• Physical Therapy Korea
• /
• v.19 no.1
• /
• pp.1-9
• /
• 2012

The purpose of this study was to investigate the kinematic and kinetic changes that may occur in the pelvic and spine regions during cross-legged sitting postures. Experiments were performed on sixteen healthy subjects. Data were collected while the subject sat in 4 different sitting postures for 5 seconds: uncrossed sitting with both feet on the floor (Posture A), sitting while placing his right knee on the left knee (Posture B), sitting by placing right ankle on left knee (Posture C), and sitting by placing right ankle over the left ankle (Posture D). The order of the sitting posture was random. The sagittal plane angles (pelvic tilt, lumbar A-P curve, thoracic A-P curve) and the frontal plane angles (pelvic obliquity, lumber lateral curves, thoracic lateral curves) were obtained using VICON system with 6 cameras and analyzed with Nexus software. The pressure on each buttock was measured using Tekscan. Repeated one-way analysis of variance (ANOVA) was used to compare the angle and pressure across the four postures. The Bonferroni's post hoc test was used to determine the differences between upright trunk sitting and cross-legged postures. In sagittal plane, cross-legged sitting postures showed significantly greater kyphotic curves in lumbar and thoracic spine when compared uncrossed sitting posture. Also, pelvic posterior tilting was greater in cross-legged postures. In frontal plane, only height of the right pelvic was significantly higher in Posture B than in Posture A. Finally, in Posture B, the pressure on the right buttock area was greater than Posture A and, in Posture C, the pressure on the left buttock area was greater than Posture A. However, all dependent variables in both planes did not demonstrate any significant difference among the three cross-legged postures (p>.05). The findings suggest that asymmetric changes in the pelvic and spine region secondary to the prolonged cross-legged sitting postures may cause lower back pain and deformities in the spine structures.

• Journal of Korean Physical Therapy Science
• /
• v.19 no.2
• /
• pp.17-24
• /
• 2012

Purpose : The purpose of this study was to show the effect of postural training through action observation (AO) on craniovertebral angle (CVA) and cranial rotation angle (CRA) of forward head posture (FHP). Methods : From 16 subjects of having the FHP who consist of postural training through the AO (n = 8) and control group (n = 8) were training to three times per one week during three weeks. FHP measurements for pre and post the intervention use to Wiz-pacs(Wiz-Picture Achiving Communication System) from X-ray change of CVA and CRA. Results : The study for the change within the group pre and post the intervention, CVA and CRA were found the significant differences only in the postural training group through the AO (p<.05). In the comparison of the rates of change between the groups pre and post the intervention CVA and CRA all showed the significant differences (p<.05), and in the comparison of the rates of average change of individual variables in each groups, the postural training group through the AO showed more change rates. Conclusion : The study suggests that when people with FHP received the postural training, the postural training through the AO resulted in more change into the correct postures.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.59 no.1
• /
• pp.220-224
• /
• 2010

In this study, we designed a device for consecutively observing position, utilizing 3-axises acceleration sensor. This method offer to check his or her wrong position and developed could to help derived a position appliance. And, we developed a Cobb's angle value in three dimensional using 3-axises acceleration sensor. A proposed device with integrated accelerometers, which can detect postural changes in terms of curvature variation of the spine in the sagittal and coronal planes, has been developed with intention to facilitate posture training. The proposed device was evaluated with 3 normal subjects daily activities. We evaluated the performance of our designed device as calculating the correlation coefficients and mean errors between the angle measured by an electro-goniometer and that estimated by a gravity accelerometer and verified the accuracy and sensitivity. The results showed that the angle obtained from the proposed device revealed a linear characteristic at the range of $\pm60^{\circ}$(correlation coefficient 0.99, error range $\pm2^{\circ}$). We demonstrated that our device could detect the changes of the motion in upper trunk accurately. Also, our device showed good potential for treatment of the patients with scoliosis and prevention of the unbalance position during a daily life.

• Journal of the Korean Society of Safety
• /
• v.20 no.4 s.72
• /
• pp.148-153
• /
• 2005

Computer dominated jobs and industrial automation have rapidly created work-related musculoskeletal disorders(WMSDs) and WMSDS are expanding to employee of other general industry. Specific risk factors associated with WMSDs include repetitive motion, heavy lifting, forceful exertion, contact stress, vibration awkward posture and rapid hand and wrist movement. The purpose of this paper is to analyze the effects of the neck muscle workload according to posture(joint angle) and load weight. Seven male students participated in this study. To analyze neck muscle workload was studied on electromyographic(EMG) activity for sternocleidomastoid and trapezius, was subjectively rated using a Borg's CR-10 scale. ANOVA showed that the CR-10 ratings and most EMG root-mean-square (RMS) value were statistically significant improvement according to posture(joint angle) and load weight. The results of this study indicate the joint angle and weight of neck muscle workload to provide safe working conditions. To reduce the large number and severity of WMSDs employees have been experiencing, we need to redesign the job in workplace to identify and control hazards that are reasonably likely to be causing or contributing to the WMSDs.

• Journal of Korean Ophthalmic Optics Society
• /
• v.18 no.4
• /
• pp.441-447
• /
• 2013

Purpose: The present study was conducted to investigate the axial rotations of toric soft lens during the change of lens wearer's posture, and the relationship between its rotation and corneal astigmatism. Methods: The amount, direction, and speed of toric soft contact lens rotation were measured for 42 eyes (aged 20s) with the rule astigmatism in the straight and lying postures, and it compared between their changes according to corneal astigmatism. Results: There was no significant difference in the axial rotation of lens for the astigmatism prescription between the straight and lying postures. However, the rotation angle was significantly different according to the posture of lens wearer. Rotating directions in straight posture were nasal direction for 20 eyes and temporal direction for 22 eyes. In lying posture, lenses of most wearers were rotated to a direction of lying posture, and the initial rotating speed was very fast in initial wearing for -0.75 D toric lenses, but consistency for -1.25 D toric lenses. The rotation angle in lying posture showed significantly different according to the amount of corneal astigmatism, the lens speed was also significantly different according to the wearing time but not the amount of corneal astigmatism. Conclusions: The axial rotation of toric soft lens was different by the lens wearer's posture and its amount was the greater with the higher degree of corneal astigmatism. Thus, these factors should be considered for the development of toric lens design.

• Journal of rehabilitation welfare engineering & assistive technology
• /
• v.6 no.2
• /
• pp.55-62
• /
• 2012

In this paper we propose a control system to preserve the interior angle between back section and upper leg section to be larger than 90 degrees using a single limit switch. To design the control system we analyze the kinematics of actuation mechanisms for the back section and the upper leg section, and find out an optimal solution for the controller design. Using a prototype control system we perform experiments to test the controller performance, and show that the interior angle between the back section and the upper leg section is always preserved larger than 90 degree. From the experimental results, we show the proposed control system is feasible to keep the body posture stability.

• Journal of the Korean Society of Physical Medicine
• /
• v.8 no.4
• /
• pp.601-608
• /
• 2013

PURPOSE: The purpose of this study was to investigate the effect of distance between trunk and desk on forward head posture and muscle activity of neck and shoulder muscles during computer work. METHODS: Twenty subjects who have healthy conditions were asked to perform computer work in two conditions (distance between trunk and desk was 0 and 15 cm). Forward head angle was analyzed with a SIMI motion analysis system. Surface electromyography recorded the upper trapezius and splenius capitis muscles. The significance of differences in distance between trunk and desk (0cm and 15cm) was tested by paired t-test. The alpha level was set at .05. RESULTS: The results showed that the change of forward head angle was significantly higher during the computer work when the distance between trunk and desk was 15cm than 0cm. The muscle activity of upper trapezius and splenius capitis was also significantly higher during the computer work when the distance between trunk and desk was 15cm than 0cm. CONCLUSION: Our study suggest that the distance between trunk and desk was should minimized for prevention of forward head posture during computer work.

• The Journal of Korean Academy of Orthopedic Manual Physical Therapy
• /
• v.22 no.1
• /
• pp.65-70
• /
• 2016

Background: To determine the correlation Between forward head posture and plantar pressor in a McKenzie Exercise. Methods: This study had a cross-sectional design. There are included 20 participants with forward head posture. We measured the craniovertebral angle (CVA), cranial rotation angle (CRA) by image obtained digital camera and the plantar pressure, static balance using Gait Analyzer each before and after McKenzie Exercise. Results: There was negative correlation between CVA and CRA (p<.05). There was negative correlation between CVA and fore foot(p<.05). There was positive correlation between CRA and both fore foot (p<.05). There was negative correlation between CVA and static balance(p<.05). There was positive correlation between CRA and static balance (p<.05). Conclusions: There is a correlation between the change a mount of forward head position and plantar pressure in the McKenzie Exercise.

• Physical Therapy Korea
• /
• v.22 no.4
• /
• pp.1-7
• /
• 2015

This case report describes the effectiveness of cervical corrective exercises in a patient with cervical radiculopathy (CR) who experienced radicular pain, upper limb paresis, and limited functional activity. A 39-year-old male with cervical radiculopathy performed the cervical corrective exercises for reducing pain. Pain intensity, cervical posture, and active range of motion of cervical intersegmental spine motion were measured baseline, after 4 weeks, and after 8 weeks with self-reported questionnaire and radiographs. After 8 weeks of intervention, the patient demonstrated alleviated radicular symptoms, improved neck posture and active range of flexion and extension of the cervical intersegmental spine. Especially in the angle between the cervical vertebra 6 and 7, the angle was changed from $-4.69^{\circ}$ to $3.30^{\circ}$ during resting position after intervention. The present case indicates that the cervical corrective exercises might be a possible treatment to effectively reduce radicular symptoms, improve neck posture, and active cervical intersegmental motion for patient with CR.

• Physical Therapy Rehabilitation Science
• /
• v.8 no.3
• /
• pp.152-157
• /
• 2019

Objective: We aimed to investigate differences of range of motion in measuring shoulder internal rotation (IR) and external rotation (ER) resulting from posture change in manual scapular stabilization in prone, hook-lying, sitting, and standing positions in healthy young adults. Design: Cross-sectional study. Methods: This study included healthy young adults who agreed to participate after a thorough explanation about the study purpose and methods. A clinometer was used to measure shoulder rotation. Measurements of shoulder rotation according to postural change were performed in prone, hook-lying, sitting, and standing positions. The repeated measures analysis of variance was used to compare between-group differences in postural change. Results: The lower the posture, the greater the average value of IR angle. In contrast, the higher the posture, the greater the average value of the external rotation angle. In active and passive IR with posture change, there was difference in average value but with no statistical significance. In active and passive ER, there was a statistically significant difference between prone and sitting, prone and standing, hook-lying and sitting, hook-lying and standing, and sitting and standing position (p<0.05). Conclusions: Our findings suggest that postural change should be considered in order to increase the strength or range of motion of the internal and external rotation of the patient's shoulder joint.