• Journal of the Korean Ceramic Society
• /
• v.18 no.3
• /
• pp.192-200
• /
• 1981

This study deals with the low temperature ($25^{\circ}C$-$600^{\circ}C$) properties of Kaolin-Phosphate-water systems. Phosphoric acid, mono aluminum phosphate, mono ammonium phosphate, the mixture of phosphoric acid and mono aluminum phosphate, and the mixture of phosphoric acid and mono ammonium phosphate were used to characterize the M.O.R. of the systems with to quantity of phosphates, curing time, and firing temperature. Firing shrinkage, viscosity, surface tension, DTA, TGA, and X-ray diffraction patterns were also measured in order to investigated the factors of strengthening. The results of this study were summarized as follows: 1. The M.O.R. of kaolin-phosphate systems were stronger than that of Kaolin-water system at room temperature or low temperature($25^{\circ}C$-$600^{\circ}C$). Though it was increased according to the longer curing time, the higher temperature, and the more addition of phosphate, the M.O.R. were decreased in the case of 10 wt% phosphate addition in the system of phosphoric acid, mono aluminum phosphate and phosphoric acid-mono aluminum phosphate. 2. When the concentration of Phosphate was at 4 wt%, the M.O.R. of specimen cured at $25^{\circ}C$ and added to the phosphoric acid was strongest among the specimens in added to the others phosphates. Whereas, when the concentration of phosphate was above 6wt%, the M.O.R. of specimen cured at $25^{\circ}C$ and added to the phosphoric acid mono ammonium phosphate system cured at $25^{\circ}C$ was the strongest. 3. The M.O.R. of the specimen heated, in the temperature range of 15$0^{\circ}C$-1$600^{\circ}C$, and added to the mixture of phosphoric acid-mono aluminum phosphate system or phosphoric acid-mono ammonium phosphate system was stronger than that of specimen added to Phosphoric acid, mono-aluminum Phosphate or mono-ammonium phosphate alone. 4. The bonding force of phosphate binders was more closely related to surface tension than viscosity and it tended to be inversely proportional to surface tension. The bonding force after heating treatment seemed to be caused by the change of structure of phosphate according to heating.

• Asian-Australasian Journal of Animal Sciences
• /
• v.13 no.4
• /
• pp.470-473
• /
• 2000

The experiment was carried out to evaluate the effect of varying levels of flaked com abomasally infused on energy metabolism and nitrogen metabolism in fattening steers. The starch levels of flaked corn of abomasally infused were 0, 300, 600 and 900 g/d. Four mature fattening steers fitted with permanent abomasum cannulas were allocated to a $4{\times}4$ Latin square design were fed at 1.2 maintenance requirement a basal diet of Chinese wildrye (Aneurolepidium Chinense). Compared with 0 g/d (control group), digestible nitrogen, retention nitrogen (RN, g/d) and the efficiency of digestible nitrogen converted into retention nitrogen (RN/DN, %) of 300, 600 and 900 g/d groups were higher (p<0.05). The post-ruminal starch digestion of flaked corn were 71.36, 80.27 and 64.71 % when the amounts abomasally infused were 300, 600 and 900 g/d, respectively. When the amount of starch abomasally infused was more than 600 g/d, the post-ruminal digestion of starch decreased. 300, 600 and 900 g/d starch infusion groups showed higher metabolizable energy intake (ME) and net energy gains (NEg, MJ/d) than the control group, and the efficiencies of metabolizable energy converted into body weight (Kf, %) of these groups were higher than the control group by 38.31, 73.18 and 67.06% (p<0.05). Kf (Y, %) had a positive curved relation to starch of flaked com abomasally infused (X, g/d), $Y=36.1605X^{0.0760}$ (n=16, r=0.9308).

• Journal of electromagnetic engineering and science
• /
• v.8 no.3
• /
• pp.119-128
• /
• 2008

In this paper, we propose a developing approach of 600 W super high frequency(SHF) traveling wave tube amplifier (TWTA) for communications. Also, we make a TWTA called the experimental-TWTA(ETWTA), which uses a cathode ripple reduction technique to improve RF performance. After implementation, we discuss, and compare it with some other TWTAs. Its RF performance is better than that of other TWTAs. Therefore, this methodology can be used to develop the high power SHF TWTA for communications.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.07a
• /
• pp.471-474
• /
• 2000

A flat type microgas sensor was fabricated on the p-type silicon wafer with low stress S $i_3$ $N_4$, whose thickness is 2${\mu}{\textrm}{m}$ using MEMS technology and its characteristics were investigated. W $O_3$thin film as a sensing material for detection of N $O_2$gas was deposited using a tungsten target by sputtering method, followed by thermal oxidation at several temperatures (40$0^{\circ}C$~$600^{\circ}C$) for one hour. N $O_2$gas sensitivities were investigated for the W $O_3$thin films with different annealing temperatures. The highest sensitivity when operating at 20$0^{\circ}C$ was obtained for the samples annealed at $600^{\circ}C$. As the results of XRD analysis, the annealed samples had polycrystalline phase mixed with triclinic and orthorhombic structures. The sample exhibit higher sensitivity when the system has less triclinic structure. The sensitivities, $R_{gas}$ $R_{air}$ operating at 20$0^{\circ}C$ to 5 ppm N $O_2$of the sample annealed at $600^{\circ}C$ were approximately 90. 90.

• YAKHAK HOEJI
• /
• v.38 no.6
• /
• pp.800-805
• /
• 1994

Antacid(AM, 600 mg/kg=aluminium hydroxide, magnesium hydroxide, and simethicone with a ratio of 1 : 1 : 0.1) and aceglutamide aluminium(AGA, 263 mg/kg)-Effect of the combined preparation containing on the gastric mucosal hexosamine, sialic acid, and aluminium contents adhered to the gastric wall of the rat was investigated. Severe ulcers were produced in rats by injecting of $30\;{\mu}l$ acetic acid(30%) into the subserosal layer of one position in the corpus. When given orally for 15 consecutive days, AM(1,200 mg/kg), AGA(525, 1,050 mg/kg), and the combined preparation significantly decreased the ulcer area. AGA(525, 1,050 mg/kg) and the combined preparation also increased the amount of hexosamine and sialic acid in the intact and ulcerated areas. On the other hand, the contents of hexosamine and sialic acid were not affected by AM (600, 1,200 mg/kg). The amount of aluminium adhered to the gastric wall of the rat was higher in the combined preparation when compared to the AM(600 mg/kg) and AGA(263 mg/kg). The aluminium contents adhered may play an important role protecting mucosa from aggresive action of gastric juice and potenting defensive factors through the increase of mucosa-forming components by AGA.

• International Journal of Air-Conditioning and Refrigeration
• /
• v.12 no.4
• /
• pp.192-197
• /
• 2004

A capillary tube, which is a common expansion device in small sized refrig-eration and air-conditioning systems, should be redesigned properly to establish an optimum operation cycle of a refrigerating system with alternative refrigerants. Based on experimental data for R-22, R-290, and R-407C, an empirical correlation is developed to predict mass flow rate through capillary tubes. Dimensionless parameters are derived from the Buckingham Pi theorem, considering the effects of operating conditions and capillary tube geometry on mass flow rate. Approximately $97\%$ of the present data are correlated within a relative deviation of $\pm\;10\%.$ The present correlation also predicts the data obtained from open literature within $\pm\;15\%.$ In addition, rating charts of refrigerant flow rate for R-12, R-22, R-134a, R-152a, R-407C, R-410A, R-290, and R-600a are developed.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.24 no.7
• /
• pp.938-944
• /
• 2000

Recently, micro fin tube is widely used to heat exchanger for high performance. And, as the alternative refrigerants for R-22, hydrocarbons such as R-290, R-600 and R-600a are very promising because of their low GWP and ODP. Thus, R-290 was used as working fluid in this study. Most design of heat exchanger had been based on heat transfer characteristics of pure refrigerant although refrigerant oil exists in the refrigeration cycles. So, the influence of oil on heat transfer characteristics have to be considered for investigating exact evaporation heat transfer characteristics. But, this is an unresolved problem of refrigeration heat transfer. Therefore the influence of the refrigeration oil to the evaporation heat transfer characteristics of R-290 were conducted in a horizontal micro tin tube. The mineral oil was used as refrigeration oil. The experimental apparatus consisted of a basic refrigeration cycle and a system for oil concentration measurement. Test conditions are as the follows; evaporation temperature $5^{\circ}C$, mass velocity 100 $kg/m^2s$, heat flux 10 $kW/m^2$, oil concentration 0, 1.3, 3.3, 5.7 wt.%, and quality $0.07{\sim}1.0$. When refrigeration oil was entered, oil foaming was observed at the low quality region. And, very small bubbles were observed as quality was increased. Pressure drop and heat transfer coefficient increased as the concentration of refrigeration oil increased to 5 wt.%.. The performance index of heat exchanger was the highest near 3.3 wt.%.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.17 no.1
• /
• pp.1-17
• /
• 1991

Multiport-600 Solar SimulatorR is one of the most recent and convenient in-strument for evaluation of sun protection factor(SPF). In this study, we examined the practicability of the SPF determining system using Multiport -600 and the effects of several factors-light sources, seasons and experimental animals-on the minimal erythema dose(MED) and SPF. We also tested the UV sensitivity according to the sites of Korean people, And the ultraviolet radiation reaching the earth's surface In Seoul have been observed for one year. As a result of this study, the determinig system for SPF using Multiport-600 was proved to be a good system in accuracy and time-saving. The biological activity of fluorescence UV lamp of PUVA-800R was significantly higher than natural light or solar simulator with Xe arc lamp, and the determined MED became lower in inverse proportion to room temperature rise. Skin sensitivity by ultraviolet adiation was hights. in order \circled1 back \circled2 inns, upper arm \circled3 outer upper arm \circled4 foream. We also observed that UV radiation intensity was highest at noon in july and 1 sun burn unit(MED) was 28 minutes at that time.

• Water for future
• /
• v.9 no.1
• /
• pp.86-100
• /
• 1976

To study influences on the downstream, and the Gunsan harbor by setting up estuary of the Gumgang, available data which were collected from the measuring stations which were established within the river basin of which results attained are as follows: 1. The discharge can be calculated as the relationship between the discharge and precipitation in the basin is $R=4{\times}10^{-4}p^2$ or R=P-600 2. The discharge flow in to small resevoirs in the basin can be estimated as $QR=QS\frac{PR-600}{PS-600}(\frac{AR}{AS})$ 3. This daily average discharge at Kongju is 31% less than the during maximum probable discharge and that in Okcheon is 48% less than the daily maximum probable flood. 4. The maximum probable flood from the small stream in the basin can be estimated by a $Q=82.45A^{0{\cdot}464}$ 5. Sediments can be computed with Qs (suspended load)=1.41 $Q^{1{\cdot}42}$ and Qb (bed load)=165.2 $Q^{0{\cdot}705}$. 6. By setting up the specific estuary the tidal movement will be reduced to 93.6% on the average and the sedimentation is reduced to 96.0%. Upon review of overall analysis, the dead wate level of estuary of Gumgang will completely sedimented in next 30 years, therefore, the dredging work at Gunsan harbor is reduced to 73.6%, it is considered that life length will be extended about 52years taking account the existing condition.

• Bulletin of the Korean Chemical Society
• /
• v.19 no.1
• /
• pp.39-44
• /
• 1998

$LiCoO_2$ powder was synthesized in an aqueous solution by a sol-gel method and used as a cathode active material for a lithium ion rechargeable battery. The layered $LiCoO_2$ powders were prepared by igniting in air for 12 hrs at 600 ℃ $(600-LiCoO_2)$ and 850 ℃ $(850-LiCoO_2)$. The structure of the $LiCoO_2$ powder was assigned to the space group R bar 3 m (lattice parameters a=2.814 Å and c=14.04Å). The SEM pictures of $600-LiCoO_2$ revealed homogeneous and fine particles of about 1 μm in diameter. Cyclic voltammograms (CVs) of $600-LiCoO_2$ electrode displayed a set of redox peaks at 3.80/4.05 V due to the intercalation/deintercalation of the lithium ions into/out of the $LiCoO_2$ structure. CVs for the $850-LiCoO_2$ electrode had a major set of redox peaks at 3.88/4.13 V, and two small set of redox peaks at 4.18/4.42 V and 4.05/4.25 V due to phase transitions. The initial charge-discharge capacity was 156-132 mAh/g for the $600-LiCoO_2$ electrode and 158-131 mAh/g for the $850-LiCoO_2$ electrode at the current density of 0.2 mA/cm2. The cycleability of the cell consisting of the $600-LiCoO_2$ electrode was better than that of the $850-LiCoO_2$. The diffusion coefficient of the $Li^+$ ion in the $600-LiCoO_2$ electrode was calculated as $4.6{\times}10^{-8}\; cm^2/sec$.