• Journal of Biosystems Engineering
• /
• v.18 no.4
• /
• pp.382-389
• /
• 1993

In this research, the surface color of 'Fuji' apples and tomatoes were measured by using Sharp PD 151 semiconductor color sensors. The measurements were compared with color-difference-meter readings and with visual sensory test scores. A negative exponential function was developed which describe the relationship between the dominant wavelength of the surface color of 'Fuji' apples and the ratio of the photoelectric currents of the color sensor. Also a linear relationship was found for the surface color of tomatoes and the color sensor output. There were good correlations between the visual test scores and the color sensor output for both 'Fuji' apples and tomatoes.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.18 no.10
• /
• pp.917-923
• /
• 2005

In this paper, effect of catalytic configuration on the sensing properties of $SnO_2$ nanoparticle gas sensitive thick film was investigated. Two types of catalytic configuration, mono and binary, were made on the $SnO_2$ nanoparticle. In case of mono catalytic system, $3 wt\%$ Pd or Pt catalyst was doped onto the $SnO_2$ nanoparticle, respectively. In case of binary catalytic system, Pd and Pt was doped simultaneously with concentration ratio of 1:2 to 2:1 onto the $SnO_2$ nanoparticle. After doping, gas sensitive thick film was printed on alumina substrate and heat-treated at 450 to $600^{\circ}C$. Gas sensing properties was evaluated using 500 to 10,000 ppm $CH_4$ gas. As a result, gas sensitive thick film with binary catalytic system showed unstable phenomena that the gas sensitivity was changed according to aging time. In contrary, the mono catalytic system showed relatively stable phenomena despite of aging time. Especially, gas sensitive thick film doped with $3 wt\%$ Pt catalyst and heat-treated at $500^{\circ}C$ showed good sensing properties such as 0.57 of $R_{3500}/R_{1000}$ and very small variation within $3.5\%$ after aging for 5 hours, and response time was very short less than 20 seconds.

• Journal of Sensor Science and Technology
• /
• v.6 no.5
• /
• pp.369-375
• /
• 1997

$V_{2}O_{5}/ThO_{2}/Pd$-doped $SnO_{2}$ sensor has a good selectivity and stability to CO at high sensor temperature of about $500^{\circ}C$, and shows rapid response. In particular, many kinds of interference gases, such as $NO_{x}$, $C_{3}H_{8}$, $CH_{4}$ and $SO_{2}$ have been found to give only a slight influence on the sensor selectivity to CO gas sensitivity by doped $V_{2}O_{5}$ (3.0 wt.%). For the sensor we used well-known thick film technological route with $V_{2}O_{5}$(3.0 wt.%), Pd(1.0 wt.%) and $ThO_{2}$(l.5 wt.%) as catalytic materials. In the case of mixed $NO_{x}$-CO gases, as combustion exhaust gas, only CO detection by $SnO_{2}$ type semiconductor sensor is generally very difficult because of $NO_{x}$ interference. The developed sensors can use to measure the exhausting gas of the automobile or the boiler for the Air-to-Fuel ratio control.

• Journal of Ginseng Research
• /
• v.10 no.1
• /
• pp.66-75
• /
• 1986

Influnces of Fuiarium solani and Phytophthora cactorum infection on the changes in saponin components of Korean ginseng (Panax ginseng C.A. Meyer)roots and some of the biology of those fungi in relation to ginseng root were investigated. Mycelial growth of F. solani was decreased as increasing concentration of the water extracts of fresh ginseng roots, while that of P. cactorum was increased as increasing the concentration of the water extracts and crude saponin. Mycelial growth of F. solani, however, was increased as increasing concentration of crude ginseng saponin upto 20 ppm, while it was tended to be decreased when the concentration was higher than 50 ppm. Nystatin also suppresed the growth of F. solani as increasing its concentration, but it did not affected on the growth of p. cactorum. Ginsenoside Ra and Ro components were not detected in ginseng roots inoculated with F. solani or P. cactorum. Panaxadiol gisenosides were increased by 3.0%, whereas panaxatriol ginsenosides were decreased by 34.9% in ginseng roots inoculated with F. iolani. In ginseng roots inoculated with P. cactorum panaxadiol ginsenosides were increased by 21.1%, but panaxatriol ginsenosides were decreased by 23.5%. PD/PT ratio in ginseng roots inoculated with F. solani or P. cactorum were equally increased by 58.4% in spite of differences in the change of panaxadiol and panaxatriol ginsenosides. The total saponin components of ginseng roots inoculated with F. solani or P. cactorum were decreased by 17.8% and 2.5%, respectively.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.21 no.6
• /
• pp.822-829
• /
• 1997

A catalytic burner was studied which can be used as a heater operated in medium temperature. Noble metal catalysts (Pd/NiO) were used, which were supported on alumina wash coated honeycomb. The maximum heat-resisting temperature of the catalyst is about 900.deg. C. Combustion efficiency of the catalytic burner reached more than 99.5 % at the excess air ratio above 1.25.NOx emissions were lower than 1.0 ppm at all operation conditions. The operation condition for a stable catalytic combustion was obtained. It was dependent on the catalyst thickness. The 30 mm thick catalyst showed the widest stable catalytic combustion region. Stable catalytic combustion region of 30 mm thick catalyst was the operation condition of excess air ratio 1.25 - 1.75 and heat flux 7 - 14 kcal/h center dot cm$^{2}$.

• Analytical Science and Technology
• /
• v.16 no.2
• /
• pp.117-124
• /
• 2003

Oxygen to metal ratio has been measured by wet and dry chemical analysis to study the properties of sintered $UO_2$ pellets and $U_3O_8$ in the lithium reduction process of spent pressurized water reactor fuels. Uranium dioxide pellets simulated for the spent PWR fuels with burnup values of 20,000~60,000 MWd/MtU were prepared by mixing $UO_2$ powder and oxides of fission product elements, pelleting the powder mixture and sintering it at $1,700^{\circ}C$ under a hydrogen atmosphere. For wet chemical analysis, the simulated spent fuels were dissolved with mixed acid (10 M HCl : 8 M $HNO_3$, 2.5 : 1, v/v) using acid digestion bomb technique. The total amount of uranium and fission products added in the simulated spent fuels were measured using inductively coupled plasma atomic emission spectrometry. Weight change of the simulated fuel during its oxydation was measured by thermogravimetry and then the O/M ratio result was compared to that obtained by wet chemical analysis. Influence of $Mo_{0.4}-Ru_{0.4}-Rh_{0.1}-Pd_{0.1}$, quaternary alloy, on the determination of O/M ratio was investigated.

• Proceedings of the Korean Society of Embryo Transfer Conference
• /
• 2002.11a
• /
• pp.95-95
• /
• 2002

Human embryonic stem (hES) cells can be induced to differentiate into tyrosine hydroxylase expressing (TH+) cells that may serve as an alternative for cell replacement therapy for Parkinson's disease (PD). To examine in vitro differentiation of hES (MB03, registered in NIH) cells into TH+ cells, hES cells were induced to differentiate according to the 4-/4+ protocol using retinoic acid (RA), ascorbic acid (AA), and/or lithium chloride (LiCl) followed by culture in N2 medium for 14 days, during which time the differentiation occurs. Immunocytochemical stainings of the cells revealed that approximately 21.1% of cells treated with RA plus AA expressed TH protein that is higher than the ratio of TH+ cells seen in any other treatment groups (RA, RA+LiCl or RA+AA+LiCl). In order to see the differentiation pattern in vivo and the ability of in vitro differentiation-induced cells in easing symptomatic motor function of PD animal model, cells (2 $\times$ 10$^{5}$ cells/2${mu}ell$) undergone 4-/4+ protocol using RA plus AA without any further treatment were transplanted into unilateral striatum of MPTP-lesioned PD animal model (C57BL/6). Following the surgery, motor behavior of the animals was examined by measuring the retention time on an accelerating rotar-rod far next 10 weeks. No significant differences in retention time of the animals were noticed until 2 weeks post-graft; however, it increased markedly at 6 weeks and 10 weeks time point after the surgery. Immunohistochemical studies confirmed that a reasonable number of TH+ cells were found at the graft site as well as other remote sites, showing the migrating nature of embryonic stem cells. These results suggest that in viかo differentiated hES cells relieve symptomatic motor behavior of PD animal model and should be considered as a promising alternative for the treatment of PD.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.11 no.3
• /
• pp.81-86
• /
• 1982

Ginseng saponins separated from Panax ginseng C.A. Meyer were analyzed by high-performance liquid chromatography using a carbohydrate analysis column. The effect on the resolution and retention time of each ginsenosides, as well as the addition effect of n-butanol on a acetonitrile/water system, was examined using various proportions of acetonitrile/water system (80/20-94/6) which have been used with typical solvent of carbohydrate analysis column. The retention time of each ginsenosides was greatly affected by the compositions and mixture proportions of the mobile phase and also markedly increased as the proprotion of acetonitrile in mobile phase increased. It was proved that acetonitrile/water system (80/20) and acetonitrile/water/n-butanol system (86/14/10) were very effective mobile phases for diol and triol sapoin analyses, respectively. According to the result obtained by this method, the PT/PD ratios of white and red ginseng saponins were 0.401 % and 0.561 %, respectively. Red ginseng increased PT/PD ratio, compared with white ginseng. This is attributed to the change of saponin pattern by processing method and the change of PT/PD ratio would greatly influence on the biochemical and pharmacological effects of ginseng and its products.

• Analytical Science and Technology
• /
• v.5 no.1
• /
• pp.63-71
• /
• 1992

Liquid chromatographic behavior of Pd(II), Ni(II) and Co(III) in N-Alkylisonitrosoacetylacetone imine(HIAA-NR) chelates was investigated by reversed phase high perfomance liquid chromatography. The optimum conditions for the separation of IAA-NR-metal chelates were examined respect to the flow rate and mobile phase strength. The metal-N-Alkylisonitrosoacetylacetone imine chelates in solution were successfully separated on Novapak $C_{18}$ column using acetonitrile/water mixture as mobile phase. The elution order of chelates is methyl>ethyl>propyl>butyl as N-alkyl group for ligand is varied. It was found that all IAA-NR-metal chelates were eluted in an acceptable range of capacity factor value($0{\leq}log\;k^{\prime}{\leq}1$). The dependence of log k' on the volume fraction of water in the binary mobile phase was examined. Also, the dependence of k' on the liquid-liquid extraction distribution ratio(Dc) in acetonitrile-water-alkane extraction system was investigated for IAA-NR-metal chelate. Both kinds of dependence are linear, which suggests that the retention of the electroneutral metal chelates on Novapak $C_{18}$ column is largely due to the hydrophobic effect.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.22 no.12
• /
• pp.1681-1690
• /
• 1998

The aim of this paper is to investigate combustion characteristics of lean premixed mixture stabilized by catalytic surface reaction. The catalytic combustor consisted of a catalyst bed and a thermal combustor. The catalyst bed was made of two stage, Pd catalyst in the first stage and Pt catalyst in the second stage. Auto ignition of lean mixture took place in the thermal combustor. Ignition temperature was about $810{\sim}820^{\circ}C$ at the fuel-air ratio of 1.5~3.0 % and the mixture velocity of 11~18m/sec. The position of flame front in the thermal combustor moved toward back as preheat temperature increased and fuel-air ratio decreased. The f1ame supported by surface reaction was stabilized without any flame stabilizers. NOx emissions from the catalytic combustor were below 2.0 ppm ($O_2$ 15 %) when gas temperature was limited below $1350^{\circ}C$. This result demonstrates that NOx emission from the catalytic combustor is much low comparing with conventional combustors.