• 한국식품저장유통학회지
• /
• 제2권1호
• /
• pp.195-202
• /
• 1995

An experiment was conducted to develop the simple methods of ginger storage which decrease the weight reduction and maintain good quality of ginger during the cellar storage. The stored boxes with volume of 0.03㎥ and ventilator diameter of 3, 4, 5cm was hurried under the ground(60, 80, 100cm) in the green house. During the cellar storage at the 100cm depth the average temperature and relative humidity in the stored box were remained in 11.7~16.3$^{\circ}C$ and 73%, respect. The higher storage amount and smaller size of ventilator size increased the CO2 concentration in the stored box, and the concentration in the stored box with 50% storage quantity rate and 3cm ventilator diameter size was more than 10% for about 2 months from early Feburary. The decay rate of ginger during the cellar storage increased with higher amount of storage quantity and smaller size of ventilator. The CO2 concentration was low and remained relatively constant with the deeper location of stored box under the ground, and the decay rate was lower in the deeper stored box. Germination rate increased with the deeper location of stored box, and with the lower storage quantity and larger ventilator size. The germination rate was low in the higher decay rate box. Weight loss, total sugar and moisture contents of ginger were decreased, while crude fiber and ash were increased during the storage.

• 한국주조공학회지
• /
• 제11권5호
• /
• pp.398-405
• /
• 1991

Al-Li alloy has a high strength with low density. Practically this alloy should use by the material which made from the rapid solidification. Therefore we examine the solidification structures of alloy with cooling rate. According to cooling rate increased, grain size and secondary dendrite arm spacing were smaller. Also grain size was further smaller by Zr added. To obtain more fine solidification structure, rapid solidification by single roll melt spinning was performed. According to higher wheel speed, cooling rate increased and cell size was smaller. Because of locally different cooling rate, different cell size was obtained in same specimen. More than cooling rate $10^6^{\circ}C$ /sec, zone A(insensible zone to corrosion)was obtained.

• 자원리싸이클링
• /
• 제29권6호
• /
• pp.104-113
• /
• 2020

기포크기는 컬럼부선에서 기포체류시간, 기포표면적플럭스(Sb) 및 운송율(Cr)에 영향을 미치는 중요 변수로 인식되고 있다. 본 논문은 부선컬럼에서 기포크기의 측정방법, 가동변수들의 관계 그리고 가스분산특성을 논한다. 기포크기는 고속카메라와 이미지 분석 시스템을 이용하여 가동변수들(가스속도, 세척수속도, 기포제농도)의 조건에 따라 부선컬럼에서 직접적으로 측정되었다. 각 측정과 산정된 기포크기 값들을 비교한 관계식이 ±15~20의 오차범위 내에서 도출되었고 평균 기포크기(Sauter mean diameter)는 0.718mm로 확인되었다. 본 시스템으로부터 기포크기 및 분포를 조절할 수 있는 경험식이 가동조건들(Jg: 0.65~1.3cm/s, JW: 0.13~0.52cm/s, frother concentration: 60~200ppm) 하에서 개발되었다. 기포제농도의 증가는 표면장면과 기포크기를 감소시킨다. 임계병합농도는 표면장력이 가장 낮은 49.24mN/m일 때인 기포제농도 200ppm이라고 판단된다. 공기속도의 감소, 기포제농도 및 세척수속도의 증가에 따라 기포크기가 감소하는 경향을 보였다. 가스홀드업은 가스속도와 비례관계에 있으며 고정된 가스속도 조건에서 기포제농도 및 세척수속도와 비례관계였다.

• 펄프종이기술
• /
• 제33권1호
• /
• pp.53-61
• /
• 2001

This study was carried out to evaluate the effect of coating pigments on the printability by investigating the pore structure of casting layer such as the number, size and distribution of pores and the pore rate. The coating structure was mainly determined by the interaction between pigment and binder. It means that the structure of pores was chiefly affected by the shape and size distribution of pigments and their packing rate. The physical properties of pore have close relationships with ink set-off, the speed of ink penetration and printing gloss. The results suggested that the rate and number of pores were greatly affected by the particle size distribution and shape of pigments. The rate of pore increased with the reduction of particle size distribution of pigments. Calcite was effective to improve greatly the printability of coated paper.

• 한국의류학회지
• /
• 제13권2호
• /
• pp.109-116
• /
• 1989

Korean clothings are admired for their beauty and traditional value. On the other hand, many of Korean women complain of chest restriction. Korean skirts may give high garment pressure to the wearers because the Korean skirt-band do not resolve physical tensions in size or in stretch. This paper aims at the identification of the garment pressure caused by the Korean skirt-band and the cardiopulmonary change caused by garment pressure. The Korean skirt-band were made in 3 kinds of size, and 21 women were selected for wearing test. The garment pressure was measured in front, side, and back parts of the body. The measured cardiopulmonary parameters were vital capacity, respiratory rate, heart rate, and blood pressure. The results were as follows: 1. The smaller the size of the Korean skirt-band, the greater the garment pressure. The pressure during inspiration was significantly greater than the pressure during expiration. 2. The pressure in side part was the greatest of the three measurements and the pressure in back part was the smallest. 3. The small size of the Korean skirt-band revealed low vital capcity and great respiratory rate. 4. As the small size grement was dressed, the respiratory rate and the heart rate during walking and rest after walking were significantly high. 5. Subjects felt uncomfortable when they wore small sized garment.

• Architectural research
• /
• 제26권1호
• /
• pp.13-20
• /
• 2024

This study is a research investigation into the properties of bubbles that affect the characteristics of foamed concrete during its production. The study examined the properties of bubbles based on the manufacturing conditions. To investigate these properties, the selected experimental factors included bead size, the length/diameter ratio of the bubble-generating tube, and compressed air. The experimental design used a design of experiments, and the test results were analyzed using analysis of variance. The foaming agent used to generate bubbles was AES (Alcohol Ethoxy Sulfate), and the method employed for bubble manufacture was the pre-foaming method. In the test results, a significant factor affecting the foaming rate of bubbles was the bead size; the highest foaming rate was observed when using 2mm beads. Bead size also primarily influenced the volume change of the aqueous solution, while other factors did not affect the foaming rate and volume change. None of the factors affected the change in bubble size, but compressed air was considered the main factor affecting bubble size and its change. The foaming rate and volume change of the aqueous solution showed a high correlation with each other. Spherical bubbles in the early stage eventually transformed into angular bubbles. Moreover, over time, it was observed that the bubble size increased.

• Journal of applied mathematics & informatics
• /
• 제7권3호
• /
• pp.861-873
• /
• 2000

Rate-based flow control plays an important role for efficient traffic management of Available Bit Rate(ABR) services. We deal with the problem of the buffer dimension for rate-based ABR control. In this paper, we analyze the Allowed Cell Rate(ACR) of a source and the queue size in a steady state. First, we investigate the effect of the number of active sources on the behavior of the ACR and the maximum queue size. Reflecting the effect of this real scenes, we determine the optimal buffer size and buffer threshold. Furthermore, our analytic results are compared with the case when the effect of the number of active sources is disregarded.

• 산업경영시스템학회지
• /
• 제30권2호
• /
• pp.44-50
• /
• 2007

This paper deals with the problem of scheduling jobs and rate-modifying activities on parallel machines. A rate-modifying activity is an activity that changes the production rate of equipment such as maintenance and readjustment. If a job is scheduled after the rate-modifying activity, then the processing time varies depending on the modifying rate of the activity. In this study, we extend the single machine problem to parallel machines problem and propose algorithms is to schedule the rate-modifying activities and jobs to minimize the makespan on parallel machines which is NP-hard. We propose a branch and bound algorithm with three lower bounds to solve medium size problems optimally. Also we develop three heuristics, Modified Longest Processing Time, Modified MULTIFIT and Modified COMBINE algorithms to solve large size problems. The test results show that branch and bound algorithm finds the optimal solution in a reasonable time for medium size problems (up to 15 jobs and 5 machines). For large size problem, Modified COMBINE and Modified MULTIFIT algorithms outperform Modified LPT algorithm in terms of solution quality.

• The Journal of Asian Finance, Economics and Business
• /
• 제8권5호
• /
• pp.99-108
• /
• 2021

As expansion of interest income business faces several limitations, non-interest revenue can play a vital role in increasing the net profit margin and the productivity of the assets to sustain the growth rate. This study aims to analyze the Effect level (partial or total) of a bank's size on the relationship between non-interest revenue and the sustainable growth rate of Jordanian commercial banks. Baron and Kenny's methodology (1986) was adopted to test and analyze the effect of non-interest revenue: including the bank's size, on the sustainable growth rate during the period from 2008-2019. Data collection was done for thirteen commercial banks which constituted 100% of the study population. Testing four hypotheses by using Amos program and a regression model to diagnose the partial and total effect of size. Findings indicate that there is a nonlinear relationship between Non-IR and SGR due to the total effect of bank size on the sustainable growth rate. The results of this study is expected to enable the banks to diversify their revenue to support financial performance towards healthy growth without facing additional financial problems. This study adopted a different methodology from the prior efforts, by using the mediation effect role to verify the effect of non-interest revenue.

• 동의신경정신과학회지
• /
• 제17권2호
• /
• pp.133-145
• /
• 2006

Objective : The purpose of this experimental-controlled study was to investigate the characteristics of the autonomic nervous system in students with Keongke by using HRV(Heart rate variability) and PSV(Pupil size variability). Method : The study group was consisted of 11 students with self recognition as the experimental group, and 25 normal students as the control group. Informations on gender and age were obtained by medical charts and personal interviews. By using heart rate variability and pupil size variability, we measured the value of HRT(Heart rate), SDNN(Standard deviation of NN intervals), LFnorm(Low frequency normalization), HFnorm(High frequency normalization), LF/HF ratio, Pupil area, B.S.(Basic size), C.R.(Max Constriction Rate) and 1s.d.(1sec Dilation Rate). I compared the degrees of the sympathetic and parasympathetic activity. Result : 1. In the result of heart rate variability between experimental and control group, none of the parameters of experimental group were significantly different from control group. And even though there were no statistical significance, there were some numerical differences in SDNN, LF norm, HF norm. 2. In pupil size variability, C.R. and 1s.d. of the experimental group were increased compared to control group. Conclusion : The study results suggest that the group with Keongke has differences of autonomic nervous system as compared to those in normal state. Measurement value of PSV is a new technical approach to estimate the autonomic nervous system.