• Applied Science and Convergence Technology
• /
• 제23권1호
• /
• pp.34-39
• /
• 2014

The programmable switches which control the delivery of electrical signals in programmable logic devices are fabricated using memory technology. Although phase change memory (PCM) technology is one of the most promising candidates for the manufacturing of the programmable switches, the threshold switching material should be added to a PCM cell for realization of the programmable switches based on PCM technology. In this work, we report the impurity-doped $Ge_2Sb_2Te_5$ (GST) chalcogenide alloy exhibiting threshold switching property. Unlike the GST thin film, the doped GST thin film prepared by the incorporation of In and P into GST is not crystallized even at the postannealing temperature higher than $200^{\circ}C$. This specific crystallization behavior in the doped GST thin film is attributed to the stabilization of the amorphous phase of GST by In and P doping.

• 전자공학회논문지A
• /
• 제33A권4호
• /
• pp.142-151
• /
• 1996

This paper presents a new symmetrical routing architecture for FPGA and an efficient routing algorithm for the architecture. The routing architecture adopts the segmented wires and the improved switch modules. Segmetned wires construct routing channels which pass through the chip in vertical and horizontal directions. To maximize the utility of a track, a track in each switch module can be separated in two part using a programmable switch to route two different net. The proposed routing algorithm finds all assignable tracks for a given net and selects the best track from assignable tracks to minimize the number of programmable switches and the unused portion of the wire segments. In order to stabilize the perfomrance of the algorithm, the routing order is defined by weighted sum of the number of wire segment, the length of wire segmetn, and the number of pin. Experimental results show that routability is improved dramatically and the number of crossing switches are reduced about 40% compared with the previous works.

• 사물인터넷융복합논문지
• /
• 제6권1호
• /
• pp.97-102
• /
• 2020

사물인터넷 환경에서 다중 객체의 스위치 제어는 고전압을 구동하기 위해 레벨 시프터가 있는 여러 솔리드 스테이트 구조로써 낮은 ON 저항과 양방향 릴레이 MOS 스위치를 통합했으며 외부 직렬 논리 제어에 의해 독립적으로 제어되어야 한다. 이 장치는 의료용 초음파 이미지 시스템, 잉크젯 프린터 제어 등의 IoT 기기뿐만 아니라, 켈빈 4 단자 측정을 사용한 PCB 개방 / 단락 및 누출 테스트 시스템과 같은 저전압 제어 신호에 의한 고전압 스위칭 제어가 필요한 응용 제품에 사용하도록 설계되었다. 이 논문에서는 FPGA (Field Programmable Gate Array) 테스트 패턴 생성을 사용한 아날로그 스위치 제어 블록의 구현 및 검증에 대하여 고찰하였다. 각 블록은 Verilog 하드웨어 설명 언어를 사용하여 구현된 후 Modelsim에 의해 시뮬레이션 되고 FPGA 보드에서 프로토타입화 되어 적용되었다. 제안된 아키텍처는 IoT 환경에서 여러개의 개체들을 동시에 제어하여야 하는 분야에 적용할 수 있으며 유사 형태의 IC를 테스트하기 위해 제안된 패턴 생성 방법을 적용할 수 있다.

• 대한전기학회논문지
• /
• 제32권7호
• /
• pp.254-260
• /
• 1983

In this paper a basic design procedure for programmable instruments of IEEE-488 BUS system has been discussed by designing a specific programmable frequency counter with its hardware and software. The designed programmable frequency counter has a programmable range switch and a function of the programable number of measurements. It contains five basic functions(Talker. Listener, Source handshake, Accepter handshake and Controller) of a IEEE-488 BUS and the Device-Trigger as a supplimentary function. The hardware has been built along with 6800 MPU and 68488 GPIA, and its software has included initialization, interrupt handler, BI.GET,BO and controller routines, The designed system given in this paper has been successfuly tested via some experiments.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2002년도 추계학술대회 논문집(II)
• /
• pp.995-1000
• /
• 2002

This paper presents general concept of DC switch gear(DCSWGR). Normally, DCSWGR consist of Digital protection unit(DPU), High Speed Circuit Breaker(HSCB), Disconnect Switch (DS), Programmable Logic Control(PLC), Auxiliary Relays and etc. Most of the components has its special characteristics and their interface between each others are various and complex. In this paper every constituent general design are preceded and interface between each component are examined. And also DCSWGR operation logic with logical diagram including interlock signal are introduced.

• 한국전기전자재료학회논문지
• /
• 제14권12호
• /
• pp.953-958
• /
• 2001

The antifuse is a semi-permanent memory device like a ROM which shows the open or short state, and a switch device connecting logic blocks selectively in FPGA. In addition, the antifuse has been used as a logic device to troubleshoot defective memory cells arising from SDRAM processing. In this study, we have fabricated ONO antifuses consisted of PIP structure. The antifuse shows a high resistance more than several G Ω in the normal state, and shows a low resistance less than 500 Ω after program. The program resistance variation according to temperature shows the very stable value of $\pm$20 Ω. At this time, its program voltage shows 6.7∼7.2 V and the program is performed within 1 second. Therefore this result shows that the PIP antifuse is a very stable and programmable logic device.

• 한국ITS학회:학술대회논문집
• /
• 한국ITS학회 2008년도 제7회 추계학술대회 및 정기총회
• /
• pp.347-350
• /
• 2008

• 한국진공학회지
• /
• 제17권4호
• /
• pp.253-261
• /
• 2008

Programmable metalization cell (PMC) memory 소자로도 명명되는 고체 전해질 메모리 소자는 비휘발성, 고속 및 높은 ON/OFF 저항비 등을 갖고 있기 때문에, 차세대 비휘발성 메모리로서 각광받고 있는 소자 중의 하나이다. 본 논문에서는 고체 전해질 메모리 소자의 동작 원리를 먼저 소개하고자 한다. 또한, 메모리향 소자 개발을 진행 중인 미국 코지키 교수 그룹, 비메모리향 소자 개발을 진행 중인 일본 NEC 그룹 등의 해외 연구진과, Te 계열의 칼코게나이드 합금을 채택하여 소자를 제작한 한국전자통신연구원 및 충남대학교 등의 국내 연구진의 연구 성과를 소개하고자 한다.

• 전기학회논문지
• /
• 제58권8호
• /
• pp.1580-1584
• /
• 2009

We have theoretically analyzed the monolithic integration of vertical cavity lasers with depleted optical thyristor (VCL-DOT) structure and experimentally demonstrated optical logic gates such as AND-gate, OR-gate, and INVERTER implemented by VCL-DOT for an optical programmable gate array. The optical AND and OR gates have been realized by changing a input bias of the single VCL-DOTs and all kinds of optical logic functions are also implemented by adjusting an intensity of the reference input beams into the differential VCL-DOTs. To achieve the high sensitivity, high slope efficiency and low threshold current, a small active region of lasing part and a wide detecting area are simultaneously designed by using a selective oxidation process. The fabricated devices clearly show nonlinear s-shaped current-voltage characteristics and lasing characteristics of a low threshold current with 0.65 mA and output spectrum at 854 nm.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2001년도 하계종합학술대회 논문집(2)
• /
• pp.369-372
• /
• 2001

This paper presents the design of high-speed virtual output queue(VOQ) management scheme for high performance cell/packet switch, which has a serial cross bar structure. The proposed VOQ management scheme has been designed for wire-speed routing with a pipelined buffer management. It provides the tolerance of requests and grants data transmission latency between the VOQ manager and central arbiter using a new request control method that is based on a high-speed shifter. The designed VOQ manager has been implemented in a field programmable gate array chip with a 77MHz operating frequency, a 900-pin fine ball grid array package, and 16$\times$16 switch size.