• Journal of the Korean Society of Propulsion Engineers
• /
• v.9 no.4
• /
• pp.31-38
• /
• 2005

In this paper, the combustion characteristics of a hybrid propulsion system were studied with various L/D(length vs diameter) ratio of the single po.1 type solid fuel. Experiments were performed for 2 cases with the fixed grain port diameter and fuel length respectively. For the first case, results show that there are no large variations for regression rates as the L/D ratio changes. And as the L/D ratio increases, the O/F ratio decreases and thrust, characteristic velocity tends to increase. For the second case, there is no large change for O/F ratio, thrust and characteristic velocity as L/D ratio changes. On the other hand, as the L/D ratio decreases, only the regression rate tends to increase. Experimentally, exponent n in $\dot{r}=a{G_0}^n$ was found about 0.5 and then the O/F ratio was shown nearly constant. In the experiment, PE and gas oxygen were used as a fuel and an oxidizer.

• Korean Journal of Optics and Photonics
• /
• v.8 no.5
• /
• pp.382-386
• /
• 1997

The composite $MgF_2$-$TiO_2$ films are fabricated by codeposition from two independent sources. To improve optical and mechanical properties of films, the films are prepared by ion-assisted deposition. Chemical compositions, optical properties and microstructures of the composite films were investigated. The chemical composition rates of Ti:Mg of $MgF_2$-$TiO_2$ composite films are nonlinearly varied according to the relative deposition rate. It is found that the refractive indices of the composite films decrease with increasing $MgF_2$ contents and can be fitted quite well with Drude's formula and that the microstructures of the composite films changes from an amorphous to crystalline with increasing $MgF_2$ mole fractions.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.4 no.3
• /
• pp.294-305
• /
• 1994

The influence of deposition parameter on the electrical, optical andsurface morphology of $SnO_2(:F)$ films prepared by ultrasonic spray deposition using DBDA and $SnCl_4.5H_2O$ as a source material was studied. Resistivity was decreased sharply with increasing F/Sn ratio in solution up to 0.6. Depending on the source material, $SnCl_4.5H_2O$ shows lower resistivity than DBDA. When F/Sn ratio in solution was 1, optical transmittance was higher DBDA than $SnCl_4.5H_2O$.

• Korean Journal of Plant Resources
• /
• v.14 no.2
• /
• pp.152-156
• /
• 2001

This study was conducted to investigate the flower organ removal effect on Atractylodes macrocephala Koidz which was introduced from China. The results were summarized as follows; The plant height of Flower Organ Cutting(F.O.N.C.) treatment short by 1.7∼2.5 cm compared to Flower Organ Non-Cutting(F.O.N.C.) treatment. But number of stem and stem diameter of F.0.C treatment were similar to that of F.O.N.C. treatment. The fresh weight of above-ground part of F.O.N.C. treatment was decreased 48∼60% compare to F.O.C. treatments. The later was period of F.O.C., the higher was fresh weight of above-ground part. The growth of underground part was more F.O.C. at July 15 and Aug. 20 treatments than F.O.N.D treatment. The dry rhizome yield of F.O.C. at July 15 treatment was increased 40% compare to F.O.N.D treatment. Essential oil content of F.O.C. at July 15 treatment was increased 12% compare to F.O.N.D treatment.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• v.y2005m4
• /
• pp.83-87
• /
• 2005

In this paper, the combustion characteristics of a hybrid propulsion system were studied with various L/D(length vs diameter) ratio of the single port type solid fuel. Experiments of L/D ratio change were performed for 2 cases with the fixed grain port diameter and fuel length respectively. For the First case, results show that there are no large variation for regression rates as the L/D ratio changes. And as the L/D ratio increases, the O/F ratio and thrust tends to increase. For the Second case, there are no large change for O/F ratio and thrust as L/D ratio changes. On the other hand, as the L/D ratio decreases, only the regression rate tends to increase.

• Journal of the Korean Magnetics Society
• /
• v.5 no.2
• /
• pp.119-122
• /
• 1995

We have measured the magnetic susceptibilities of a CuF/sub 2/ .center dot. 2H/sub 2/O sample by means of the SQUID(superconducting quantum interference device) at the magnetic fields of 0.5 T and 1 mT, in the temperature range 5-300 K. The sample was found to contain some nonmagnetic calcium and magnesium impurities by the elemental analysis. Our measurements differ from known results for pure Cu F/sub 2/ .center dot. 2H/sub 2/O and are well explained by the effect of the nonmagnetic impurities in our sample. The purity of our sample derived from the temperature dependence of the susceptibilities was compared with that from the elemental analysis.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.16 no.2
• /
• pp.59-65
• /
• 2006

Al-doped and F-doped ZnO (ZnO : Al & ZnO : F) thin films were coated onto glass substrate by sol-gel method. These films showed c-axis orientation in common, but different I(002)/[I(002) + I(101)] and FWHM (full width at half-maximum). In particular, the grain size of the ZnO : Al films decreased with the increase in the Al-doping concentration, while for the ZnO : F films the grain siae increased up to F 3 at% and then decreased. For the electrical properties, Hall effect measurement was used. The resistivity of the ZnO : Al films and the ZnO : F films were, respectively, $2.9{\times}10^{-2}{\Omega}cm$ at Al 1 at% and $3.3{\times}10^{-1}{\Omega}cm$ at F 3 at%. Moreover compared with ZnO:Al films, ZnO:F films have lower carrier concentration (ZnO : Al $4.8{\times}10^{18}cm^{-3}$, ZnO : F $3.9{\times}10^{16}cm^{-3}$) and higher mobility (ZnO : Al $45cm^2/Vs$, ZnO : F $495cm^2/Vs$). For average optical transmittances, ZnO : Al thin films have $86{\sim}90%$ and ZnO : F films have $77{\sim}85%$ comparatively low.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2007.11a
• /
• pp.256-259
• /
• 2007

In this paper, the combustion characteristics of hybrid rocket were studied with various port number of the cylindrical multi-port grain. For the regression rate case, as the port number increases, the both port regression rate and end-surface regression rate tend to increase. For the performance parameter case, as the port number increases, the O/F ratio tends to decreases and the specific impulse tends to increase.

• Journal of the Korean Chemical Society
• /
• v.42 no.6
• /
• pp.629-637
• /
• 1998

The HF-SCF, MP2 and B3LYP calculations have been performed on the two conceivable clusters $(HF)_2(CO)$ trimers as well as their dimer complexes FH…FH, FH…CO and FH…OC applying $6-31+G^{\ast}^{\ast}$, and $6-311+G^{\ast}^{\ast}$ basis sets. A variety of ground state properties of these trimer complexes have been listed, and compared with corresponding properties of isolated monomers and combined dimers. It was calculated that FH…CO is more stable than FH…OC by average 0.85 kcal/mol and F-H…F-H…C≡O is more stable than F-H…F-H…O≡C by 1-2 kcal/mol. The C≡O stretching bands of the F-H…F-H…C≡O and F-H…F-H…O≡C were red shifted by 24, $37\;cm^{-1}$ compared with the FH…CO and FH…OC respectively. Also, H-F stretching bands were red shifted by 54 and $353\;cm^{-1}$.

• Journal of the Korean Magnetics Society
• /
• v.7 no.5
• /
• pp.243-248
• /
• 1997

The effect of $O_2$ partial pressure on microstructure and soft magnetic properties of as-deposited Fe-Hf-O thin film alloys, which are produced by rf magnetron sputtering method in $Ar+O_2$ mixed gas atmosphere, are investigated. Saturation magnetization ($4{\pi}M_s$) of Fe-Hf-O film were decreased with increasing $O_2$ partial pressure, the best soft magnetic properties exhibit at $O_2$ partial pressure of 10%. With further increase of $O_2$ partial pressure, soft magnetic properties decreased continuously. The $Fe_{82}Hf_{3.4}O_{14.6}$ film with $P_{O2}=10%$ exhibits good soft magnetic properties with $4{\pi}M_s=17.7kG$, $H_c=0.7Oe$ and ${\mu}_ {eff}$ (1~100 MHz)=2,500, respectively. The addition of O is effective in grain refinement. In case of $P_{O2}=15%$, it is observed that $Fe_3O_4$ compound is formed and high frequency soft magnetic properties are decrease. The electrical resistvity($\rho$) of Fe-Hf-O film is increased with increasing $O_2$ partial pressure. Electrical resistivity of $Fe_{82}Hf_{3.4}O_{14.6}$ film was 5 times higher than that of the film without oxygen. Thus, it is considered that the good magnetic properties of $Fe_{82}Hf_{3.4}O_{14.6}$ film results from decreasing the $\alpha$-Fe grain size by precipitates (Hf and O), high electrical resistivity.