• Journal of Environmental Health Sciences
• /
• v.19 no.4
• /
• pp.44-50
• /
• 1993

This paper has concentrated on estimating the improvement of sludge dewaterability for the application of ozone in sewage treatment plant sludge. The experiment for the study was conducted by batch reactor, contacting ozone (5.0 g O$_3$/hr/l) to waste sludge and measured the Specific Resistance to Filtrate (SRF) varying pH, pressure and reaction time of ozone. And then checked the dissolved solids concentration of flitrate. The results of experiment were as follows: 1. When the total solids concentration of excess sludge was 9, 000 mg/l, the optimum injection rate of ozone was 5.0 g O$_3$/hr/l, and then pressure was 50 cm Hg for the measuring SRF. 2. In the range of pH 3~5, the effect of ozone injection was excellent, but it was unsatisfactory in the range of pH 9~11. Therefore, the ozone injection by acidifying pH level was effective in improving the dewaterability of sludge. 3. It was estimated that the dissolved solids concentration of flitrate was increased in proportion to the injection rate of ozone.

• Journal of Food Hygiene and Safety
• /
• v.12 no.2
• /
• pp.111-116
• /
• 1997

For the purpose of improving hygienic quality of dried-Angelica Keiskei Koidz powder, the effect of ozone treatment and gamma irradiation on the microbial decontamination and physicochemical properties were investigated. Gamma irradiation at 5 to 7.5 kGy resulted in sterilizing total aerobic bacteria, molds and coliforms below detective levels, while ozone treatment for 8 hours up to 18 ppm did not sufficiently eliminate the total aerobic bacteria of the sample. The physicochemical properties of the sample were not changed by gamma irradiation up to 7.5 kGy, whereas, ozone treatment caused remarkable changes in pH, TBA value, chlorophyll, carotenoid and fatty acid compositions. Therefore, this investigation demonstrated conclusively that gamma irradiation was more effective than ozone treatment for decontaminating and sterilizing the dried-Angelica Keiskei Koidz powder, with minimal effect on the physicochemical properties analyzed.

• The Journal of Advanced Prosthodontics
• /
• v.8 no.4
• /
• pp.290-295
• /
• 2016

PURPOSE. The aim of this study was to evaluate the effect of paracetic acid (PAA) and ozone disinfection on the tensile bond strength (TBS) of silicone-based resilient liners to acrylic resins. MATERIALS AND METHODS. One hundred and twenty dumbbell shaped heat-polymerized acrylic resins were prepared. From the mid segment of the specimens, 3 mm of acrylic were grinded off and separated parts were reattached by resilient liners. The specimens were divided into 2 control (control1, control7) and 4 test groups of PAA and ozone disinfection (PAA1, PAA7, ozone1 and ozone7; n=10). While control groups were immersed in distilled water for 10 min (control1) and 7 days (control7), test groups were subjected to PAA (16 g/L) or ozone rich water (4 mg/L) for 1 cycle (10 min for PAA and 60 min for ozone) per day for 7 days prior to tensile tests. Measurements of the TBS were analyzed using 3-way ANOVA and Tukey's HSD test. RESULTS. Adhesive strength of Mollosil decreased significantly by application of ozone disinfection. PAA disinfection had no negative effect on the TBS values of Mollosil and Molloplast B to acrylic resin. Single application of ozone disinfection did not have any negative effect on TBS values of Molloplast B, but prolonged exposure to ozone decreased its adhesive strength. CONCLUSION. The adhesion of resilient liners to acrylic was not adversely affected by PAA disinfection. Immersion in ozonated water significantly decreased TBS of Mollosil. Prolonged exposure to ozone negatively affects adhesion of Molloplast B to denture base materials.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.33 no.3
• /
• pp.18-23
• /
• 2001

The effect of pulp consistency on the deinking properties in the ozone deinking of ONP was investigated in order to develop the environmentally friendly deinking method. The pulp consistency and ozone treatment time were varied for this purpose. Higher pulp consistency during ozone treatment gave better ink removal efficiency than the conventional deinking method. In was also found that the increase of pulp consistency can decrease the ozone treatment time which can meet the deinking quality. WRV of ozone deinked pulp obtained at 10% and 30% of pulp consistencies was lower than those of the conventional deinking method. However, the higher pulp consistency during ozone treatment improved WRV. Highest brightness was obtained at the ozone treatment condition of 30% pulp consistency and 10 minutes. The lower brightness at the other ozone treatment condition should be originated from the excessive decrease of ink particle size and then decrease of true ink removal efficiency. Scott bond was increased with the increase of pulp consistency and treatment time. However, the improvement of breaking length with ozone treatment was no significant.

• Journal of Korean Society of Water and Wastewater
• /
• v.9 no.3
• /
• pp.78-87
• /
• 1995

A study on the fouling control by periodical ozone-scrubbing was conducted in a membrane filtration process for drinking water treatment. Hydrophilic hollow fiber polyethylene membrane with pore size of $0.1{\mu}m$ and its surface area of $0.42m^2$ was used. Dead-End filtration method was selected to obtain high efficiency of energy. Laboratory prepared synthetic raw water with kaolin was used and the membranes were scrubbed by ozone once in an hour and once in two hours. When the duration of ozone scrubbing was increased from 10 seconds to 20 seconds, the rate of membrane fouling was significantly decreased. Although the frequency of ozone-scrubbing was reduced from once in an hour to once in two hours. the effect of fouling control was unchanged. However, ozone-scrubbing was not effective after a membrane was fouled and washed with detergent for reuse. Among several possible working effects of ozone, bactericidal effect was confirmed to be the primary reason of fouling control.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.30 no.2
• /
• pp.71-77
• /
• 2016

The dielectric barrier discharge (DBD) has low efficiency due to about 70% input power is consumed as thermal energy in the discharge space. However, because of the usage of DBD ozone generator is easier than other methods. The DBD ozone generator has been widely applied for high concentration ozone generation in the industrial application. But, the low-capacity compact DBD ozone generator is not applied so far. Therefore, the DBD ozone generator is necessary to improve ozone production efficiency and reduce the capacity. In this paper, the stainless steel pipe inner electrode was designed with hall type and screw type to improve the ozone production yield. The manufactured two inner electrodes were experimented with normal type for comparison of the discharge characteristics and the ozone generating characteristics. As the experimental results, the discharge current effective value of designed inner electrodes with hall type and screw type are higher than the normal type, due to unequal electric field is formed at the boundary. However, the difference of designed and original electrodes is less than 0.1mA that has no effect on the discharge characteristic. On the other hand, the screw type inner electrode increased higher than original model about 7 times when the flow rate of the oxygen source gas was increased from $0.6{\ell}/min$ to $1.0{\ell}/min$ The reason was assumed by the flow rate of the raw gas through the inner electrode was became fast that has a cooling effect. The designed hall type and screw type inner electrodes have shown good performances in ozone generation and ozone production that better than normal type in the same electrode surface area.

• Journal of Veterinary Clinics
• /
• v.23 no.3
• /
• pp.279-285
• /
• 2006

Thirty dairy cows with pododermatitis were selected and treatment effect of ozone ointment for bovine pododermatitis was investigated. In addition, bactericidal effect of ozone ointment on etiological agent of bovine pododermatitis was evaluated. The pathohistological examination for the pododermatitis, according to application with ozone ointment was investigated. Thirty dairy cows were divided two groups: control group(vaseline group: 15 cows), treatment group(ozone ointment group: 15 cows). Various parameters were evaluated in terms of the lameness score, swelling score, lesion score, WBC, neutrophil, pathohistological finding, and antimicrobial action. As compared with vaseline group, ozone ointment group revealed significant decrease of lameness(p<0.05), swelling(p<0.01) and lesion score(p<0.05) were shown in hoof lesions on 14 days after application. In hematological findings, WBC count revealed slightly high values within normal range before treatment, however, this was 1Corresponding author improved on 14 days after application of ozone ointment. The number of neutrophils was slightly higher than that of normal, however, this was improved on 14 days after application of ozone ointment. In pathohistological findings, normal dermal tissue was found in tissues with pododermatitis on 14 days after application of ozone ointment. In antimicobial action, marked decrease rate of bacteria was observed in feet of all cases treated with ozone ointment. The decreasing rate of bacteria in anaerobic culture was higher than that in aerobic culture.

• Food Science and Preservation
• /
• v.5 no.2
• /
• pp.177-185
• /
• 1998

For the purpose of enhanceing soybean-sprouts quality, the optimum conditions for ozone treatment of soybean during soaking before cultivation at 18~2$0^{\circ}C$ were evaluated with ozone concentration, treatment time and treatment frequency by response surface methodology. Germination rates of cleaned soybean by ozone water in the conditions of solubilized-ozone concentrations of 0.15 to 0.35ppm, ozone-treatment frequency of 1.5 to 2.3 times and ozone-treatment time of 30 to 36min. increased 18.8 to 24.0% for the control products. And, length of hypocotyl in conditions of 0.12 to 0.33ppm, 1.7 to 2.7 times and 45 to 90min. were also increased by 69.36 to 79.40%. On the other hand, weight of roots with ozone treatment were decreased in the conditions of solubilized ozone concentrations of 0.1 to 0.2ppm and ozone-treatment time of 30 to 57min. But, ozone-treatment frequency did not affected root growth. Putrefaction rates of the control were 5 to 15%, but those of ozone-treated samples during cultivation did not show. The overall optimum conditions for above 16% germination rates, above 9% hypocotyl yields compared to the control samples and below 98% of the control root weight were solubilized-ozone concentrations of 0.25 to 0.30ppm, ozone-treatment time of 43 to 49min. and ozone-treatment frequency of one time.

• Asian-Australasian Journal of Animal Sciences
• /
• v.15 no.4
• /
• pp.596-601
• /
• 2002

The present study was designed to examine the effect of ozone treatment in microencapsulated ${\beta}$-galactosidase on inactivation of the enzyme and sterilization of microorganism. The efficiency was the highest as 78.4% when the ratio of polyglycerol monostearate (PGMS) was 15:1. Activities of lactase remaining outside the capsule were affected by ozone treatment. With the increase of ozone concentration and duration of ozone treatment, the activity reduced significantly. In sensory aspect, with 2% microcapsule addition, no significant difference in sweetness was found compared with a market milk during 12 d storage. Above result indicated that the additional washing process of lactase was not necessary to inactivate the residual enzyme. In a subsequent study, the vegetative cells of microorganisms were completely killed with 10 ppm for 10 min treatment by ozone. The present study provides evidence that ozone treatment can be used as an inactivation and a sterilization process. In addition, these results suggest that acceptable milk products containing lactase microcapsules made by PGMS can be prepared with ozone treatment.

• Journal of Environmental Science International
• /
• v.16 no.8
• /
• pp.985-994
• /
• 2007

To investigate the effect of NOx and VOCs(volatile organic compounds) on the generation of high ozone episode, examined the hourly variations of ozone, NOx and VOCs concentrations, and calculated the ozone isopleth about maximum ozone concentrations using OZIPR which was presented by U. S. EPA at three sites in Busan. There was some difference by the sites, but decreasing VOCs concentration was effective for reduction of ozone at 22 July, the episode day of 2005. In the year 2006, the episode day was 8 August and the variations of NOx and VOCs concentration was little than variation of ozone. So it was estimated that the photochemical production of ozone was low than transportation of ozone. And the result of the OZIPR modeling was that decreasing VOCs concentration was effective for reduction of ozone.