• Journal of electromagnetic engineering and science
• /
• v.5 no.4
• /
• pp.153-160
• /
• 2005

In this paper, the novel microwave oscillator incorporating a planar cavity resonator(PCR) is presented to reduce the phase noise of the oscillator in a planar environment. Compared to the conventional planar( $\lambda$/4 open stub resonator), the phase noise is improved about 16 dBc/Hz @100 kHz. The design of the oscillator is based on a reflection type configuration using the low 1/f SiGe HBT transistor(LPT16ED). The output power is measured 2.76 dBm at 12.5 GHz. In this paper, the oscillator used to the PCR can be expected to provide a solution for low phase noise oscillator in microwave circuits.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.7 no.1
• /
• pp.68-74
• /
• 2008

The substrate integrated waveguide (SIW) structure can be approximated as the rectangular waveguide using common dielectric substrate with via-holes. To realize reflection-type resonator, $50-{\omega}$ microstrip line can be used for coupling with the center plane of the cavity. The oscillator is designed to operate at 9.45 GHz using the reflection-type SIW cavity resonator. The phase noise of oscillator shows -98.1dBc/Hz at 100 KHz offset. In experiment, the reflection type SIW cavity resonator improves the loaded quality factor making the low phase noise oscillator possible. Due to the entirely planar structure of this resonator, this technique can also be adequate in oscillator applications for a low cost and low phase noise performance.

• 한국ITS학회:학술대회논문집
• /
• v.2007 no.10
• /
• pp.144-148
• /
• 2007

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.8
• /
• pp.709-716
• /
• 2016

In this paper, A duplexer module with temperature-insensitive electrical characteristics was proposed for remote wireless communication system. Duplexer modules are required to have performances of low insertion loss, high isolation between transmitted band and received band, harmonic suppression as well as high power durability in the system for transmitting guided information to missile flying a free space on the ground. The proposed duplexer module are consist of transmission bandpass filter and receiving bandpass filter which are connected to common antenna port, planar coupler for output power monitoring and low pass filter for harmonic attenuation of power amplifier and coaxial cavity resonator. The material and dimensions of the resonator are determined for minimum frequency shift by temperature variation using 3D EM simulation. The measured results of the prototype showed a good agreement with the simulation results, and it should be well applied not only for guided weapon systems but also for any other communication systems such as remote radio head.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.12
• /
• pp.1367-1374
• /
• 2008

A new high-gain Fabry-$P{\acute{e}}rot$ cavity antenna for wireless broadband internet(Wibro) base station antennas, which is covered with metamaterial superstrate presenting simultaneous negative values of permittivity and permeability, is proposed. To facilitate the fabrication process using the printed circuit board(PCB) technology of today, a new planar-type metamaterial superstrate is designed, which shows negative and low positive values of a refractive index near the Wibro service frequency band. And the principle of antenna gain enhancement is analyzed from the two different view points of effectively low refractive index and of the Fabry-$P{\acute{e}}rot$ resonance condition. Single square patch antenna is used as a feeder. The separation distance is determined by considering the reflection phases of the metamaterial superstrate and the substrate satisfying Fabry-$P{\acute{e}}rot$ resonance condition, respectively. Comparison between the prediction and the measurement shows good agreement, which verifies the validity of our design approach.