• Proceedings of the KIPE Conference
• /
• 2017.07a
• /
• pp.375-376
• /
• 2017

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.06a
• /
• pp.253-256
• /
• 2006

This paper shows operating characteristics of DFIG(Double Fed Induction Generator) for wind turbine. The back to back PWM voltage-fed inverter connected between the rotor and grid network operated sub and super-synchronous operating mode, and the vector-controlled DFIG enables the decoupling between active and reactive power as well as between torque and power factor. This paper is validated by simulations and experimental results.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.8 no.2
• /
• pp.77-88
• /
• 1988

This research investigated the effect of COD/N ratio on nitrogen removal, and the use of organics in raw wastewater as a carbon source for denitrification in SBR(Sequencing Batch Reactor) systems. Four laboratory scale reactors were operated in three modes. Only the difference between modes were; Mode I operated in aerated condition during fill while Mode II in anoxic condition and Mode III operated on two fills per cycle in anoxic condition. When COD/N ratio increased, total nitrogen removal efficiencies increased from 8.7 to 57.7 percent in Mode I, from 28.9 to 83.2 percent in Mode II and from 42.7 to 97.8 percent in Mode III, respectively. COD removal efficiencies ranged from 93 to 98 percent throughout the study. SBR operation in Mode III of feeding twice per cycle in anoxic condition was an effective operating method for nitrogen removal and nitrogen concentration in effluent can be estimated using influent COD and nitrogen concentrations.

• 제어로봇시스템학회:학술대회논문집
• /
• 1997.10a
• /
• pp.183-186
• /
• 1997

This paper presents the new MR rotary brake with a permanent magnet, based on the shear operating mode. Due to the permanent magnet, the MR rotary brake can give the nominal resistance to the external disturbance and give the fail safe capacity to the system even when the power supply is accidentally cut off. As we apply the positive or negative current to the electric magnet coil, the resistance torque of the MR rotary brake can be reduced to the value less than the nominal resistance or increased up to the magnetic saturation point.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.31B no.3
• /
• pp.141-149
• /
• 1994

In this paper, we could find optimum quantum sequence(OQS) to minimize the output ripple voltage of the quantum series resonant converter(QSRC). This sequence control is so general that it is irrelevant to the voltage gain so far as it is operating in the continuous conduction mode(CCM). Further more the dynamic range of QSRC is much extended by the optimum quantum sequence control(OQSC). Througuout the time-domain analysis, the solution of steady state and the boundary condition between continuous and discontinuous mode is QSRC is obtained. This feature is verified by simulations and experiments with good agreements.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 1995.10a
• /
• pp.337-341
• /
• 1995

This paper presents a robust control scheme using a multilayer network for the robot manipulator operating under the sea which has large uncertainties such as the buoyancy and the added mass/moment of inertia. The multilayer neural network acts as a compensator of the conventional sliding mode controller to maintain the control performance when the initial assumptions of uncertainty bounds are not valid. By the computer simulation results, the proposed control scheme dose not effectively compensate large uncertainties, but also reduces the steady stare error of the conventional sliding mode controller.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.56 no.5
• /
• pp.898-904
• /
• 2007

This paper presents the generalized and explicit expressions for evaluating the performance of the multi-phase interleaved boost converter (IBC) operating in discontinuous inductor current mode (DICM). The full order averaged model is derived. The generalized transfer functions of interest are presented and the dynamic characteristics are analyzed. The generalized analysis of converter performance is verified through the experimental and simulation results.

• ETRI Journal
• /
• v.29 no.6
• /
• pp.829-831
• /
• 2007

This letter proposes an analytical model to characterize medium utilization in IEEE 802.11e operating in HCCA-EDCA mixed mode (HEMM). In contrast to existing works which model the backoff process in individual stations, we consider the channel occupancy pattern. Additionally, our work considers the operation of HEMM, which is not widely documented. We show that the proposed model accurately characterizes medium utilization with no more than 5% error.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.842-845
• /
• 2006

We studied for high transmittance panel technology in the FFS mode. We found that fine slit of pixel electrode makes increase of panel transmittance, and at the same time this structure has an issue which is increasing operation voltage (Vop). We analyzed the reason of high Vop in the FFS pixel with fine slit using two-dimensional LC analyses. Finally we suggest the solution which has high transmittance with suitable operating voltage.

• 제어로봇시스템학회:학술대회논문집
• /
• 1990.10b
• /
• pp.1108-1111
• /
• 1990

Sorce noise effect in 1.5 Mach-Zehnder (MZ) interferometer is analyzed. It is shown numerically that with fine adjustments to the feedback gain and initial phase biases, the operating point of the interferometer to achives common mode compensation can be made to lie in a region where the measurand sensitivity is greater than it would be in a conventional Mach-Zehnder interferometer even if the source is less coherent.