• KIEAE Journal
• /
• v.11 no.3
• /
• pp.63-68
• /
• 2011

Building deterioration would be proceeded by various causes such as physical, social, economic degradation. The deterioration would be inevitably prevented or delayed to get the decent function and performance in various building part and components. The maintenance and management are continued to provide the decent living condition for the household. The maintenance means mainly a repair, including the on-time and longterm plan. The longterm repair would be conducted by the systemic preparation in management activity and a required cost. Therefore, the annual due for the longterm repair plan is important to prepare the repair cost in a required time. In this paper, it aimed at analyzing the longterm repair cost and modelling to forecast the required cost in total area, number of household and time elapse in apartment housing. The estimation model of a repair cost is used with a power function which has a good statistics. Results of this study are shown that the sample has a longterm repair due in a $2,032won/m^2{\cdot}yr$ averagely which is higher than $912won/m^2{\cdot}yr$ in domestic. Second, the longterm repair due is proportionally correlated with the time elapse in both a total area and the number of household. Third, the estimation model for the longterm repair amount is suitable for the power function which is most in any other estimation models. Fourth, the ration of the longterm plan repair due a year to the cumulated longterm amount is about 26%.

• The KIPS Transactions:PartD
• /
• v.11D no.2
• /
• pp.351-360
• /
• 2004

Most mobile agents are migrated to many mobile agent systems by the sequential node migration method. However. in this case, if some problems such as host's fault or obstacle etc. happened, mobile agent falls infinity walt or orphan states. Therefore, it is difficult to get an expectation effect as use of other distribution technologies because the required time for networking between nodes increases. And so, many researches have been performed to solve this problems. However, most of methods decide node migration based on passive routing table or detour hosts which have some problems. Actually, the researches for reducing the total required time for networking are insufficient yet. In this paper, to reduce the required time for networking of mobile agent we design an active routing table based on the information of implemented objects which are registered in the meta-table of naming agent. And also, for user's keyword, we propose an replication model that replicates many agent object according to the information and number of object references corresponding to meta-table. Replicated objects are migrated to mobile agent systems in parallel and it provides minimized required time for networking.

• Annals of Laboratory Medicine
• /
• v.38 no.6
• /
• pp.585-590
• /
• 2018

Background: Although testing to detect weak D antigens using the antihuman globulin reagent is not required for D- patients in many countries, it is routinely performed in Korea. However, weak D testing can be omitted in D- patients with a C-E- phenotype as this indicates complete deletion of the RHD gene, except in rare cases. We designed a new algorithm for weak D testing, which consisted of RhCE phenotyping followed by weak D testing in C+ or E+ samples, and compared it with the current algorithm with respect to time and cost-effectiveness. Methods: In this retrospective study, 74,889 test results from January to July 2017 in a tertiary hospital in Korea were analyzed. Agreement between the current and proposed algorithms was evaluated, and total number of tests, time required for testing, and test costs were compared. With both algorithms, RHD genotyping was conducted for samples that were C+ or E+ and negative for weak D testing. Results: The algorithms showed perfect agreement (agreement=100%; ${\kappa}=1.00$). By applying the proposed algorithm, 29.56% (115/389 tests/yr) of tests could be omitted, time required for testing could be reduced by 36% (8,672/24,084 min/yr), and the test cost could be reduced by 16.53% (536.11/3,241.08 USD/yr). Conclusions: Our algorithm omitting weak D testing in D- patients with C-E- phenotype may be a cost-effective testing strategy in Korea.

• Journal of Dental Anesthesia and Pain Medicine
• /
• v.22 no.2
• /
• pp.117-128
• /
• 2022

Background: Moderate sedation is an integral part of dental care delivery. Target-controlled infusion (TCI) has the potential to improve patient safety and outcome. We compared the effects of using TCI to administer remifentanil/manual bolus midazolam with manual bolus fentanyl/midazolam administration on patient safety parameters, drug administration times, and patient recovery times. Methods: In this retrospective chart review, records of patients who underwent moderate intravenous sedation over 12 months in a private dental clinic were assessed. Patient indicators (pre-, intra-, and post-procedure noninvasive systolic and diastolic blood pressure, respiration, and heart rate) were compared using independent t-test analysis. Patient recovery time, procedure length, and midazolam dosage required were also compared between the two groups. Results: Eighty-five patient charts were included in the final analysis: 47 received TCI-remifentanil/midazolam sedation, and 38 received manual fentanyl/midazolam sedation. Among the physiological parameters, diastolic blood pressure showed slightly higher changes in the fentanyl group (P = 0.049), respiratory rate changes showed higher changes in the fentanyl group (P = 0.032), and the average EtCO₂ was slightly higher in the remifentanil group (P = 0.041). There was no significant difference in the minimum SpO₂ levels and average procedure length between the fentanyl and remifentanil TCI pump groups (P > 0.05). However, a significant difference was observed in the time required for discharge from the chair (P = 0.048), indicating that patients who received remifentanil required less time for discharge from the chair than those who received fentanyl. The dosage of midazolam used in the fentanyl group was 0.487 mg more than that in the remifentanil group; however, the difference was not significant (P > 0.05). Conclusion: The combination of TCI administered remifentanil combined with manual administered midazolam has the potential to shorten the recovery time and reduce respiration rate changes when compared to manual administration of fentanyl/midazolam. This is possibly due to either the lower midazolam dosage required with TCI remifentanil administration or achieving a stable, steady-state low dose remifentanil concentration for the duration of the procedure.

• Journal of the Korea Society of Computer and Information
• /
• v.27 no.8
• /
• pp.69-75
• /
• 2022

In this paper, a method for predicting the speed for each lane from the link speed using an artificial neural network is presented to increase the accuracy of predicting the required time of a driving route. The time required for passing through a link is observed differently depending on the direction of going straight, turning right, or turning left at the intersection of the end of the link. Therefore, it is necessary to predict the speed according to the vehicle's traveling direction. Data required for learning and verification were constructed by refining the data measured at the Gongpyeong intersection of Gukchaebosang-ro in Daegu Metropolitan City and four adjacent intersections around it. Five neural network models were used. In addition, error analysis of the prediction was performed to select a neural network experimentally suitable for the research purpose. Experimental results showed that the error in the estimation of the time required for each lane decreased by 17.4% for the straight lane, 4.4% for the right-turn lane, and 3.9% for the left-turn lane. This experiment is the result of analyzing only one link. If the entire pathway is tested, the effect is expected to be greater.

• Proceedings of the Computational Structural Engineering Institute Conference
• /
• 2008.04a
• /
• pp.203-208
• /
• 2008

Recently, high-rise building structures connected by a sky-bridge are frequently constructed. To predict accurate dynamic responses of structures connected a sky-bridge, time history analysis is required. Repetitive analyses are required in the design process. If the entire structure model is employed in the repetitive time history analysis, it would take a lot of computational time and engineers' efforts. Therefore, an equivalent model for high-rise building structures connected by a sky-bridge was proposed in this study. The proposed model consists of cantilever having original structure's stiffnesses and masses. Based on the analytical results, it has been shown that the equivalent model can reduce the analysis time and provide similar seismic responses to the original model.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2000.11a
• /
• pp.681-688
• /
• 2000

This study presented the new method for evaluating the coefficient of consolidation by using inflection point method which was based on the fact that time factor, T corresponding to the inflection point of a semilogarithmic plot of a time curve is fixed and equals to T ＝ 0.405 at 70% consolidation. In the proposed method, the next load increment is applied as soon as the necessary time required to identify the inflection point. Thus, the coefficient of consolidation may be easily evaluated. The time required to complete the testing using this rapid consolidation method could be as low as 1.5-3 hours compared with 1 or 2 weeks in the case of the conventional consolidation test.

• 한국전산유체공학회:학술대회논문집
• /
• 2004.10a
• /
• pp.33-36
• /
• 2004

The ballast tank of a ship is a system that realizes the required shipping condition and controls the draft of a ship. The loading/unloading of the ballast tank is frequently operated during navigation and the accurate prediction of the loading/unloading time is very important. A numerical algorithm that predicts the loading/unloading time of the ballast tank has been developed and applied to the prediction of the loading/unloading time of the ballast tank with various piping systems. This algorithm can be useful in optimizing the ballast tank system in early design stage.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2003.09a
• /
• pp.217-221
• /
• 2003

Variation of decision variables for optimal remediation using the pump-and-treat method is examined to estimate the effect of the degree of concentration constraint. Simulation-optimization method using genetic algorithm is applied to minimize the total pumping volume. In total volume minimization strategy, the remediation time increases rapidly prior to significant increase in pumping rates. When the concentration constraint is set severer, the more wells are required and the well on the down-gradient direction from the plume hot-spot gives more efficient remediation performance than that on the hot-spot position. These results show that the more profitable strategy for remediation can be achieved by increasing the required remediation time than raising the pumping rate until the time reaches a certain limitation level. So, the remediation time has to be considered as one of the essential decision variables fer optimal remediation design.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2005.10a
• /
• pp.156-159
• /
• 2005

The outer race of CV(constant velocity) joint is an important load-supporting automotive put that transmits torque between the transmission gear box and driving wheel. The outer race is difficult to forge because its shape is very complicated and the required dimensional tolerances are very small. To guarantee the dimensional accuracy of the forged CV Joint, the quick and precise measurement is required to increase the inspection speed of forged products. Therefore in this study, PP(Pre-Position) Device to decrease the inspection time of measuring system has been developed to cope with forging cycle time. The measured inspection time confirms that the PPD is very effective in decreasing inspection time.