• 한국자기학회지
• /
• 제5권4호
• /
• pp.299-303
• /
• 1995

In order to improve the read-out signal waveform, a shielded magnetoresistive (SMR) head has been designed and studied by applying the transmission-line model. The bias and signal field distribution, the voltage output, the harmonic output signal and resistance value of MR element are simulated as functions of bias current and recording displacement. The results show that the SMR head has good linear character with respect to the medium recording signal in high recording frequency of about 2.5 MHz. The amplitude and waveform of reroduction signal have been obviously improved. The saturation effect on the symmetry and amplitude of reproducing output have also been analyzed.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제49권5호
• /
• pp.345-351
• /
• 2000

To improve the current waveform of diode rectifiers, we propose a new operating principle of the voltage diode rectifiers. In the conventional voltage rectifier circuit, relatively large capacitors are used to boost the output voltage, while the proposed circuit uses ones and a small reactor not boost the output voltage but improve the input current waveform. A circuit design method is shown and confirmed simulation. It explained that compared conventional PWM(Pulse-width modulated)inverter with HPWM(Half Pulse-width modulated)inverter. Proposed HPWM inverter eliminated dead-time by lowering switching loss and holding over-shooting. Output voltage and current of this paper were applied for real air-conditioner.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1995년도 하계학술대회 논문집 A
• /
• pp.400-402
• /
• 1995

A novel type of single phase multi-step inverter is proposed, which has twelve-stepped levels of the output voltage. In this inverter the waveform of the output votage has smaller harmonic contents than those of a conventional six-step inverter. In this paper a new multi-step technique is analyzed. This new multi-step technique of the twelve-stewed single phase voltage source inverter has the advantage compared with the conventional six-step inverter, and the experimental results are proved by the calculation using spectrum-analyzer.

• 전력전자학회논문지
• /
• 제4권1호
• /
• pp.66-72
• /
• 1999

본 논문은 고주파 공진형 PWM 인버터식 X-선 장치의 인버터에 단상과 3상 전파정류방식 및 PSU 전원을 연결시켰을 때 나타나는 단시간 출력특성에 대해 분석하였다. X-선의 선질은 X-선관에 입력되는 DC 전압 파형에 의존한다. DC 출력전압 파형은 DC 전압전원의 고조파 왜곡에 의해 영향을 받는다. 이러한 관전압 파형의 왜곡은 X-선 출력의 직선성, 재현성 및 출력선질을 저하시킨다. 따라서 본 논문에서는 DC 출력전압 파형과 세 가지 형식의 DC 입력전원 형식에 따른 출력선량을 비교하였고 이에 따른 실험결과를 검토하였다.

• Journal of international Conference on Electrical Machines and Systems
• /
• 제2권1호
• /
• pp.120-126
• /
• 2013

The main aim of this paper is to expound high-efficiency operation of Switched Reluctance Generator (SRG) based on the current waveform. For this purpose, theoretical analysis of the copper loss and iron loss of the system is done first. Then, necessary simulation is done to find the variation trend of the copper loss and iron loss with the variation of the current waveform at the same output power. Finally, the best current waveform which can make the system operate with high efficiency is obtained by considering the influence of these two kinds of loss. In order to verity the simulation results, the experimental platform of DC motor-SRG is built and the modified angle position control (APC) method which can specify the current shape optionally is presented. By comparing the system efficiency at the three kinds of typical current waveform, the correctness and feasibility of the theory is verified. The proposed method is simple, reliable, and easy to achieve.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1998년도 전력전자학술대회 논문집
• /
• pp.180-184
• /
• 1998

Recently the performance of CO2 arc welding machine has been advanced significantly through the adoption of inverter circuit topology which made it possible to control the waveform of welding current and thus to suppress the spatter generation. However, the optimum waveform is still uncertain. As a first step for figuring out the promising waveforms, this study was performed to set-up the experimental system for studying the effect of waveform variables. The overal system is controlled digital controller using single chip microprocessor of 80C196KC. As a result of performance test of this system, it was demonstrated all of the waveform variables could be set individually and the generated spatter is reduced compare to conventional inverter arc welding machine.

• Journal of electromagnetic engineering and science
• /
• 제4권2호
• /
• pp.63-67
• /
• 2004

DAM(Delay-And-Multiplier) intercept receiver usually detects the symbol rate of the transmitted DS spread spectrum signal for the feature extraction. It is important for secure communication to reduce the normalized output signal-to-noise ratio that is generated at the DAM intercept receiver as a measure of detectability. In this paper, several kinds of chip waveforms are novelly analyzed for LPI(Low-Probability of Intercept) communication against DAM intercept receiver. Consequently, it is shown that the rectangular chip waveform shows the best LPI performance in the bandwidth of 2/$T_c$TEX>, 4/$T_c$TEX>, and 6/$T_c$TEX>/. Except the rectangular waveform, kaiser chip waveform show better LPI performance than the other waveforms in the bandwidth of 4/$T_c$TEX> and 6/$T_c$TEX>.

• 한국통신학회논문지
• /
• 제23권8호
• /
• pp.2064-2071
• /
• 1998

휴대용 기기에서 자체 발진하여 클럭원으로 사용되는 TCXO의 출력과 같은 작은 진폭(400mV)의 정현파 입력을 내부 논리회로의 클럭원으로 사용하기 위한 파형정형 및 50%의 듀티 비(duty ratio)의 출력을 가지는 새로운 디지털 클럭레벨 변환기를 설계, 개발 하였다. 정, 부 두 개의 비교기, RS 래치, 차아지 펌프, 기준 전압 발생기로 구성된 새로운 신호 변환회로는 출력파형의 펄스 폭을 감지하고, 이 결과를 궤환루프로 구성하여 입력 비교기 기준 전압단자로 궤환시킴으로서 다지털 신호레벨의 정확한 50%의 듀티 비를 가진 출력을 생성할 수 있다. 개발한 레벨변환기는 ADC등의 샘플링 클럭원, PLL 또는 신호 합성기의 클럭원으로 사용할 수가 있다. 설계는 $0.8\mu\textrm{m}$ double metal double poly analog CMOS 공정을 사용하고, BSIM3 model을 사용하였으며, 실험결과 370mV의 정현파 입력율 50 + 3%의 듀티 비를 가진 안정된 논리레벨 출력 동작특성을 얻을 수 있었다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2010년도 추계학술대회 논문집
• /
• pp.543-543
• /
• 2010

The objective of this research is estimating the location of interested sound source by using the similarity between a beamformer output in time domain and the candidate signal. The waveform of beamformer output at the location of sound source is similar with the waveform emitted by that source. To estimate the location of sound source by using this feature, we define quantified similarity between candidate signal and beamformer output. The candidate signal describes the signal which is generated by interested source. In this paper, similarity is defined by four methods. The two methods use time vector comparison, and the other two methods use time-frequency map or linear prediction coefficients. To figure out the results and performance of localization by using similarities, we demonstrate two conditions. The one is when two pure tone sources exist and the other condition is when several bird sounds exist. As a consequence, inner product with two time-vectors and structural similarity with spectrograms can estimate the locations of interest sound source.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제48권8호
• /
• pp.448-454
• /
• 1999

This paper describes a new dc-ac inverter system which for achieving sinusoidal ac waveform makes use of parallel loaded high frequency resonant inverter consisting of full bridge. Each one of the pair of switches in the inverter is driven to synchronous output frequency and the other is driven to PWM signal with resonant frequency proportional to magnitude of sine wave. A forced discontinuous conduction mode is used to realize the quasi-sinusoidal pulse in each switching period. Therefore the inverter generates sinusoidal modulated output voltage including carrier frequency that is resonant frequency. Carrier frequency components of modulated output voltage is filtered by low pass filter. Since current through switches is always zero at its turn-on in the proposed inverter, low stress and low switching loss is achieved. Operating characteristics of the proposed system is analyzed in per unit system using computer simulation. The output voltage of if includes low harmonics and it is almost close to sine wave. Also, the theoretical analysis is proved through the experimental test.