• Journal of Korean Society for Atmospheric Environment
• /
• v.22 no.3
• /
• pp.353-360
• /
• 2006

This study identified a particle size distribution (PSD) of fine particulate matter and emission characteristics of V and Ni by the comparison between anthropogenic sources of oil combustion (industrial boiler, oil power plant, etc.) and lab-scale combustion using a drop-tube furnace. In oil combustion source, the mass fraction of fine particles (less than 2.5 micrometers in diameter) was higher than that of coarse particles (larger than 2.5 micrometers in diameter) in $PM_{10}$ (less than 10 micrometers in diameter) as like in lab-scale oil combustion. In addition to this, it was identified that ultra-fine particles (less than 0.1 micrometers in diameter) had a large distribution in fine particles. Toxic metals like V and Ni had large mass fractions in fine particles, and most of all was distributed in ultra-fine particles. Most of ultra-fine particles containing toxic metals have been emitted into ambient by combustion source because it is hard to control by the existing air pollution control device. Hence, we must be careful on these pollutants because it is obvious that these are associated with adverse health and environmental effect.

• Journal of Satellite, Information and Communications
• /
• v.8 no.4
• /
• pp.135-141
• /
• 2013

Subway in Korea, most of a metropolitan public transport use only worth ten million people a day floating population of wireless communication can be considered HOT SOPT. These three operators' 2G/3G/4G / Wi-Fi / T-DMB frequency and the number of services to co-exist, and the subway train passengers and subway party for operation and management of the communication network is also the co-subway passenger safety and for this service for the effects of mutual interference of whether the verification was necessary. This research and testing different frequency / communication interference between services and testing to determine whether, through the subway authorities and mobile operators in each frequency-specific interaction check and there is no interference to the safety and quality of subway passengers communication services that can be verified as the data was found. The verification methods in the metro area, not just from one region to determine whether the interference with a common verification methods can be applied.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.8A
• /
• pp.814-819
• /
• 2006

This paper presents the impacts of Ultra Wide-Band(UWB) system applied in Indoor and Handhold communications using frequency band from 3.1 GHz to 10.6 GHz on Wireless Broad-band(WiBro) system based on Orthogonal Frequency Division Multiplexing(OFDM) using frequency of 2.3 GHz. The Minimum Coupling Loss(MCL) method for the case of single interference and Monte Carlo(MC) simulation for multiple interference considering practical scenario were used to evaluate the interference effects of UWB system on WiBro system. As a result, the minimum separation distance between single interferer and the victim receiver required 34.4 m and above to guarantee the co-existence. Also, the UWB transmitting PSD of around - 81 dBm / MHz below should be required to meet the minimum throughput loss of WiBro mobile station in case of multiple UWB interference.

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.26 no.2
• /
• pp.113-118
• /
• 2020

Due to the rapid increase in cyber shopping mall of agricultural products, the parcel delivery service industry also increased, making it necessary to design an optimum packaging for agricultural products. And Due to the recent increase in strawberry consumption, there is also a need for a packaging system for parcel delivery service. In order to establish the criteria for optimum cushioning packaging design of strawberries, the bioyield strength of strawberries by storage time was measured through the ASABE test standards, and the peak acceleration in the resonance frequency and resonance frequency bands of strawberries was measured through the vibration test regulated in the ASTM test specifications. Tray cup pad and corrugated fiberboard box of delivery strawberries were designed using FEM theoretical analysis of contact stress and resonant frequency. In addition, an optimum packaging system was developed with a cushioning and vibration design considering the impact characteristics when distributing agricultural products. Through the performance evaluation and on-site evaluation of the optimum packaging system of strawberries for parcel delivery service, the random PSD test results of the delivery showed a 74% reduction in the acceleration level, and the actual distribution test of the delivery showed that the damage rate of strawberries was not more than 6.7%, indicating that it was possible to use the optimum packaging of strawberries for delivery.

• Journal of Environmental Health Sciences
• /
• v.43 no.2
• /
• pp.122-129
• /
• 2017

Objectives: Most of the $PM_{10}$ in subway stations is spread by the train-induced wind from the tunnels. Therefore, in order to improve air quality in subway stations, it is important to remove the $PM_{10}$ from the tunnels. After the installation of PSD (platform screen doors), the influence of train-induced wind and $PM_{10}$ at the platform has decreased, but is estimated to have increased in subway tunnels. This study was conducted to investigate the control of $PM_{10}$ in subway tunnels by applying a 500-fold diluted solution mixed with a humectant using a natural polymer. Methods: For this purpose, we tested the dust reduction effect in a laboratory and corrosion test and water pollution using fish and aquatic plants for the natural dust collecting agent. In the tunnel of a subway station, we used the natural dust collecting agent over 15 days. The study was carried out on $PM_{10}$ control during operation, which accounts for more than 70% of subway dust. Results: As results, the natural dust collecting agent exhibited an excellent dust control effect, and it was safe for water quality and soil. It showed the effect of controlling $PM_{10}$ in the subway tunnel by 49.5- 64.7% over 15 days. The use of the dust collecting agent for the control of $PM_{10}$ could be confirmed in the subway. Conclusion: It is necessary to clearly explain the major portions of chemical components contained in $PM_{10}$ to figure out the characteristics of $PM_{10}$ and to develop effective reduction measures to decrease the adverse effects of $PM_{10}$ in the subway.

• Advances in nano research
• /
• v.8 no.2
• /
• pp.183-190
• /
• 2020

The objectives of this research were the reduction of membrane fouling and improvement of sludge properties by using synthesized H-ZSM-5 and NH₄-ZSM-5 zeolites. These two nano zeolites were synthesized and added to the membrane bioreactor (MBR). Three similar MBRs with the same operational condition were used in order to evaluate their effect on the mentioned matters. The evaluated parameters were trans-membrane pressure (TMP), Fourier-transform infrared spectroscopy (FTIR), particle size distribution (PSD), soluble microbial product (SMP), extracellular polymeric substances (EPS) and, excitation-emission matrix (EEM). The MBR₀ was without any additional zeolite while 0.4 g/L of H-ZSM-5 and NH₄-ZSM-5 were added to MBR_HZSM-5 and MBR_NH4ZSM-5, respectively. The COD removal of the MBR₀, MBR_H-ZSM-5 and MBR_NH4-ZSM-5 were 87.5%, 93.3% and 94.6%, respectively. The TMP of the MBR_H-ZSM-5 was 45% less than MBR₀ whereas the reduction for MBR_NH4-ZSM-5 was 65.5%. Also results showed that both H-ZSM-5 and NH₄-ZSM-5 caused reduction in protein and polysaccharide related EPS but the NH₄-ZSM-5 had better performance toward the elimination of organic compounds.

• The Journal of the Acoustical Society of Korea
• /
• v.35 no.2
• /
• pp.102-109
• /
• 2016

This paper proposes a noise suppression method through SNR (Singal-to Noise Ratio) estimation in the two microphone array environment of close spacing. The conventional method uses a noise suppression method for a gain function obtained through the SNR estimation based on coherence function from full band. However, this method cause performance decreased by the noise damage that affects all the feature vector component. So, we propose a noise suppression method that allocates a frequency domain signal into N constant multi frequency band and each frequency band gets a gain function through SNR estimation based on coherence function. Performance evaluation of the proposed method is shown by comparison with PESQ (Perceptual Evaluation of Speech Quality) value which is an objective quality evaluation method provided by the ITU-T (International Telecommunications Union Telecommunication).

• Journal of Korean Society on Water Environment
• /
• v.35 no.5
• /
• pp.409-417
• /
• 2019

In this study, a $480m^3/day$ pilot device was constructed through laboratory experiments based on the Ministry of Environment manual. The purpose of this study was to analyze the characteristics of CSO treatment and backwashing characteristics by applying the pilot device to the field. The purpose of this study was to acquire the basic data necessary for the design and operation management of the real scale filtration type non-point pollution control system. The filtration was conducted while maintaining the linear velocity of 20m/hour. The CSO treatment efficiencies of the pilot devices were 0.4-76.1%(mean 49.0 %), SS 51.4-91.6%(mean 77.8%), COD 22.2-59.4% (mean 38.3%) and TP 14.5-52.6%(mean 38.1%),respectively. The correlation coefficient between SS and the turbidity of influent water was 0.90, higher than that of CSO. To operate the treatment system effectively, the turbidity can be easily measured in real time as the monitoring item is the most appropriate because SS is the main target substance of the non-point source. As a result of analyzing the adsorbent treatment characteristics of PP filter material applied to this pilot device, the average particle diameter range of influent was $4.6-40.1{\mu}m$(mean $21.2{\mu}m$) and the treated water was $0.9-24.5{\mu}m$(mean $6.4{\mu}m$), respectively. Particles of approximately 10m or less are leached out, and so it is necessary to compensate for the raw water containing micro particulate matter.

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.28 no.2
• /
• pp.143-149
• /
• 2022

PCS needs to freely switch AC and DC to connect the battery, external AC loads and renewable energy in both directions for energy efficiency. Whenever converting happens, power loss inevitably occurs. Minimization of the power loss to save electricity and convert it for usage is a very critical function in PCS. PCS plays an important role in the ESS(Energy Storage System) but the importance of stabilizing semiconductors on PCB(Printed Circuit Board) should be empathized with a risk of failure such as a fire explosion. In this study, the temperature variation inside PCS was reviewed by cooling fan on top of PCS, and the vibration characteristics of PCS were analyzed during truck transportation for reliability of the product. In most cases, a cooling fan is mounted to control the inner temperature at the upper part of the PCS and components generating the heat placed on the internal aluminum cooling plate to apply the primary cooling and the secondary cooling system with inlet fans for the external air. Results of CFD showed slightly lack of circulating capacity but simulated temperatures were durable for components. The resonance points of PCS were various due to the complexity of components. Although they were less than 40 Hz which mostly occurs breakage, it was analyzed that the vibration displacement in the resonance frequency band was very insufficient. As a result of random-vibration simulation, the lower part was analyzed as the stress-concentrated point but no breakage was shown. The steel sheet could be stable for now, but for long-term domestic transportation, structural coupling may occur due to accumulation of fatigue strength. After the test completed, output voltage of the product had lost so that extra packaging such as bubble wrap should be considered.

• Nuclear Engineering and Technology
• /
• v.55 no.7
• /
• pp.2613-2620
• /
• 2023

Excellent thermal neutron absorption performance of boron expands the potential use of boron rich slag to prepare epoxy resin matrix nuclear shielding composites. However, shielding attenuation behaviors and mechanism of the composites against gamma rays are unclear. Based on the radiation protection theory, Phy-X/PSD, XCOM, and ⁶⁰Co gamma ray source were integrated to obtain the shielding parameters of boron rich slag/epoxy resin composites at 0.015-15 MeV, which include mass attenuation coefficient (µ_t), linear attenuation coefficient (µ), half value thickness layer (HVL), electron density (N_eff), effective atomic number (Z_eff), exposure buildup factor (EBF) and exposure absorption buildup factor (EABF).µ_t, µ, HVL, N_eff, Z_eff, EBF and EABF are 0.02-7 cm²/g, 0.04-17 cm^-1, 0.045-20 cm, 5-14, 3 × 10²³-8 × 10²³ electron/g, 0-2000, and 0-3500. Shielding performance is BS4, BS3, BS3, BS1 in descending order, but worse than ordinary concrete. µ and HVL of BS1-BS4 for ⁶⁰Co gamma ray is 0.095-0.110 cm^-1 and 6.3-7.2 cm. Shielding mechanism is main interactions for attenuation gamma ray by BS1-BS4 are elements with higher content or higher atomic number via Photoelectric Absorption at low energy range, and elements with higher content via Compton Scattering and Pair Production in Nuclear Field at middle and higher energy range.