• The Korean Journal of Pain
• /
• v.6 no.2
• /
• pp.237-246
• /
• 1993

세포막에서 마취제의 작용점을 규명하기 위하여, 마취제의 많은 부분을 차지하는 n-Alkanol을 이용하여, 소의 synaptosomal plasma membrane vesicles(SPMV)에서 n-Alkanol의 침투 정도를 형광 probe를 이용한 형광소광법을 통하여 검색하였다. n-Alkanols는 SPMV 외부 단층(outer monolayer)의 표면에 주로 분포하되 그 탄소수에 비례하여 소수성 부위에 분포되는 양이 증가되는 경향을 나타내었다(1-decanol은 제외). Methanol, Ethanol, 1-propanol, 1-butanol, 1-pentano, 1-hexanol, 1-heptanol, 1-octanol, 1-nonanol 및 1-decanil은 SPMV 외부 단층의 표면(친수성 부위)에 분포되는 것에 비하여 각각 949, 416.8, 214.8, 90.3, 53.7, 15.20, 6.80, 2.00, 1.03 및 2.40 배가 된다는 것을 확인하였다. 1-decanol은 $C_{10}$인데도 불구하고 $C_8$인 1-octanol에 비하여 적은 양이 소수성 부위에 침투 분포한다는 것이 확인되었다.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.09a
• /
• pp.1132-1140
• /
• 2009

Recently soil improvement methods are using in many ways such as costal and soft ground of inland. Among them, sand compaction pile be widely used because of quiet few advantages. There are two ways for quality evaluation method of sand compaction pile. Especially standard penetration test is used the most general method. However, Current method have problems in that it is not consider the condition of construction site. Therefore this study is propose new quality evaluation method. Relation of N-$\Phi$ is always not fixed but changing by condition of construction site. By through the Laboratory test we can know relationship between relative density and internal friction. Also this study propose revision for effective stress. From these study, we can acquire more accurate and reasonable result than current method.

• Journal of the Korean GEO-environmental Society
• /
• v.2 no.1
• /
• pp.5-13
• /
• 2001

The purpose of this paper is to present the pressuremeter test result and analysis for Yulchon Combined Cycle Power Plant(CCPP) site. The CCPP site is old backfill area with the hillcut materials obtained from the borrow sources near the mountains. The geology of this area consists of 6-layers from the ground level such as hillcut material, dredged clay fill, silty sand, original marine clay, weathered rock, soft rock, etc.. The pressuremeter test has been carried out with three different probe, in size and membrane type for all layers except the clay layers. The cone penetration test has been also carried out to collaborate with the pressuremeter test in the hillcut material layer.

• Journal of the Korean Geotechnical Society
• /
• v.24 no.4
• /
• pp.89-100
• /
• 2008

Applying graph and correlation developed in other countries to the domestic field has limits. Therefore, it is necessary that Piezocone factor should be determined by including ground characteristics obtained from various test results in the domestic site for better application. In this study, laboratory tests and field tests were performed to find the characteristics of soft ground which was widely distributed around Siwha lake. A comparative analysis of these tests with Piezocone penetration test was performed and the Piezocone factor was estimated by correlationship analysis of undrained shear strength and cone resistance. Also, an appropriate Piezocone factor in the study site was reestimated by utilizing statistical analysis method for deriving reliable result.

• Journal of the Korean GEO-environmental Society
• /
• v.19 no.4
• /
• pp.33-38
• /
• 2018

The internal erosion due to poor compaction of the material was the main cause of collapse of the embankment in Korea. The assessment of the compaction state of the dam body was a very important check in the safety diagnosis of the embankment. In this study, the correlation between dynamic cone penetration test and plate loading test which is the most typical compaction evaluation technique was analyzed to verify the applicability of the dynamic cone penetration test in evaluating the compaction state of the dam body. The standard penetration tests were carried out six times to define soil properties and depth of the test site. The spatial distributions were obtained by the Kriging method after 15 times of plate loading tests and 47 times of dynamic cone penetration tests. The Pearson correlation coefficient between the spatial distribution of the plate loading test and the dynamic cone penetration test spatial distribution at the constant penetration depth was calculated. The load distribution in the plate loading test and the blow counts at penetration depths of 5 cm, 10 cm and 15 cm in the dynamic cone penetration test showed a weak positive correlation.

• The Journal of Engineering Geology
• /
• v.17 no.3
• /
• pp.351-358
• /
• 2007

Using the results of the Piezocone Penetration Test(PCPT) which were executed at the Yangsan-Mulgum site, the applicability of the interpretation methods far estimating the OCR(Overconsolidation Ratio) of soft clay was evaluated. At the same time, the results from the laboratory tests using the total of 172 undisturbed soft clay samples taken from the 44 bore holes of the Yangsan-Mulgum site were used to compare the OCR values obtained from the consolidation test with those from the PCPT. The relationship between the predicted overconsolidation ratio($OCR_p$) using the PCPT and the measured overconsolidation ratio($OCR_c$) from the laboratory consolidation tests are investigated and presented in this study. The $OCR_p$ by using the Powell et al.'s method for non-fissured clay from the results of the PCPT shows the best relationship with the $OCR_c$ obtained from the laboratory consolidation test.

• Journal of the Korea Institute of Building Construction
• /
• v.18 no.6
• /
• pp.507-515
• /
• 2018

The purpose of this research is to develop a slurry-type accelerator that contains various beneficial properties such as reduction of dust generation, lower alkalinity, early age strength development, etc., and uses such slurry type accelerator to produce high performance shotcrete that present excellent resistant against chloride ion penetration. In this work, shotcrete mixtures of 0.44 and 0.338 water-to-binder ratio (w/b) were produced at construction site using slurry-type accelerator. The mechanical properties and chloride ion penetration resistance of such shotcrete (including base concrete) were evaluated. According to the experimental results, the slurry-type accelerator was successfully used to produce both w/b 0.44 and 0.338 shotcretes. The 1 day and 28 day compressive strength of shotcrete were found to be closer to or higher than 10MPa and 40MPa, respectively. The w/b 0.338 shotcrete that used 40% replacement of blast furnace slag showed lower compressive strength than w/b 0.44 shotcrete without any mineral admixture at 1 day. However, the compressive strength with 40% blast furnace slag increased significantly at 28 day. Moreover, there was more than 50% increase in chloride ion penetration resistance with blast furnace slag, showing its strong potential for higher performance shotcrete application.

• Journal of the Korean GEO-environmental Society
• /
• v.7 no.5
• /
• pp.13-20
• /
• 2006

We have conducted standard penetration tests and static cone penetration tests that are widely used the land base examination on the soft ground subsurface of Yongdong area, and examined the correlation between them. We have also made a comparative analysis of the correlation between the indoor tests on the materials collected on the site and on-the-spot penetration tests. The results are as follows : The relationship between Standard Penetration Test N-value and Dutch Cone Tset show $Q_c=1.93N+0.29$ for organic soil, $Q_c=2.19N+0.20$ for clay, $Q_c=2.34N+1.06$ for silt, $Q_c=3.02N+0.54$ for silty sand, and $Q_c=3.47N+0.46$ for sand. In this case of sand $Q_c/N$ increases when the soil particles are larger. The relationship between standard penetration test N-value and Unconfined Compression Strength $q_u$ show $q_u=0.11N+0.03$ for organic soil, $q_u=0.11N+0.25$ for clay, and $q_u=0.18N-0.03$ for silt.

• Journal of the Korean GEO-environmental Society
• /
• v.24 no.12
• /
• pp.5-11
• /
• 2023

Economic damage is occurring due to landslides and debris flows that occur when the ground artificially created for roads or photovoltaic power generation facilities is weakened by rainfall such as torrential rain. In order to understand the stability of the artificially created ground, it is very important to check the ground information such as the compositional state and mechanical characteristics of the stratum. However, since most of the investigation sites are steep slopes or there are no access roads, it is not easy to enter the drilling equipment commonly used to check ground information and perform standard penetration tests. In this study, a dynamic cone penetration test (DCP) device using a miniaturized auger drilling equipment and an automatic drop device was developed to check the cone resistance value and the dynamic cone penetration test value and analyze the correlation with the standard penetration test value to confirm its applicability at the mountain solar power generation site. As a result, the cone resistance value is q_d = 0.46 N and the dynamic cone penetration test value is N_d = 1.58 N, confirming a value similar to the results of existing researchers to secure its reliability.

• Journal of the Korean GEO-environmental Society
• /
• v.15 no.8
• /
• pp.23-30
• /
• 2014

In-situ penetration tests have been widely used in geotechnical engineering for site investigation in support of analysis and design. Standard Penetration Test (SPT) and Dynamic Cone Penetration Test (DCPT) are typical dynamic sounding. DCPT was originally developed as an alternative for evaluating the properties of subgrade soils. The main advantages of DCPT are that it is fast, inexpensive, and it is particularly useful in delineating areas of weak soils overlying stronger strata and in quickly assessing the variability of the soil conditions. But lack of standardization is main reason that this test method has not been advanced more in recent years. In this study, it is clarified the correlation with the SPT blow count, N from DCPT data using big DCP eqipment. Regression analysis and correlationship analysis were conducted with the data from relationship between SPT and DCPT. The analysis results showed that the convert fact are in the range of 1.12~1.31 with variation with soil property.