• ETRI Journal
• /
• v.26 no.4
• /
• pp.307-314
• /
• 2004

The application of a discrete pseudomorphic high electron mobility transistor (p-HEMT) as a grounded switch allows for the development of low cost phase shifters and phase modulators operating in a Ku band. This fills the gap in the development of phase control devices comprising p-i-n diodes and microwave monolithic integrated circuits (MMICs). This paper describes a discrete p-HEMT characterization and modeling in switching mode as well as the development of a low-cost four-bit phase shifter and direct quadrature phase shift keying (QPSK) modulator. The developed devices operate in a Ku band with parameters comparable to commercially available MMIC counterparts. Both of them are CMOS compatible and have no power consumption. The parameters of the QPSK modulator are very close to the requirements of available standards for satellite earth stations.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.07b
• /
• pp.616-619
• /
• 2003

This work presents the design, fabrication and microwave performance of distributed analog phase shifter (DAPS) fabricated on $(Ba,\;Sr)TiO_3$ (BST) thin films for X-band applications. Ferroelectric BST thin films were deposited on MgO substrates by pulsed laser deposition. The DAPS consists of high impedance coplanar waveguide (CPW) and periodically loaded tunable BST interdigitated capacitors (IDC). In order to reduce the insertion loss of DAPS and to remove the alteration of unloaded CPW properties according to an applied dc bias voltage, BST layer under transmission lines were removed by photolithography and RF-ion milling. The measured results are in good agreement with the simulated results at the frequencies of interest. The measured differential phase shift based on BST thin films was $24^{\circ}$ and the insertion loss decreased from 1.1 dB to 0.7 dB with increasing the bias voltage from 0 to 40V at 10 GHz.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.11
• /
• pp.31-37
• /
• 1998

Magnitude/phase controlling circuit which is composed of attenuator and phase shifter make phase/gain cross-coupling, so too much tuning time is needed to find optimum operation point. In this paper, vector attenuator which control magnitude and phase of input signals is proposed. Vector attenuator in past ignores phase variation characteristics of attenuator, but vector attenuator of this paper compensates phase variation characteristics of attenuator. This vector attenuator consists of 0$^{\circ}$/180$^{\circ}$ phase shifter and low phase shifting attenuator and so forth. A 0$^{\circ}$/180$^{\circ}$ phase shifter has 0$^{\circ}$/179.9$^{\circ}$ phase shifting characteristics at a center frequency 881 MHz and a low phase shifting attenuator has an attenuation of 25dB, within the limit of 3.6$^{\circ}$ phase shift and less than -20dB reflection characteristics at both input and output ports. The designed vector attenuator shows that cartesian coordinate plane of output signal space can be represented correctly.

• Proceedings of the IEEK Conference
• /
• 2003.07a
• /
• pp.613-616
• /
• 2003

This paper describes the design and implementation of wideband 360$^{\circ}$ phase shifter by using I/Q vector method. One of four quadrants was selected by a switching operation and the desired phase value was obtained by varying attenuation level of attenuator located in I/Q path. The minimum phase RMS error of 3.6$^{\circ}$ and the maximum phase RMS error of 25.2$^{\circ}$ were measured over 6~180Hz frequency range. Those characteristics are good enough for the requirement of ECM radar equipment. The phase values can be adjusted by control module.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.12 no.4
• /
• pp.325-334
• /
• 1987

Microwave integrated circuit phase shifters have undergone remarkable development to satisfy the fast and precise phase control requirements for phased array antennas. It is shown how relection type phase shift circuits using PIN diode can be analyzed and implemented so as to derve design equations for any phase shift. The reflection properties are achieved by the use of an impedance transforming two-port network and the virtual matching impedance method. Experimental and theoretical performance of 2-bit hybrid phase shifter designed by this method are found to be in good agreement for each bit.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.6
• /
• pp.501-504
• /
• 2017

In this paper, a hybrid beamforming antenna system using broadband butler matrix and phase shifter is proposed. In the previous works, an $8{\times}8$ butler matrix is used to overcome a drawback of the $4{\times}4$ butler matrix based switched beamforming which provides only 4 beam patterns. However the $8{\times}8$ butler matrix should be designed on the bi-layered substrate using via holes due to its complex structure. It causes performance degradation. To overcome these problems, the proposed hybrid beamforming antenna system is designed on the single side of the substrate for simple structure. By addition of two phase shifter, it provide various beam patterns. The proposed antenna system provides more than 10 dBi radiation gain in the ${\pm}45^{\circ}$ scanning range by 16 input combinations.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.5C
• /
• pp.496-499
• /
• 2002

In this paper, a phase shifter with shifting photonic bandgap(PBG) cell in linear feedforward amplifier is designed and fabricated in 5GHz wireless LAN band. Now a day, the phase shifter has been fabricated with hybrid type. In this paper, a portion of PBG cell is shifted for the tuning phase. The phase shift was achieved maximum 80o in our PBG structure. Shifting PBG cell has been applied in feedforward main loop to cancel the main two tone signal.

• 한국정보통신설비학회:학술대회논문집
• /
• 2008.08a
• /
• pp.131-136
• /
• 2008

System을 통해 출력되는 신호를 측정할 때 정확한 측정을 방해하는 요소로 잡음이 있다. 이런 신호 측정의 방해 요소인 잡음을 제거 하는 방법 중의 하나로 Lock-in Amp(LIA)가 사용되고 있다. 본 논문에서는 잡음 신호의 제거를 위해 사용 하는 LIA를 제작 하고 특성을 파악 하였으며 RF통신을 이용하여 무선 형태로 제작 하였다. 현재 상용화된 LIA는 프로브를 통한 유선으로 측정신호의 입력을 받게 되지만 본 논문에서 제작된 LIA는 무선신호 형태로 입력 하게 된다. RF통신의 케리어 주파수는 447.9[MHz]로 Digital GMSK 변복조방식을 이용하였다. LIA의 제작은 Dual Phase Sensitive Detecter을 사용하였으며, 주요 구성 요소인 Phase Locked Loop, Phase Shifter, Phase Sensitive Detector, Low Pass Filter등의 구조와 특성을 조사하였다.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2004.10a
• /
• pp.1282-1285
• /
• 2004

The high voltage driving system with multi-phase shifter including piezoelectric actuators comprised a driving power unit for outputting the driving power by converting input alternate current into direct current, a frequency shifting unit for supplying the direct current power and shifting or generating a frequency, a high-voltage amplification unit for amplifying the input signal outputted from the driving power unit and the frequency shifting unit into a high-voltage signal, and a phase shifting unit for shifting the phase difference of the amplified signal applied to the high-voltage amplification unit and driving plural piezoelectric actuators sequentially. The results that the operating voltage was stable, the voltage loss ratio was low and the response velocity was fast could be obtained. An experiment on performance of the high voltage driving system with multi-phase shifter designed and manufactured as above described was conducted by using a piezoelectric pump having 3 sheets of round unimorph piezoelectric actuators laminated respectively in a rectangular case. It sucks any fluid by causing the first piezoelectric actuator to shift from the inlet porter side, the phase delay of 60$^{\circ}$ causes the second piezoelectric actuator to begin to shift, and the phase delay of 120$^{\circ}$ causes the third piezoelectric actuator to begin to shift. As a result of measuring each change in the outlet flow rate of the piezoelectric pump, it was shown that the frequency-flow rate characteristic, the voltage-flow characteristic, and the load pressure-flow rate characteristic were improved.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.24 no.4
• /
• pp.43-47
• /
• 2024

This paper introduces a phased-array single-channel transceiver beamformer IC built using 65nm CMOS technology, covering the 8-16 GHz range and targeting the X and Ku bands for radar and satellite communications. Each signal path in the IC features a low noise amplifier (LNA), power amplifier (PA), phase shifter (PS), and variable gain amplifier (VGA), which allow for phase and gain adjustments essential for beam steering and tapering control in typical beamforming systems. Test results show that the phase-compensated VGA offers a gain range of 15 dB with 0.25 dB increments and an RMS gain error of 0.27 dB. The active vector modulator phase shifter delivers a 360° phase range with 2.8125° steps and an RMS phase error of 3.5°.