• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.11B
• /
• pp.991-1000
• /
• 2004

This paper presents an application layer multicast tree constructing algorithm to minimize the average time delay from the sender to end-systems for the effective real-time media delivery. Simultaneously, the proposed algorithm takes into account the computing power and the network condition of each end-system as a control variable and thus avoids the undesirable case that loads are concentrated to only several end-systems. The multicast tree is constructed by clustering technique and modified Dijkstra's algorithm in two steps, i.e. tree among proxy-senders and tree in each cluster. By the experimental results, we show that the proposed algorithm can provide an effective solution.

• Journal of Information Processing Systems
• /
• v.2 no.1
• /
• pp.39-43
• /
• 2006

In this paper, we proposed TASL-MAC, a medium-access control (MAC) protocol for wireless sensor networks. In wireless sensor networks, sensor nodes are usually deployed in a special environment, are assigned with long-term work, and are supported by a limited battery. As such, reducing the energy consumption becomes the primary concern with regard to wireless sensor networks. At the same time, reducing the latency in multi-hop data transmission is also very important. In the existing research, sensor nodes are expected to be switched to the sleep mode in order to reduce energy consumption. However, the existing proposals tended to assign the sensors with a fixed Sleep/Listening schedule, which causes unnecessary idle listening problems and conspicuous transmission latency due to the diversity of the traffic-load in the network. TASL-MAC is designed to dynamically adjust the duty listening time based on traffic load. This protocol enables the node with a proper data transfer rate to satisfy the application's requirements. Meanwhile, it can lead to much greater power efficiency by prolonging the nodes' sleeping time when the traffic. We evaluate our implementation of TASL-MAC in NS-2. The evaluation result indicates that our proposal could explicitly reduce packet delivery latency, and that it could also significantly prolong the lifetime of the entire network when traffic is low.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.14 no.3
• /
• pp.1377-1399
• /
• 2020

In search and rescue mission, micro aerial vehicles (MAVs) are typically used to capture image and video from an aerial perspective and transfer the data to the ground station. Because of the power limitation, a cluster of MAVs are required for a large search area, hence an ad-hoc wireless network must be maintained to transfer data more conveniently and fast. However, the unstable link and the intermittent connectivity between the MAVs caused by MAVs' movement may challenge the packet forwarding. This paper proposes a delay tolerant packet forwarding algorithm based on location estimation for MAV networks, called DTN_est algorithm. In the algorithm, ferrying MAVs are used to transmit data between MAVs and the ground station, and the locations of both searching MAVs and ferrying MAVs are estimated to compute the distances between the MAVs and destination. The MAV that is closest to the destination is selected greedy to forward packet. If a MAV cannot find the next hop MAV using the greedy strategy, the packets will be stored and re-forwarded once again in the next time slot. The experiment results show that the proposed DTN_est algorithm outperforms the typical DTN_geo algorithm in terms of packet delivery ratio and average routing hops.

• Journal of Information Processing Systems
• /
• v.16 no.5
• /
• pp.1113-1128
• /
• 2020

Ad hoc networks play an important role in mobile communications, and the performance of nodes has a significant impact on the choice of communication links. To ensure efficient and secure data forwarding and delivery, an intelligent routing protocol (IAODV) based on learning method is constructed. Five attributes of node energy, rate, credit value, computing power and transmission distance are taken as the basis of segmentation. By learning the selected samples and calculating the information gain of each attribute, the decision tree of routing node is constructed, and the rules of routing node selection are determined. IAODV algorithm realizes the adaptive evaluation and classification of network nodes, so as to determine the optimal transmission path from the source node to the destination node. The simulation results verify the feasibility, effectiveness and security of IAODV.

• ETRI Journal
• /
• v.37 no.3
• /
• pp.480-490
• /
• 2015

The reliability of sensor networks is generally dependent on the battery power of the sensor nodes that it employs; hence it is crucial for the sensor nodes to efficiently use their battery resources. This research paper presents a method to increase the reliability of sensor nodes by constructing a connected dominating tree (CDT), which is a subnetwork of wireless sensor networks. It detects the minimum number of dominatees, dominators, forwarder sensor nodes, and aggregates, as well as transmitting data to the sink. A new medium access control (MAC) protocol, called Homogenous Quorum-Based Medium Access Control (HQMAC), is also introduced, which is an adaptive, homogenous, asynchronous quorum-based MAC protocol. In this protocol, certain sensor nodes belonging to a network will be allowed to tune their wake-up and sleep intervals, based on their own traffic load. A new quorum system, named BiQuorum, is used by HQMAC to provide a low duty cycle, low network sensibility, and a high number of rendezvous points when compared with other quorum systems such as grid and dygrid. Both the theoretical results and the simulation results proved that the proposed HQMAC (when applied to a CDT) facilitates low transmission latency, high delivery ratio, and low energy consumption, thus extending the lifetime of the network it serves.

• Journal of Korea Society of Industrial Information Systems
• /
• v.27 no.6
• /
• pp.41-49
• /
• 2022

The Internet Engineering Task Force (IETF) has standardized RPL (IPv6 Routing Protocol for Low-power Lossy Network) as a routing protocol for Low Power and Lossy Networks (LLNs), a low power loss network environment. RPL creates a route through an Objective Function (OF) suitable for the service required by LLNs and builds a Destination Oriented Directed Acyclic Graph (DODAG). Existing studies check the residual energy of each node and select a parent with the highest residual energy to build a DODAG, but the energy exhaustion of the parent can not avoid the network disconnection of the children nodes. Therefore, this paper proposes EC-RPL (Enhanced Connectivity-RPL), in which ta node leaves DODAG in advance when the remaining energy of the node falls below the specified energy threshold. The proposed protocol is implemented in Contiki, an open-source IoT operating system, and its performance is evaluated in Cooja simulator, and the number of control messages is compared using Foren6. Experimental results show that EC-RPL has 6.9% lower latency and 5.8% fewer control messages than the existing RPL, and the packet delivery rate is 1.7% higher.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.8 no.2
• /
• pp.23-28
• /
• 2008

In this paper, we propose location-aided cooperative routing protocol (LACARP) for supporting power saving and stable route lifetime in mobile ad-hoc wireless sensor networks. The main ideas and features of the proposed routing protocol are as follows. First, the definition of the area of route search using location-based information to support power saving transmission. Second, the expect zone-based establishment of routing route within the area of route search. Third, the cooperative-aided transmission method. In the operation of data transmission over the established rout the datas are transmitted via both the established route and cooperative route aided by neighbor nodes. The performance evaluation using OPNET(Optimized Network Engineering Tool) shows the LACARP can improve the packet delivery ratio and power saving transmission efficiently.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.5
• /
• pp.1020-1030
• /
• 2016

This paper propose an improving relay node selection method for node-to-node connectivity. This concern with the mobility and analysis of deployed for masking operation using highest connectivity node. The major of Delay Tolerant Network (DTN) routing protocols make use of simple forwarding approach to transmit the message depend on the node's mobility. In this cases, the selection of the irrelevant mobile node induced the delay and packet delivery loss caused by limiting buffer size and computational power of node. Also the proposed algorithm provides the node connectivity considering the mobility and direction select the highest connectivity node from neighbor node using masking operation. From the simulation results, the proposed algorithm compared the packet delivery ratio with PROPHET and Epidemic. The proposed Enhanced Prediction-based Context-awareness Matrix(EPCM) algorithm shows an advantage packet delivery ratio even with selecting relay node according to mobility and direction.

• Journal of KIISE:Information Networking
• /
• v.33 no.2
• /
• pp.165-174
• /
• 2006

Data dissemination using either flooding or legacy ad-hoc routing protocol is not realistic approach in the wireless sensor networks, which are composed of sensor nodes with very weak computing power, small memory and limited battery. In this paper, we propose the ELF(Energy-efficient Localized Flooding) protocol. The ELF is energy-efficient data dissemination protocol for wireless sensor networks. In the ELF protocol, there are two data delivery phases between fixed source and mobile sink node. The first phase, before the tracking zone, sensing data are forwarded by unicasting. After that, within the tracking zone, sensing data are delivered by localized flooding. Namely, the ELF Properly combines advantages from both unicasting and flooding. According to evaluation results by simulation, the proposed ELF protocol maintains very high data delivery ratio with using a little energy. Also, the property of average delay is better than others. From our research results, the ELF is very effective data dissemination protocol for wireless sensor networks.

• Journal of Korea Multimedia Society
• /
• v.9 no.5
• /
• pp.606-614
• /
• 2006

The conventional on-demand mobile ad hoc routing algorithms (DSR and AODV) initiate route discovery only after a path breaks, incurring a significant cost and time in detecting the disconnection and establishing a new route. In this theory, we investigate adding proposed pro-active route selection and maintenance to the conventional on-demand mobile ad hoc routing algorithms(DSR and AODV). The key idea is to be only considered likely to be a path break when the received packet power becomes close to the minimum critical power and to be generated the forewarning packet when the signal power of a received packet drops below a optimal threshold value. After generated the forewarning packet, the source node can initiate rout discovery in advance; potentially avoiding the disconnection altogether. Our extensive simulation study shows that the proposed advance-active route selection and maintenance algorithms outperforms the conventional on-demand routing protocol based on DSR and AODV in terms of packet delivery ratio, packet latency and overhead.