• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.8 no.4
• /
• pp.1344-1367
• /
• 2014

Mobile traffic is increasing a masse because of the propagation of the Internet and the development of wireless mobile technology. Accordingly, the Network Local Mobility Management (NETLMM) working group [1] of the Internet Engineering Task Force (IETF) has standardized Proxy Mobile IPv6 (PMIPv6) [2] as a protocol for accomplishing the transmissibility of mobile terminals. PMIPv6 is a network-led IP-based mobility management protocol, which can control terminal mobility without depending on the type of access system or the capability of the terminal. By combining PMIPv6 and the mobility of Session Initiation Protocol (SIP), we can establish terminal mobility and session mobility through a more effective route. The mobility function can be improved and the overlap of function reduced as compared to that in the case of independent operation. PMIPv6 is appropriate for a non-real-time service using TCP, and SIP is appropriate for a real-time service using RTP/UDP. Thus, in the case of a terminal using both services, an effective mobility management is possible only by using PMIPv6 together with SIP. In order to manage mobility in this manner, researches on PMIPv6-SIP are in progress. In line with this trend, this paper suggests a new PMIPv6-SIP architecture where when a mobile terminal conducts a handover, a network-led handover while maintaining the session without the addition of a special function or middleware is possible along with effective performance evaluation through mathematical modeling by comparing the delay and the packet loss that occur during the handover to the Pure-SIP.

• Journal of Korean Society on Water Environment
• /
• v.24 no.1
• /
• pp.91-98
• /
• 2008

This work was performed to develop a model possible to predict the influent flow and influent components, which are one of main disturbances causing process problems at the operation of municipal wastewater treatment plant. In this study, artificial neural network (ANN) was used in order to develop a model that was able to predict the influent flow, $COD_{Mn}$, SS, TN 1 day-ahead, 2day-ahead and 3 day ahead. Multi-layer feed-forward back-propagation network was chosen as neural network type, and tanh-sigmoid function was used as activation function to transport signal at the neural network. And Levenberg-Marquart (LM) algorithm was used as learning algorithm to train neural network. Among 420 data sets except missing data, which were collected between 2005 and 2006 at field plant, 210 data sets were used for training, and other 210 data sets were used for validation. As result of it, ANN model for predicting the influent flow and components 1-3day ahead could be developed successfully. It is expected that this developed model can be practically used as follows: Detecting the fault related to effluent concentration that can be happened in the future by combining with other models to predict process performance in advance, and minimization of the process fault through the establishment of various control strategies based on the detection result.

• The Journal of Information Technology
• /
• v.5 no.4
• /
• pp.1-8
• /
• 2002

This thesis is about power line communication(PLC) over the low voltage grid. The main advantage with power line communication is the use of an existing infrastructure. The PLC channel can be modeled as having multi-path propagation with frequency-selective fading, typical power lines exhibit signal attenuation increasing with length and frequency. OFDM(Orthogonal Frequency Division Multiplexing) is a modulation technique where multiple low data rate carriers are combined by a transmitter to form a composite high data rate transmission. To implement the multiple carrier scheme using a bank of parallel modulators would not be very efficient in analog hardware. Each carrier in an OFDM is a sinusoid with a frequency that is an integer multiple of a base or fundamental sinusoid frequency. Therefore, each carrier is a like a Fourier series component of the composite signal. In fact, it will be shown later that an OFDM signal is created in the frequency domain, and then transformed into the time domain via the Discrete Fourier Transform(DFT).

• Journal of the Korean Geophysical Society
• /
• v.3 no.4
• /
• pp.251-260
• /
• 2000

Applicabilities of two numerical methods, the 2-dimensional and the 3-dimensional method, are evaluated to inverse test results obtained from the underwater SASW(Spectral -Analysis-of-Surface-Waves) method. As a result of this study, it has been found that the 2-dimensional method can supposed to be applicable for the cases where stiffness of soil layer increases gradually with depth, and the stiffness is relatively low. For the other cases, however, it has been concluded that the 3-dimensional method needs to be applied to determine realistic theoretical dispersion curves. An example is also shown that in situ soil profile underwater is estimated from experimental dispersion curves using the 3-dimensional method. As a results, it can be concluded that the underwater SASW method can be effectively applied to explore the underwater soil condition.

• Journal of the Korea Society of Computer and Information
• /
• v.13 no.2
• /
• pp.51-57
• /
• 2008

We present a modeling of constraint satisfaction problems and provide heuristic algorithms of backtracking search to optimize the frequency assignment. Our research objective is to find a frequency assignment that satisfies all the constraints using minimum number of frequencies while maximizing the number of community radio stations served for a given area. In order to get a effective solution, some ordering heuristics such as variable orderings and value orderings are provided to minimize the backtracking in finding all solutions within a limited time. To complement the late detection of inconsistency in the backtracking, we provide the consistency enforcing technique or constraint propagation to eliminate the values that are inconsistent with some constraints. By integrating backtracking search algorithms with consistency enforcing techniques, it is possible to obtain more powerful and effective algorithms of constraint satisfaction problems. We also provide the performance evaluation of proposed algorithms by comparing the theoretical lower bound and our computed solution.

• Journal of Korea Water Resources Association
• /
• v.39 no.12 s.173
• /
• pp.1013-1022
• /
• 2006

Urban flooding is usually caused by the surcharge of storm sewers. For this reason, previous studies on urban flooding are mainly concentrated on the simulation of urban drainage systems. However these approaches that find the pipes which have insufficient drainage capacity are very approximate and unreasonable ways in establishing both flood prevention and flood-loss reduction planning. In this study, a two-dimensional model linked the existing ILLUDAS model is developed to calculate the accurate and resonable solution about urban flood inundation and it is verified by using the simulation of July 2001 flood in Seoul. In the urban area with a small difference of ground elevations, the two-dimensional flood propagation phases must be considered to make a accurate analysis for inundated area and depth. The result of this study can be used to construct fundamental data for a flood control plan and establish a urban flood forecasting/warning system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.10A
• /
• pp.1461-1472
• /
• 2000

Recently, the mobile users seem to be rapidly increasing and then the capacity limit will be reached at close hand. In these situations, to provide them with good quality of service in the coming future, newly planned cell design is needed. In the next generation mobile communication systems, namely IMT-2000, good quality services will be possible only by designing the cell structure hierarchically with the help of appropriate cell planning. In the research process, the standardization reports on the future mobile cellular IMT-2000 system (3GPP) are investigated and the parameters, that are essential to cell planning, are also researched. Modeling of IMT-2000 radio link and the numerical analysis on that make it possible to calculate the forward/reverse link budget, system capacity call blocking probability Erlang capacity and cell coverage. In planning the cell of IMT-2000 system, various parameters are considered, such as hierarchical cell structure, number of users, data service forms and propagation area environments. From the results, efficient cell planning methods are proposed. Through this thesis efficient cell planning and maximum capacity will be achieved in the beginning of commercial IMT-2000 service.

• Journal of the Korean Society of Safety
• /
• v.28 no.3
• /
• pp.39-43
• /
• 2013

The present study has been conducted to investigate the fire combustion properties and fire behavior of an IEEE-383 qualified flame retardant cable. The reference reaction rate and reference temperature which are commonly used in pyrolysis model of fire propagation process was obtained by the thermo-gravimetric analysis of the cable component materials. The mass fraction of FR-PVC sheath abruptly decreased near temperature range of $250{\sim}260^{\circ}C$ and its maximum reaction rate was about $2.58{\times}10^{-3}$[1/s]. For the XLPE insulation of the cable, the temperature causing maximum mass fraction change was ranged about $380{\sim}390^{\circ}C$ and it has reached to the maximum reaction rate of $5.10{\times}10^{-3}$[1/s]. The flame retardant cable was burned by a pilot flame meker buner and the burning behavior of the cable was observed during the fire test. Heat release rate of the flame retardant cable was measured by a laboratory scale oxygen consumption calorimeter and the mass loss rate of the cable was calculated by the measured cable mass during the burning test. The representative value of the effective heat of combustion was evaluated by the total released energy integrated by the measured heat release rate and burned mass. This study can contribute to study the electric cable fire and provide the pyrolysis properties for the computational modeling.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.53 no.1
• /
• pp.29-36
• /
• 2011

HPAI (High pathogenic avian influenza) which is a disease legally designated as an epidemic generally shows rapid spread of disease resulting in high mortality rate as well as severe economic damages. Because Korea is contiguous with China and southeast Asia where HPAI have occurred frequently, there is a high risk for HPAI outbreak. A prompt treatment against epidemics is most important for prevention of disease spread. The spread of HPAI should be considered by both direct and indirect contact as well as various spread factors including airborne spread. There are high risk of rapid propagation of HPAI flowing through the air because of collective farms mostly in Korea. Field experiments for the mechanism of disease spread have limitations such as unstable weather condition and difficulties in maintaining experimental conditions. In this study, therefore, computational fluid dynamics which has been actively used for mass transfer modeling were adapted. Korea has complex terrains and many livestock farms are located in the mountain regions. GIS numerical map was used to estimate spreads of virus attached aerosol by means of designing three dimensional complicated geometry including farm location, road network, related facilities. This can be used as back data in order to take preventive measures against HPAI occurrence and spread.

• Geophysics and Geophysical Exploration
• /
• v.22 no.2
• /
• pp.49-55
• /
• 2019

In this study, we presented a reference-shot subset method for stable convergence of full waveform inversion using a cyclic-shot subsampling technique. Full waveform inversion needs repetitive modeling of wave propagation and thus its calculation time increases as the number of sources increases. In order to reduce the computation time, we can use a cyclic-shot subsampling method; however, it makes the cost function oscillate in the early stage of the inversion and causes a problem in applying the convergence criteria. We introduced a method in which the cost function is calculated using a fixed reference-shot subset while updating the model parameters using the cyclic-shot subsampling method. Through the examples of full waveform inversion using the Marmousi velocity model, we confirmed that the convergence of cost function becomes stable even under the cyclic-shot subsampling method if using a reference-shot subset.