• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.9
• /
• pp.776-782
• /
• 2002

The microstructure, V-Ι characteristics, and stability of ZnO-P $r_{6}$ $O_{11}$ CoO-C $r_2$ $O_3$- $Y_2$ $O_3$-based varistor ceramics were investigated with cooling rate in the range of 2~8$^{\circ}C$/min. The cooling rate relatively weakly affected the microstructure, the varistor voltage, and the leakage current in the V-Ι characteristics. But the nonlinear exponent relatively strongly affected by cooling rate. The cooling rate also greatly affected the stability of V-Ιand dielectric characteristics for DC accelerated aging stress. On the whole, the varistors cooled with 4$^{\circ}C$/fin exhibited the highest performance in the densification, nonlinearity, and stability. Especially, they exhibited a high stability, in which the variation rate of the varistor voltage( $V_{1㎃}$), the nonlinear exponent($\alpha$), and the dissipation factor(tan $\delta$) is -1.4%, -4.9%, and ＋60.0%, respectively, under DC accelerated aging stress such as 0.95 $V_{1㎃}$15$0^{\circ}C$/12 h)

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.30B no.7
• /
• pp.70-82
• /
• 1993

In this paper, employing the 3-dimensional discrete cosine transform (DCT) for the utilization of the temporal correlation, an adaptive motion sequence coding technique is proposed. The energy distribution in a 3-D DCT block, due to the nonstationary nature of the image data, varies along the veritical, horizontal and temporal directions. Thus, aiming an adaptive system to local variations, adaptive procedures, such as the 3-D classification, the classified linear scanning technique and the VLC table selection scheme, have been implemented in our approach. Also, a hybrid structure which adaptively combines inter-frame coding is presented, and it is found that the adaptive hybrid frame coding technique shows a significant performance gain for a moving sequence which contains a relatively small moving area. Through an intensive computer simulation, it is demonstrated that, the performance of the proposed 3-D transform coding technique shows a close relation with the temporal variation of the sequence to be code. And the proposed technique has the advantages of skipping the computationally complex motion compensation procedure and improving the performance over the 2-D motion compensated transform coding technique for rates in the range of 0.5 ~ 1.0 bpp.

• Journal of the Society of Naval Architects of Korea
• /
• v.39 no.4
• /
• pp.11-16
• /
• 2002

Flow mechanism of peristaltic motion is numerically and experimentally investigated to obtain a propulsive force in highly viscous fluid. Computing code for the analysis of the motions is developed with cell-centered unstructured grid scheme. The computed results by the developed code is compared with the experimental results which have been carried out to find out the propulsion mechanism in highly viscous fluid. The computed results shows good correlation with the experimental results and further the propulsive force can be obtained by sinusoidal motion which makes a pressure difference on waving surface. The more computation with variation of Reynolds number and parameters of motion is expected for finding a proper working range.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.41 no.8
• /
• pp.105-113
• /
• 2004

MRAM uses magneto-resistance material as a storage element, which stores cell data as a polarization of spin in a free magnetic layer. This magneto-resistance material has hysteresis, asteroid curve at the thermal variation, and R-V characteristics for switching the data. Therefore, a macro-model which can reproduce these characteristics is required for MRAM simulation. We propose a macro-model of TMR (Tunneling Magneto Resistance) that can reproduce all of these characteristics on HSPICE. Also we propose a novel sensing scheme, which generates reference resistance having the medium value, ( $R_{H}$+ $R_{L}$)/2, for a wide range of applied voltage and present simulation results based on the HSPICE macro-model of MTJ that we have developed.d.d.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2004.03a
• /
• pp.327-334
• /
• 2004

Spectroscopic and electrostatic probe measurements were made to examine plasma characteristics with or without a metal plate for a 10-㎾-class direct-current arcjet Heat fluxes into the plate from the plasma were also evaluated with a Nickel slug and thermocouple arrangement. Ammonia and mixtures of nitrogen and hydrogen were used. The NH$_3$ and $N_2$+3H$_2$ plasmas in the nozzle and in the downstream plume without a plate were in thermodynamical nonequilibrium states. As a result, the H-atom electronic excitation temperature and the $N_2$ molecule-rotational excitation temperature intensively decreased downstream in the nozzle although the NH molecule-rotational excitation temperature did not show an axial decrease. Each temperature was kept in a small range in the plume without a plate except for the NH rotational temperature for NH$_3$ gas. On the other hand, as approaching the plate, the thermodynamical nonequilibrium plasma came to be a temperature-equilibrium one because the plasma flow tended to stagnate in front of the plate. The electron temperature had a small radial variation near the plate. Both the electron number density and the heat flux decreased radially outward, and an increase in H$_2$ mole fraction raised them at a constant radial position. In cases with NH$_3$ and $N_2$+3H$_2$ a large number of NH radical with a radially wide distribution was considered to cause a large amount of energy loss, i.e., frozen flow loss, for arcjet thrusters.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.5
• /
• pp.1908-1916
• /
• 2018

This paper proposes a controller design method for suppressing the resonance generated in the slave motor in the middle and low speed operation range, according to the load and parameter differences between two motors, during parallel operation using the master and slave method that controls two surface permanent magnet synchronous motors connected in parallel by a single inverter. The proposed resonance suppression controller is directly obtained by analyzing the resonance characteristics, using the lead controller method. Therefore, it is possible to fundamentally reduce trial and error to set the controller gain. In addition, because the proposed resonance suppression controller was designed as a lead controller, the stability region of the system increased owing to the added zero point, making the system robust with respect to parametric variations. Simulations and experiments confirmed the usefulness of the proposed method and the system's robustness with respect to parametric variations.

• Electrical & Electronic Materials
• /
• v.10 no.7
• /
• pp.674-681
• /
• 1997

Ternary compound ceramics, (1-y-x) BaTiO$_3$-y SrTiO$_3$-x MgTiO$_3$(0.00 x 0.20), were fabricated by the conventional ceramic process. The structural and dielectric properties of specimens were investigated while varying the composition and sintering temperature(1,200~1,45$0^{\circ}C$) in order to obtain the optimum condition of capacitor. As is well known, Curie temperature(T$_{c}$) of high dielectric-based ceramic(BaTiO$_3$) was shifted and temperature of capacitance was decreased in according to increase of solid solution with (Sr, Mg)TiO$_3$. As a result, a suitable condition of compound rate for capacitor was obtained such as the BSM-11(0.8BaTiO$_3$-0.1SrTiO$_3$-0.1MgTiO$_3$), and sintering temperature was sintered at 1,25$0^{\circ}C$ for two hours. In this case, dielectric constant<1,300, dielectric loss(tan$\delta$)<0.03, and the variation rate of capacitance had less than 3% in the range -10~7$0^{\circ}C$.>.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.11a
• /
• pp.467-471
• /
• 2001

DC accelerated aging characteristics of Pr$_{6}$O$_{11}$-based ZnO varistors, which are composed of ZnO+Pr$_{6}$O$_{11}$+CoO+Cr$_2$O$_3$+Dy$_2$O$_3$ ceramics were investigated with CoO content in the range of 0.5~5.0 mol%. The varistors doped with 1.0 mol% revealing maximum value(66.61) in the nonlinear exponent exhibited excellent stability, in which the variation rates of the varistor voltage, the nonlinear exponent and leakage current are -1.93%, -10.48%, and 288.79%, respectively, under DC accelerated aging stress, such as (0.85 V$_{1mA}$/115$^{\circ}C$/24h)+(0.90 V$_{1mA}$/12$0^{\circ}C$/24h)+(0.95 V$_{1mA}$/1$25^{\circ}C$/24h)+(0.95 V$_{1mA}$/15$0^{\circ}C$/24h). Next the varistors doped with 2.0 mol% exhibiting the nonlinear exponent of 47.39 showed high stability,ity,ability,ity,

• Analytical Science and Technology
• /
• v.14 no.6
• /
• pp.516-521
• /
• 2001

This research was for reducing leachated concentration of hazardous pollutants in bottom ash from municipal solid waste combustors(200 tons/day) of Korea. Lead and copper compounds were selected as main pollutants. For reducing of leachated level, optimal conditions were observed using air oxidation for lead compounds and water washing method for copper compounds. and it was observed stable pH range of bottom ash from analyzing lechated level by pH variation.

• Journal of the Society of Disaster Information
• /
• v.8 no.2
• /
• pp.197-203
• /
• 2012

In these days, the design of a structure for reducing or eliminating noise and vibration is getting more important, as the social demands for reducing environmental pollution rise. In this paper, the basic concept and performance verification test results of the recently developed vertical vibration isolator are presented. The isolator attenuates vibration using the damping action from the friction plane made of PTFE and provides the restoring force from the polyurethane springs arranged in vertical and horizontal directions. The performance verification tests consist of a test for identifying performance change during load rate variation and a test for confirming the force-displacement relationship assumption in vibration force range.