• Journal of Advanced Marine Engineering and Technology
• /
• 제21권4호
• /
• pp.387-392
• /
• 1997

This paper describes a combination surge generator for carrying out performance tests on the surge protection circuits of shipboard electrical systems. Pspice simulations were performed to decide the values of the parts required and to analyze the characteristics of the generator circuitry. The surge generator fabricated can produce four of the most common surge test waveforms : the O.5i/S/100kHz Ringwave, the 1.2/50$\mu$S voltage, the 8/20$\mu$S current, and the lO/lOOOi/S voltage wave¬forms specified in ANSI Std. C62. Source impedances of the surge generator are 12$\Omega$ in the O.5$\mu$S/100kHz mode, O.5$\Omega$ in the 1.2/50$\mu$S and 8/20$\mu$S mode, and 40$\Omega$in the l0/1000$\mu$S mode, and are determined by the ratio of the maxi¬mum open - circuit voltage to the maximum short - circuit current. Experimental results show that the surge generator provides most of the outputs required for the testing of the surge protection circuits on shipboard electrical systems.

• Journal of Power Electronics
• /
• 제12권2호
• /
• pp.317-325
• /
• 2012

Resonant immittance converter (RIC) topologies can transform a current source into a voltage source (Type-I RICs) and vice versa (Type-II RICs), thereby making them suitable for many power electronics applications. RICs are operated at a fixed frequency where the resonant immittance network (RIN) exhibits immittance conversion characteristics. It is observed that the low-frequency response of Type-II RINs is relatively flat and that the state variables associated with Type-II RINs affect the response only at the high frequencies in the vicinity of the switching frequency. The overall response of a Type-II RIC is thus dominated by the filter response, which is particularly important for the controller design. Therefore, an approximate equivalent circuit model and a small-signal model of Type-II RICs are proposed in this paper, neglecting the high-frequency response of Type-II RINs. While the proposed models greatly simplify and speed-up the analysis, it adequately predicts the open-loop transient and small-signal ac behavior of Type-II RICs. The validity of the proposed models is confirmed by comparisons of their results with those obtained from a cycle-by-cycle simulation and with an experimental prototype.

• 센서학회지
• /
• 제16권6호
• /
• pp.475-483
• /
• 2007

This paper proposes a readout integrated circuit (ROIC) for $32{\times}32$ infrared focal plane array (IRFPA) detector, which consist of reference resistor, detector resistor, reset switch, integrated capacitor and operational amplifier. Proposed ROIC is designed using $0.35{\;}{\mu}m$ 2P-4M (double poly four metal) n-well CMOS process parameters. Low noise folded cascode operational amplifier which is a key element in the ROIC showed 12.8 MHz unity-gain bandwidth and open-gain 89 dB, phase margin $67^{\circ}$, SNR 82 dB. From proposed circuit, we gained output voltage variation ${\Delta}17{\};mV/^{\circ}C$ when the detector resistor varied according to the temperature.

• 전기학회논문지
• /
• 제65권3호
• /
• pp.526-531
• /
• 2016

This paper presents an experimental study on the optimal settings for the selected DC fault relay (50F) to improve the operating performance for the high-speed circuit breaker on DC feeding system which ensure safety within rolling stock maintenance depot. In this study, current supplied to overhead contact wire was calculated on 1 ms interval to analyze the correction values of DC fault selective relay for the operation of current supply cutout. Particularly, standards for the accurate detection of accidents between an electric railway vehicle and the electric power facilities are shown by investigating the optimal correction values for detection of fault current, and the results indicated that it takes about 213 ms for the DC fault selective relay(50F) to fully open. In the future, the correction values of DC fault selective relay suggested in this paper will be used as the reference values of protective relay for the safe operation of DC electric railroad system such as urban railway.

• 한국산학기술학회논문지
• /
• 제8권5호
• /
• pp.1076-1081
• /
• 2007

본 논문은 시분할 송수신 시스템에 사용될 수 있는 새로운 구조의 스위칭회로를 제안한다. 기존의 시분할 송수신 시스템에 사용되는 스위칭 회로의 경우 안테나, 송신단 그리고 수신단을 서큘레이터로 각 단자를 분리하였다. 이러한 기존의 방법은 서큘레이터 사용으로 인하여 회로전체의 가격을 증가시키는 원인이 되며, 원치 않는 상호 변복조 성분이 만들어져 전체 시스템의 악화로 이어지게 된다. 본 논문에서 제안하는 회로는 비선형 소자인 서큘레이터를 사용하지 않고 기본적인 가지선로 결합기의 한 쪽 선로를 결합선로로 등가 모델링하여 응용한 회로이다. 이 회로는 등가 모델링 된 결합선로의 격리 포트를 개방/단락의 종단조건을 이용하여 신호의 흐름을 제어하는 새로운 구조의 스위칭회로이다. 본 논문에서는 제시한 설계법의 타당성을 검증하기 위하여 Wibro 서비스 주파수대역인 2.3GHz에서 제작 및 측정하였다.

• 한국전기전자재료학회논문지
• /
• 제35권1호
• /
• pp.98-101
• /
• 2022

Liquid-based Triboelectric nanogenerator (L-TENG) is one of the alternatives to solid-based Triboelectric nanogenerator (S-TENG) because of the absence of surface damage which can decrease the durability of the generator. However, the L-TENG also has an obvious drawback of significantly lower output than that of S-TENG. This article produces water-sloshing-based electricity generating device (W-ED) with a new design of L-TENG that improves electrical output in portable form. The dual-electrode system, consisting of closed-loop circuit and inner electrode which enables water to contact directly in the bottle, can generate the open-circuit voltage and the short-circuit current of up to 348 V and 5.1 mA, respectively. By investigating the motion of water for each frequency, we propose that W-ED is suitable device for a variety of human motions. We expect that W-ED can be applied in small electrical devices or sensors in daily-use items.

• 신재생에너지
• /
• 제5권3호
• /
• pp.22-25
• /
• 2009

For increasing the output voltage, six SMD(surface mount device) type AlGaAs/GaAs solar cells were connected in series. The electrical properties of the array were measured and compared with one sun (100 mW/$cm^2$) and indoor light (480 lux) conditions. Under one sun condition, output power was 21.57 mW and it was $14.67\;{\mu}W$ under indoor light condition. Under the indoor light condition, the intensity of the light is very low compared to one sun condition. Thus the Voc(open circuit voltage) and Isc (short circuit current) of the sample under indoor light condition decreased very much compared to that of under the one sun condition. This kind of solar cell power supply can be used as a power source for ubiquitous sensor network (USN).

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2010년도 추계학술대회 초록집
• /
• pp.39.1-39.1
• /
• 2010

이종접합태양전지는 단결정 실리콘 기판 표면에 고품질 비정질 실리콘층을 적층함으로써 전기의 근원인 전하의 재결합 손실을 줄여 높은 개방전압을 얻을 수 있다는 특징이 있다. 초박형 태양전지는 기존 태양전지보다 뛰어난 광전변환 특성(Photovoltaic characteristic)을 가지고 두께가 얇아 제품 형상 시 자유도가 높아진다. 본 논문에서는 n-type Bare wafer($160{\sim}180{\mu}m$)를 이용하여 $50{\mu}m$의 웨이퍼를 제작하였다. a-Si:H(p)_a-Si:H(i)_c-Si(n)의 광흡수층 구조를 성막하여 cell을 제작하였다. 그 결과 Voc(Open Circuit Voltage)가 0.666, Jsc(Short-Circuit Current)가 34.77, FF(Fill Factor) 69.413, Efficency 16.07%를 달성했다.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2010년도 추계학술대회 초록집
• /
• pp.60.1-60.1
• /
• 2010

Chemically functionalized plant oils such as acrylated epoxidized soybean oil (AESO) and maleinized acrylated epoxidized soybean oil (MAESO) were used as new bio-based binders for $TiO_2$ electrodes of dye-sensitized solar cells (DSSC). More porous networks and larger porosities were fabricated on the $TiO_2$ films using plant oil binders due to the larger number of functionalities, in comparison with the film using polyethylene glycol (PEG). The charge-transfer resistance in the $TiO_2$ films was considerably shrunk due to the reduced impurity states. The short circuit photocurrent (Isc) and the open circuit photovoltage (Voc) of the cell using plant oil binders increased and the conversion efficiency improved significantly.

• ETRI Journal
• /
• 제37권2호
• /
• pp.369-379
• /
• 2015

Fault management of virtualized network environments using user-driven network provisioning systems (NPSs) is crucial for guaranteeing seamless virtual network services irrespective of physical infrastructure impairment. The network service interface (NSI) of the Open Grid Forum reflects the need for a common standard management API for the reservation and provisioning of user-driven virtual circuits (VCs) across global networks. NSI-based NPSs (that is, network service agents) can be used to compose user-driven VCs for mission-critical applications in a dynamic multi-domain. In this article, we first attempt to outline the design issues and challenges faced when attempting to provide mission-critical applications using dynamic VCs with a protection that is both user-driven and trustworthy in a dynamic multi-domain environment, to motivate work in this area of research. We also survey representative works that address inter-domain VC protection and qualitatively evaluate them and current NSI against the issues and challenges.