• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2005.05a
• /
• pp.473-477
• /
• 2005

This paper presents a highly efficient HDD (Hard Disk Drive) spindle motor with a passive magnetic thrust bearing and a fluid dynamic journal bearing and its effectiveness is verified through experiment. It eliminates the mechanical friction loss of a thrust bearing which is around 18% of total power consumption of a 3.5' HDD spindle motor, by replacing a conventional fluid dynamic thrust bearing with a passive magnetic thrust bearing. The passive magnetic thrust bearing using permanent magnets is inherently unstable in radial direction. However, the radial fluid dynamic force of the fluid dynamic journal bearing counterbalances the radial magnetic force of magnetic thrust bearing to achieve the stability as the motor spins up. It has less or equivalent runout and less flying height than the conventional spindle motor.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.12 no.4
• /
• pp.405-410
• /
• 2012

This paper presents an inductorless 8-Gb/s adaptive passive equalizer with low-power consumption and small chip area. The equalizer has a tunable RC filter which provides high-frequency gain boosting and a limiting amplifier that restores the signal level from the filter output. It also includes a feedback loop which automatically adjusts the filter gain for the optimal frequency response. The equalizer fabricated in $0.18-{\mu}m$ CMOS technology can successfully equalize 8-Gb/s data transmitted through up to 50-cm FR4 PCB channels. It consumes 6.75 mW from 1.8-V supply voltage and occupies $0.021mm^2$ of chip area.

• ETRI Journal
• /
• v.31 no.3
• /
• pp.348-350
• /
• 2009

To fit the limited volume and power consumption of the passive radio frequency transmission system of the electronic time fuze, an improved coded mark inversion (CMI) is proposed in this letter. From the performance analysis, the energy transmission efficiency of this encoding method is at least 50% higher than that of CMI and NRZ. Finally, the experiment results show that by adopting this improved CMI, the change of DC voltage through magnetic coupling is lower than 0.2 V when the accuracy of data transmission is above 99.5%.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.13 no.1
• /
• pp.9-21
• /
• 2010

In this paper, optimum design of distributed detection is considered for a parallel sensor network system consisting of a fusion center and multiple passive sonar nodes. Nonrandom fusion rules are employed as the fusion rules of the sensor network. For the nonrandom fusion rules, it is shown that a threshold rule of each sensor node has uniformly most powerful properties. Optimum threshold for each sensor is investigated that maximizes the probability of detection under a constraint on energy consumption due to false alarms. It is also investigated through numerical experiments how signal strength, false alarm probability, and the distance between three sensor nodes affect the system detection performances.

• Korean Journal of Human Ecology
• /
• v.20 no.4
• /
• pp.801-817
• /
• 2011

The purpose of this research was to explore the levels of ethical consumption of the college students and classify their types on ethical consumption behaviors. This research was conducted with university students living in Gwangju. Statistical analysis was achieved by using t-test, one-way ANOVA, Duncan's multiple range test, $X^2$, and Ward' hierarchical cluster analysis with a total of 761 questionnaires. The research results are summarized as follows: First, the overall ethical consumption average mark of college students was 3.14. Second, all surveyed college students were classified into five types based on the means scores of three dimension ethical consumption behaviors. A total 16.7% of students belonged to Type 1 (named as entire region active group) where students scored high points on three dimension ethical consumption behaviors. Type 2 (named as entire region average group) had about 41.6% of students whose scores were the average mark level in three dimension ethical consumption behaviors. Type 3 (named as future-oriented group) occupied 13.9% and this group scored low on the ethical consumption in commercial transaction but high on the ethical consumption for the future generation. Type 4 (named as commercial transaction oriented group) occupied 9.1% and this group scored low on the ethical consumption for contemporary humankind and the ethical consumption for the future generation but high on the ethical consumption in commercial transaction. Type 5 (named as entire region passive group) had 18.7% of students whose scores of three dimension ethical consumption behaviors were low.

• Fashion & Textile Research Journal
• /
• v.14 no.3
• /
• pp.381-389
• /
• 2012

This study presents a marketing communication strategy from the aspect of new consumption orientation. Consumer preference on ads media, on-line ads media, and WOM usage were examined for new consumption orientation groups. This study was executed in a question survey format. A total of 182 questionnaires were obtained and data were analyzed by PASW 18.0 and AMOS 7. The results were as follows. First, 8 types of consumption orientation factors were revealed; 'impulsive purchase', 'promotion oriented', 'social contribution', 'passive conformity', 'innovative', 'conspicuous', 'rational', and 'environmental conservation'. Then 4 groups were formed, 'Rational & Positive', 'Conspicuous Conforming', 'Positive Social Interested' and 'Low Price Oriented'. Second, communication responses were analyzed through consumption orientation groups. The 'Rational & Positive' group responded positively to every type of advertising media (especially new media). The 'Conspicuous Conforming' and 'Positive Social Interested' groups preferred traditional media such as TV, radio, and magazines; in addition, the 'Low Price Oriented' group liked only online banner ads. For WOM preference, the 'Rational & Positive' and 'Positive Social Interested' group preferred verbal consumer information like WOM. In distribution types, the just 'Positive Social Interested' group revealed a significant result for internet shopping malls. The results from this study will help establish marketing communication strategies based on the features of consumption orientation.

• Journal of the Korean Society for Geothermal and Hydrothermal Energy
• /
• v.19 no.4
• /
• pp.27-38
• /
• 2023

The Government the Republic of Korea is showing a lot of interest in net zero-energy buildings (NZEBs) to reduce energy consumption of buildings and to promote green growth policy in construction sector. The application of building passive technologies and renewable energies is essential to achieving NZEBs. Green remodeling reinforced the insulation of the exterior walls and roofs of the buildings and replaced high-efficiency windows and doors. In this study, the energy performance before and after green remodeling applied in a detached house was comparatively analyzed for baseline scenario and three different ones, ALT 1, ALT 2 and ALT 3. A building modeling and simulation software (DesignBuilder V7.0) with EnergyPlus (V9.4) calculation engine was used to calculate the energy demand and energy consumption for each scenario. Based on the calculation results of the building's energy demand for baseline, it was determined that the target building required more heating energy than cooling energy. The simulation results also showed that the implementation of building envelope performance improvement technologies (ALT 1) could notably decrease the heating energy consumption of the building. After the remodeling (ALT 1), the source energy consumption per unit floor area was assessed to be reduced by 65.2%, compared to prior remodeling of 338.7 kWh/m² -y. Meanwhile, ALT 2 can achieve energy savings of 67.7% and ALT 3 can achieve savings of 73.1%. Following completion of the remodeling project, actual construction costs, and on-site measurements and verification results will be gathered and compared with the simulation results. Additionally, economic analysis including construction costs and payback period will be conducted using actual site data.

• Journal of international Conference on Electrical Machines and Systems
• /
• v.2 no.3
• /
• pp.275-282
• /
• 2013

Applications such as vibration isolation, gravity compensation, pick-and-place machines, etc., would benefit from (long-stroke) cylindrical/tubular permanent magnet (PM) actuators with integrated passive gravity compensation to minimize the power consumption. As an example, in component placing (pick-and-place) machines on printed circuit boards, passive devices allow the powerless counteraction of translator including nozzles or tooling bits. In these applications, an increasing demand is arising for high-speed actuation with high precision and bandwidth capability mainly due to the placement head being at the foundation of the motion chain, hence, a large mass of this device will result in high force/power requirements for the driving mechanism (i.e. an H-bridge with three linear permanent magnet motors placed in an H-configuration). This paper investigates a tubular actuator topology combined with passive gravity compensation. These two functionalities are separately introduced, where the combination is verified using comprehensive three dimensional (3D) finite element analyses.

• Smart Structures and Systems
• /
• v.24 no.1
• /
• pp.95-110
• /
• 2019

The semi-active impact damper (SAID) is proposed to improve the damping efficiency of traditional passive impact dampers. In order to investigate its damping mechanism and vibration control effects on realistic engineering structures, a 20-story nonlinear benchmark building is used as the main structure. The studies on system parameters, including the mass ratio, damping ratio, rigid coefficient, and the intensity of excitation are carried out, and their effects both on linear and nonlinear indexes are evaluated. The damping mechanism is herein further investigated and some suggestions for the design in high-rise buildings are also proposed. To validate the superiority of SAID, an optimal passive particle impact damper ($PID_{opt}$) is also investigated as a control group, in which the parameters of the SAID remain the same, and the optimal parameters of the $PID_{opt}$ are designed by differential evolution algorithm based on a reduced-order model. The numerical simulation shows that the SAID has better control effects than that of the optimized passive particle impact damper, not only for linear indexes (e.g., root mean square response), but also for nonlinear indexes (e.g., component energy consumption and hinge joint curvature).

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.29 no.3
• /
• pp.211-221
• /
• 2023

This study was conducted as a basic study for the selection of tags suitable for logistics management in the palletized unit-load unit and the development of various technologies to activate the palletized unit-load shipment of agricultural products through local APCs. Three types of passive RFID tags of UHF 900 MHz and one type of active RFID tag of 2.4 GHz band designed and manufactured through this study were used to analyze the receiving strength according to the tag's attachment location and distance of the palletized unit-load of agricultural products. In the passive RFID tag, there was a large difference in receiving strength by the tag's attachment location and a large amount of data loss depending on the distance within 30 m, whereas, in the active RFID tag, it was superior to the passive tags in terms of both receiving strength and data loss. Therefore, active tags are desirable from the perspective of multiple identification of warehouses with large spaces in relation to the application of RFID tags for palletized unit-loads of agricultural products, but the development of low-power technologies such as software wakeup power management as well as hardware to minimize battery power consumption is necessary.