• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.9
• /
• pp.1087-1093
• /
• 2012

In this paper, we implemented a HF-band magnetic-field communication system consisting of an amplitude shift keying(ASK) transmitter, a pair of loop antennas, and an ASK receiver. Especially, we suggested a new ASK transmitter architecture, where a drain bias of class E amplifier is switched alternatively between two voltage levels with respect to input data. A maximum 5 W class E amplifier was designed using a low cost IRF510 power MOSFET at the frequency of 6.78 MHz. A measured sensitivity of the designed ASK receiver is -78 dBm, which consists of a log amplifier, a filter, and a comparator. Maximum communication range of magnetic-wave communication system with loop antennas was calculated using magnetic field equations in both near-field and far-field ranges. Also, in order to verify the calculated values, an indoor propagation loss was measured using a pair of loop antennas whose dimensions are $30{\times}30cm$. Maximum operating range is estimated about 35 m in case of transmitter's output power of 1 W and receiver sensitivity of -70 dBm, respectively. Finally, the communication field test using the designed ASK transmitter and receiver was successfully done at the distance of 5 m.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.19 no.4
• /
• pp.294-299
• /
• 1999

In this paper, the calibration system for contact transducer has been developed to improve the reliability of the inspection result of ultrasonic testing on rotors. This system consists of signal processing parts: (oscilloscope, spectrum analyzer, pulser/receiver), standard block, and user interface program. Signal processing for the calibration system was performed quickly with high accuracy. The developed system has been applied to a practical calibration of probe using the non-destructive testing on rotors, and demonstrated high sensitivity and precision.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.12
• /
• pp.2228-2233
• /
• 2008

This research paper aims to establish a test process of the AFE SiP chip. It measured the sensitivity, current consumption and power consumption both on the evaluation socket board and Catalyst load board. As a result, the sensitivity became deteriorated with an average of 0.2[dBm] at the channel 62 only, the current consumption increased to an average of 0.57[mA] and the power consumption increased to an average of 1.76[mW], But all characteristics incomes the tolerance of the measurement, it also keeps almost the same level. Therefore this design of the test process improved a valid design.

• Communications for Statistical Applications and Methods
• /
• v.27 no.2
• /
• pp.211-224
• /
• 2020

Sensitivity and specificity are popular measures described by the receiver operating characteristic (ROC) curve. There are also two other measures such as the positive predictive value (PPV) and negative predictive value (NPV); however, the PPV and NPV cannot be represented by the ROC curve. Based on the total operating characteristic (TOC) curve suggested by Pontius and Si (International Journal of Geographical Information Science, 97, 570-583, 2014), explanatory methods are proposed to geometrically describe the PPV and NPV by the TOC curve. It is found that the PPV can be regarded as the slope of the right-angled triangle connecting the origin to a certain point on the TOC curve, while 1 - NPV can be represented as the slope of the right-angled triangle connecting a certain point to the top right corner of the TOC curve. When the neutral zone exists, the PPV and 1-NPV can be described as the slopes of two other right-angled triangles of the TOC curve. Therefore, both the PPV and NPV can be estimated using the TOC curve, whether or not the neutral zone is present.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.6
• /
• pp.1032-1035
• /
• 2008

In this paper, a DC power management scheme is proposed for efficient battery operation of 60-GHz receivers. It consists of a rectenna and a zero-cross detector. The harmonic rejection capability of a circular sector antenna is used to simplify the rectenna. The zero-cross detector is introduced to increase sensitivity. When the received power density is larger than 0.013 $mW/cm^2$, it can generate enough DC power to activate an RF receiver. Experimental data is used to verify the proposed idea.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2005.05a
• /
• pp.281-286
• /
• 2005

This paper presents sensitivity analysis of generalized rapid relaxation inversion (GRRI) algorithm for inverting controlled-source audio-frequency magnetotelluric (CSAMT) data. The algorithm was originally developed by modifying the RRI algorithm to recover a two-dimensional (2-D) conductivity structure of the Earth from MT data, but can be extended to include CSAMT data if it is combined with 2.5-D forward modeling. These GRRI approximate sensitivities are validated by comparison with exact 1-D and 2.5-D sensitivities. The comparison shows that the GRRI sensitivity is a good approximation to the exact sensitivity and has about half magnitude of the RRI sensitivity. Although the magnitude of the GRRI sensitivity is still slightly larger than that of the 2.5-D sensitivity, both sensitivities are broadly similar in shape when source-receiver offsets are greater than one skin depth on the Earth.

• Journal of Korean Neurosurgical Society
• /
• v.52 no.5
• /
• pp.472-475
• /
• 2012

Objective : The aim of this study is to establish the value of hand elevation test as a reproducible provocative test for the diagnosis of carpal tunnel syndrome (CTS). Methods : We had a prospective study of 45 hands of 38 patients diagnosed with CTS between April 2005 and February 2009. The diagnosis of CTS was based on the American Academy of Neurology clinical diagnostic criteria. Experimental and control group patients underwent Tinel's test, Phalen's test, carpal compression test and hand elevation test as provocative tests for CTS. Results : We used chi-square analysis to compare Tinel's test and Phalen's test, carpal compression test with hand elevation test. The sensitivity and specificity of the hand elevation test is 86.7% and 88.9% each. Tinel's test had 82.2% sensitivity and 88.9% specificity. Phalen's test had 84.4% sensitivity and 86.7% specificity. Carpal compression test had 84.4% sensitivity 82.2% specificity. Comparisons of sensitivity and specificity between hand elevation test and Tinel's test, Phalen's test, and carpal compression test had no statistically significant differences. To compare the diagnostic accuracies of four tests, the area under the non-parametric receiver operating character curve was applied. Conclusion : The hand elevation test has higher sensitivity and specificity than Tinel's test, Phalen's test, and carpal compression test. Chi-square statistical analysis confirms the hand elevation test is not ineffective campared with Tinel's test, Phalen's test, and carpal compression test.

• Korean Journal of Optics and Photonics
• /
• v.13 no.4
• /
• pp.295-300
• /
• 2002

We developed an optical transmitter and receiver for an electrical time division multiplexed (ETDM) 20 Gb/s optical transmission system, and experimentally investigated their characteristics. Especially, the clock extraction circuit, which is a key component in realizing broadband optical transmission receivers, was realized by using an NRZ-to-PRZ converter implemented with a half-period delay line and an EX-OR, a high-Q bandpass filter using a cylindrical dielectric resonator, and a microstrip coupled-line bandpass filter. Finally, the bit-error-rate of demultiplexed 10 Gb/s electrical signal after back to-back transmission was measured, and a high receiver sensitivity [-26.2 dBm for NRZ ($2^{7}-1$) pseudorandom binary sequence (PRBS)] was obtained

• Journal of Broadcast Engineering
• /
• v.15 no.6
• /
• pp.731-741
• /
• 2010

In this paper, we propose the methodology of prediction of field strength for a digital television (DTV) receiver by virtue of Recommendation ITU-R P.1546. The curves shown in this recommendation represent the point-to area field strength for 1.0 kW effective radiated power in the 30 MHz ~ 3000 MHz. Based upon the procedures described in this Recommendation, computation results are presented here from the derived formulation of field strength for DTV receiver. To show the validity of this method, some results are compared with the analysis by Okumura-Hata model and it was shown that the error of field strength is in the range of 6.9 ~ 11.5 %. The presented method provides not only the predicted values of field strength for DTV receiving area to check the quality of transmitted signal, but also an appropriate site selection for obtaining good propagation environment. In addition, it can be directly used for analyzing the protection ratio or separated distance for frequency sharing in the same band.

• Journal of Veterinary Clinics
• /
• v.19 no.3
• /
• pp.312-315
• /
• 2002

Diagnostic tests often require the determination of cut-off values that discriminate uninfected from infected individuals. The receiver operating characteristic (ROC) curve has been frequently used to attain this purpose and gives a representation of diagnostic accuracy (sensitivity and specificity) of a prediction model when varying the cut-point of a decision rule on a whole spectrum. We have written and tested a visual basic application program in EXCEL for maximum likelihood estimation of a binormal ROC curve, which also computes univariate statistics of a diagnostic test employed. Examples applying for computed tomographic images in radiology and methicillin-resistant Staphylococcus aureus research are given to illustrate this approach. This stand-alone module is available from the first author on request.