• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.11 no.1
• /
• pp.42-52
• /
• 2012

In this paper, a waveguide antenna is designed and fabricated for side and rear radar sensor of vehicles in UWB (Ultra Wide Band) high band (center frequency : 9.5 GHz, -10 dB bandwidth : 600 MHz (6.4 %)). For the radar antenna, a probe fed rectangular waveguide antenna having simple structure and wide bandwidth is used. An important performance factor in this antenna is the isolation between transmitting (TX) and receiving (RX) waveguide antennas because this radar system uses TX and RX antennas separately. Thus the isolation between two antennas was simulated for E-plane and H-plane array. As a result, it was verified that the isolation of the H-plane array of the antennas is better than E-plane array, due to the TE10 mode. Therefore, H-plane arrayed waveguide antennas were mounted on a T-shaped radar module and performance of antennas was investigated. The -10 dB bandwidth of the TX and RX antenna mounted on T-shaped radar module was measured as 1000 MHz (10.52 %) and 1090 MHz (11.47 %) respectively and the isolation is less than -50 dB in the operation band. The peak gain is 7.65 dBi for the TX antenna and 7.26 dBi for the RX antenna and the beamwidth of H-plane of TX and RX antenna was measured as $64^{\circ}$ and $65^{\circ}$ respectively. Consequently, we verified that the proposed waveguide antenna is appropriate for a vehicle radar applications.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.7
• /
• pp.521-527
• /
• 2014

Most of Sea Surveillance Radar(SSR)s which are used in Vessel Traffic Service are Magnetron-based Non-Coherent Method and use the pulse integration technique having a signal to noise ratio enhancement function to satisfy a surveillance performance about target. Especially, Pulse Integration technique has an effect on target serveillance performance through signal to noise ratio, in addition, has an effect to improve a signal interference and noise spike. In this paper, we have a simulation experiment by using MATLAB simulation tool for appling a pulse integration technique in VTS system using a Non-Coherent radar, and verify an optimum pulse integration technique through out performance analysis between frequently use pulse integration techniques.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.64 no.6
• /
• pp.922-934
• /
• 2015

In this paper, The classification between precipitation echo(PRE) and non-precipitation echo(N-PRE) (including ground echo and clear echo) is carried out from weather radar data using neuro-fuzzy algorithm. In order to classify between PRE and N-PRE, Input variables are built up through characteristic analysis of radar data. First, the event classifier as the first classification step is designed to classify precipitation event and non-precipitation event using input variables of RBFNNs such as DZ, DZ of Frequency(DZ_FR), SDZ, SDZ of Frequency(SDZ_FR), VGZ, VGZ of Frequency(VGZ_FR). After the event classification, in the precipitation event including non-precipitation echo, the non-precipitation echo is completely removed by the echo classifier of the second classifier step that is built as Type-2 FCM based RBFNNs. Also, parameters of classification system are acquired for effective performance using PSO(Particle Swarm Optimization). The performance results of the proposed echo classifier are compared with CZ. In the sequel, the proposed model architectures which use event classifier as well as the echo classifier of Interval Type-2 FCM based RBFNN show the superiority of output performance when compared with the conventional echo classifier based on RBFNN.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.54 no.5
• /
• pp.90-96
• /
• 2017

Due to the merit of having wide range with low cost, HF radar's ship detection and tracking research as maritime surveillance system has been recently studied. Many ship detection and tracking algorithms have been developed so far, however, performance comparison cannot be conducted properly because the states of target ships (such as moving path, size, etc.) differ from each study. In this paper, we propose a simulator based on compact HF radar, which generates data according to the size and moving path of target ship. Given the generated data with identical ship state, it is possible to conduct performance comparison. In order to validate the proposed simulator, the simulated data has been compared with real data collected by the SeaSonde HF radar sites. As a result, it has been shown that our simulated data resembles the real data. Therefore, the performance of various detection or tracking algorithms can be compared and analyzed respectively by using our simulated data.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.12
• /
• pp.1292-1299
• /
• 2014

Weather radar systems can provide weather information of the ground, sea, and air in extensive spatial coverage in near real time. However, it becomes problematic when ground clutter signal exists around precipitation because strong signals of ground can cause a false precipitation report. A large percentage of land coverage of Korea consists of mountainous regions where ground clutter needs to be mitigated for more accurate prediction. Thus, it is considered necessary to introduce a new suitable ground clutter removal technique specifically adequate for Korea. In this paper, the C-Map(Clutter Map) method using raw radar signals is proposed for removing ground clutter using a terrain-adaptive clutter map. A clutter map is generated using raw radar signals(I/Q) of clear days, then it is subtracted from received radar signals in frequency domain. The proposed method is applied to the radar data acquired from Sobaeksan rain radar and the result shows that the clutter rejection ratio is about 91.17 %.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.9
• /
• pp.3016-3033
• /
• 2014

The downlink performance of distributed antenna systems (DAS) with antennas selection is investigated in Rayleigh fading multicell environment, and the corresponding system capacity and bit error rate (BER) analysis are presented. Based on the moment generating function, the probability density function (PDF) and cumulative distribution function (CDF) of the effective signal to interference plus noise ratio (SINR) of the system are first derived, respectively. Then, with the available CDF and PDF, the accurate closed-form expressions of average channel capacity and average BER are further derived for exact performance evaluation. To simplify the expression, a simple closed-form approximate expression of average channel capacity is obtained by means of Taylor series expansion, with the performance results close to the accurate expression. Besides, the system outage capacity is analyzed, and an accurate closed-form expression of outage capacity probability is derived. These theoretical expressions can provide good performance evaluation for DAS downlink. It can be shown by simulation that the theoretical analysis and simulation are consistent, and DAS with antenna selection outperforms that with conventional blanket transmission. Moreover, the system performance can be effectively improved as the number of receive antennas increases.

• Proceedings of the Korea Society for Industrial Systems Conference
• /
• 2000.05a
• /
• pp.59-64
• /
• 2000

Active radar reflector may be less familiar, since their uses have been limited to military applications, especially the enhancement of the effective radar cross-sections of missile test range in the drone aircraft and missiles. Perhaps the most widely-blown applications of radar transponders are Identification Friend or Foe(IFF) and its civilian counterpart, secondary surveilliance radar for Air Traffic Control(ATC), and most recently, as Search And Rescue Transponder(SART) in the Global Maritime Distress and Safety System(GMDSS). Since it happens frequently accidents on the sea, the problems of the contamination more seriously considered. The conventional navigation buoy and utilities are not sufficient to maintain the safety of the sea and thus new structured concept must be considered. Therefore, this paper propose and implement the active radar reflector with a enhanced structure. The results are shown that the performance of the system is significantly improved comparing with the conventional utilities.

• Proceedings of KOSOMES biannual meeting
• /
• 2003.05a
• /
• pp.125-134
• /
• 2003

This paper describes on the design of Passive-type Radar Reflector for small Ship (PRR-S) based on the newly revised 2000 SOLAS regulations. The design idea, adopted in the study, is to hold PRR-S in the proper ‘catch rain’ position to avoid fluctuations of Radar Cross Section (RCS) due to ship's heeling. The PRR-S consists of octahedral-type radar reflector with circular plates and three-axis gimbaled stabilizer with weight on the bottom of outer gimbal ring. Performance test for the PRR is carried out in an anechoic chamber. The test results show that the reflected radar signal from PRR-S is more uniformly distributed than the reference model (Davis Echomaster).

• Journal of Astronomy and Space Sciences
• /
• v.26 no.4
• /
• pp.667-676
• /
• 2009

The payload can be classified as a passive and active type. Generally radar satellite to acquire specific information through various radar images will use the SAR (Synthetic Aperture Radar) as active type payload. the principal of SAR satellite is to receive the signal returned from certain objects and/or surfaces in order to construct an radar image. The data acquired from the satellite in its real orbit shall be needed to perform successful CAL/VAL (Calibration & Validation) because the SAR satellite have to receive the returned signal for SAR image construction. In order to do the above, the returned signal shall be related to ground targets. Especially ground target is the corner reflector (CR) for CAL/VAL. Generally the reflector has various types and shapes. Their selection can be dependent on characteristics and mission objectives of SAR satellite. In this paper, reflector focused on the optimal case and effective case has been studied and then the trihedral corner reflector under this study has been designed and its performance also analyzed.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.11
• /
• pp.2206-2212
• /
• 2017

When it comes to naval surface warfare, the probability of detection is an important factor in survivability and the Radar Cross Section(RCS) is a major parameter. In this paper, the RCS reduction technology of the Radar Absorbing Material(RAM) method is carried out for the general frequency range for naval warfare. We set the analysis model with the simplified ship model and the wide band metamaterial which is high-tech radar absorbing materials is selected for the RAM method. The modeling of the wide band metamaterial composed of an MIK surface which has the wide band resonant properties and flexible substance and the electromagnetic absorptions and reflections of the wide band metamaterial has been simulated to explore the performance. Also, the wide band metamaterial is compared with the paint absorber to analyze RCS reduction in terms of RCS values.