• Transactions of the Korean Society of Automotive Engineers
• /
• v.22 no.4
• /
• pp.55-64
• /
• 2014

This work was investigated on pilot injection strategy of blended fuels(Diesel-DME) for combustion and emissions in a single cylinder direct injection compression ignition engine. Diesel and DME were blended by the method of weight ratio. Weight ratios for diesel and DME were 95:05 and 90:10 respectively. dSOI between main and pilot injection timing was varied. A total amount of injected fuels(single injection) was adjusted to obtain the fixed BMEP as 4.2 bar in order to compare with the fuel conditions. Also, the amount of pilot injection fuel was varied by 5%, 10% and 20% of total injection fuel. The engine was equipped with common rail and injection pressure is 700 bar at 1200 rpm. As a result, when mixing ratio increase, indicated thermal efficiency was increased in comparison with DD 100 and CO, THC and smoke were lower than DD 100. The influence of reducing NOx by pilot injection was more effective than DD 100. When pilot injection quantity increase, abrupt increase of NOx was occured at pilot injection quantity of 20%.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.13 no.9
• /
• pp.4390-4407
• /
• 2019

The paucity of pilot signals in Massive MIMO system is a vital issue. To accommodate substantial number of users, pilot signals are reused. This leads to interference, resulting in pilot contamination and degrades channel estimation at the Base Station (BS). Hence, mitigation of pilot contamination is exigency in Massive MIMO system. The proposed Time Shifted Pilot Signal Transmission with Pilot signal Hopping (TSPTPH), addresses the pilot contamination issue by transmitting pilot signals in non-overlapping time interval with hopping of pilot signals in each transmission slot. Hopping is carried by switching user to new a pilot signal in each transmission slot, resulting in random change of interfering users. This contributes to the change in channel coefficient, which leads to improved channel estimation at the BS and therefore enhances the efficiency of Massive MIMO system. In this system, Uplink Signal Power to Interference plus Noise Power Ratio (SINR) and data-rate are calculated for pilot signal reuse factor 1 and 3, by estimating the channel with Least Square estimation. The proposed system also reduces the uplink Signal power for data transmission of each User Equipment for normalized spectral efficiency with rising number of antennas at the BS and thus improves battery life.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2000.05a
• /
• pp.222-225
• /
• 2000

In this paper, a synchronous CDMA system accepted for the cdma2000 standard is simulated to propose optimized reverse link power ratio and channel estimation lengths. Differently from IS-95, the pilot channel is used in the proposed system to estimate fading channel, so optimized estimation lengths are needed. Therefore, in this paper we analyze optimized estimation lengths which is needed to decide the power ratio of pilot channel and fundamental channel. From fixed estimation lengths, we calculate FER with various power ratio values.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.9 no.4
• /
• pp.32-38
• /
• 2006

In this paper a sequence estimator of CDMA communication system is suggested. A sequence estimator uses Galois Field operation. A sequence estimator can provide another CDMA pilot signal which is un-modulated spreaded signal. A estimated sequence signal and received signal have no correlation. Tow signals can be summed using MRC(maximal ratio combine) method. The stronger signal can be added as a larger ratio, but the weaker signal can be added as a smaller ratio. We can distinguish strong signal using SNR estimator. Therefore it is possible to receive an additional pilot signal, and to support more reliable communications by using sequence estimator.

• 한국연소학회:학술대회논문집
• /
• 2003.05a
• /
• pp.27-32
• /
• 2003

Diesel-Fueled HCCI(Homogeneous Charge Compression Ignition) Engine is an advanced combustion process explained as a premixed charge of diesel fuel and air is admitted into the cylinder and compression ignited. It has possibility to reduce NOx by spontaneous auto-ignition at multiple points that allows very lean combustion resulting in low combustion temperatures. Also PM could be reduced by the premixed combustion and no fuel-rich zones. But HCCI couldn't be realized because of the difficulties in vaporizing the diesel, control of combustion phase directly. To solve these problems, new fuel injection strategy, explained as the pilot fuel injection to promote ignition near TDC following the main fuel injection at the extremely advanced timing, is applied during the compression ratio is varied from 18.9:1 to 27.7:1 This is not a pilot fuel to promote the ignition but also the direct control method of the combustion phase. Experimental result shows the pilot fuel injection promote the ignition and the compression ignition of the HCCI engine is achieved as compression ratio becomes higher. Also there is an optimal pilot fuel injection timing for the HCCI combustion. NOx is reduced more than 90% compared to DI-Diesel case but PM and THC emission needs more investigation.

• Journal of electromagnetic engineering and science
• /
• v.7 no.4
• /
• pp.195-200
• /
• 2007

Doubly-selective channel estimator for orthogonal frequency division multiplexing(OFDM) systems is proposed in this paper. Based on the generalized complex exponential basis expansion model(GCE-BEM), we describe the time-variant channel with time-invariant coefficients over multiple OFDM blocks. The time variation of the channel destroys the orthogonality between subcarriers, and the resulting channel matrix in the frequency domain is no longer diagonal, but the main interference comes from the near subcarriers. Based on this, we propose a channel estimator with low pilot ratio. We first develop a least-square(LS) estimator under the assumption that only the maximum Doppler frequency and the channel order are known at the receiver, and then verify that the correlation matrix of inter-channel interference(ICI) is a scaled identity matrix based on which we derive an optimal pilot insertion scheme for the LS estimator in the sense of minimum mean square error. The proposed estimator has the advantages of low pilot ratio and robustness against inter-carrier interference.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.9
• /
• pp.965-970
• /
• 2010

Because of a large number of subcarriers, the high PAPR(Peak-to-Average Power Ratio) is the major drawback of NC-OFDM system used for wireless communication system. Comb type pilot assignment is more efficient and lower computational complexity for the channel estimation than the block type pilot. However, even if the CAZAC(Constant Amplitude Zero Autocorrelation) matrix transform is used for the PAPR reduction of the data symbols, PAPR increases when the pilot is inserted in comb type with the data symbols. Therefore, in this paper, we additionally use a new SLM technique in order to lower the PAPR again even in the comb type pilot. Also, a new SLM technique suggested in this paper does not need any additional bandwidth for sending selection information for SLM. This combined method has good PAPR reduction performance and efficient data transmission.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.5
• /
• pp.806-808
• /
• 2015

In this paper, we suggest the method of pilot tone design for a compressed channel sensing in order to decrease the peak to average power ratio (PAPR) in orthogonal frequency division multiplexing (OFDM) systems.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.4
• /
• pp.718-723
• /
• 2017

We propose a pilot hopping scheme that improves the limited system capacity due to pilot contamination in multi-cell environment with large-scale antenna arrays at a base station, assuming the infinite number of antennas. In the conventional fixed pilot scheme, each user obtains the same signal-to-interference ratio (SIR) over a long period of time. Therefore, a user with strong interference has continuously low SIR which degrades its service quality. In the proposed pilot hopping scheme, different pilot signals are used for each time slot, and different amounts of interference are received every time. When such a pilot hopping technique is applied, the SIR fluctuates at every time slot. When the Hybrid Automatic Repeat & reQuest (HARQ) technique is applied in such a channel, the outage probability and transmission rate are improved. We show that there is the performance gain of the proposed scheme over the conventional scheme through computer simulations.

• Journal of the Korea Society of Computer and Information
• /
• v.18 no.7
• /
• pp.79-84
• /
• 2013

In this paper, the method of multiple PS(pilot symbol) QAM channel compensation is suggested in order to analyze and improve occurring problems in case of delay waves in Frequency-Selective Rayleigh fading channels through Pilot Symbol Assisted Modulation(PSAM) which is a method predicting and compensating fading information, using Pilot Symbol in flat fading channels. This suggested method shows stable improvement in its performance even though it is effected by the level of delay on delay waves while the existing PSAM method has severe malfunction with a small amount of level of delay on delay waves regardless of signal-to-noise ratio(SNR).