• 제목/요약/키워드: Pulsed Mode Operation

검색결과 27건 처리시간 0.025초

EMTDC를 이용한 8.5 MVA급 Magnetic Power Supply의 전력공급 시스템 분석 (Analysis of Power Supply System for 8.5 MVA Magnetic Power Supply Using EI)

  • 정응후;노의철;김인동;최정완
    • 대한전기학회:학술대회논문집
    • /
    • 대한전기학회 2002년도 하계학술대회 논문집 B
    • /
    • pp.1114-1116
    • /
    • 2002
  • The characteristics of voltage drop and THD for parallel operating 11 PCRs (Phase Controlled Rectifiers) are analysed. The PCRs are used to drive high current (1.6 kA ${\sim}$ 3.7 kADC) electromagnetic coils for electromagnets. All the PCRs operate simultaneously in pulsed mode, and the pulse shot occurs every 150 seconds. During the pulse operation the PCR output current ramps up for 4 seconds, and then keeps flat top state for 2 seconds, and finally ramps down for 4 seconds. For the flat top mode a severe voltage drop and distortion appear in the power system because transformers for the PCRs are designed considering pulsed mode operation. It is expected that the analysis method can be applied to improve the system performance including power factor and design of high power pulsed mode operating power supply systems.

  • PDF

Modified 멀티레벨 컨버터 기반 펄스모드 동작 직류전원장치 (A Pulsed Mode Operating DC Power Supply Based on Modified Multilevel Converter)

  • 안종수;노의철;김인동;김흥근;전태원
    • 전력전자학회:학술대회논문집
    • /
    • 전력전자학회 2003년도 춘계전력전자학술대회 논문집(1)
    • /
    • pp.264-268
    • /
    • 2003
  • This paper describes a high voltage high power DC power supply which has the ability of pulsed mode operation. The power supply Is constructed with several series connected power converters based on modified multilevel converters. The modified multilevel converters are suitable for the protection of frequent output short-circuit. The output dc power of the proposed converter can be disconnected from the load within several hundred microseconds at the instant of short-circuit fault. The rising time of the dc load voltage is as small as several hundred microseconds, and there is no overshoot of the do voltage because the dc output capacitors keep undischarged state. Analysis, simulations, and experiments are carried out to Investigate the operation and usefulness of the proposed scheme.

  • PDF

헬기탑재 다중모드 레이다 시스템 모델 설계 (Multi-Mode Radar System Model Design for Helicopter)

  • 곽영길;배재훈
    • 한국전자파학회:학술대회논문집
    • /
    • 한국전자파학회 2003년도 종합학술발표회 논문집 Vol.13 No.1
    • /
    • pp.208-212
    • /
    • 2003
  • An airborne radar is an essential aviation electronic system of the helicopter to perform various missions in all-weather environments. This paper presents the conceptual design results of the multi-mode pulsed Doppler radar system testbed model for helicopter. Due to the inherent flight nature of the hovering vehicle which is flying in low-altitude and low speed, as well as rapid maneuvering, the moving clutters from the platform should be suppressed by using a special MTD (Moving Target Detector) processing. For the multi-mode radar system model design, the flight parameters of the moving helicopter platform were assumed: altitude of 3 Km, average cruising velocity of 150knots. The multi-mode operation capability was applied such as short-range, medium-range, and long-range depending on the mission of the vehicle. The nominal detection ranges is 30 Km for the testbed experimental model, but can be expanded up to 75 Km for the long range weather mode. The detection probability of each mode is also compared in terms of the signal-to noise ratio of each mode, and the designed radar system specifications ate provided as a design results.

  • PDF

인젝션 록킹 방법에 의한 펄스 색소레이저의 단일 종모우드 발진 (Single Longitudinal Mode Operation of a Pulsed Dye Laser Injection-seeded with a CW Ring Dye Laser)

  • 김재완;공홍진;한재원;박승남
    • 한국광학회지
    • /
    • 제5권1호
    • /
    • pp.84-89
    • /
    • 1994
  • 연속발진 색소레이저를 시드레이저로 하고, Nd:YAG 레이저로 펌핑하는 인젝션 록킹된 단일 모우드 펄스 색소레이저를 제작하였다. 위상민감 검출법으로 얻은 오차신호로 시드빔과 공진 상태를 유지하도록 공진기 길이를 조절하였을 때 99% 이상의 펄스가 시드레이저의 주파수에 록킹 되었다. 이때 레이저 출력빔의 중심 주파수 요동이 10MHz 이내로 안정되었다. 펄스폭(FWHM)은 6ns이고 선폭은 130 MHz이었다. 50mJ로 펌핑하였을 때 2mJ의 출력을 얻었으며 이때의 첨두출력은 0.33 MW이다.

  • PDF

단일 타원 펄스형 Nd:YAG 레이저의 $TEM_{00}$ 모드화 (A study on the $TEM_{00}$ mode of the pulsed Nd:YAG laser with a single elliptical cavity)

  • 이동훈;문진규;곽병구;김희제;조정수;박정후
    • 대한전기학회:학술대회논문집
    • /
    • 대한전기학회 1996년도 하계학술대회 논문집 C
    • /
    • pp.1759-1761
    • /
    • 1996
  • Md:YAG laser has been used in many applications such as micromachining, nonlinear optical experiments, holography, and rangefinding. These applications quite often require operation of the laser at the $TEM_{00}$ mode since this mode produces the smallest beam divergence, the highest power density, and, hence, the highest brightness. In this study, a pinhole is put between a rod and a half mirror to make the $TEM_{00}$ mode, and then we measured the intensity distribution of the output beam as reducing the diameter of the pinhole from 6mm to 1.5mm. As a result, the optimum size of the pinhole fixed in a resonator to make the $TEM_{00}$ mode was obtained, and we found out that the output beam of the pulsed Nd:YAG laser with a single elliptical cavity has a Gaussian distribution.

  • PDF

포화 흡수체의 투과변조깊이 조절을 통한 다양한 펄스상태 조작 방법에 관한 전산 모사 (Simulation of Manipulating Various Pulsed Laser Operations Through Tuning the Modulation Depth of a Saturable Absorber)

  • 진진화;염동일;김병윤
    • 한국광학회지
    • /
    • 제28권6호
    • /
    • pp.351-355
    • /
    • 2017
  • 본 논문에서는 포화흡수체의 투과변조깊이 조절을 통해 다양한 펄스 상태를 한 공진기 안에서 구현하는 방법에 관한 전산 모사를 진행하였다. 포화흡수체의 투과변조깊이의 크기 변화만으로 큐스위치드 레이저, 큐스위치드 모드 잠금 레이저, 모드 잠금 레이저 등 원하는 펄스 레이저 상태로 전환이 가능하다는 실험적 연구가 있어 왔으며, 이러한 연구가 이론적으로 부합하는 내용임을 확인하기 위해 Haus master 식을 사용하여 전산 모사를 진행하였다. 큐스위칭된 광 파워를 모사하기위해 이득 값은 시간 의존성을 가지도록 반응속도식을 적용하였다. 그 결과 투과변조깊이가 증가함에 따라 모드 잠금 레이저에서부터, 큐스위치드 레이저, 큐스위치드 레이저로 동작함을 확인하였고, 이는 이론적으로 예측된 경향성과 일치하였다.

직류 마이크로그리드에서 펄스형 부하 보상용 슈퍼커패시터 무순단 제어법 (A Seamless Control Method for Supercapacitor to Compensate Pulsed Load in DC Microgrid)

  • 담두이헝;이홍희
    • 전력전자학회논문지
    • /
    • 제23권4호
    • /
    • pp.265-272
    • /
    • 2018
  • This paper proposes a new control method for the supercapacitor (SC) to compensate the pulsed load and to enhance the power quality of the DC microgrid. By coordinating the operating frequency, the SC is controlled to handle the surge current, while the low-frequency current component is dealt with by the remaining sources in the system. The operation mode of the SC unit is automatically changed based on the state of charge and DC bus voltage level. Meanwhile, the mismatch in the power demand is covered by the SC unit by regulating the DC bus voltage level. The effectiveness of the proposed method is verified experimentally by the prototype with two distributed generators and one SC unit.

펄스 및 직류 중첩형 전기집진기용 고전압 전원장치 개발 연구 (A High Voltage Poorer Supply for Electrostatic Precipitator with Superimposing Voltage Pulse on DC Source)

  • 김종수;임근희;이성진;김승민;조창호
    • 대한전기학회논문지:전기기기및에너지변환시스템부문B
    • /
    • 제50권12호
    • /
    • pp.624-630
    • /
    • 2001
  • The trend of the regulations on environmental issues are getting tight. Responding to this trend new technologies such as moving electrodes, wide pitch and pulsed power supply are also introduced in the electrostatic precipitator(EP) systems. The introduction of wide pitch and moving electrodes enhances the system performance of the EPs by improving air-flow and by improving the ash reentrainment on rapping. The power supplies for the EPs developed up to date include thyristor-based dc or intermittent type, SMPS(switching mode power supply) type and the pulsed-power supply type. The use of the pulsed ones is known to improve dust-collecting efficiency of high resistivity ash and reduces back corona occurrence in the collecting plate. There are two kinds of pulsed-power supplies; one with pulsed transformers and the other with direct dc switching devices. The latter uses rotary spark gap switches or semiconductor switches. Both have the merits and demerits: the spark gap switches are simple and robust but has short life time, hence, high maintenance cost, whereas the semiconductor switches have long life time but are costly. In this study, A high voltage power supply with superimposing voltage pulse on dc source was developed for EPs. This study describes circuit topology, operating principle of the scheme, and analysis of experimental results on Dong-Hae Power Plant. The pulsed power supply consists of a variable dc power supply with ratings of 60kV, 800mA and pulse generator which is made of high voltage thyristor-diode switch strings, an LC resonant tank and a blocking inductor. The pulse generator generates variable pulse-voltage up to 70kV using a high frequency resonant inverter with a variable dc source. Two prototypes were built and tested on 250MW DongHae power plant to verify the possibility of the commercial use and the normal operation in the transient states.

  • PDF

새로운 방식의 고속 펄스모드 스위칭 기능을 갖는 고역률 직류전원장치 (A New High Speed Pulsed Mode Switching DC Power Supply with High Power Factor)

  • 안종수;노의철;김인동
    • 대한전기학회논문지:전기기기및에너지변환시스템부문B
    • /
    • 제53권1호
    • /
    • pp.47-54
    • /
    • 2004
  • A new high voltage DC power supply is proposed. The proposed power supply is constructed with several power converters connected in series. It is easy to obtain high DC voltage for the same structure of each power converter. The output DC power of the proposed power supply can be disconnected from the load within several hundred microseconds at the instant of a load short-circuit fault. The rising time of the output DC voltage is also as small as several hundred microseconds, and there is no overshoot of the voltage because all of the output filter capacitors keep undischarged state even in load short-circuit condition. Therefore, the proposed scheme is suitable for the protection of frequent output short-circuit and fast on/off switching of output DC voltage. The proposed power supply has improved features such as simple structure, high power factor, and reduced size and volume compared with the conventional schemes. The operating principle is described and the validity of the proposed scheme is proved through simulations and experiments.

On the cyclic change in the dynamics of the IBR-2M pulsed reactor

  • Yu.N. Pepelyshev;Sumkhuu Davaasuren
    • Nuclear Engineering and Technology
    • /
    • 제55권5호
    • /
    • pp.1665-1670
    • /
    • 2023
  • It is shown that in the IBR-2M reactor by the end of the reactor cycle, changes in dynamics are observed associated with a strong weakening of the fast power feedback (PF), as a result of which the reactor becomes oscillatorily unstable. After each week of zero-power operation the negative changes in reactor dynamics disappear and the stability of the reactor is restored. Thus, the reactor undergoes cyclic changes in the oscillatory instability. The correlation between of a fast PF and a slow PF is experimentally observed, which makes it possible to almost completely eliminate the cyclic component of instability by changing the control mode of rods of the control system.