• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.16 no.6
• /
• pp.69-74
• /
• 2017

In the current machining industry, machining precision is necessary and machining is being carried out. In this ultra-precision machining industry, the fixation of the workpiece is very important and the degree of machining depends on the degree of fixation of the workpiece. In ultra-precision machining, various methods, such as using a vise chuck or the like and using bolt nut coupling, are used for fixing a workpiece to an existing machine tool. In particular, when the precision gripping force of the jig is insufficient during machining of the ultra-precision mold parts, the machining material shakes due to the vibration or friction, and the machining precision is lowered. In the ultra-precision machining of power transmission parts, such as gears, the accuracy of the product is then determined. In addition, the amount of heat generated during machining has a significant effect on the machining accuracy. This is because the vibration value changes according to the grasp force of the jig that fixes the workpiece, and the change in the calorific value due to the change in the main shaft rotation speed of the ultra-precision machining. The increase in the spindle rotation speed during machining decreased the heat generation during machining, and the machining accuracy was also good, and it was confirmed that the machining heat changed according to the fixed state of the workpiece and the machining accuracy also changed. In this study, we try to optimize the driving part of the power vise by using structural analysis, rather than the power vise, using the basic mechanical-type power unit.

• 전기의세계
• /
• v.27 no.6
• /
• pp.54-57
• /
• 1978

An analytical investigation has been carried out for the motion of moving element in electro-dynamometer type directional power relay under A.C source. For the more a time dependent kinetic performance of the element can also be deduced for the D.C component in fault current. The results obtained thus for show that, in the relay with stopper, the performance time for the equal D.C and A.C component can be shorten ca. 0.5Hz in comparison with the fact, the performance time exhibits to delay ca. 0.75Hz under the same conditions for the case of the relay without stopper, it appear that these differences of performance times will not give vise any difficultys for the apects of practical case, however, the obtain results can be applicable in the course of the design of the relay.

• Journal of the Korean Chemical Society
• /
• v.43 no.2
• /
• pp.182-192
• /
• 1999

The new GD/ICP-AES quick change over system has been developed and characterized. Within less than 15 minutes, ICP-AES could be switched to GD-AES and vise a versa. As a result, both solid and liquid samples could be analyzed in a very short period of time by the ICP/GD-AES quick change over system developed in our laboratory. The influences of the experimental variables, such as flow rate of coolant gas, flow rate of auxiliary gas, flow rate of sample carrier gas, sampling depth, orifice size of sampling cone, and rf (radio frequency) power on emission intensity have been presented. The detection limits of Cd(I) 228.8 nm, Mn (II) 257.61 nm, and Fe(II) 259.95 nm were found to be 3.86, 1.49, and 5.79 ppb, respectively. And linealities of the calibration curves were measured to be unity.