrated under this coding system. The breakage size distribution of Gaudin and Schumann equation were selected for the shredding operation simulation. The Gaudin's liberation model was suitable fur the liberation simulation. Both of these equations were transformed weight percentage into particles distribution for the necessary of particle coding method. A better recycling operation for this shredded solid waste can be concluded from the comparison of simulation results with their sorted grade, recovery or economic of materials in different processes.

• Journal of Drive and Control
• /
• v.9 no.1
• /
• pp.1-9
• /
• 2012

Nowadays, various researches about eco-friendly vehicles such as hybrid electric vehicle, fuel cell vehicle and electric vehicle have been actively carried out. Since most of these green cars have electric motors, the regenerative energy technology can be used to improve the fuel economy and the energy efficiency of vehicles. The regenerative brake is an energy recovery mechanism which slows a vehicle by converting its kinetic energy into electric energy, which can be either used immediately or stored until needed. This technology plays a significant role in achieving the high energy usage. However, there are some technical problems for controlling the regenerative braking and the electro-hydraulic brake during switching at transient region. In this paper, the performance simulator for fuel-cell vehicle is developed and transient response characteristics of the regenerative braking system are analyzed in the various driving situations. And the hardware-in-the-loop simulation of electro-hydraulic brake is performed to validate the transient characteristics of the regenerative braking system for fuel-cell electric vehicle.

• The Transactions of the Korean Institute of Electrical Engineers B
• /
• v.54 no.11
• /
• pp.519-526
• /
• 2005

This paper presents computer simulation results for developing new type of SF$_{6}$ Circuit Breaker in terms of cold gas flow after small current interruption. This cold gas flows down a nozzle into the chamber of a circuit breaker. There are many difficult problems in analyzing the gas flow due to complex geometry, moving boundary, shock wave and so on. When predicting the dielectric capability of a gas circuit breaker after interruption, the gas pressure and density distributions due to the cold gas must be considered in addition to the electrical field imposed across the gas. A self-coded computational fluid dynamics (CFD) program is used for the simulation of cold gas flow in order to evaluate the electrical field characteristic across open contacts and transient characteristics of insulations after small current interruption.