• Proceedings of the IEEK Conference
• /
• 2003.07b
• /
• pp.955-958
• /
• 2003

본 논문에서는 개방형 파이프라인 구조를 이용한 8비트 500Msamples/s ADC를 제안하였다. 8-비트의 해상도에 적합하면서 전력 소모가 적은 5 단 파이프라인 구조로 설계하였으며, 고속 동작에 적합하게 MUX 스위치에서 선택한 신호를 인터폴레이션하는 개방형 구조를 채택하였다. 전력 소모와 전체 칩 면적을 줄이기 위해서, 각 단에서 필요한 신호의 수를 줄이도록 설계하였다. 설계된 ADC 는 3 개의 신호를 이용하여 구현 함으로서 각 단에서의 증폭기 수틀 줄일 수 있었다. 또한 1.8V 의 낮은 전원 전압에 의한 작은 입력 범위에서 8-비트의 해상도를 만족하기 위해서 Offset Cancellation 기법을 사용하였다. 제안된 ADC 는 0.18μ m 일반 CMOS 공정을 이용하여 설계되었으며 시뮬레이션 결과 500Msamples/s에서 220mW의 전력 소모를 가지며, 1.2Vp-p (Differential) 입력 범위에 대해서 약 48dB의 SNDR을(8-비트의 해상도) 가짐을 확인할 수 있었다.

• Proceedings of the KIEE Conference
• /
• 2007.10a
• /
• pp.481-482
• /
• 2007

This paper describes the design of a l0-bit 100 KSample/S CMOS A/D Converter for biomedical applications such as pulse oximetry, body weight scale, ECG etc. We adopted an asynchronous architecture in the 10-b DAC design and hence reduces the number of switches by 11 and resistors by 64 compared with the conventional l0-b DAC. We also reduced the power consumption compare with the conventional architecture by 0.4mW. Output offset cancellation technique is applied to the design of comparator. The total power consumption of designed circuit is 190uW at the supply voltage of 1.8V with the 0.18um general CMOS technology.

• Proceedings of the KIEE Conference
• /
• 2003.11c
• /
• pp.920-923
• /
• 2003

An wearable electrocardiogram (ECG) monitoring system is a widely used non-invasive diagnostic tool for ambulatory patient who may be at risk from latent life-threatening cardiac abnormalities. In this paper, we have a portable ECG monitoring system with conductive fiber which was characterized by the small-size and the low power consumption. The system consists of conductive fibers, one-chip microcontroller, ECG preprocessing circuit, and monitoring software to be able to record and analyze in PC. ECG preprocessing circuit is made of pre-amplifier with gain of 10, band-pass filter with bandwidth of 0.5-120Hz and 2.5V offset circuit for A/D conversion. ECG signals obtained by sensor are included with corrupted noises such as a baseline wandering, 60 Hz power noise and interference noise by body movement. For cancellation corrupted noises in signals obtained by conductive fiber, we used the wavelet decomposition of wavelet transforms in MATLAB toolbox.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.4
• /
• pp.418-425
• /
• 2014

This paper presents a Ku-Band Doppler Radar System to measure respiration and heart rate. It was measured by using simultaneous radar and ECG(Electrocardiogram). Arctangent demodulation without dc offset compensation can be applied to transmitted I/Q(In-phase & Quadrature-phase) signal in order to improve the RMSE(Root Mean Square Error) about 50 %. The power leaked to receiving antenna from the transmitting antenna is always generated because of continuously opening the transceiver of CW(Continuous Wave) Doppler radar. As the output power increase, leakage power has an effect on the SNR(Signal-to-Noise Ratio) of the system. Therefore, in this paper, leakage cancellation technique that adds the signal having the opposite phase of the leakage power to the leakage power was implemented in order to minimize the decline of receiver sensitivity. By applying the leakage cancellation techniques described above, it is possible to measure the heart rate and respiration of the human at a distance of up to 35 m. the heart rate of the measured data at a distance of 35 m accords with the heart rate extracted from the ECG data.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.12
• /
• pp.1030-1038
• /
• 2013

The proposed Alamouti coded OFDM effectively cancels Inter Carrier Interference (ICI) due to frequency offset between distributed antennas. The conventional Alamouti coded OFDM schemes to mitigate ICI utilize N-point Inverse Fast Fourier Transform/Fast Fourier Transform (IFFT/FFT) operations for OFDM modulation and demodulation processes with total N subcarriers. However, the performance degrades because ICI is also repeated in N periods due to the property of N-point IFFT/FFT operation. In order to avoid this problem, null data are used at the subcarriers with large ICI and thus, data rate decreases. The proposed scheme employs 2N-point IFFT/FFT instead of N-point IFFT/FFT in order to increase sampling rate. By increasing sampling rate, the amount of interference significantly decreases because the period of ICI also increases. The proposed scheme increases the data rate and improves the performance by reducing amount of ICI and the number of null-data. Furthermore, the gain of the performance and data rate of the proposed scheme is significant with higher modulation such as 16-Quadarature Amplitude Modulation (QAM) or 64-QAM.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.12 s.91
• /
• pp.1152-1160
• /
• 2004

OFDM technique was adopted as the standard of IEEE 802.1 la and it has been widely used for wireless LAN, European DVB/DAB system, Korean DMB system. In the standard of IEEE 802.11a the data packet is composed of two parts, preamble and data. Preamble is composed of short pilots and long pilots, which are used for synchronization and estimation of frequency offset and channel. We can also compensate phase noise effect in the transceiver by using above pilots. The phase noise is more complicate than frequency offset and seriously affects system performance. In this paper, we newly propose CPE and ICI simultaneous compensation method to compensate phase noise generated by transceiver oscillator and compare with previous studies. As results, phase noise effect can be significantly compensated by CPE cancellation method, PNS algorithm and our proposed CPE and ICI compensation method. Especially, the proposed CPE and ICI compensation method can achieve the best BER performance compared with original OFDM, CPE cancellation method and PNS algorithm.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.10
• /
• pp.1143-1153
• /
• 2010

In this paper, we propose an alternative method to increase the distortion cancellation bandwidth of an analog RF feedback power amplifier by using a negative group delay circuit(NGDC). A limited distortion cancellation bandwidth due to the group delay(GD) mismatch discouraged the use of feedback technique in spite of its powerful linearization performance. With the fabricated NGDC with positive phase slope over frequency, the feedback amplifier of the proposed topology experimentally achieved adjacent channel leakage ratio(ACLR) improvement of 15 dB over 50 MHz bandwidth at wideband code division multiple access(WCDMA) downlink band when tested with 2-carrier WCDMA signal. At an average output power of 28 dBm, ACLR of 25.1 dB is improved to obtain -53.2 dBc at 5 MHz offset.

• ETRI Journal
• /
• v.26 no.3
• /
• pp.229-240
• /
• 2004

This paper reports on our development of a dual-mode transceiver for a CMOS high-rate Bluetooth system-onchip solution. The transceiver includes most of the radio building blocks such as an active complex filter, a Gaussian frequency shift keying (GFSK) demodulator, a variable gain amplifier (VGA), a dc offset cancellation circuit, a quadrature local oscillator (LO) generator, and an RF front-end. It is designed for both the normal-rate Bluetooth with an instantaneous bit rate of 1 Mb/s and the high-rate Bluetooth of up to 12 Mb/s. The receiver employs a dualconversion combined with a baseband dual-path architecture for resolving many problems such as flicker noise, dc offset, and power consumption of the dual-mode system. The transceiver requires none of the external image-rejection and intermediate frequency (IF) channel filters by using an LO of 1.6 GHz and the fifth order onchip filters. The chip is fabricated on a $6.5-mm^{2}$ die using a standard $0.25-{\mu}m$ CMOS technology. Experimental results show an in-band image-rejection ratio of 40 dB, an IIP3 of -5 dBm, and a sensitivity of -77 dBm for the Bluetooth mode when the losses from the external components are compensated. It consumes 42 mA in receive ${\pi}/4-diffrential$ quadrature phase-shift keying $({\pi}/4-DQPSK)$ mode of 8 Mb/s, 35 mA in receive GFSK mode of 1 Mb/s, and 32 mA in transmit mode from a 2.5-V supply. These results indicate that the architecture and circuits are adaptable to the implementation of a low-cost, multi-mode, high-speed wireless personal area network.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.7A
• /
• pp.733-742
• /
• 2008

In 3GPP LTE downlink system, initial cell search is essential for mobile station to connect to base station. In order to obtain information of the base station, the mobile station detects frame timing, frequency offset, and cell identification using primary synchronization channel(PSC) and secondary synchronization channel(SSC), which are defined in downlink OFDMA specification. In this paper, we analyze various detection algorithms in practical environment of inter-cell-interference, frequency offset, and multi-path fading channel and propose the optimal algorithm. Simulation results show that partial correlation method (for PSC acquisition) and interference cancellation method (for SSC detection) are the most superior algorithms among the applicable algorithms. Employ these two algorithms for receiver design, initial cell search is performed with 99% probability within 70ms in the channel environment considered.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.1C
• /
• pp.131-137
• /
• 2009

Binary offset carrier (BOC) signal synchronization is one of the most important steps to recover the transmitted information in global navigation satellite systems (GNSS) including Galileo and global positioning system (GPS). Generally, BOC signal synchronization is based on the correlation between the received and locally generated BOC signals. Thus, the multiple side-peaks in BOC autocorrelation are one of the main error sources in synchronizing BOC signals. Recently, a novel correlation function with reduced side-peaks was proposed for BOC signal synchronization by Julien [8]; however, Julien's correlation function not only still has the side-peaks, but also is only applicable to sine phased BOC(n, n), where n is the ratio of the pseudo random noise (PRN) code rate to 1.023 MHz. In this paper, we propose a new correlation function for BOC signal synchronization, which does not have any side-peaks and is applicable to general types of BOC signals, sine/cosine phased BOC(kn, n), where k is the ratio of a PRN chip duration to the period of a square wave sub-carrier used in BOC modulation. In addition, an efficient correlator structure is presented for generating the proposed correlation function.