• Korean Journal of Applied Biomechanics
• /
• v.30 no.1
• /
• pp.1-6
• /
• 2020

Objective: The incidence rate of elbow ulnar collateral ligament injuries is dependent on the throwing speed or pitching type, especially in adolescent baseball players. However, mixed results have been reported due to a lack of controlled biomechanical analysis. Thus, the purpose of this study was to investigate the biomechanical analysis of the elbow in relation to throwing speed and pitching type. Method: Four overhead type high-school baseball players were recruited for this study. The participants were asked to throw balls with different types of pitch and speed. While the throwing speeds were measured, each pitching moment of the elbow was recorded. Descriptive statistics, frequency analysis, mean comparison analysis, and Pearson's correlation analysis were performed in order to examine differences in peak varus and valgus moment during pitching motion in the elbow in all throwing speed and pitching types. Results: There was no significant difference in physical characteristics, throwing speed, and momentum variability among all players. The mean varus moments were 44.38±1.55 Nm, 48.83±1.66 Nm, and 48.94±0.95 Nm, and the moment gaps between varus and valgus were 7.36±3.25 Nm, 7.44±2.02 Nm, and 7.36±2.62 Nm in fastball, curveball, and slider ball, respectively. The varus moment was higher in the curved and slider balls than in the fastballs, and there was no significant differences between the varus moments regarding the pitching type. However, the increase in valgus moment and decrease in moment gap according to throwing speed was significantly increased in the slider ball (r=0.718 and -0.591, respectively). Conclusion: The possibility of elbow injury caused by the valgus moment or moment gapincreases more rapidly in slider balls as the speed increases. Based on our results, appropriate pitching guidelines should be suggested to prevent ulnarligament injuries, especially in adolescent baseball players.

• Proceedings of the KSR Conference
• /
• 2011.05a
• /
• pp.842-848
• /
• 2011

The low-floor tram is a kind of railway vehicles which is operated on the street way track. For reducing the radius of curvature of the track, the tram consists of some carbody modules, and the articulation systems connect and support these carbody modules. The kind of articulation systems would be the hinge type and the pitching type. The hinge type articulation could allow only the yawing motion of the carbody modules, and the pitching type articulation could allow the pitching and yawing motions of the carbody modules simultaneously. With these function of the articulation systems, the tram could be operated on the horizontal and vertical curvature of the track. The number of each type of articulation could be decided with the number of carbody modules, and the manufacturer would decided the position of each type of the articulation in the view of the stability of carbody modules in the operation condition.

• Bulletin of the Society of Naval Architects of Korea
• /
• v.17 no.2
• /
• pp.33-42
• /
• 1980

This paper compared the seakeeping quality of U, V type ships in infinite depth by using the finite element method. From the calculated results, it is found that heaving and pitching motions of V type are comparatively better than those of U type ship in the water of infinite depth and the reversed phenomenon occures in the water of finite depth. And the seakeeping quality of U type is better than V type ship in larger ranges than the nondimensional wave number 2.0.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.3 no.5
• /
• pp.100-110
• /
• 1995

The human subject perception response according to vertical vibration and pitching was analyzed with a five degree of freedom model. The vehicle dynamic system with the delayed colored noise excitation and the passenger perception response was arranged as an integrated viration system and could be analyzed simultaneously for seven different combination of vehicle suspension. ISO2631 and BS6841 was adapted for analyzing the passenger perception reponse. Simulation results shows that passenger feel relatively less discomfort due to pitching compared to vertical vibration and road type was not necessary to be considered as a design parameter in view of comfort analysis.

• The Journal of the Acoustical Society of Korea
• /
• v.19 no.7
• /
• pp.77-84
• /
• 2000

In measurement of ship speed with a Doppler log sensor, we encounter the nonhorizontal movement of a ship, i.e. pitching and rolling, and that causes inaccuracy of the measurement. In this study, we develop a Janus type ultrasonic transducer that can resolve the problems in accuracy due to the pitching and other environmental factors of common ultrasonic sensors attributed to the underwater usage. For the development, we analyze the operation mechanism of the transducer, fabricate a prototype of the sensor, and evaluate its performance through experiments.

• 제어로봇시스템학회:학술대회논문집
• /
• 1995.10a
• /
• pp.162-165
• /
• 1995

For an accurate on-line measurement of the ship's attitude the paper develops an intelligent sensing system which uses one servo-type accelerometer and two servo-type inclinometers appropriately located on the ship. By considering the dynamics of the servo-controlled rigid pendulums of the inclinometers, linear equations for the rolling and pitching of the ship are derived separately from each other. Moreover, one accelerometer is used for extracting the heaving signal. Through the introduction of linear dynamic models and the linear observation equations for the heaving, rolling and pitching, the on-line measurement of the three signals can be reduced to the state estimation of the linear dynamic systems. A bank of Kalman filters is adaptively used to achieve the on-line accurate state estimation and to overcome changes in parameters in the linear dynamic models.

• International Journal of Naval Architecture and Ocean Engineering
• /
• v.8 no.3
• /
• pp.252-261
• /
• 2016

A spar-type floating substructure that is being widely used for offshore wind power generation is vulnerable to resonance in the heave direction because of its small water plane area. For this reason, the stable dynamic response of this floating structure should be ensured by accurately identifying the resonance characteristics. The purpose of this study is to analyze the characteristics of the combination resonance between the excitation frequency of a regular wave and natural frequencies of the floating substructure. First, the nonlinear equations of motion with two degrees of freedom are derived by assuming that the floating substructure is a rigid body, where the heaving motion and pitching motions are coupled. Moreover, to identify the characteristics of the combination resonance, the nonlinear term in the nonlinear equations is approximated up to the second order using the Taylor series expansion. Furthermore, the validity of the approximate model is confirmed through a comparison with the results of a numerical analysis which is made by applying the commercial software ANSYS AQWA to the full model. The result indicates that the combination resonance occurs at the frequencies of ${\omega}{\pm}{\omega}_5$ and $2{\omega}_{n5}$ between the excitation frequency (${\omega}$) of a regular wave and the natural frequency of the pitching motion (${\omega}_{n5}$) of the floating substructure.

• Journal of the Korean Society of Visualization
• /
• v.2 no.2
• /
• pp.58-65
• /
• 2004

The purpose of this visualization study is to investigate the effect of reduced frequency qualitatively by examining wake patterns for dragonfly flight motion. Dragonflies have two pairs of wing (a forewing and hindwing) and flight is achieved by a pitching and plunging, so it makes a separation over the wings. The separation affects the wake pattern and changed wake pattern has an influence on lift, drag, and propulsion. This experiment was conducted by using a smoke wire technique and a camera fixed above the test section used to take a photograph of the wake. An electronic device is mounted below the test section to find the exact mean positional angle of the wing. The reduced frequency in the experiment is 0.15, 0.3 and 0.45. Results show that reduced frequency is closely related to the wake pattern that determines flight efficiency.

• Journal of computational fluids engineering
• /
• v.21 no.3
• /
• pp.48-54
• /
• 2016

In the present work, numerical simulations were conducted on the scaled model of the BWB type UCAV in the subsonic region using ANSYS FLUENT V15. The prediction method was validated through comparison with experimental results and the effect of the twisted wing was investigated. To consider the transitional flow phenomenon, ${\gamma}$ transition model based on SST model was adopted. The coefficients of lift, drag and pitching moment were compared with experimental results and the pressure distribution and streamlines were investigated. The twisted wing decreases the lift force but increases lift-to-drag ratio through delay of stall and leading edge vortex's movement to the front, also the non-linearity of the pitching moment is decreased.

• 제어로봇시스템학회:학술대회논문집
• /
• 2003.10a
• /
• pp.859-864
• /
• 2003

This paper presents a design for the novel suspension mechanism of a two-wheeled mobile robot having two casters which is used for indoor environment. Although the indoor environment is less rough than the outdoor one, the fixed caster mechanism has some problems such as causing the robot to be immovable because robot's driving wheels do not have contact with the ground. Therefore, we tried installing a spring-damper suspension mechanism to keep driving capability and to remove pitching phenomenon. However, this suspension mechanism also has the problem, which the robot body inclined by disturbances does not return to the initial position. To deal with above problems and to accomplish desired performances, we designed the Multilayered Suspension Mechanism, which has springs and dampers working partially according to the inclined angle and angular velocity of robot body concerned with pitching. To analyze design, the equations of motion describing their dynamics were developed. Using the equations, simulation results show the improved performance. We confirm the usefulness of the Multilayered Suspension Mechanism by construction and test of a actual prototype.